• Journal of the Korea Society of Computer and Information
• /
• v.11 no.5 s.43
• /
• pp.165-173
• /
• 2006

Network Mobility Basic Support protocol enables mobile network to change their point of attachment to the Internet, but causes some problems such as suboptimal muting and multiple encapsulations. The proposed scheme, combining Prefix Delegation protocol with HMIPv6 concept can provide more effective route optimization and reduce the amount of packet losses and the burden of location registration for handoff. It also uses hierarchical mobile network prefix (HMNP) assignment and provides tree-based routing mechanism to allocate the location address of mobile network nodes (MNNs) and support micro-mobility. In this scheme, Mobility Management Router (MMR) not only maintains the binding informations for all MNNs in nested mobile networks, but also supports binding procedures to reduce the volume of handoff signals oyer the mobile network. The performance is evaluated using NS-2.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37 no.8B
• /
• pp.687-694
• /
• 2012

In OFDMA-based cellular system, inter-cell interference (ICI) reduces system capacity by aggravating receiving performance of the users located in edge of the cell. Therefore, to mitigate ICI is very important issue in cellular system. To deal with ICI problem, fractional frequency reuse (FFR) is introduced. FFR is an interference management technique. It separates each cell into inner cell and outer cell. Then, it allocates whole system bandwidth to inner cell and different frequency partition to each sector of outer cell. By doing this, outer cell users can ignore interferences from adjacent cells. So, the receiving performance of the cell edge users can be fairly increased. However, using FFR technique has a fatal side effect. In order to use different frequency partition among three sectors of outer cell, they can use only a third of the whole system bandwidth. Then, the reduction of available bandwidth reduces the system throughput directly. To solve this problem, we propose a new FFR method that allocates partially overlapped frequency partition to each sector of outer cell. And then, we suggest a proper overlapping ratio for practical cellular system.

• Journal of Advanced Navigation Technology
• /
• v.23 no.3
• /
• pp.237-244
• /
• 2019

Since SBAS provides users with GNSS orbit, clock, and ionospheric corrections and integrity, the more precise positioning is possible. As the SBAS service area is expanded due to the development of the SBAS and the installation of the additional ground stations, there is a region where two or more SBAS messages can be received. However, the research on multi-constellation SBAS selection method has not carried out. In this study, we compared the result of positioning accuracy after applying the SBAS correction selected by using WAAS priority, EGNOS priority, or error covariance comparison method to LEO satellites in the regions where WAAS and EGNOS signals are transmitted simultaneously. When using WAAS priority method, 3D orbit error is smallest at 2.57 m. The covariance comparison method is outperform at the center of the overlap region far from each WAAS and EGNOS stations. In the eastern region near the EGNOS stations, the 3D orbit errors using EGNOS priority method is 8% smaller than the errors using the WAAS priority method.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.06a
• /
• pp.461-465
• /
• 2007

MANET(Mobile Ad hoc Networks) is free-mobility formation of mobile nodes in the wireless networks. Generally, wireless networks has two main type of structures which Tree and Mesh. These general structure is difficult to do which connectivity, redundancy transmit and network continuant. In this paper, we would suggest a new ODDMRP(Ontology Doppler effect-based Dynamic Multicast Routing Protocol) technology for effective MANET which Ontology Doppler effect-based. ODDMRP consist of the parameters for node entropy when using Doppler effect which moving position of round node, moving time, and distribution chart in velocity also it express distance of destination node and property structure organization. It would be used to provide improvement to keep the optimal communication routing and also could be improve network stabilization, and continuation durability of connectivity.

• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.35S no.10
• /
• pp.42-51
• /
• 1998

This paper suggests a congestion control scheme for CL (ConnectionLess) overlay network using the feedback loops between CL user and CL server, between CL servers, and between end-to-end CL users, and the header translation table of CL server. The CL overlay network for CBDS(Connectionless Broadhand Data Service) defined by ITU-T((International Telecommunication Union-Telecommunication) consists of CL servers which route frames and links which connect between CL user and CL server or between CL servers. In the CL overlay network, two kinds of congestion, CL link congestion and CL server congestion, may occur. We considered the schemes to solve the congestion. link-by-link method[18] has used the ABR feedback loops of ATM layer between CL user and CL server or between CL servers, and the congestion table using header translation table of CL server. As in congestion of output virtual channel this method has an effect on all the traffic transmitting through the link, then it has an effect on the traffic that has not caused the congestion. As a result, the link utilization of output virtual channel that does not bring the congestion and outputs the traffic is decreased. To overcome this drawback of link-by-link, we proposed the hybrid method that are using the ABR feedback loops of link-by-link method, the feedback loop between CL users in end-to-end, the congestion table using and the header translation table. This scheme deals with teh congestion immediately by link-by-link loops and the header translation table, and then regulates the sending rate of CL user that causes the congestion by end-to-end loop.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.37 no.10
• /
• pp.26-36
• /
• 2000

In this paper, we design the nonoverlapping multicarrier modulation (MCM) system for high rate paging system and evaluate the Performance by computer simulation. In conventional paging system, FSK was usually used, but we select QAM for high bandwidth efficiency. Transmitter structure adopts that of 4-16QAM of the iDEN$\^$TM/ and receiver consists of symbol timing recovery, carrier recovery and automatic gain control. In addition, pilot symbol aided modulation (PSAM) which can overcome the simulcast fading channel is considered and we also propose the optimum pilot symbol pattern. Finally, we show the performance of the overall 4-16QAM system by computer simulation.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.19 no.12
• /
• pp.2813-2819
• /
• 2015

In this paper, we investigate the physical layer network coding (PNC) technique in a two-way relay channel (TWRC) where two source nodes send and receive data with each other via a relay node. In particular, we consider the communication scenario where packet length from the two sources is different from each other. We analyze the bit error rate (BER) of the received packet at the relay node according to degree of overlapping between two packets. The BER of the short packet remains unchanged regardless of the degree of overlapping since the entire packet is overlapped with the longer packet, while the BER of the longer packet becomes improved as the degree of overlapping decreases. Thus, we need a novel transmission scheme to enhance BER performance of the PNC technique in TWRC environments since the overall BER performance of the PNC technique at the relay node depends on the worse BER between two ovelapping packets' BERs.

• Journal of KIISE:Information Networking
• /
• v.31 no.1
• /
• pp.62-69
• /
• 2004

The cluster structure reduces the number of retransmission messages, when a broadcast to all hosts in ad hoc network is needed. A cluster maintenance scheme is employed to preserve this advantage from time to time. However, most of the cluster maintenance schemes require additional control messages for cluster reformation as well as control messages for acquiring neighbor information. This mitigates the advantages of employing cluster structure in ad hoc network. In this paper, a cluster maintenance scheme which forces only clusterheads to broadcast control messages during hello time is proposed. When the cluster reformation is needed, the proposed scheme employs a strategy to reduce the control messages to a minimum. In these processes, the proposed scheme doesn't violate the definition of 2-cluster and produces the clusters in fully distributed method. The simulation results prove that our scheme is better than LCC(1).

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.2
• /
• pp.40-49
• /
• 2015

PicoCast is a recently proposed short-range wireless communications technology that supports both low rate sensor/control data and high speed data such as voice and video traffic in the personal space, defined by the user-centric space of radius tens of meters, with one unified protocol. When the users are in the same area, personal spaces defined by each user may overlap. Since these PicoCast piconets may simultaneously operate, mutual interference is unavoidable. It is necessary to investigate the effect of mutual interference on data transmission and to conduct research on minimizing the interference among PicoCast devices. In this paper we analyze the effect of mutual interference between PicoCast piconets based on data throughput using OPNET network simulator. We have implemented the PicoCast protocol and measured the average throughput and packet loss rate.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.1 s.116
• /
• pp.53-61
• /
• 2007

This paper researches on the scheme superimposing the rotation phases over the pilot and data symbols in order to reduce the peak-to-average power ratio(PAPR) of the orthogonal frequency division multiplexing(OFDM) communication. The bandwidth and power efficiency are the main consideration. The phases of rotation vector are added to those of both pilot symbols and data symbols interlaying between any two pilot symbols in an OFDM block. Owing to this scheme the transmitter reduces the PAPR using the partial transmit sequences(PTS) and the receiver restores the data symbol utilizing the channel estimation of pilot symbols. Therefore, the bandwidth efficiency is accomplished by not using the further subcarriers for the reduction of PAPR and the enormous increase of bit error rate according to the receiving error of the side information, i.e. the phases of rotation vector, is prevented. In other words, both bandwidth-and power-efficiency and quality of communication performance can be improved.