• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.10 no.5
• /
• pp.69-75
• /
• 2010

Advanced T-DMB(Terrestial DMB )system which is a new portable mobile broadcasting system has been developed to increase data rate up to double of conventional T-DMB in same bandwidth while maintaining backward compatibility, using hierarchical modulation method. The Advanced T-DMB system realize high qualification of conventional T-DMB system by adding BPSK signal or QPSK signal as enhanced layer to existing DQPSK signal. The enhanced layer signal should be small enough to maintain backward compatibility and to minimize the coverage loss of existing T-DMB service area. But this causes the enhanced layer signal of Advanced T-DMB susceptible to fading effect in transmission channel. In this paper we applied the duo-binary turbo code which has powerful error correction capability to the enhanced layer signal for compensating channel distortion. And the computer simulation results about the performance of the duo-binary turbo code in Advanced T-DMB system are presented along with analysis comments.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.25 no.4
• /
• pp.393-400
• /
• 2014

In this paper, we have designed the transmitter for earth station terminal operating with military geostationary satellite on Ka-band that is complied with MIL-STD-188-164A. The designed antenna of this terminal is dual-offset gregorian reflector which is consist of corrugated horn and iris polarizer, othermode transducer. This antenna meets radiation pattern and transmit EIRP spectral density requirements in this standard. The designed RF systems of this terminal are consist of Block Up Converter(BUC) converting frequency band from IF to Ka band and SSPA having low-power consumption and compact light-weight using the pHEMT MMIC compound devices. This RF systems applied with VSWR, spurious/harmonic suppression, output flatness and phase noise requirement in this standard.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.6
• /
• pp.472-480
• /
• 2009

This paper describes the overmodulative SVPWM technique and harmonics analyses of three phase NPC type three-level inverter to the modulation index. Three phase NPC type three-level inverter adopted SVPWM to extend the linear region to 0.907, moreover, the following voltage compensation using Fourier series was adopted in the region of overmodulation to make it work to six-step level. PD type of multi carrier method is used with the double Fourier series for the analysis of output power harmonics characteristic. Simulation was performed by PSIM, and the harmonics characteristics of 3-level inverter in each region are analyzed. The side band harmonics of carrier frequency are dominant in the linear region, but these harmonic components are decreased as the inveter goes to overmodulation region, and the harmonics due to the fundamental frequency is increased gradually at the same time. The harmonic analyses are verified through the simulation and experimental results under the same condition.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.39 no.4
• /
• pp.25-35
• /
• 2002

This work describes an 8b 200MHz time-interleaved subranging analog-to-digital converter (ADC) based on a single-poly digital CMOS process. Two fine ADCs for lower digital bits of the proposed ADC employ a time-sharing double-channel architecture to increase system speed and a new reference voltage switching scheme to reduce settling time of the reference voltages and chip area. The proposed intermeshed resistor string, which generates reference voltages for fine ADCs, improves linearity and settling time of the reference voltages simultaneously. The proposed sample- and-hold amplifier(SHA) is based on a highly linear common-drain amplifier and passive differential circuits to minimize power consumption and chip area with 8b accuracy and employs input dynamic common mode feedback circuits for high dynamic performance at a 200MHz sampling rate. A new encoding circuit in a coarse ADC simplifies the signal processing between the coarse ADC and two successive fine ADCs.

• Journal of the Institute of Electronics Engineers of Korea CI
• /
• v.38 no.4
• /
• pp.33-38
• /
• 2001

Readout signal of high density DVD-RAM disk output was simulated to analyze the effect of crosserase and crosstalk to the readout signal which is one of the main difficulties to realize high density DVD-RAM system having single side recording density of 4.7 G13 and 15 G13 media. Laser beam intensity impinged on the disk was approximated as Gaussian and recorded marks were assumed elliptical and the readout signal was calculated as a two dimensional convolution of laser beam pattern and recored mark pattern. From the readout signal obtained by varying crosserase ratio, carrier levels with period of 3T to 11 T were calculated and compared. Jitter due to crosserase and crosstalk was calculated and compared using 1,000 random marks having 3T to 11T period. The results showed that the jitter due to crosserase turned out to be smaller than the jitter due to crosstalk.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.3
• /
• pp.3-9
• /
• 2014

Two-way full-duplex relay network provides improved spectral efficiency by using either superposition coding or physical layer network coding at relays compared to conventional two-way half-duplex relay network. In this paper, we investigate the impact of residual loop interference on the performance of the two-way full-duplex relay network. Users and relays in the two-way full-duplex relay network estimate the residual loop interference in order to cancel it. However, it is difficult to perfectly cancel the residual loop interference from the received signal due to the estimation error. Numerical results show the impact of the estimation error on the outage probability of the two-way full-duplex relay network.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.12 s.103
• /
• pp.1206-1212
• /
• 2005

In this paper, we propose a novel antenna structure which uses the electric and magnetic currents so as to eliminate nulls on their radiation pattern. The tag antenna was matched to the conjugate impedance of the commercial tag chip using the modified double T matching network. The radiation efficiency is about $90\%$, and the bandwidth($S_{11}< -10 dB$) is 848${\~}$926 MHz. Also it shows the gain deviation between the maximum and minimum gains about 4 dB at any direction of the tag antenna at the operating frequency. The readable range of the tag is 1.7${\~}$2.4 m for an arbitrary rotation angle of the tag with a commercial tag chip.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.16 no.12 s.103
• /
• pp.1222-1228
• /
• 2005

Analysis on the field uniformity inside of a reverberation chamber was done at 2.45 GHz which is an operating frequency of MWO(Microwave Oven). The Schroeder's Quadratic Residue Diffuser was designed for the chamber, and 3 different types of diffusers have been investigated using the finite-difference time-domain(FDTD) method for the field characteristics of each type. Type 2 and 3 diffusers were filled with dielectric material, and the size of these could be designed smaller than Type 1, without degradation of field characteristic. Type 3 diffuser shows better results among the three types of diffusers in view of increased test region and better field uniformity.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.11
• /
• pp.1259-1268
• /
• 2010

In this paper, we presented a new LC prototype synthesis method for the multi-band filter. For synthesis a multi-band filter with the required frequency response, we proposed the diagram of poles and zeros, also, we proposed the optimization process for finding the combination of optimized poles and zeros. From the transfer and reflection functions calculated from poles and zeros, we performed the quasi-elliptic LC prototype synthesis of multi-band filter. Using the proposed LC prototype synthesis method of multi-band filter, dual-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500 MHz) and triple-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500, 5,725~5,850 MHz) were designed and fabricated.

• Proceedings of KOSOMES biannual meeting
• /
• 2007.11a
• /
• pp.211-214
• /
• 2007

In this paper, we have designed microstrip antenna if 800[MHz] band It will be able to integrate TRS(Trunked Radio System), GSM(Global System for Mobile telecommunication) band including the CDMA(Code Division Multiple Access) band we designed repeater and a base station antenna which is possible at the ship and marine of safety. It is improves a narrow bandwidth problem of microstrip antenna. It had U-shaped feeding structure at a rectangular patch And ground or feeding structure used between dielectric constant(${\varepsilon}_T$ = 2.1), patch or feeding structure used between dielectric constant(${\varepsilon}_T$ =1). So it used a duplex resonance effect Designed frequency bandwith(V5WR 2:1) if the antenna showed good characteristic of $780[MHz]{\sim}1.83[GHz]$ to 2.61[GHz]. Also the E-plan and H-plan all profit 9.4[dBi] above, the 3[dB] beam width showed the characteristic over the E-plan and H-plan $60^{\circ}$ to be improved.