• Clean Technology
• /
• v.19 no.2
• /
• pp.184-188
• /
• 2013

To increase flash point which is related to flammability, seven unprecedented new cleaning agents containing fluoride atoms have been invented. These newly synthesized cleaning agents's physical properties which were conducted by Korea Institute of Petroleum Management by using a standard method showed excellent values. Particularly, flash point of newly synthetic cleaning agents is more higher than that of fluoride free compound. A specimen for cleaning ability was prepared by cutting in $60mm{\times}40mm$ size of stainless steel plate. The surface of the above specimens was applied with four kinds of contaminants, such as paraffin based drawing oil, flux abietic acid, water-insoluble cutting oil, and lubricating oil. Contaminated specimens were immersed in new compounds (1-7) for 1 to 5 minutes to dissolve oil in the cleaning agent. Although the data indicate that all compounds (1-7) exhibit lower cleaning ability toward cutting oil, it is observed that in the case of the present study more than 80% of pollutants on the surface were almost removed within 5 minutes.

• Journal of the Korean Chemical Society
• /
• v.51 no.3
• /
• pp.265-269
• /
• 2007

A comparative study on crystal structures and UV-visible diffuse reflectance spectra for Nb-containing oxyfluorides was performed to probe the relationship between energy band gap and local structure. The oxyfluorides, RbSrNb2O6F, RbCaNb2O6F and RbNb2O5F are commonly composed of the corner-sharing NbO5F octahedra as structural building units. The average Nb-O(F)-Nb bond angles, which can be a measure of the structural distortion, are 158.6° for RbSrNb2O6F, 149.6° for RbCaNb2O6F and 139.5° for RbNb2O5F. As the bond angle decreases, the band gap increases: 3.48eV for RbSrNb2O6F, 3.75eV for RbCaNb2O6F and 4.03 eV for RbNb2O5F. This experimental result implies that the band gap can be controlled with a range of 0.6 eV through a variation of local structure for the Nb-containing oxyfluorides.

• Clean Technology
• /
• v.14 no.3
• /
• pp.184-192
• /
• 2008

Fluoride-type cleaning agents such as 2,2,2-trifluoroethanol (TFEA) and hydrofluoroethers (HFEs) do not destroy ozone in the stratosphere and have low global warming potential compared to hydrofluorocarbons(HFCs) and hydrochlorofluorocarbons (HCFCs). Especially, HFEs which have no flash point are paid attention as next generation type of cleaning agents for chlorofluorocarbons (CFCs) since they are safe in handling and have excellent penetration ability compared to hydrocarbon cleaning agents with low flash point. Here, the physical properties and cleaning abilities of fluoride-type cleaning agents such as TFEA, HFE-7100, HFE-7200, HFE-476mec, HFE-449mec-f, AE-3000 and AE-3100E and silicide-type cleaning agents such as trifluoroetoxytrimethylsilane (TFES) and hexamethyldisilazane (HMDS) were measured and compared with those of ozone destruction substances such as CFC-113 and 1,1,1-trichloroethane. They were also compared with toxic methylene chloride (MC) and isopropyl alcohol (IPA) which are now being used as an alternative cleaning agents. As a result, TFEA and HFEs had lower cleaning ability for removal of various soils compared to chloride-type cleaning agents, but they showed excellent cleaning ability fur fluoride-type soils. TFES and HMDS also showed excellent cleaning ability for silicide-type soils.

• Journal of dental hygiene science
• /
• v.16 no.4
• /
• pp.272-283
• /
• 2016

This study compared and analyzed the occluding effects of fluoride compounds and desensitizers, which are commonly used in dental clinics, on dentinal tubules. This study also evaluated the persistence of the active ingredients over time by performing toothbrushing with an electric toothbrush. Thirty-five molar teeth, which had been extracted within the past 3 months from healthy people without tooth decays, amalgam fillings, or dental crowns, were divided into 4 pieces each. Of these, 135 teeth pieces were used as study specimens. These specimens were divided into a control group, an untreated group, and 5 experimental groups (acidulated fluoride gel, fluoride varnish, Gluma, Super Seal, and SE-Bond). The specimens were then subjected to toothbrushing equivalent to 1 week (140 times), 2 weeks (280 times), and 4 weeks (560 times), and the occluding effects on dentinal tubules in 3 regions of each specimen were examined under a scanning electron microscope. The fluoride varnish treated group showed the highest degree of dentinal tubule occlusion effects during the first, second, and fourth weeks of toothbrushing, with the SE-Bond treated group showing the second highest degree and the Gluma treated group showing the lowest degree. After 4 weeks of toothbrushing, the Gluma treated group and the Super Seal treated group showed the lowest degrees of dentinal tubule occlusion effects. In summary, the fluoride varnish treated group and the SE-Bond treated group displayed higher occlusion effects even after 4 weeks of treatment than did the other experimental groups. Therefore, it is the authors' belief that fluoride varnish and SE-Bond are effective for treating dentinal hyperesthesia.

• Applied Chemistry for Engineering
• /
• v.5 no.1
• /
• pp.176-181
• /
• 1994

The hydrolysis of biochemical kinetic resolutions for 2-[1-(acetoxy-2, 2, 2-trifluoroethyl)]-5-trimethylsilylfuran(1) using kinds of Lifase(talpase, paratase, M1000L, SP398, SP435) was investigated. In the results SP435 of Novo Nordish comp any was confirmed to show the capacity of biochemical kinetic resolutions, and 2-(1-(2, 2, 2-trifluoro-1-hydroxyethyl)]-5-trimethylsilylfuran(2) to have the optical purity expressed as 92.4% enantiomeric excess(ee) was produced in this studies.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.14 no.6
• /
• pp.648-654
• /
• 2003

Diamond MIS(Metal-Insulator-Semiconductor) diodes and MISFETs(Metal-Insulator-Semiconductor Field Effect Transistors) were fabricated by employing various fluorides as gate insulator, and their electrical properties were closely investigated by means of C-V measurements. The A1/BaF$_2$/diamond MIS structure exhibited outstanding electrical properties. The MIS diode showed a very low surface state density of ∼10$\^$10//$\textrm{cm}^2$ eV near the valence band edge, and the observed effective mobility(${\mu}$$\_$eff/) of the MISFET was 400 $\textrm{cm}^2$/Vs, which is the highest value obtained until now in the diamond FET. From the chemiphysical point of view, the above result might be explained by the reduction of adsorbed-oxygen on the diamond surface via strong chemical reaction by the constituent Ba atom in the insulator during the film deposition(Oxygen-Gettering Effect).

• Journal of Environmental Health Sciences
• /
• v.39 no.4
• /
• pp.346-353
• /
• 2013

Objectives: The goal of this study is to identify the distribution of the foliar fluorine content of vegetation surrounding the area where hydrofluoric acid was accidently released in Gumi, Gyeongsangbuk-do on September 27, 2012. In addition, it also aims to estimate the concentration of hydrogen fluoride in the air on the day of the accident. Methods: Samples of plant leaves were collected on October 7, 2012 within 1 km from the site where the accident occurred. These samples were analyzed for soluble fluorine ion with an ion selective electrode. The ambient concentration of hydrogen fluoride was calculated using the fluoride content in the plant via the dose-rate equation (${\Delta}F$=KCT). Results: The arithmetic and geometric means of the concentrations were 2158.2 and 1183.7mg F $kg^{-1}$ for leaves and, 2.4 and 1.1 ppm HF for the air, respectively. The highest concentration of hydrogen fluoride in the air was 14.7 ppm, which is higher than the maximum concentration reported by the government (1 ppm) and the exposure limit (ceiling, 3 ppm). The concentrations of both fluorine and hydrogen fluoride decreased with increasing distance from the accident site and showed a significant decrease outside of a 500m radius from the site (p <0.05). Conclusions: The area around the accident site was highly polluted with hydrogen fluoride according to the results of this study. Considering the persistency of hydrogen fluoride in the environment, long-term monitoring and environmental impact assessment should be pursued.

• Journal of the Korea Convergence Society
• /
• v.12 no.4
• /
• pp.87-94
• /
• 2021

While the shielding substances of radiation shields in medical institutions are beginning to be replaced by environmentally friendly materials, radiation protection according to the shielding properties of environmentally friendly substances is becoming an important factor rather than the existing lead shielding properties. Tungsten and barium sulfate are representative shielding materials similar to lead, and are made in sheets or fiber form with eco-friendly materials. Ytterbium is an impermeable material used as a fluorine compound in the dental radiation field. This study aims to evaluate the shielding performance in the x-ray shielding area by comparing the shielding properties of ytterbium by energy band and that of existing eco-friendly materials. When three types of shielding sheets were fabricated and tested under the same process conditions, the shielding performance of the medical radiation area was about 5 % difference from tungsten. Furthermore, shielding performance was superior to barium sulfate. In the cross-sectional structure of the shielding sheet, there was a disadvantage that the arrangement of particles was not uniform. Ytterbium oxide showed sufficient potential as a medical radiation shielding material, and it is thought that it can improve the shielding performance by controlling the particle arrangement structure and particle size.

• The Korean Journal of Pesticide Science
• /
• v.13 no.2
• /
• pp.63-69
• /
• 2009

New morpholinylcarbonylmethyl-2-phenylimino-1,3-thiazolines 2(X=O) and piperidinylcarbonylmethyl-2-phenylimino-1,3-thiazolines 3(X=C) to which morpholinyl or piperidinyl functional group were introduced at C-4 side chain of the 2-phenylimino-1,3-thiazoline scaffold were synthesized to investigate the effect of NH hydrogen of 2-phenylimino-1,3-thiazoline-4-acetanilide derivatives on the antifungal property against rice blast. Synthesized 30 compounds were screened against 6 kinds of typical plant fungi. Treatment of ketene dimer with chlorine followed by the reaction of morphorine or piperidine without isolation of the intermediate acetoacetylchloride gave $\gamma$-chloro-$\beta$-keto derivatives. These were reacted with thioureas to give morpholinylcarbonylmethyl-2-phenylimino-1,3-thiazolines and piperidinylcarbonylmethyl-2-phenylimino-1,3-thiazolines respectively in good yield (27-98%). The compound 3j, in which two fluorine atoms are substituted at ortho and para position of phenyl group of 2-phenylimino moiety and piperidinyl group is substituted at C-4, showed the highest antifungal activity (100 ppm, 90%). This result suggested that the substituent at C-4 of the 2-phenylimino-1,3-thiazolines may play a supplementary role to show the antifungal activity against rice blast.

• Polymer(Korea)
• /
• v.34 no.2
• /
• pp.137-143
• /
• 2010

A series of partially fluorinated, sulfonated poly(biphenylene-co-sulfone)ether containing perfluorocyclobutane(PFCB) groups were prepared for fuel cell applications through three synthetic steps: synthesis of trifluorovinylether-terminated monomers, thermal cycloaddition and post-sulfonation. Two kinds of trifluorovinylether-terminated monomers were synthesized and statistically copolymerized via thermal cycloaddition to obtain a series of polymers containing 20-60 mol% of biphenyl units(PBS-X). The post-sulfonation of PBS-X was carried out using chlorosulfonic acid(CSA) to obtain copolymers with various sulfonation levels(SPBS-X). All the synthesized compounds, monomers and polymers were characterized by $^1H$-NMR, $^{19}F$-NMR and FT-IR. It was confirmed that the ion exchange capacity(IEC), water uptake and ion conductivity of SPBS-X increased with the increment of sulfonated biphenyl units. Particularly, SPBS-60 showed higher ion conductivity compared to Nafion$^{(R)}$-115 at 25~80 $^{\circ}C$.