• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2008년도 하계학술대회 논문집 Vol.9
• /
• pp.138-138
• /
• 2008

In this study, effect of thickness on structural, electrical and optical properties of B doped ZnO:Al (AZOB) films was investigated. AZOB films were deposited on PC substrates by DC magnetron sputtering. The thickness range of films were from 300 nm to 800 nm to identified as increasing thickness, stress between substrate and AZOB film. The. average transmittance of the films was over 80 % until 500 nm. Then a resistivity of $1.58\times10^{-3}\Omega$-cm was obtained. We presented that a AZOB film of 500 nm was optimization to obtain a high transmittance and conductivity.

• 한국전기전자재료학회논문지
• /
• 제16권8호
• /
• pp.657-662
• /
• 2003

This paper presents a new fabrication method of selective SiGe epitaxial growth at 650 $^{\circ}C$ on (100) silicon wafer with oxide patterns by reduced pressure chemical vapor deposition. The new method is characterized by a cyclic process, which is composed of two parts: initially, selective SiGe epitaxy layer is grown on exposed bare silicon during a short incubation time by SiH$_4$/GeH$_4$/HCl/H$_2$system and followed etching step is achieved to remove the SiGe nuclei on oxide by HCl/H$_2$system without source gas flow. As a result, we noted that the addition of HCl serves not only to reduce the growth rate on bare Si, but also to suppress the nucleation on SiO$_2$. In addition, we confirmed that the incubation period is regenerated after etching step, so it is possible to grow thick SiGe epitaxial layer sustaining the selectivity. The effect of the addition of HCl and dopants incorporation was investigated.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2000년도 하계학술대회 논문집 C
• /
• pp.1763-1765
• /
• 2000

This paper presents deposition and characterizations of microcrystalline silicon ($\mu$ c-Si:H) films prepared by hot wire chemical vapor deposition at substrate temperature at 300$^{\circ}C$. The flow rates of $SiH_4$ gas are critical parameter for the formation of Si films with microcrystalline phase. We could obtain $\mu$ c-Si:H with columnar grain structure and volume fraction of 75% without H2 dilution. The electronic properties, hydrogen bonding configurations, and $H_2$ concentration inside the films are also strongly affected by $SiH_4$ flow rate, which is provided in this paper.

• 한국세라믹학회지
• /
• 제40권3호
• /
• pp.262-267
• /
• 2003

Off-axis 고주파 마그네트론 스퍼터링법으로 사파이어(0001) 기판 위에 이종에피텍셜 ZnO 박막을 제조하였다. ZnO 박막의 결정성은 증착압력, RF power 그리고 기판온도의 공정조건 변화에 많은 영향을 받았으며, 스퍼터링된 입자의 적당한 kinetic energy와 기판표면에서의 표면이동도(surface mobility)가 조화를 이룰 때 결정성이 우수한 이종에피텍셜 박막을 을 얻을 수 있었다. 이종에피텍셜 ZnO 박막의 Photoluminescence(PL) 특성 측정 결과, 저온(17K)에서 약 3.36 eV의 자외선 영역 발광을 관찰할 수 있었으며, 상온에서도 3.28 eV의 자외선 영역 발광을 관찰할 수 있었다. ZnO 박막을 산소 분위기에서 열처리함에 따라 결정성은 향상되는 반면 자외선 영역의 발광은 급격히 감소하는 경향을 보였다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2002년도 춘계합동학술대회 논문집
• /
• pp.153-157
• /
• 2002

This paper deals with the relationships between MgO manufacturing condition and misfiring at low temperature. The characteristics of MgO are affected by substrate temperature and MgO deposition current. In this study. the. substrate temperature was varied from $100^{\circ}C$ to $200^{\circ}C$. And the MgO deposition current was varied from 5mA to 20mA. As a result. the misfiring at low temperature was decreased in the panels with substrate temperature $200^{\circ}C$ and MgO deposition current 5mA. These results may be explained that the higher substrate temperature and lower MgO deposition current makes the denser film formation.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.42-42
• /
• 2007

In the future, electronic components will be integrated on flexible polymer substrates and then miniaturized by thin films using suitable thin film technologies. In this article, the concept of a room temperature CVD is demonstrated using $Bi_3NbO_7$ (BNO) films with a cubic fluorite structure and their structural and electrical properties were investigated in films deposited without substrate heating. Effects of substrate temperature on electrical properties of BNO films were also studied. Films deposited without substrate heating (real temperature of $50^{\circ}C$) show partially crystallized BNO single phases with grain size of approximately 6.5 nm. Their dielectric and leakage properties are comparable to those of films deposited by pulsed laser deposition at room temperature. The concept of room temperature CVD will become a new paradigm in the deposition of dielectric thin films for flexible electron device applications.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.169-170
• /
• 2007

In this paper we report upon an investigation into the effect of sputter pressure and RF power on the electrical properties of Gallium doped zinc oxide (GZO) film. GZO films were deposited on glass substrate without substrate temperature by RF magnetron sputtering from a ZnO target mixed with 5 wt% $Ga_2O_3$. Argon gas pressure and RF power were in the range of 1~11 mTorr, and 50~100 W, respectively. However, the resistivity of the film was strongly influenced by the sputter pressure and RF power. We were able to achieve as low as $1.5{\times}10^{-3}\;{\Omega}cm$, without substrate temperature.

• 대한금속재료학회지
• /
• 제48권12호
• /
• pp.1109-1115
• /
• 2010

ZnO thin films were deposited on Si(100) substrates at low temperatures ($44^{\circ}C{\sim}210^{\circ}C$) by atomic layer deposition using DEZn (diethyl zinc) and water as precursors. The film thickness was measured by ellipsometry calibrated with cross-sectional TEM. The phase formation, microstructure evolution, UV-absorbance, and chemical composition changes were examined by XRD, SEM, AFM, TEM, UV-VIS-NIR, and AES, respectively. A uniform amorphous ZnO layer was formed even at $44^{\circ}C$ while stable crystallized ZnO films were deposited above $90^{\circ}C$. All the samples showed uniform surface roughness below 3 nm. Fully crystallized ZnO layers with a band-gap of 3.37 eV without carbon impurities can be formed at substrate temperatures of less than $90^{\circ}C$.

• 대한금속재료학회지
• /
• 제48권5호
• /
• pp.449-455
• /
• 2010

To enhance the efficiency of dye sensitized solar cells, we proposed crystalline anatase-$TiO_{2}$ by using a low temperature process ($150^{\circ}C{\sim}250^{\circ}C$). We successfully fabricated 30 nm-$TiO_{2}$ at a fixed atomic layer deposition condition of 1.0 sec of TDMAT pulse, 20 sec of TDMAT purge, 0.5 sec of H$_{2}$O pulse, and 20 sec of H$_{2}$O purge. In order to examine the microstructure, phase, and band-gap of the TiO$_{2}$ respectively, we employed a Nano-Spec, transmission electron microscope, high resolution XRD, Auger electron spectroscopy, scanning probe microscope, and UV-VIS-NIR. We were able to fabricate a crystalline anatase-phase of 30 nm-TiO$_{2}$ successfully at temperatures above $180^{\circ}C$. Our results showed that our proposed low temperature ALD process (below $200^{\circ}C$) might be applicable to glass and flexible polymer substrates.

• 한국자기학회지
• /
• 제17권2호
• /
• pp.81-85
• /
• 2007

분자선 증착법을 이용하여 MnTe 박막을 Si(100):B 및 Si(111) 기판 위에 성장시켰다. 두개의 K-cell을 사용하여 기판온도 $400^{\circ}C$ 및 Te가 풍부한 조건에서 MnTe 합성이 잘 이루어졌다. 이 경우 증착속도는 $1.1 {\AA}/s$이었고 성장된 층의 두께는 $700{\AA}$ 정도이었다. 합성된 MnTe 박막들에 대하여 X선회절, 초전도 양자 간섭계, Physical Property Measurement System, 홀효과 측정 등을 사용하여 그 구조적, 자기적, 전기적 특성들을 조사하였다. X선회절 측정 결과 Si(100) : B및 Si(111)기판 위에 성장된 MnTe는 다결정성의 hexagonal 구조를 나타내었으며, 자기적, 전기적 특성 측정 결과 분말형태의 MnTe와 비교하여 매우 다른 특성을 나타내었다. Zero-field-cooling(ZFC) 및 field-cooling(FC) 조건에서 취해진 자화율 측정에서 다결정 박막은 21 K, 49K, 210K 근처에서 자기적 전이 현상을 보였으며, ZFC와 FC 자화율 사이의 큰 불가역성이 나타났다. MnTe박막의 5K와 300K에서의 자기이력곡선은 강자성 상태를 나타내었으며 잔류자화값과 보자력은 5 K에서 $M_R= 3.5emu/cm^3$와 $H_c=55Oe$를, 300 K에서 $M_R= 2.1emu/cm^3$와 $H_c=44Oe$로 나타났다. 전기수송 특성 측정 결과, 온도에 따른 비저항은 저온에서 Mott variable range hopping 전도특성을 나타내는 전형적인 반도체 성질을 보여주었다.