• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.16 no.5
• /
• pp.152-161
• /
• 2017

The CBTC(Communication based Train Control) system employed on 2.4GHz ISM band adopt the IEEE802.11.x standard. Therefor communication time delay, distortion and data losses will be produced. To overcome these problems, CPSK(Continuous Phase shift keying) modulated DS/SS(Direct Sequence Spread Spectrum) transmitter with 908MHz carrier frequency is proposed. Through the eye diagram and scatter diagram the performance is analysed. And the phase noise characteristic of the local oscillator is measured about 60dBc/Hz, this means that the phase noise performance is very good compared to the signal. Reference frequency suppression of the 2nd local oscillator is 50dB below compared to the signal. Through the polarities of the complementary signal equally probable, the line spectrum of the output spectrum is eliminated. The nonlinear effects which introduce the spectral spreading or spectral regeneration is reduced remarkably.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.5
• /
• pp.83-91
• /
• 2001

This paper proposes the Focused beamforming to estimate the location of target residing near to the observation platform in the underwater environment. The Focused beamforming technique provides the location of target by the coherent summation of a series of incident spherical waveforms considering distinct propagation delay times at the sensor array. But due to the movement of the observation platform and the variation of the underwater environment, the shape of the sensor array is no longer to be linear but it becomes distorted as the platform moves. Thus the Focused beamforming should be peformed regarding to the geometric shape variation at each time. To estimate the target location, the artificial image plane comprised of cells is constructed, and the delays are calculated from each cell where the target could be proximity to sensors for the coherent summation. After the coherent combining, the beam pattern can be obtained through the Focused beamforming on the image plane. Futhermore to compensate the variation of the shape of the sensor array, the paper utilizes the Nth-order polynomial approximation to estimate the shape of the sensor array obeying the water pulley modeling. Simulation results show the performance of the Focused beamforming for different frequency bands of the radiated signal.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.3
• /
• pp.603-611
• /
• 2013

In this paper, we propose a new method which estimates and encrypts significant component of digital image such as digital cinema using discrete wavelet packet transform (DWPT). After analyzing the characteristics of images in spatial and frequency domain, the required information for ciphering an image was extracted. Based on this information an ciphering method was proposed with wavelet transform and packetization of subbands. The proposed algorithm can encrypt images in various robust from selecting transform-level and energy threshold. From analyzing the encryption effect numerically and visually, the optimized parameter for encryption is presented. Without additional analyzing process, one can encrypt efficiently digital image using the proposed parameter. Although only 0.18% among total data is encrypted, the reconstructed image dose not identified. The paketization information of subbands and the cipher key can be used for the entire secret key.

• The Journal of Engineering Geology
• /
• v.5 no.2
• /
• pp.181-192
• /
• 1995

The discrimination studies between earthquakes and underground nuclear explosions have been carried out by various seismologists(Nuttli and Kim, 1976; Dahiman and Israelson, 1977; Masse, 1981). The discrimination between local microearthquakes and artificial underground explosions(epicentral distance not greater than 400Km), however, has not been actively studied so far in the light of seismological aspects. Futhermore this kind of research has never been performed in Korea even if it is of great importance for IAEA (International Atomic Energy Agency) to clearly analyze the military nuclear power of North Korea at present. This research has been carried out by using some of the artificial underground explosions(about 100 events) have occurred in North Korea for the last six years. The azimuths, apparent incidence angles, epicentral distances and locations are determined using a single station of 3 - component data. The detection, location and identification are performed through the polarization and the bandpass filtering. This technique can be also applied to study the inhomogeneous crustal structure finding the converted waves.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.11C
• /
• pp.905-916
• /
• 2008

In this paper, we propose a new method which estimates and encrypts significant component of digital hologram using discrete wavelet packet transform (DWPT). After analyzing the characteristics of digital hologram in spatial and frequency domain, the required information for ciphering digital hologram was extracted. Based on this information an ciphering method was proposed with wavelet transform and packetization of subbands. The proposed algorithm can encrypt digital hologram in various robust from selecting transform-level and energy threshold. From analyzing the encryption effect numerically and visually, the optimized parameter for encryption is presented. Without additional analyzing process, one can encrypt efficiently digital hologram using the proposed parameter. Although only 0.032% among total data is encrypted, the reconstructed object dose not identified. The paketization information of subbands and the cipher key can be used for the entire secret key.

• Geophysics and Geophysical Exploration
• /
• v.21 no.2
• /
• pp.94-102
• /
• 2018

To characterize virtual reflection images of deep subsurface by the method of seismic interferometry, we analyzed effects of offset range, ambient noise, missing data, and statics on interferograms. For the analyses, seismic energy was simulated to be generated by a 5 Hz point source at the surface. Vertical components of particle velocity were computed at 201 sensor locations at 100 m depths of 1 km intervals by the finite difference method. Each pair of synthetic seismic traces was cross-correlated to generate stacked reflection section by the conventional processing method. Wide-angle reflection problems in reflection interferometry can be minimized by setting a maximum offset range. Ambient noise, missing data, and statics turn to yield processing noise that spreads out from virtual sources due to stretch mutes during normal moveout corrections. The level of processing noise is most sensitive to amplitude and duration time of ambient noise in stacked sections but also affected by number of missing data and the amount of statics.

• The Proceedings of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.11 no.1
• /
• pp.92-98
• /
• 1997

In this paper, the results of the measurement and analysis of extremely low freqency(ELF) eletric field in the vicinity of 154[kV] overhad transmission lines have been described. The planar-type electric field sensor has been fabricated by three dimensional structure with special consideration of taking the power frequency and lower components. The calibration experiments have been carried out according to the procedures of IEEE recommendation. The electric field measuring system has the frequency bandwidth of 7[Hz] to 2.7[MHz] and the response sensitivity of 0.094[mV/V/m]. Also the practical measurements of electric field under an 154[kV] double corcuit overhead transmission lines have been made abd abalyzed. It was known that the lateral electric field profiles under an 154[kV] double circuit overhead transmission lines show the asymmetrical distributions owing to the environmental metal frame structures and their maximum electric field magnitude is less than 3[kV/m]. It can be concluded that the measured results of the electric fields satisfy with all limits or guide -lines of the various authorized international institutes' recommendations.

• The KIPS Transactions:PartB
• /
• v.15B no.4
• /
• pp.307-314
• /
• 2008

This paper presents a new robust watermarking method for curves that uses informed-detection. To embed watermarks, the presented algorithm parameterizes a curve using the B-spline model and acquires the control points of the B-spline model. For these control points, 2D mesh are created by applying Delaunay triangulation and then the mesh spectral analysis is performed to calculate the mesh spectral coefficients where watermark messages are embedded in a spread spectrum way. The watermarked coefficients are inversely transformed to the coordinates of the control points and the watermarked curve is reconstructed by calculating B-spline model with the control points. To detect the embedded watermark, we apply curve matching algorithm using inflection points of curve. After curve registration, we calculate the difference between the original and watermarked mesh spectral coefficients with the same process for embedding. By calculating correlation coefficients between the detected and candidate watermark, we decide which watermark was embedded. The experimental results prove the proposed scheme is more robust than previous watermarking schemes against print-scan process as well as geometrical distortions.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.6
• /
• pp.155-166
• /
• 2016

It is important to configure capacitance(C) of the capacitor and the induction coefficient(L) of the work coil on the resonant circuit design stage in order to induce heating on the object by a precise and constant frequency components in the electromagnetic induction heating equipment. Work coil conducts a direct induction heating according to heating point and area of the object which has a fixed heat factor so that work coil is designed to has fixed value. On the other hands, Capacitor should be designed to be changed in order to be the higher the utilization of the entire equipment. It is extracted the samples by variation of single electrode capacity from the selection stage of raw materials for capacity to the stage of process design for output of the high frequency LC resonance of 700kHz on 1000 VAC maximum voltage and current to $200I_{MAX}$. It is suggested fundamental experiment results in order to prove relation for the optimal design of HF-LC resonance conduction-cooled capacitor based on the response of frequency characteristics and results of output parameters according to variation of the capacitance size.

• Journal of the Korea Convergence Society
• /
• v.8 no.2
• /
• pp.121-126
• /
• 2017

In this study, we measured the bioelectrical impedance of whole body in various frequency bands by non-invasive method by four electrode method using a portable small impedance measurement system developed to understand the bioimpedance characteristics of intracellular fluid and extracellular fluid components through a skin equivalent model. The measurements were performed on 10 male subjects (mean age $24{\pm}3.0$, body mass index(BMI) $20.3kg/m^2$) for four weeks and the bioimpedances were measured at multi-frequencies (1 kHz, 5 kHz, 50 kHz, 70 kHz, 100 kHz and 500 kHz). Experimental results show that the impedance is the highest in the low frequency range of 1 kHz and the lowest in the high frequency range of 500 MHz. Especially, it was confirmed through experiments that the impedance is rapidly lowered above 50 kHz band. In addition, it was confirmed that similar characteristics to the measured values of the bioimpedance measuring system were obtained in the simulations for understanding the impedance characteristics of the intracellular fluid and the extracellular fluid through the skin equivalent circuit model.