• Journal of the Korean Society for Nondestructive Testing
• /
• v.21 no.2
• /
• pp.147-151
• /
• 2001

An optical fiber sensor is capable of nondestructive measurement of a structure and it has an advantage of the immunity to electromagnetic interference because light is not affected by electromagnetic wave. In addition, if optical fibers are buried in an object like a concrete, this sensor tan analyze defects and physical status of the object without disassembling it. Especially, the fiber Bragg grating sensor is a promising optical fiber sensor capable of nondestructive test of such an object. A fiber Bragg grating has the characteristics of reflecting or blotting light of a specific wavelength. If we apply physical quantity like strain to the fiber Bragg grating, the center wavelength of the reflected light is shifted and then we can find the physical quantity applied to the fiber Bragg grating by measuring the center wavelength shift of the reflected light. The fiber Bragg grating sensor capable ot static and dynamic strain measurement is being used in health-monitoring of buildings, structures, etc. Recently increasing is interest in dynamic strain measurement inevitable to the civil structures such as roads and bridges. In this study we implemented the optical fiber sensor system which can measure dynamic strain at multiple points using Fabry-Perot wavelength demodulation. And we measured the static and dynamic strain using this sensor system with a test structure(cantilever). Measurement results were similar to those obtained with the conventional electrical measurement methods.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.9
• /
• pp.1688-1695
• /
• 2016

Underwater communication has multipath error because of reflection by sea-level and sea-bottom. The multipath of underwater channel causes signal distortion and error floor. The excessive multipath encountered in underwater communication channel creates inter symbol interference, which is a limiting factor to achieve a high data rate and bit error rate performance. Therefore, to increase throughput efficiency and improve performance, this paper consider FTN (Faster-than-Nyquist) signalling based on turbo equalization. FTN signalling is a technique of transmitting information at a rate higher than the allowed Nyquist limit. This paper presented efficient decoder structure of FTN transmission in the environment of multipath underwater channel and we compare the performance between FTN method and conventional punctured method in lake experimentation. As a results of lake experiment, we confirmed FTN method based on turbo equalization is applicable and efficiency in underwater communication.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.21 no.11
• /
• pp.1259-1268
• /
• 2010

In this paper, we presented a new LC prototype synthesis method for the multi-band filter. For synthesis a multi-band filter with the required frequency response, we proposed the diagram of poles and zeros, also, we proposed the optimization process for finding the combination of optimized poles and zeros. From the transfer and reflection functions calculated from poles and zeros, we performed the quasi-elliptic LC prototype synthesis of multi-band filter. Using the proposed LC prototype synthesis method of multi-band filter, dual-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500 MHz) and triple-band filter operating at GSM(880~960 MHz) and ISM(2,400~2,500, 5,725~5,850 MHz) were designed and fabricated.

• Korean Journal of Remote Sensing
• /
• v.37 no.5_1
• /
• pp.947-958
• /
• 2021

This study was conducted to provide basic data for crop monitoring by comparing and analyzing changes in reflectance and vegetation index by sensor of multi-spectral sensors mounted on unmanned aerial vehicles. For four types of unmanned aerial vehicle-mounted multispectral sensors, such as RedEdge-MX, S110 NIR, Sequioa, and P4M, on September 14 and September 15, 2020, aerial images were taken, once in the morning and in the afternoon, a total of 4 times, and reflectance and vegetation index were calculated and compared. In the case of reflectance, the time-series coefficient of variation of all sensors showed an average value of about 10% or more, indicating that there is a limit to its use. The coefficient of variation of the vegetation index by sensor for the crop test group showed an average value of 1.2 to 3.6% in the crop experimental sites with high vitality due to thick vegetation, showing variability within 5%. However, this was a higher value than the coefficient of variation on a clear day, and it is estimated that the weather conditions such as clouds were different in the morning and afternoon during the experiment period. It is thought that it is necessary to establish and implement a UAV flight plan. As a result of comparing the NDVI between the multi-spectral sensors of the unmanned aerial vehicle, in this experiment, it is thought that the RedEdeg-MX sensor can be used together without special correction of the NDVI value even if several sensors of the same type are used in a stable light environment. RedEdge-MX, P4M, and Sequioa sensors showed a linear relationship with each other, but supplementary experiments are needed to evaluate joint utilization through off-set correction between vegetation indices.

• Korean Journal of Remote Sensing
• /
• v.32 no.5
• /
• pp.529-538
• /
• 2016

This study, multispectral and hyperspectral sensors were utilized to use radiometric cross validation for the purpose of radiometric quality evaluation of a 'KOMPSAT-3'. Images of EO-1 Hyperion and Landsat-8 OLI sensors taken in PICS site were used. 2 sections that have 2 different types of ground coverage respectively were selected as the site of cross validation based on aerial hyperspectral sensor and TOA Reflectance. As a result of comparison between the TOA reflectance figures of KOMPSAT-3, EO-1 Hyperion and CASI-1500, the difference was roughly 4%. It is considered that it satisfies the radiological quality standard when the difference of figure of reflectance in a comparison to the other satellites is found within 5%. The difference in Blue, Green, Red band was approximately 3% as a comparison result of TOA reflectance. However the figure was relatively low in NIR band in a comparison to Landsat-8. It is thought that the relatively low reflectance is because there is a difference of band passes in NIR band of 2 sensors and in a case of KOMPSAT-3 sensor, a section of 940nm, which shows the strong absorption through water vapor, is included in band pass resulting in comparatively low reflectance. To overcome these conditions, more detailed analysis with the application of rescale method as Spectral Bandwidth Adjustment Factor (SBAF) is required.

• Journal of the Korean Vacuum Society
• /
• v.20 no.3
• /
• pp.225-232
• /
• 2011

Reactive ion etching (RIE) technique for maskless surface texturing of mc-silicon solar wafers has been applied and succeed in fabricating a grass-like black-silicon with an average reflectance of $4{\pm}1%$ in a wavelength range of 300~1,200 nm. In order to investigate the optimized texturing conditions for mass production of high quantum efficiency solar cell Surface characteristics such as the spatial distribution of average reflectance, micrscopic surface morphology and minority carrier lifetime were monitored for samples from saw-damaged $15.6{\times}15.6\;cm^2$ bare wafer to key-processed wafers as well as the mc-Si solar cells. We observed that RIE textured wafers reveal lower average reflectance along from center to edges by 1% and referred the origin to the non-uniform surface structures with a depth of 2 times deeper and half-maximum width of 3 times. Samples with anti-reflection coating after forming emitter layer also revealed longer minority carrier lifetime by 40% for the edge compared to wafer center due to size effects. As results, mc-Si solar cells with RIE-textured surface also revealed higher efficiency by 2% and better external quantum efficiency by 15% for edge positions with higher height.

• Journal of Navigation and Port Research
• /
• v.31 no.5 s.121
• /
• pp.409-414
• /
• 2007

The effect of multipath is especially serious in urban area and sea surface where buildings and water reflect GPS signal. Multipath brings about the performance degradation on many GPS application because the presence of multipath causes the diminution of pseudorange measurement accuracy in turn position accuracy. In this paper, a multipath mitigation named weighted correlation method is implemented on software GPS receiver, in which the asymmetric correlation function is compensated by modifying the late correlation value. Asymmetry compensation is obtained as weighted sum of two correlators which have different early-late chip spaces. This structure is adopted to lessen the computation load lower keeping up performance similar to that. The performance of implemented multipath mitigation technique is evaluated using GPS signal and multipath signal generated by GPS signal generator and software GPS receiver. The test results show that the weighted correlation method gives hefter performance than the standard correlator and the narrow correlator.

• Spatial Information Research
• /
• v.15 no.1
• /
• pp.25-33
• /
• 2007

The purpose of this study is to assess spatio-temporal variation of Imha Dam water quality according to suspended sediment algorithm using Landsat and SPOT 5 data. In order to learn synchronous suspended sediment concentrations(SSC) in Imha Dam waters, the satellite remote sensing data are analyzed. The key procedure of this research is that we should know the relationships between suspended sediment concentrations and satellite-detected reflectance. However, the SSC algorithm has the limitation that it must be compared calculated SSC with synchronous ground-truth data in the Dam water. Based upon the linear response from satellite-detected reflectance, SSC algorithm validated an efficient algorithm to estimate proportional factor and then derived an empirical equation far SSC estimations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.5
• /
• pp.815-821
• /
• 1994

Short-term fading in a mobile radio channel is mainly caused by multipath reflected wave by local scatterers or natural obstacles surrounding a mobile unit. In this paper, we analyze probability density function(PDF), level crossing rate(LCR) and widths and depths of fades for the measured field strength data in Seoul and Daejeon areas. As a result, the satatistical distribution of signal variations within any small area with the constant mean value becomes the Rayleigh distribution The variation of fade depths is small regardless of the environment such as urban, suburban. etc. However, the variation of fade widths is large with the change of circumstantial structures and environment. the maximum level crossing rate is obtained near the mean value.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.10B
• /
• pp.1240-1245
• /
• 2011

In this paper, channel modeling and analysis of wireless visible light communication(VLC) were studied in indoor circumstance. Photons emitted from LED straightly moved and navigated within indoor, after that a part of photons reached on PD via LOS(Line Of Sight) or NLOS(None Line Of Sight). These received signals had characteristics of delay profile and attenuation, which was multiple-path fading. In this paper, computer simulation of VLC channel was executed under the condition that two LEDs were used for transmitter and three PDs were located at different positions of the 20*8*2.3m sized indoor. BER performance simulation was excuted based on the characteristics of each VLC channel.