• The Transactions of the Korean Institute of Power Electronics
• /
• v.5 no.2
• /
• pp.163-169
• /
• 2000

From the viewpoint of the cost effective design of power conversion systems, it is very important to fully u utilize the CillTent capacity of power devices over all circumstances. Therefore this paper deals with the l practical design of digital CillTent controller to meet the requirements of fast and overshoot free control r response over the varying control voltage bOlmds, the accompanied computational delay, and the system U W1certainties. The proposed controller consists of high gain PI control schemes using both the conditional i integrator and the modified delay compensator. The simulation and experimental results show the validity of t the proposed controller.

• Proceedings of the IEEK Conference
• /
• 2001.09a
• /
• pp.951-954
• /
• 2001

본 논문에서는 SDR (Software Defined Radio)시스템을 위한 디지털 IF (Intermediate Frequency)수신기를 구현하였다[1][2]. 구현된 수신기의 하드웨어 구조는 AD변환부, PDC(Programmable Down Converter)부, DSP (Digital Signal Processing)부분으로 이루어졌다. AD변환부는 Analog Devices사의 AD6644를 이용하여 아날로그 신호를14bit의 디지털 신호로 변환된다. PDC부분은 Intersil사의 HSP 50214B를 이용하여 14bit 샘플 된 IF(Intermediate Frequency)입력을 혼합기와 NCO(Numerically Controlled Oscillator)에 의해 기저대역으로 다운 시키는 역할을 한다. PDC는 CIC (Cascaded Integrator Comb)필터, Halfband 필터 그리고 프로그램할 수 있는 FIR필터로 구성되어 있다. 그리고 PDC부분을 제어하고 PDC부분에서 처리할 수 없는 캐리어, 심볼 트래킹을 위해 Texas Instrument사의 16비트의 고정소수점 DSP인 TMS320C5416과 Altera사의 FPGA를 사용하였다. 그러므로 중간주파수 대역과 기저대역 간의 신호변환을 디지털 신호처리를 수행함으로써 일반적인 아날로그 처리방식보다 고도의 유연성과 고성능 동작이 가능하고 시간과 환경 변화에 우수한 동작 특성을 제공한다.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2007.10a
• /
• pp.187-191
• /
• 2007

This paper describes a 3.3V 10 bit CMOS digital-to-analog converter with a divided architecture of a 7 MSB and a 3 LSB, which uses an optimal Thermal-to-Binary Decoding method with monotonicity, glitch energy. The output stage utilizes here implements a return-to-zero circuit to obtain the dynamic performance. Most of D/A converters in decoding circuit is complicated, occupies a large chip area. For these problems, this paper describes a D/A converter using an optimal Thermal-to-Binary Decoding method. the designed D/A converter using the CMOS n-well $0.35{\mu}m$ process0. The experimental data shows that the rise/fall time, settling time, and INL/DNL are 1.90ns/2.0ns, 12.79ns, and a less than ${\pm}2.5/{\pm}0.7$ LSB, respectively. The power dissipation of the D/A converter with a single power supply of 3.3V is about 250mW.

• Journal of IKEEE
• /
• v.26 no.4
• /
• pp.577-583
• /
• 2022

Verilog-HDL-based modeling can be performed to confirm the fast operation characteristics after setting the design parameters of each block considering the stability of the system by performing linear phase-domain modeling on the phase-locked loop. This paper proposed Verilog-HDL modeling including DCO noise and DTC nonlinear characteristic. After completing the modeling, the time-domain transient simulation can be performed to check the feasibility and the functionality of the proposed PLL system, then the phase noise result from the system design based on the functional model can be verified comparing with the ideal phase noise graph. As a result of the comparison of simulation time (6 us), the Verilog-HDL-based modeling method (1.43 second) showed 484 times faster than the analog transistor level design (692 second) implemented by TSMC 0.18-㎛.

• Journal of Sensor Science and Technology
• /
• v.10 no.2
• /
• pp.142-147
• /
• 2001

Using transmission-line equivalent circuit based on cross-field model for an interdigital acoustic wave transducer, an efficient simulation technique of SAW filters by SPICE is proposed. Propagation of surface acoustic wave is modeled as transmission line so that frequency-dependent circuit elements are not needed in the equivalent circuit of an interdigital transducer. Because the equivalent circuits for frequency-dependent circuit elements are not derived approximately, and a small number of circuit elements are used in the equivalent circuit for filters, simulation time is much reduced. The utility of the proposed technique is demonstrated through simulation for the characteristics of SAW filters such as insertion loss, input admittance, passband ripple, and harmonic frequency response.

• Journal of Digital Contents Society
• /
• v.5 no.3
• /
• pp.199-204
• /
• 2004

A problem of many fractal image compression algorithms providing good quality at low bit rate is that the decoding time rests on an iterative procedure whose complexity is imag-dependent. This paper proposes an iterative-free fractal image decoding algorithm to reduce the decoding time. In the proposed method, under the encoder previously with the same codebook image as an initial image to be used at the decoder, the fractal coefficients are obtained through calculating the similarity between the codebook image and an input image to be encoded. As the decoding time could be remarkably reduced. For verifying the validity and universality of proposed method, We evaluated and analyzed the performance of decoding time and image quality for a number of still images and a moving picture with different distributed characteristics.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10C
• /
• pp.1019-1024
• /
• 2007

In this paper, the 10bit 20MHz pipelined analog-to-digital converter that is able to apply to WLAN system was modeled for ADC design. Each blocks in converter such as sample and hold amplifier(SHA), comparator, multiplyng DAC(MDAC), and digital correction logic(DCL) was modeled. The pipelined ADC with these modeled blocks takes 1/50 less time than the one of simulation using HSPICE.

• Proceedings of the Korean Society Of Semiconductor Equipment Technology
• /
• 2003.12a
• /
• pp.50-53
• /
• 2003

본 연구에서는 AD 변환기, QEP(Quadrature Encoder Pulse Circuit)등 모터 제어에 필요한 주변 소자의 디지털 제어를 통해서 AC 서보 모터의 벡터 제어를[3] 구현하고 시간 지연에 의한 노이즈를 최소화하기 위해 저 전압형 DSP인 TMP320F2812를 이용하였다. TMP320F2812는 MOS 타입으로 8 depth pipeline을 가진 Harvard bus 를 채택해서 최대 150MIPS의 고속 처리 능력을 갖고 있으며 12 비트의 AD 변환기 QEP 회로와 공간 전압 벡터 PWM을 발생시킬 수 있는 기능을 가진 모터 제어용 원칩 DSP이다 모터 제어에 필요한 주변 회로들을 내장한 DSP는 하드웨어적인 구성을 간소화시키고 이로 인한 비용 절감을 얻을 수 있다. 간단한 구조로 고속 연산을 하기 위해 TMP320F2812는 고정 소수점 연산 처리 방식[6]을 사용하게 되었다. 고정 소수점 연산 처리로 인한 오차는 각 변수에 대한 스케일링을 통해 유효 자리를 확보 하는 방법을 사용하였다.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.17 no.3
• /
• pp.285-290
• /
• 2007

In this paper, we presents robust digital redesign (DR) method for observer-based linear time-invariant (LTI) system. The term of DR involves converting an analog controller into an equivalent digital one by considering two condition: state-matching and stability. The design problems viewed as a convex optimization problem that we minimize the error of the norm bounds between interpolated linear operators to be matched. Also, by using the bilinear and inverse bilinear approximation method, we analyzed the uncertain parts of given observer-based system more precisely, When a sampling period is sufficiently small, the conversion of a analog structured uncertain system to an equivalent discrete-time system have proper reason. Sufficiently conditions for the state-matching of the digitally controlled system are formulated in terms of linear matrix inequalities (LMIs).

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.6
• /
• pp.137-143
• /
• 2015

A delay-line type time-to-digital converter (TDC) implemented in a field-programmable gate array (FPGA) is most widely owing due to its simple structure and high conversion rate. However, the delay-line type TDC suffers from nonlinearity error caused by the long delay-line because its time interval measurement range is determined by the length of the used delay line. In this study, a new TDC structure with a shorter delay line by taking a pulse train as an input is proposed for improved time accuracy and efficient use of resources. The proposed TDC utilizes a pulse-train with four transitions and a transition state detector that identifies the used transition among four transitions and prevents the meta-stable state without a synchronizer. With 72 delay cells, the measured resolution and maximum non-linearity were 20.53 ps, and 1.46 LSB, respectively, and the time interval measurement range was 5070 ps which was enhanced by approximately 343 % compared to the conventional delay-line type TDC.