• Information and Communications Magazine
• /
• v.11 no.2
• /
• pp.77-89
• /
• 1994

High speed optical fiber transmission technology has been remarkably improved during the past 20 years. This paper presents recent research status and future technological issues for the future information society, that is, the Tb/s transmission by frequency division multiplexing and the ultra long-distance by optical soliton transmission. Erbium-doped fiber amplifier and recent optical technology have brought optical transmission system of up to 10 Gb/s to the point of commercialization. Taking into account the future super information highway, that is, B-ISDN network, ultra wide-band picture-based information can be provided for many subscribers via existing optical fiber cables. However, to achieve the high speed transmission, the technologies must be developed not only for transmission lines but also for transmission nodes. Since the conventional signal transmission/processing technique using electronics has the limit in its speed, novel photonic technology is being developed for this purpose. On the other hand, optical solitons propagate stably through optical fibers, without pulse broadening effect of the fiber dispersion. Since the pulse broadening effect becomes serious as the transmission speed increases, optical solitons is the important technologies to realize the high speed, long distance transmission.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.22 no.5
• /
• pp.500-507
• /
• 2002

By this study, on-line real-time radiometric system was developed using a 64 channels linear array of solid state detectors to measure wall thickness of insulated piping system. This system uses an Ir-192 as a gamma ray source and detector is composed of BGO scintillator and photodiode. Ir-192 gamma ray source and linear detector array mounted on a computer controlled robotic crawler. The Ir-192 gamma ray source is located on one side of the piping components and the detector array on the other side. The individual detectors of the detector array measure the intensity of the gamma rays after passing through the walls and the insulation of the piping component under measurement. The output of the detector array is amplified by amplifier and transmitted to the computer through cable. This system collects and analyses the data from the detector array in real-time as the crawler travels over the piping system. The maximum measurable length of pipe is 120cm/min. in the case of 1mm scanning interval.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.705-711
• /
• 2004

We propose novel OCDMA system with the structure of reconfigurable may encoder/decoder(RAE/ RAD), which are able to reallocate the 2-D optical codes to each subscriber and recover the transmitted data at all the receiving nodes. We have first implemented the double hard limiters composed of limiting amplifier(first hard limiter) that maintain a level of the encoded data from receiving node and AND detector(second hard limiter) for detecting the position of the encoded data and recovering the data. With the proposed system, it was successfully implemented to recover a specific channel data out of 16 code-multiplxed channels using FPGA and 4 DFB-LDs having distinct wavelengths. From experimental results, the code length resulted from increasing the number of the simultaneously connected channels has been reduced by using 2-D OCDMA multiplexed in time and wavelength instead of 1-D OCDMA. In addition, bit errors phenomenon on account of deterioration of autocorrelation peak-to-side lobe ratio is enhanced by using the double hard limiters composed of AND detector and limiting amplifiers.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.7
• /
• pp.1747-1753
• /
• 2013

Signal performances according link span dispersion compensation conditions at the 2000 km long-haul transmission distance using 10 Gbps 40 wavelength division multiplexing channels were analyzed and compared. 95%, 97.5%, 100%, 102.5% and 105% compensation conditions were applied and 97.5% gave the best performance without post dispersion compensation. the effects of accumulated dispersion value and average dispersion value per transmission link for each link compensation condition were analyzed. When post dispersion compensation optimization was applied to five link span dispersion compensation conditions, 102.5% was given the best performance.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.12
• /
• pp.83-91
• /
• 1998

Fiber Bragg grating which has a blazed ang1e to the plane of incident wave generates a side-mode as well as main-mode. The side-mode has an identical characteristics with a long period grating that couples with a cladding mode, so rejects the special wavelength. We experimented on the side-mode characteristics with two fibers which Ge doped depressed index fiber and very high photosensitive H$_2$ loaded step index fiber according to the tilted angle. Also, using a phase mask equipped with rotation plate which has 0.02$^{\circ}$ resolution, we can control the bandwidth and the peak value of a total loss spectrum by aligned tilted grating in a fiber and using this, tried to compose the ASE band rejection filter of the Erbium doped fiber amplifier.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.12 no.4
• /
• pp.28-34
• /
• 1975

텔레비젼 수신용 안테나로써 가장 널리 사용되고있는 Yagi안테나는 구조가 간단하고 지향성 이득등이 좋으나 방사주파수에 대한 반파장길이의 소자를 사용하므로 칫수가 커지고 주파수대역이 좁다. 따라서 설치 취급등에 불편을 느낄 경우가 많다. 한편 최근 일반적으로 아무곳에서나 용이하계 설치할 수 있을만큼 소형이면서 화질이 좋은 수상이 가능한 수신안테나에 대한 요망이 커지고 있는데 본 연구에서는 그 파장에 비해서 소형인 폴디드·다이폴 안테나 소자 2개를 좁은 간격으로 배열하고 이들을 이상결합하므로써 VHF텔레비젼전파의 고채널 주파수대에서 비교적 양한 단일지향성을 얻고 있다. 본 안테나에 능동소자를 이용한 저잡음광대역증폭기를 삽입한다면 다소자 Yagi안테나에 비나될 전후방비를 갖는위에 그의 이득도 크게 증가되어 일반수상안테나로 뿐만 아니라 고우스트 방지용실내안테나로서 상당한 기여틀 할것으로 생각된다. The Yagi antenna, which is most widely used for television receiving, has simple form and good directiyity as well as high gain, but it must be made with linear elements of half wave length. Therefore, the dimension of multi-element Yagi antenna becomes bulky and so a(ten it is inconvenient to install and handle, because of its big size. Moreover the frequency band width of the Yagi antenna is usually not broad enough to cover the total frequency range of VHF TV channels in our country. Recently, the aemand for an antenna which is not only small enough to install it easily anywhere but also assures good quality of pictures is generally increasing. In this study 2 elements o( folded dipole, which is small compared to its electrical ways length, are fixed parallel to each other with a narrow distance and the emfs induced in them are made to get together with some phase difference. This new phased array antenna has shown a relatively good unidirectivity through over the high channel VHF television frequency hand as well as the good PIB ratio which is comparable to that of multielements Yagi antenna. As a result this new antenna will be used as a VHF high channel TV receiving antenna and it may become better antighost antenna when used inside the room than other room antennas.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.16 no.9
• /
• pp.6254-6259
• /
• 2015

On the optical system and the system itself of the noise of the noise from the outside always present. This noise is to function as reducing performance of the optical system. Therefore, the probability of error, thereby changing the system. In this paper, the error probability of the optical system due to changes in various values by introducing the characteristic variable the value of the optical system was calculated using the ${\kappa}$-square method. Was confirmed also in accordance with the calculation result is an error probability of the optical system changes, it was confirmed that when the value of the holding case for holding the standard about 400 Lux on the probability of the optical system. This case was found to be an optical system using a light source with a low output, so that means the smaller output is no problem to maintain the error probability value of the optical system is large. This means that more effective and less expensive to implement because it means that the optical system does not require the use of pre-amplifier for amplifying the signal at the receiving end of an optical system using a light source with a low output when the normal case.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.14 no.9
• /
• pp.4462-4466
• /
• 2013

In optical system, the signal and additive noise for statistical properties of a variety of ways to evaluate the performance of the system is essential for the optimization. In this paper, performance analysis of spectrum-sliced optical system in the optical pre-amplifier in the receiver the received signal by including the error limits for the bit that is, the bit error rate (BER: Bit Error Rate) required to maintain the average optical power represents the number of photons per bit is included in this paper to digital form, noticeable signal the receiver to calculate the sensitivity of the method for the calculation was performed. The general strength of the transmission of the modulated signal and digital signal transmission was required for the comparison of optical power. As shown in Figure 3, the general strength of the digital signal transmission system for transmitting a modulated signal compared with the case is improved by at least 10dB.

• Korean Journal of Optics and Photonics
• /
• v.28 no.1
• /
• pp.22-27
• /
• 2017

Time-encoded near-infrared spectroscopy (NIRS) system is proposed, based on a near-infrared (NIR) swept laser source, for comparison to the conventional NIRS method using a detector-type spectrometer. The cavity of the NIR swept laser source consists of a semiconductor optical amplifier (SOA) with a gain region around 800 nm, and several fiber-optic components. To change the output wavelength in time using an applied electric radio-frequency signal, an acousto-optic tunable filter (AOTF) is introduced in the fiber ring cavity configuration. To demonstrate the feasibility of an NIR swept laser source for NIRS imaging, the spectroscopic comparison of two kinds of absorbance-measuring systems a detector-type spectrometer using a white light source, and a source-type spectrometer using an NIR swept laser is successfully performed with an NIR-absorbing dye.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1096-1103
• /
• 2008

This paper proposes an individual order predistortion linearizer using intermodulation distortion(IMD) generator for cancellation the third and the fifth IMD of power amplifier. The IMD generator for controlling the third and the fifth IMD consist of common Emitter amplifier and Schottky diode. These signals are generated by series feedback of Schottky diode to obtain the inverse AM/AM and AM/PM characteristics of power amplifier. The individual order predistorters are consisted of individual IMD generator, power splitter and combiner. The test results show that the third and the fifth IMD can be improved by a maximum 13.5 dB and 0.9 dB in case of CW 2-tone signals. Also, the Adjacent Channel Leakage Ratio(ACLR) can be improved 2.3 dB, 2.5 dB at ${\pm}0.885$ MHz, ${\pm}1.23$ MHz offset frequency for CD-MA IS-95 2FA signals.