• The Journal of the Acoustical Society of Korea
• /
• v.36 no.3
• /
• pp.218-227
• /
• 2017

In this paper, an algorithm to calculate both bearing and distance error for target detection and localization is proposed using the Cramer Rao lower bound to estimate the minium variance of their error in DOA (Direction Of Arrival) estimation. The performance of arrays in detection and localization depends on the accuracy of DOA, which is affected by a variation of SNR (Signal to Noise Ratio). The SNR is determined by sonar parameters such as a SL (Source Level), TL (Transmission Loss), NL (Noise Level), array shape and beam steering angle. For verification of the suggested method, a Monte Carlo simulation was performed to probabilistically calculate the bearing and distance error according to the SNR which varies with the relative position of the target in space and noise level.

• The Journal of the Acoustical Society of Korea
• /
• v.37 no.6
• /
• pp.412-421
• /
• 2018

The Line array sonar consisting of several hydrophones increases array gain and improves the performance for detecting the direction of the target compared to single hydrophone. However, line array sonar produces the bearing error that makes it difficult to determine the bearing of incoming source signal due to the relation between bearing angle of target and vertical angle of multipath signals. Vertical angles of multipath are varied with the geometry of receiver and target and various underwater environments, therefore it is necessary to consider the bearing error to estimate accurately the bearing of the target. In this study, acoustic modelling was performed to understand the effect of multipath signals on the target signal. The errors of bearing angle estimated from the bottom bounced signals are calculated with several environment. In addition, the expected bearing line, as a function of source-receiver range, compensated for the bearing error is predicted from the estimated bearing angle.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.49 no.2
• /
• pp.130-136
• /
• 2012

In this paper, we propose a near-field range estimation method for a uniform linear array that can calibrate bearing estimation error which give a bad influence on a range estimation process. When a range is fixed, the bearing error is calibrated to maximize the beamformer output by the proposed algorithm based on the gradient method. Simulation results show that the proposed algorithm can compensate the bearing error which is less than the mainlobe beamwidth so that reduce the range estimation error as similar as the case of no bearing error.

• Journal of the Institute of Convergence Signal Processing
• /
• v.20 no.4
• /
• pp.245-251
• /
• 2019

Sonar bearing accuracy is the correspondence between the target orientation predicted by sonar and actual target orientation, and is obtained from measurements. However, when measuring sonar bearing accuracy, many errors are included in the results because they are made at sea, where complex and diverse environmental factors are applied. In particular, parallax error caused by the difference between the position of the GPS receiver and the sonar sensor, and the time delay error generated between the speed of underwater sound waves and the speed of electromagnetic waves in the air have a great influence on the accuracy. Correcting these parallax errors and time delay errors without an automated tool is a laborious task. Therefore, in this study, we propose a sonar bearing accuracy measurement equipment with parallax error and time delay error correction. The tests were carried out through simulation data and real data. As a result of the test it was confirmed that the parallax error and time delay error were systematically corrected so that 51.7% for simulation data and more than 18.5% for real data. The proposed method is expected to improve the efficiency and accuracy of sonar system detection performance verification in the future.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.11
• /
• pp.4503-4508
• /
• 2010

A direction finding(DF) technology of a signal is very important for electronic warfare and has studied for a long time. The method of TDOA(time difference of arrival) is one of good DF methods in this time, and that is to receive an emitter signal with two antennas, to measure the time difference of a signal at two antennas, and converse the time difference to direction of the signal. For small DF error, high time resolution receiver and long baseline are needed. In this paper we suggest a good baseline with adaptive antenna arrangement into 10m*10m area.

• Journal of the Korean Institute of Navigation
• /
• v.20 no.3
• /
• pp.73-84
• /
• 1996

선진국에서의 GPS 위성정보를 활용한 자세결정 센서개발은 새로운 GPS 관련연구 분야로 떠오르고 있는 실정이다. 지금까지 국제학회에 보고된 대부분의 연구는 GPS 위성신호의 Carrier phase 측정을 통해 고중차등을 이용한 방법으로 주로 3-D 자세결정방식에 치중하고 있으나, 아직 실무에서의 활용은 이른 것으로 알려지고 있다. 본 논문은 GPS 위성신호의 범용이 C/A 코드 프로세싱 GPS 수신기 정보를 활용하여 선박의 방위센서 개발에 관한 연구이다. 본 연구에서는 1차적으로 GPS 위성신호의 오차벡터를 진시간으로 측정 및 분석을 통해 GPS 위성오차중 가장 심각한 S/A 오차 발생기간에도 방위센서 구측을 위한 정보획득에는 문제가 되지 않음을 확인하였고, 수신된 Two-Point 위성정보를 이용 새로운 선박의 방위센서 "GPS-Compass"를 구측 비선형 모델하에서의 해상 실험을 통해 본 연구에서 제시한 "GPS-Compass"의 새로운 선박 방위센서로의 활용가능성을 보였다.박 방위센서로의 활용가능성을 보였다.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.2
• /
• pp.221-228
• /
• 2020

A sonobuoy is dropped onto the surface of water to estimate the bearing of an underwater target. A Directional Frequency Analysis and Recording (DIFAR) sonobuoy has an error in the specific angular section due to the method of estimating bearing and noise, which causes an error in target localization using multiple sonobuoys. In addition, the position of the sonobuoy continues to move, but since a sonobuoy with a GPS is intermittently arranged, it is difficult to estimate the exact position of the sonobuoy. This also causes target localization performance degradation. In this paper, we propose a technique to improve the target localization performance by compensating for bearing errors using characteristics of the DIFAR sonobuoy and multiple-sonobuoy position errors based on the intermittently arranged active sonobuoy with a GPS.

• Proceedings of the Korean Society of Precision Engineering Conference
• /
• 2000.05a
• /
• pp.672-675
• /
• 2000

There are many sources of errors in the parallel device. This study investigates the effect of a clearance error at a U-joint on the position and orientation errors of the platform of a new parallel device, cubic parallel manipulator. In this study, the limits of errors can be estimated for given conditions.

• Korean Journal of Remote Sensing
• /
• v.36 no.3
• /
• pp.441-448
• /
• 2020

GMTI (Ground Moving Target Indication) radar system can detect ground moving targets and can provide position and velocity information of each target. However, the azimuth position of target has some offset because of the hardware errors such as mechanical tolerances. In this case, an error occurs no matter how accurate the monopulse ratio is. In this paper, target position correction method in azimuth direction has been proposed. The received sum and difference signals of monopulse GMTI system are post-processed to correct the target azimuth angle error. This method is simple and adaptive for nonhomogeneous area because it can be implemented by using only software without any hardware modification or addition.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.6
• /
• pp.630-636
• /
• 2019

Passive Ranging Sonar (PRS) is a type of passive sonar consisting of three sub-array on the port and starboard, and has a characteristic of detecting a target and calculating a bearing and a distance. The bearing and distance calculation requires physical sub-array position information, and the bearing and distance accuracy performance are deteriorated when the position information of the sub-array is inaccurate. In particular, it has a greater impact on distance accuracy performance using plus value of two time-delay than a bearing using average value of two time-delay. In order to improve this, a study on sub-array position error estimation and error compensation is needed. In this paper, We estimate the sub-array position error based on enetic algorithm, an optimization search technique, and propose a method to improve the performance of distance accuracy by compensating the time delay error caused by the position error. In addition, we will verify the proposed algorithm and its performance using the sea-going data.