• Proceedings of the KIPE Conference
• /
• 2015.07a
• /
• pp.497-498
• /
• 2015

Random PWM 방식은 기본파의 배수 고조파에 밀집된 성분을 광대역화할 수 있기 때문에 특정 주파수의 노이즈 감소 및 소음 저감 등에 효과가 있는 인버터 스위칭 방식이다. Random PWM을 구현하는 방법은 랜덤 변수를 생성하고 이를 이용하여 스위칭 주파수를 가변하거나, 인가되는 벡터의 위치를 변화시키는 등의 다양한 방법이 있다. 본 연구에서는 Random PWM 구현 방식, 랜덤 변수의 변동 주기, 랜덤 변수가 적용되는 크기 등의 차이에 따라 주파수 광대역화에 미치는 효과를 분석하였다. 이 결과로부터 구현을 위해 요구되는 조건에 따른 Random PWM의 효과를 비교할 수 있으며, 투입 비용 및 시스템 제한 조건 대비 최적의 Random PWM 방식을 선정할 수 있는 기준으로 활용될 수 있다.

• Proceedings of the Korean Environmental Sciences Society Conference
• /
• 2008.11a
• /
• pp.447-451
• /
• 2008

28 kHz 주파수, 조사강도 70 W/L, pH 7로 조정, 조사시간 5 min으로 전처리된 비산재를 사용하여 인공경량골재의 시편을 제조하여 압축강도, 흡수율, 단위용적중량을 분석하였다. 분석 결과 압축강도는 평균 18 MPa 이상으로 측정되어 기준인 18 MPa를 만족하였으며, 흡수율은 국내 기준은 없지만 일본의 기준인 12% 이하보다 매우 높은 흡수율을 나타내었다. 단위용적중량은 기준(1650 kgf/m$^3$ 이하)에는 만족하지만 비교적 낮은 값을 보였으며, 중금속 용출시험결과 측정항목에서 매우 저농도로 나타나 환경상 위해성은 매우 미미할 것이라 판단된다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.8
• /
• pp.1552-1557
• /
• 2007

In this work, temperature stable pulse width modulation controller using bandgap reference voltage is proposed. Two bandgap reference voltages are designed by using BiCMOS technology which are temperature dependent and independent voltage references. PWM controller is designed by using 3.3 volt supply voltage and the output frequency is 1MHz. From simulation results, the variation of output pulse width is less than form +0.86% to -0.38% in the temperature range $0^{\circ}C\;to\;70^{\circ}C$.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.2A
• /
• pp.194-200
• /
• 2006

A 26.4 GHz phase locked oscillator(PLO) for communication satellite transponder is developed. The PLO consists of fundamental frequency generation module(FFGM) and frequency multiplication part(FMP). The signal of 26.4 GHz is generated through frequency tripling process of 8.8 GHz fundamental frequency. Phase locking technique using sampling phase detector(SPD) is adopted to design the FFGM. The MMIC tripler and amplifier are also designed for the reduction of the size and mass of FMP. The phase noise characteristics are exhibited as -96 dBc/Hz at 10 tHz offset frequency and -105 dBc/Hz at 100 kHz offset frequency, respectively, with the output power over 11 dBm. All performance parameters are complied with the design requirements.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.6
• /
• pp.241-249
• /
• 2012

In the many countries, research about ultra wideband wireless transmission technique is widely studied for efficient utilization of frequency resource due to a sudden increase of demand of frequency resource all over the world. The ultra wideband communication system has the some specific advantages. First, it can transmit data with high speed, second short transmission range can increase the frequency reuse rate, and finally it has high security property. However, there is a interference between ultra wideband system and other communication system but study to solve this problem is insufficient. To efficient utilization of limited frequency resource, a novel frequency avoidance technique and setup the standardization of frequency interference must need. So, the purpose of this paper is that increases communication efficiency of microwave communication systems to analyze the technical trends for transmission of the low power device, and to research the implementation and technical research of wireless access network technique of wideband communication systems.

• Journal of Advanced Navigation Technology
• /
• v.16 no.2
• /
• pp.219-226
• /
• 2012

Since OFDM(Orthogonal Frequency Division Multiplexing) technology is applied into LTE(Long Term Evolution)/LTE-Advanced system, it is important to estimate the spectrum sharing and to analyze interference in LTE system based on the characteristics of frequency assignment. Therefore, in this paper, a study on the adjacent channel interference between two operators/systems to provide LTE services. For co-existence of LTE systems, the relative capacity loss and the relative throughput loss in uplink and downlink have been simulated to evaluated ACIR(Adjacent Channel Interference Ratio) values with 5% loss rate. Some parameters such as the location of user, aggressor bandwidth, and the separation offset affect the required ACIR value for spectrum sharing, and these results and interference analysis schemes in this article can provide reliable reference for LTE RF standardization and efficient frequency utilization in future.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.38 no.3
• /
• pp.211-217
• /
• 2014

This study analyzes the nonlinear interaction between two different vortex shedding frequencies from a cylinder with two diameters. In particular, two different vortex shedding frequencies are generated by preparing a cylinder having two diameters artificially. Flow velocity fluctuations behind the cylinder are measured three-dimensionally. Additionally, we fabricated a hole and placed a pressure transducer for measuring the pressure on the cylinder surface. The pressure signal from the pressure transducer is used as basic signal. A TSC(Trans Spectrum Coherence) is used for checking the strength of the nonlinear interaction between two different vortex shedding frequencies. As a result, the following are clarified: i) frequency distribution behind the cylinder, ii) three-dimensional flow state behind the cylinder through calculation of ensemble average, and iii) close relationship between the vertical vortex and change of low frequency by nonlinear interaction between two different vortex shedding frequencies from the cylinder with two diameters.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.22 no.8
• /
• pp.109-115
• /
• 2008

A design criterion of grounding systems is commonly based on the ground resistance measured with low frequency in Korea. When lightning surges which have high frequency components are injected into the grounding system, the grounding impedance is great]y different from the static grounding resistance. In order to investigate the effect of water resistivity on the high frequency performance of grounding systems, this paper presents the frequency-dependent admittance using water tank simulating the grounding system in different water resistivities. As a result, because of capacitive effect admittances and conductance are increased with increasing frequency in higher water resistivity of greater than 500[${\Omega}{\cdot}m$]. On the other hand, admittances and conductances are decreased with increasing frequency due to inductive effect in lower water resistivity of less than 500[${\Omega}{\cdot}m$]. The phase difference between the current and voltage increases in the range of 200[kHz] to 5[MHz]. Consequently, frequency-dependent performance of grounding systems is closely related to the soil resistivity, it is necessary to consider the effect of grounding system performance on the frequency and soil resistivity.

• Journal of IKEEE
• /
• v.23 no.3
• /
• pp.858-864
• /
• 2019

A clock system is proposed to eliminate data loss due to frequency difference between sensor nodes in a sensor utility network. The proposed clock system for each sensor node consists of a bust clock-data recovery (CDR) circuit, a digital phase-locked loop outputting a 32-phase clock, and a digital frequency synthesizer using a programmable open-loop fractional divider. A CMOS oscillator using an active inductor is used instead of a burst CDR circuit for the first sensor node. The proposed clock system is designed by using a 65 nm CMOS process with a 1.2 V supply voltage. When the frequency error between the sensor nodes is 1%, the proposed burst CDR has a time jitter of only 4.95 ns with a frequency multiplied by 64 for a data rate of 5 Mbps as the reference clock. Furthermore, the frequency change of the designed digital frequency synthesizer is performed within one period of the output clock in the frequency range of 100 kHz to 320 MHz.

• The Journal of the Acoustical Society of Korea
• /
• v.39 no.6
• /
• pp.559-567
• /
• 2020

This paper proposes a noise cancelling algorithm to remove own-ship noise for a towed array sonar. Extra beamforming is performed using partial channels of the acoustic array to get a reference beam signal robust to the noise bearing. Frequency domain Adaptive Noise Cancelling (ANC) is applied based on Normalized Least Mean Square (NLMS) algorithm using the reference beam. The bearing of own-ship noise is estimated from the coherence between the reference beam and input beam signals. Own-ship noise level is calculated using a beampattern of the noise with estimated steering angle, which prevents loss of a target signal by determining whether to update a filter so that removed signal level does not exceed the estimated noise level. Simulation results show the proposed algorithm maintains its performance when the own-ship gets out off its bearing 40 % more than the conventional algorithm's limit and detects the target even when the frequency of the target signal is same with the frequency of the own-ship signal.