• Proceedings of the Korea Institute of Fire Science and Engineering Conference
• /
• 2012.04a
• /
• pp.258-261
• /
• 2012

풀화재에서 화염화염진동은 주위공기와의 밀도차에 의한 부력효과에 기인하여 주로 발생한다. 본 연구는 풀화재의 화염불안정성에 대해 산화제 유속 및 농도 변화에 따른 효과를 검토하기 위하여 컵버너 실험을 수행하였다. 실험결과는 산화제의 농도를 변화시켰을 경우에는 산화제의 불활성기체의 농도가 증가할수록 청염의 길이가 길어지고 컵버너 끝단으로부터 부상되는 것이 관찰된다. 한편, 산화제의 유속이 증가함에 따른 진동주파수가 감소함을 보인다. 이는 무차원 변수로 표현되는 주파수와 부력의 관계로 도시하였을 때 다양한 속도스케일을 사용할 수 있었지만, 연료와 산화제의 유속차로 정의되는 특성속도인 경우에 정지되어 있는 공기중에서의 풀화재 진동과 일치하는 관계식을 얻을 수 있었다. 그리고 진동주파수는 산화제 희석율과는 특정한 관계를 보이지 않는데 이는 국부적 화염구조와 연관성을 가지기 때문으로 판단된다.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.2
• /
• pp.105-110
• /
• 2004

The objective of this study is to obtain the instability characteristics of the plane jet impinging on circular cylinder associated with the cylinder-tone. It is found that the characteristics depends upon he ratio of the cylinder diameter to the nozzle width, D/h, and the jet velocity. When the ratio is oderate the cylinder-tone is similar to the edge-tone. With increase of the ratio, its characteristics ecomes similar to that of the plate-tone in which only the high-speed tone associated with turbulent et is generated. When D/h 〈1. the frequency range, especially the lower limit of frequency, is ignificantly influenced by the cylinder diameter. At around D/h = 1/2, while low speed tones are nduced with the antisymmetric mode of instability and affected by the vortex shedding from the ylinder, high-speed tones are generated, at first, with the symmetric mode of instability. and then, ith antisymmetric mode, as the jet velocity increases.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.7 no.2
• /
• pp.44-53
• /
• 2003

A vertical hot-firing test facility was established to carry out the IPPT(Integrated Propulsion Performance Test) and SQT(Stage Qualification Test) of KSR-III(Korea Sounding Rocket-III). The components for actual launcher were mostly used, hence these tests were carried out under the condition of relatively lower safety margin. To perform hot-firing tests with the maximum safety, an engine emergency blockage system was investigated and applied. An emergency blockage system using combustion chamber pressures and acceleration signals was set up to monitor ignition delay and fail, flame out, propellant feeding status, unstable combustion and excessive structural vibration. With such a system, the test safety could be secured by rapid judgement and follow-up measures, which made IPPT and SQT be safely completed.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.17 no.6
• /
• pp.1-10
• /
• 2013

In this paper, the main cause on excitation of the combustion instability which may occur in the hybrid rocket motor with a diaphragm was studied. Hybrid rocket motor propulsion tests considering various experimental conditions such as with a diaphragm or not, a diameter of diaphragm, oxidizer mass flow rate, fuel length, etc were performed, and the combustion visualization for the inside of a hybrid rocket motor with a diaphragm was performed. With these experimental results, it was confirmed that the main cause of a large excitation was the hole-tone, and it was shown that the hole-tone model can be predicted experimental primary pressure oscillation frequency quite well.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.18 no.1
• /
• pp.150-159
• /
• 2014

A simplified method for the calculation of buckling and vibrational characteristics of initially stressed rectangular plate and antisymmetric angle-ply laminated plates is presented in this paper using the natural frequencies under unloading state. The equation of motion of rectangular plate with two opposite edges simply supported is investigated on the basis of Rayleigh-Ritz method and Mindlin plate theory with effect of the curvature term. The relationships of the non-dimensional natural frequencies with initial stresses the coeffcients of critical buckling and the boundaries of the dynamic principal instability region can be characterized by the non-dimensional natureal frequencies under unloading state. Numerical examples are presented to verify the simplified equations and to illustrate potential applications of the analysis.

• Journal of Korean Association for Spatial Structures
• /
• v.10 no.1
• /
• pp.127-134
• /
• 2010

The dynamic instability for snapping phenomena has been studied by many researchers. Few paper deal with the dynamic bucking under the load with periodic characteristics, and the behavior under periodic excitation is expected the different behavior against STEP excitation. We investigate the fundamental mechanisms of dynamic instability when shallow EP(Elliptic Paraboliodal) shell of two degree of freedom are subjected to sinusoidal excitation with direct snapping and indirect snapping. By using Newmark-$\beta$ method, we can get the nonlinear response, and characteristics of the dynamic instability through the running response spectrum by FFT(fast Fourier Transform) and attractors are compared in the phase plane. Dynamic buckling loads are strongly influenced by the relationships between the natural frequency of structures and the dominant frequency of incident excitations.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.4
• /
• pp.371-377
• /
• 2020

Combustion instability occurred in the combustion test of solid rocket motor with large aspect ration Length/Diameter (L/D) and cylinder-slot grain. As a result of spectral analysis of the pressure perturbation, it was confirmed that the central axis longitudinal frequency was dominant, so that the length of the cylinder part was increased to eliminate the coincidence with acoustic node. In addition, acoustic modal analysis and flow analysis were performed to analyze the cause of instability by unsteady flow structure in solid rocket motors. It was confirmed that the combustion instability is reduced by quantitative comparison of the amplitude and frequencies of the pressure inside the combustion chamber using the grain shape before and after the design change. Finally, a combustion test was performed to verify that the combustion instability was resolved as in the flow analysis.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.13 no.3
• /
• pp.373-384
• /
• 1989

The motions of a spinning rotor and a fluid enclosed in its cavity are known to have mutual interactions, which change the frequencies of forced vibrations and cause instabilities. These phenomena are of technical importance for fluid-cooled turbines as well as spin-stabilized satellites or rockets containing liquid fuels. In this paper the characteristics of unstable whirling of a rotor containing a partitioned cavity filled with two kinds of liquids are investigated experimentally. It studies the influence of rotational speed and filling ratio of two kinds of liquids on unstable whiring. As a result, it is found that the whirl velocity is approximately equal to, or slightly lower for large masses of trapped fluid than rotor critical speed. In case of a spinning rotor partially filled with two kinds of liquids the boundary surface plays a similar role to the free surface, and cases unstable forward whirl.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2002.04a
• /
• pp.70-71
• /
• 2002

연소실의 세장비(aspect ratio)가 작으면서 추진제의 고 충전을 이용한 단시간 연소 모타는 유도탄의 사출 모타 용으로 사용될 수 있다. 사출 모타는 일반적으로 모타 무게에 대한 제약 조건이 까다롭지 않기 때문에 무게 경량화에 대한 부담은 줄어들지만, 모타의 부피가 커지면 유도탄 발사 장치의 부피가 커지기 때문에 공간적인 측면에서 가능한 작게 하는 것이 시스템 전체의 효율을 증대시킬 수 있다. 또한 사출 모타의 연소 시간이 짧기 때문에(1초 이내) 추진제의 웹 두께가 작으므로 연소실의 주어진 공간에서 추진제를 많이 채우기 위한 방법으로 원통 튜브형 그레인을 여러 개의 다발로 사용하는 방법이 효과적이다. 이러한 관점에서 사출 모타용으로 다발 원통 튜브형 그레인을 설계/제작/연소시험을 하였더니 작은 저주파(약 10Hz)의 연소 불안정 현상이 발생하였다. (그림1). 이러한 주파수 대역은 일반적으로 잘 알려진 연소 불안정 모드 (longitudinal, tangential, and radial mode)와는 다른 아주 특이한 현상이다. 이러한 현상의 주 원인은 연소실 내 압력의 비평형에 의한 현상이라 판단되어 다음과 같은 연구를 수행하였다. 1) 그레인 튜브간의 압력 평형을 원활하게 하기 위하여 그레인에 구멍(홀)을 뚫어서 연소 안정화에 미치는 영향에 대한 연구(그림2), 2) 그레인에 홀을 뚫지 않고 격자와 격자간의 공간을 이용하여 그레인 간에 발생된 저주파의 압력 진동을 산란/소멸 시키는 연소 안정화 연구(그림3).

• Proceedings of the KIPE Conference
• /
• 2014.11a
• /
• pp.131-134
• /
• 2014

PMSM(Permanent Magnet Synchronous Motor)은 가공기, 로봇, 공장 자동화 등 현재까지도 산업 시스템 전반에 널리 쓰이고 있으며, 그에 대한 연구도 활발히 진행되고 있다. 하지만 PMSM에 부하를 인가하거나 혹은 기계 몸체와의 결합 과정에서 기구부가 가지고 있는 고유진동 주파수에 의해 동력 전달 부분에 있어 기계계의 응답 특성은 불안정해지고, 떨림 현상이 발생된다. 본 논문에서는 PMSM을 이용한 회전 운동 시스템에서 출력되는 전류에 기구부가 가지고 있는 특정 영역의 고유진동 주파수를 제거한 전류를 적응 노치필터를 통해 내보낸다. 그 결과 기계부의 떨림 현상을 제거하고, 안정적인 제어 시스템을 제안한다. 이 제어알고리즘을 가상실험으로 필터 통과 전과 후의 결과를 비교 및 분석하도록 한다.