• Journal of the Korean Ceramic Society
• /
• v.27 no.1
• /
• pp.79-85
• /
• 1990

A study on the oxidation of SiO2 sensing layer was done at 950, 1000, 105$0^{\circ}C$ under dry O2 atmosphere. The rate determining step around the oxide layer thickness, 1000$\AA$ was different with the oxidation temperature, as follows ; ⅰ) linear growth at 95$0^{\circ}C$ and ⅱ) parabolic growth at 100$0^{\circ}C$ and 105$0^{\circ}C$. The flatness of SiO2 film was observed within $\pm$1% and surface state charge density was reduced by annealing in N2 atmosphere. Finally, pH sensitivity of SiO2 film, in the range of pH 3-9, was 20mV/pH.

• Journal of the Korean Ceramic Society
• /
• v.31 no.11
• /
• pp.1293-1298
• /
• 1994

(Zr, Sn)TiO4 powders were prepared in 0.05~0.13 ${\mu}{\textrm}{m}$ by coprecipitating (Zr4+, Ti4+)hydroxide on SnO2 particles and followed by calcination at 90$0^{\circ}C$ for 2 h. They sinter to 95% of relative density at 140$0^{\circ}C$ for 2 h. and shows dielectric constant, $\varepsilon$r=37.5 and quality factor, Qxf(GHz)=46,000. With 3 mol% of ZnO it sinters to rel=97.5%, $\varepsilon$r=39 and Qxf(GHz)=40,050 at 135$0^{\circ}C$ for 2 h., but raising sintering temperature to 140$0^{\circ}C$ deteriorates quality factor, relative density and microstructure with developing second phase.

• The Korean Journal of Mycology
• /
• v.25 no.4 s.83
• /
• pp.369-376
• /
• 1997

These researches were carried out for improvement of medium for mycelial growth of Hericium erinaceus isolate KU-1. It grew well at pH 4 and $25^{\circ}C$. Glucose and sucrose were favorable carbon sources for mycelial growth. As nitrogen sources, ammonium acetate and arginine enhanced mycelial growth. Optimum C/N ratio was 200. Based On the results, the following recipe is suggested for synthetic medium for the mycelial growth: glucose 18.02 g, arginine 2.613 g, ammonium acetate 2.313 g, $CaCl_2\;0.33\;g$, $KH_2PO_4\;8.5\;g$, $MgSO_4{\cdot}7H_2O\;2.0\;g$, $FeSO_4{\cdot}7H_2O\;0.02\;g$, $ZnSO_4{cdot}7H_2O\;0.02\;g$, $MnSO_4{\cdot}7H_2O\;0.02\;g$, water 1 liter. This medium was superior for the mycelial growth to other conventional media such as Yeast malt extract agar (YMA), Park medium, Potato dextrose agar (PDA), Malt extract agar, Czapek-dox agar, Macaya-lizano medium and Yeast extract agar. This new synthetic medium is designated as Ko medium.

• Korean Journal of Materials Research
• /
• v.18 no.11
• /
• pp.628-633
• /
• 2008

ZnO nanopowders were synthesized by the sol-gel method using hydrazine reduction, and their gas responses to 6 gases (200 ppm of $C_2H_5OH$, $CH_3COCH_3$, $H_2$, $C_3H_8$, 100 ppm of CO, and 5 ppm of $NO_2$) were measured at $300\;{\sim}\;400^{\circ}C$. The prepared ZnO nanopowders showed high gas responses to $C_2H_5OH$ and $CH_3COCH_3$ at $400^{\circ}C$. The sensing materials prepared at the compositions of [$ZnCl_2$]:[$N_2H_4$]:[NaOH] = 1:1:1 and 1:2:2 showed particularly high gas responses ($S\;=\;R_a/R_g,\;R_a$ : resistance in air, $R_g$ : resistance in gas) to 200 ppm of $C_2H_5OH$($S\;=\;102.8{\sim}160.7$) and 200 ppm of $CH_3COCH_3$($S\;= 72.6{\sim}166.2$), while they showed low gas responses to $H_2$, $C_3H_8$, CO, and $NO_2$. The reason for high sensitivity to these 2 gases was discussed in relation to the reaction mechanism, oxidation state, surface area, and particle morphology of the sensing materials.

• Journal of the Korean Ceramic Society
• /
• v.56 no.4
• /
• pp.350-353
• /
• 2019

Porous alumina ceramics with addition of 0, 5, 10, 15, and 20 wt% Al(H₂PO₄)₃ were sintered at 1300, 1350, and 1400℃. The effects of the Al(H₂PO₄)₃ addition on crystal phases, water absorption, open porosity, pore size distribution, microstructures, and flexural strength were studied extensively. The experimental results revealed that only characteristic peaks of corundum were indexed in the XRD patterns of the as-prepared porous ceramics. The water absorption and open porosity of the porous Al₂O₃ ceramics increased remarkably with an increase in Al(H₂PO₄)₃ addition. The flexural strength first increased to a maximum value when 5 wt% Al(H₂PO₄)₃ was added and then decreased as additional Al(H₂PO₄)₃ was further added. SEM images showed that the average Al₂O₃ grain size in the porous ceramics changed in an opposite way as the flexural strength. The porous Al₂O₃ ceramics with 10 wt% Al(H₂PO₄)₃ addition exhibited comparable flexural strength to the ceramics without Al(H₂PO₄)₃ addition, although the latter had much higher porosity.

• Korean Journal of Veterinary Research
• /
• v.36 no.2
• /
• pp.379-387
• /
• 1996

The objects of the present study were to establish the method of purification, subunit dissociation of verotoxin-2 (VT2) produced by Escherichia coli O157:H7, and to investigate the characteristics of purified verotoxin-2 such as molecular weight and composition of amino acid. The results were summerized as follows; Verotoxin-2 was extracted by addition of polymyxin B sulfate into bacterial cell lysate prepared from Escherichia coli O157:H7(KSC109). As an initial step, the bacterial cell lysate was precipitated with 30% saturated ammonium sulfate. The precipitated crude toxin was then subjected to anion-exchange, chromatofocusing and cation-exchange chromatography. Using this scheme, we obtained highly purified toxin with a specific activity of $1.1{\times}10^9$ $CD_{50}/mg$. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis(SDS-PAGE) for purified VT2 showed two protein bands. The upper band, approximately 32 Kd, was supposed as A subunit and the lower band, approximately 7.7 Kd, was supposed as B subunit. When the toxin was separated in the subunit-dissociating solution, two peaks emerged with retention times of 15 and 28 min by HPLC. These peaks represented A subunit and B subunit, respectively. The amino acid composition of purified VT2 were made up in order of glutamic acid, histamine, asparaginic acid, histidine, lysine, alanine and leucine etc. The largest amount among the amino acid composing VT2 was methionine.

• Journal of Surface Science and Engineering
• /
• v.39 no.6
• /
• pp.250-254
• /
• 2006

Effect of hydrogen partial pressure ratio on the structural and electrical properties of highly c-axis oriented ZnO films deposited by oxygen ion-assisted pulsed filtered vacuum arc at a room temperature was investigated. The hydrogen partial pressure ratio were $1.4%\sim9.8%$ at 40% oxygen pressure ratio. The conductivity of ZnO:H films was increased from 1.4% up to 4.2% due to relatively high carrier mobility caused by improvement of crystallinity While the conductivity of ZnO:H films were decreased over than 4.2% and (0002) orientation was also deteriorated. The lowest resistivity of ZnO:H films was $2.5{\times}10^{-3}\;{\Omega}{\cdot}cm$ at 4.2% of hydrogen pressure ratio. Transmittance of ZnO:H films in visible range was 85% which is lower than that of undoped ZnO films because of declined preferred orientation.

• Clean Technology
• /
• v.23 no.1
• /
• pp.95-103
• /
• 2017

In this study, $ATiO_3$ (A = Ca, Sr, Ba) perovskite, which is the widely known for non $TiO_2$ photocatalysts, were synthesized using sol-gel method. And Ni was added at the A site of $ATiO_3$ by using that it is easy to incorporate. The physicochemical characteristics of the obtained $ATiO_3$ and Ni-$ATiO_3$ particles were confirmed using the X-ray diffraction (XRD) UV-visible spectroscopy, scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), the $N_2$ adsorption-desorption isotherm measurement, and X-ray photoelectron spectroscopy (XPS). The $H_2$ was produced using the photolysis of MeOH. Using the Ni-$ATiO_3$ photocatalysts, $H_2$ production was higher than using the $ATiO_3$ photocatalysts. Especially, $273.84mmolg^{-1}$ $H_2$ was produced after 24 h reaction over the Ni-$SrTiO_3$. Also in the water (0.1 M KOH) with the Ni-$SrTiO_3$, $H_2$ production was $961.51mmolg^{-1}$ after 24 h reaction.

• Journal of Integrative Natural Science
• /
• v.12 no.4
• /
• pp.101-104
• /
• 2019

A hydrated strontium iron fluoride, Sr₂Fe₂F₁₀(H₂O) has been synthesized and characterized. The material was synthesized through mild hydrothermal reaction using an aqueous CF₃COOH solution. The material exhibits a one-dimensional structure consisting of chains of corner-shared Fe³⁺F₆ octahedra, isolated Fe³⁺F₅(H₂O) octahedra, chains of SrF₁₀ polyhedra and isolated SrF₈ polyhedra, respectively. Magnetic property measurements on Sr₂Fe₂F₁₀(H₂O) reveals an antiferromagnetic order at T_N of ~2.5 K with a Weiss temperature (θ) of -61.51 K.

• Bulletin of the Korean Chemical Society
• /
• v.25 no.12
• /
• pp.1955-1958
• /
• 2004