• Korean Journal of Applied Biomechanics
• /
• v.13 no.3
• /
• pp.99-116
• /
• 2003

The purpose of this study was to kinematics factors on during round-off at end of beam-salto backward stretched with step-out to cross on balance beam. Four elite female gymnastics players participated as subject of this study. The methods of this study was analyzed using three dimentional analysis. The results and conclusion of this paper is obtained as follows ; 1. The phase of time was the most short time in board touch down phase and board take-off phase. Also, it was shown a more long time in total time compared to previous study. 2. The horizontal displacement of each phase was shown the most high levels in balance beam landing. The vertical displacement was display a non-linearity increase in board take-of phase, and it was shown the most high levels in vertical displacement during landing of balance beam. 3. The horizontal velocity of each phase was shown the most high levels in board touch down, and it was display a gradually decreased levels because flight during board take-of. The resultant velocity of CG on each phase was shown the most high levels in board touch down and board take-off. 4. The angle of hip joint was shown the most high levels as performed a motion in extension state during board take-off, and the angle of knee joint was display a increased levels because of flight cause body extension in board take-off. Also the angle of ankle joint was shown a increasing levels during board take-off. Considering to this results, it is suggest that the change of kinematics factors in board touch down and board take-off is key role on the effective board control.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.23 no.5
• /
• pp.1384-1396
• /
• 1998

This paper ivestigates the performance of a relative rate (RR) switch algorithm for the rate-based available bit rate (ABR) flow control in asynchronous transfer mode (ATM) networks. A RR switch may notify the network congestion status to the source by suing the congestion indication (CI) bit or no increase (NI)bit in the backward RM (BRM) cells. A RR switch can be differently implemented according to the congestion detectio and notification methods. In this paper, we propose three implementation schemes for the RR switch with different congestion detection and notification methods, and analyze the allowed cell rate (ACR) of a source and the queue length of a switch in steady state. In addition, we derive the upper and lower bounds for the maximum and minimum queue lengths for each scheme respectively, and evaluate the effects of the ABR parameter values on the queue length. Furthermore, we suggest the range of the rage increase factor (RIF) and rate decrease factor (RDF) parameter values which can prevent buffer overflow and underflow at a switch.

• Journal of the Korean Society of Physical Medicine
• /
• v.14 no.4
• /
• pp.153-162
• /
• 2019

PURPOSE: This study compared ankle joint exercise and thigh exercise on the isometric strength of the lower limb and balance ability. METHODS: Twenty-seven subjects were divided into ankle joint exercise (AEG, n=9), tight exercise (TEG, n=9), and control group (CON, n=9). AEG and TEG performed ankle joint and tight exercises three times a week for four weeks. The following were measured before and four weeks after each exercise: isometric strength at knee flexion and extension of the lower limb; isometric strength at ankle plantar flexion and dorsiflexion of the lower limb; static balance of trace length and C90 area; and the dynamic forward, backward, leftward, and rightward balance for each region. RESULTS: The results showed that the isometric strength of plantar flexion (p<.05) was increased significantly in AEG compared to those in TEG and CON. The dynamic leftward (p<.05) and rightward balance (p<.05) were increased significantly in both AEG and TEG compared to that in CON. On the other hand, the static balance of the trace length and C90 area, isometric strength of ankle dorsiflexion, knee flexion and extension of the lower limb, and dynamic forward and backward balance did not show significant differences between the groups. CONCLUSION: Ankle joint exercise improves the isometric strength of plantar flexion compared to tight exercise.

• Journal of KIISE:Information Networking
• /
• v.27 no.1
• /
• pp.98-107
• /
• 2000

This paper compares the performance of feedback consolidation algorithms with or without a fast overload indication function which has been recently proposed in the ATM Forum for multicast ABR (Available Bit Rate) services in ATM networks. We use the performance criteria such as the ACR (Allowed Cell Rate) of a source, queue length at a switch, link utilization, fairness, and BRM (Backward Resource Management) cell overhead. Simulation results show that performance of the feedback consolidation algorithms with a fast overload indication function can be improved sign.ificantly than that of algorithms without this function in terms of ramp-down delay, particularly in initial start-up period or under a severe overload situation. The fast overload indication function can be combined with any feedback consolidation algorithm, whereas its performance is highly dependent on an underlying basic feedback consolidation algorithm.

• The Journal of the Korea Contents Association
• /
• v.4 no.2
• /
• pp.68-75
• /
• 2004

In this paper, n study a distributed establishment scheme to setup lightpath in WDM/TDM Network considering user traffic characteristics. We propose a GBTA(guaranteed-bandwidth time-slot allocation) algorithm which assigns time-slots according to the requred traffic so that it can utilize given network resources efficiently in RWTA(routing and wavelength time-slot assignment) schemes. We consider traffic specification on the basis of ATM traffic classes. Also, in order to increase link utilization and minimize blocking probability, we extend distributed lightpath establishment protocol based on GBTA algorithm. In order to establish lightpath in distributed WDM/IDM network, we use backward resonation protocol that resewes resource with recent information. We use DOWTns(Distributed Optical WDM/TDM ns) that is extended from NS(Network Simulator), in order to verify proposed GBTA-based optical wavelength routed network.

• Journal of Biomedical Engineering Research
• /
• v.21 no.4
• /
• pp.385-390
• /
• 2000

The alignment of the prosthetics is very important in an amputee's gait. In the present study. a static prosthesis-alignment device was developed. It consisted of a force plate with four load cells, a laser beam controlled by a step motor, and a control part programmed by PCBASIC. Using the static prosthesis-alignment device, we measured the distance between the load line and various joints of 24 normal volunteers in three standing postures. such as neutral, forward leaning, and backward leaning. Only neutral postures were evaluated on four trans-tibial amputees. The load line for the normal person's neutral position located anterior to the ankle, the knee, and the greater trochanter, but posterior to the shoulder joint. Forward and backward leaning of the normal person resulted in a significant anterior and posterior movements of the load line, respectively. The load line for the amputated side of the trans-tibial amputee also located anterior to the ankle, the extremity prostheses, providing a good relative locations of the load line with respect to various joints.

• Physical Therapy Rehabilitation Science
• /
• v.8 no.1
• /
• pp.40-44
• /
• 2019

Objective: The purpose of this study was to examine the changes in postural stability according to ankle fixation in healthy university students. Design: Cross-sectional study. Methods: Thirty healthy subjects (15 males and 15 females, 20.13 years, 167.49 cm, 65.87 kg) were recruited on a voluntary basis. The BT4 system (HUR Laps Oy, Tampere, Finland) was used to measure the static (standing posture with eyes open and eyes closed) and dynamic (external perturbation and limits of stability (LOS) in the forward, backward, left, and right side) balance abilities. External perturbation was measured by the subject's postural sway velocity and area for 20 seconds after being impacted by a gym ball. Static and dynamic stabilities were measured with ankle joint fixation and non-fixation conditions. Ankle fixation was provided using Mueller tape on both ankle joints. Results: For static stability under the standing posture, there was no significant difference between standing with ankle joint fixation and non-fixation conditions. However, dynamic stability (external perturbation and LOS in the forward, backward, left, and right side) was significantly higher in the standing with the non-fixation condition compared to the standing with ankle joint fixation condition (p<0.05). Conclusions: Our results reveal that ankle joint fixation can influence dynamic stability during standing. Thus, we believe that this result provides basic information for making improvements in postural control and may be useful in balance training for fall prevention.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.35 no.4
• /
• pp.652-661
• /
• 2008

The purpose of this study was to evaluate the skeletal and dental effects obtained by the Frankel functional regulator III in growing children with Class III malocclusions. Cephalometric changes in thirty children at the time of mixed dentition malocclusions (initial mean age, $7.9{\pm}1.1$ years; mean treatment duration, $1.5{\pm}0.8$ years) were analysed. The results were as follows : 1. The skeletal effects on the maxilla showed a significant downward displacement whereas forward displacement was not significant in comparison with the control group. 2. The skeletal effects on the mandible showed statistically significant backward and downward displacement. 3. The dental effects showed statistically significant backward movement in the mandibular incisor tip and increase of overjet The results suggested that forward displacement on the maxilla was insufficient and treatment effects were caused mainly by downward displacement of the maxilla, backward and downward rotation of the mandible, and the increase of overjet during short period.

• Maxillofacial Plastic and Reconstructive Surgery
• /
• v.27 no.4
• /
• pp.365-371
• /
• 2005

In esthetic treatment of bimaxillary protrusion, it is important to move backward the anterior teeth segment. For the backward movement of the anterior teeth segment, orthodontic force and segmental osteotomy have been applied on the clinical treatment until recently. These methods caused long treatment time, anchorage loss, the possibility of root resorption and the complication followed by segmental osteotomy. Therefore, corticotomy has become a major concern lately. This research has been conducted to study the efficiency of corticotomy in the treatment of bimaxillary protrusion comparing the profile change, canine retraction velocity and space closing time. The research compared and analyzed space closing time, canine retraction velocity and profile change in two groups of patients. Both groups were formed out of patients over 18 years old who visited the department of dentistry in Hanyang University for treatments. The experimental group who was treated by corticotomy and Skeletal Anchorage System(SAS). The control group who received orthodontic treatment using SAS. The following results are produced after analyzing both groups. The significant statistic difference in space closing time has been observed in the experimental group as compared with the control group(p<0.05). In the experimental group, the significant statistic increase in canine retraction velocity was also observed(p<0.05). There was no significant difference in profile change between the control group and the experimental group(p<0.05). As a result, orthodontic treatment using corticotomy has a reasonable efficiency in space closing time as compared with the existing orthodontic treatment. Therefore, it is concluded that corticotomy with orthodontic treatment can be reasonably applied to dentofacial abnormality.

• Physical Therapy Rehabilitation Science
• /
• v.5 no.4
• /
• pp.178-184
• /
• 2016

Objective: Tension-type headache is caused by hormones, foods, irritants, stress, obesity, fatigue, and neck and head trigger points-prolonged abnormal posture. The purpose of this study was to evaluate the effects of relaxation approach on head posture, static postural stability, and headache in persons with tension-type headache. Design: Randomized controlled trial. Methods: Thirty-five persons with tension-type headache participated in this study. This study was a pretest-posttest with a control group design for a duration of 4 weeks (60 min/3 times/1 wk). The participants were randomly allocated to the relaxation approach group (n=18) and the control group with conventional rehabilitation including thermotherapy and transcutaneous electrical stimulation for the same period (n=17). Outcome measures involved forward head posture (FHP), foot pressure, neck disability index (NDI), and six-item headache impact test (HIT-6). Results: Relaxation approach and control groups improved significantly in the amount of forward head posture, neck disability index, and six-item headache impact test scores after training (p<0.05). The control group was found to be significantly different in the amount of FHP, backward foot pressure, NDI, and HIT-6 after training compared to before training (p<0.05). The relaxation approach group significantly improved in forward head posture, neck disability index, and six-item headache impact test compared with control group after training (p<0.05). Neck disability index and six-item headache impact test significantly improved after training compared with before training in the control group (p<0.05). However, the foot pressure was not significantly different between relaxation approach and control groups. Conclusions: This study suggests that treatment with relaxation approach combined with self-exercise would be effective in reducing the amount of forward head posture, neck disability and headache impacts.