Objectives: This study was conducted in order to investigate the diesel exhaust particle(DEP) concentrations in the thirteen parking lots of large shopping complex. Methods: The real-time black carbon(BC) concentration was determined using an Aethalometer, and elemental/organic carbon concentration was determined according to the method of the National Institute for Occupational Safety and Health(NIOSH) 5040. The particle number concentration(NC), lung deposited surface area concentration(LDSA) and geometric mean diameter(GMD) were determined using a DiSCmini aerosol monitor. Results: The average concentration of BC, EC, OC, NC, LDSA and GMD were $19.1{\mu}g/m^3$, $12.6{\mu}g/m^3$, $51.5{\mu}g/m^3$, $94,000particles/cm^{-3}$, $298{\mu}m^2/cm^{-3}$ and 57 nm in all parking lots, respectively, approximately 3-fold higher than those found in the urban outdoor. The average concentration of BC were $21.3{\mu}g/m^3$ in underground parking lots, 3-fold higher than above parking lots. Conclusions: Therefore, the parking lots at the large shopping complex can be considered a potentially dangerous environment with a high concentration of DEP nanoparticles.

Objectives: This study was designed to establish an accurate analytical method for asbestos in a biological sample for determining occupational asbestos-related diseases and relief of the health effects of environmental asbestos. Methods: Biological samples were obtained from lungs of rats following intratracheal instillation of asbestos(Chrysotile, anthophyllite) and were prepared according to digestion method(Wet digestion, high temperature ashing, low temperature ashing). The samples were then analyzed for asbestos fibers using a transmission electron microscope equipped with an energy dispersive X-ray spectrometer. Results: Low temperature plasma ashing removed more of the organic components and reduced fiber loss compared to the wet digestion method, making specimens so prepared more suitable for transmission electron microsocpy. Conclusions: The low temperature ashing technique is the most accurate method for analyzing asbestos in biological samples.

Objectives: The aim of this study is to investigate the differences in airborne TDI concentrations based on the filter collection method and liquid collection method and to compare airborne TDIs concentrations by sampling method change when using the filter collection method in the spray-painting process. Methods: For the sample measurement, the filter collection method(OSHA#42) and liquid collection method(NIOSH#5522) were used; for the sampling method, the full-period single sampling and full-period consecutive sampling methods were used. The samples were collected in spray-painting and drying process locations. Results: In all samples collected from the spray-painting and drying process locations through the filter collection and liquid collection methods, greater amounts of 2,6-TDI than 2,4-TDI were detected. When the TDI collection concentrations based on the sampling methods were compared, the concentrations of 2,4-TDI and 2,6-TDI collected by the consecutive sampling method were higher than the concentrations of 2,4-TDI and 2,6-TDI collected by the single sampling method for both the filter collection method and liquid collection method used in the spray-painting process. These differences were statistically significant. Conclusions: When TDI collection concentrations based on the sample measurement methods were compared, the concentration of 2,4-TDI and 2,6-TDI collected through the liquid collection method were higher than the concentrations of 2,4-TDI and 2,6-TDI collected by the filter collection method, and the differences were statistically significant. In the drying process, no difference was shown in the collection concentrations of 2,4-TDI and 2,6-TDI with the two measurement methods.

Objectives: In working environment measurement, sampling is an important stage for obtaining reliable result as analysis. A personal air sampling pump is one of the most fundamental and important element in the work environment measurement, but it remains at the level of calibrating the flow rate of the pump before and after sampling. There is no checking whether the flow rate set at the initial stage would be hold during sampling. The purpose of this study was to develop a method to evaluate the flow rate performance of particulate sampling pump with three-pieces cassette holder containing filters commonly used to sample particulate. Materials and methods: We tested back pressure of particulate sampling pumps commonly used in Korea with three-pieces cassette holder containing various filters, and tried to find out the combination conditions of filters in accordance with back pressure required by ISO standard 13137. Results: We found out the matrix of sampling media such as three-pieces cassette holder containing filters applicable to the pressure drop required by the ISO standard for evaluating the flow rate stability under increasing pressure drop and long term(8 hour) performance. Conclusions: This evaluation method using sampling media matrix for checking flow rate stability proposed by this study could be very useful tool to find out good performance pumps before sampling.

Objectives: This study was conducted in order to evaluate $PM_{2.5}$ concentrations at 20 offices connected to the manufacturing industry from the beginning of September to the end of November 2012. Methods: A total of 20 samples were collected from 20 office buildings. Each $PM_{2.5}$ sample was collected by a 37 mm PTFE filter attached to a Personal Environment Monitor. Results: The geometric mean concentrations of $PM_{2.5}$ in the offices was $23.47{\mu}g/m^3$, and the mean $PM_{2.5}$ concentrations measured in smoking offices were much higher than those of measured in non-smoking offices($24.83{\mu}g/m^3$ and $21.55{\mu}g/m^3$, respectively). $PM_{2.5}$ was revealed to be higher in small offices($39.52{\mu}g/m^3$) than in medium or large offices($22.69{\mu}g/m^3$ and $11.04{\mu}g/m^3$, respectively). The mean $PM_{2.5}$ concentration of offices located on the 1st floor was higher than that of those on the 2nd floor, and those of offices located in the workplace were higher than those out of the workplace. The multiple regression model showed that concentration of $PM_{2.5}$ was positively associated with the method of ventilation. Conclusions: Smoking, ventilation method, location, and inflow of outdoor particulate matter are the most important factors for office $PM_{2.5}$ concentrations.

Objectives: Employee exposure record refers to a record containing information about environmental (workplace) monitoring or measuring of a toxic substance or harmful physical agent. The aims of this study were to examine problems related to exposure records and provide some amendments to the Korean Industrial Safety & Health Act for the effective management of chemical substances under the law. Methods: This study performed a literature search and review on legal provisions related to exposure records of a number of different countries, including Korea, the USA, Japan, EU, Germany, and the UK. They were compared and investigated and the amendment of articles was suggested. Results: The results of this study were provided as suggested amendments to the related act. There were a variety of ways of improvement, including a 30-year retention period and the introduction of new access methods, contents, transfer, and maintenance methods. All exposure data elements have to be standardized, including reference to a similar exposure group (SEG), sampling strategy, and circumstances of exposure (e.g., date, shift length, use of personal protective equipment, etc.). The SEGs are described by process, job, task, and environmental agent. Conclusions: This study is expected to provide for the amendment of the related act in order to ensure effective management of exposure records and is helpful for solving the cause and result of occupational disease by keeping exposure records according to the Industrial Safety & Health Act.

Objectives: The major objective of this study is to review overall and in detail the Corporate Manslaughter and Corporate Homicide Act 2007 in the U.K.and the principal contents of this act. Methods: A variety of articles related to the background and circumstances under which the legistration was enacted and the details of this act were investigated and analyzed. Results: In enacting Corporate Manslaughter and Corporate Homicide Act 2007, legislators mainly took elements of legal culture into account and focused on seeking to broaden the law on corporate manslaughter. An indictable offence is considered to have been committed if the way in which an organization's activities are managed or organised causes a person's death and amounts to a gross breach of the relevant duty of care owed by the organization to the deceased. The way in which its activities are managed or organized by its senior management is a substantial element in the breach. Upon conviction, a corporation may be ordered to remedy any breach, publicize its failures, or be given an unlimited fine. Conclusions: The enactment background and details of Corporate Manslaughter and Corporate Homicide Act 2007 is understood accurately. On the basis of the findings, it is necessary to heighten effectiveness of punishment.for senior management or corporations that cause a person's death in Korea.

Objective: This study inspected incident cases, legal control levels, and GHS(Globally Harmonized System of Classification and Labeling of Chemicals) classification results of strong acids such as hydrogen fluoride, hydrogen chloride, nitric acid, and sulfuric acid, which have been responsible for many recent chemical accidents. As a result, it is deemed necessary for legal control levels of these strong acids to be revised and GHS classification be managed nation-wide. Methods: This study inspected incident cases and legal control levels for strong acids such as hydrogen fluoride, hydrogen chloride, nitric acid, and sulfuric acid. The study analyzed and compared chemical information status and GHS classification results. Results: There were 76 domestic incidents involving strongly acidic hazardous materials over the five years between 2007 and 2011. They include 37 leakage incidents(46.7%) within a workplace, 30 leakage incidents(39.5%) during transportation, and nine leakage incidents(13.8%) following an explosion. The strongly acidic materials in question are defined and controlled as toxic chemicals according to the classes of Substances Requiring Preparation for Accidents, Managed Hazardous Substance, Hazardous Chemical(corrosive) as set forth under the Enforcement Decree of the Toxic Chemicals Control Act and Rules on Occupational Safety and Health Standards of Occupational Safety and Health Act. Among them, nitric acid is solely controlled as a class 6 hazardous material, oxidizing liquid, under the Hazardous Chemicals Control Act. The classification results of the EU ECHA(European Chemicals Agency) CLP(Commission Regulation(EC) No. 790/2009 of 10 August 2009, for the purposes of its adaptation to technical and scientific progress, Regulation(EC) No 1272/2008 of the European Parliament and of the Council on classification, labeling and packaging of substances and mixtures) and NIER (National Institute of Environmental Research) are almost identical for the three chemicals, with the exception of sulfuric acid. Much of the classification information of NITE (National Institute of Technology and Evaluation) and KOSHA(Korea Occupational Safety and Health Agency, KOSHA) is the same. NIER provides 12(41.4%) out of 29 classifications, as does KOSHA.

Objectives: Endotoxins in dust generated in occupational settings is known to contribute to the occurrence of respiratory illness among workers. The relationship between the level of endotoxins in total dust or respirable particulates collected from swine farms and immunological markers related with respiratory allergy was evaluated among swine husbandry workers. Materials and Methods: Peripheral blood samples were collected from ten workers at ten swine farms at Gyeonggi province, Korea. Peripheral mononuclear cells were stimulated with phorbol 12-myristate 13-acetate and ionomycin for 48 hours. The levels of various cytokines produced at culture supernatants were determined using a commercially available ELISA kit. The concentration of particulate matter($PM_{10}$) in the indoor air of the swine farms was evaluated using a PVC membrane filter and mini volume air sampler, and endotoxin levels in the dust were measured by Limulus Amebocyte Lysate Kinetic QCL method. Results: Levels of endotoxins in the total dust were categorized into high(geometric mean: $109.35EU/m^3$) and low concentrations (geometric mean: $0.95EU/m^3$) for five swine farms. Interleukin-4 levels were higher in the high endotoxin group than in the low endotoxin group, while interferon-${\gamma}$ levels were lower in the high endotoxin group than in the low endotoxin group. The ratio (interferon-${\gamma}$ to interleukin-4), indicating immunologic skewedness against allergic reactivities, was lower in the high endotoxin group($1.15{\pm}0.60$) than the low endotoxin group($3.09{\pm}2.38$). In addition, the level of interleukin-13, another cytokine contributing to the occurrence of allergic responses, was significantly higher in the at the high endotoxin group($1.12{\pm}0.37ng/m{\ell}$) than in the low endotoxin group($0.37{\pm}0.04ng/m{\ell}$). Hematologic assessment showed significantly lower cellularity in the number of total leukocytes, neutrophils, and eosinophils in the high endotoxin group than in the low endotoxin group. Conclusions: Even though a sufficient number of swine workers and farms were not investigated, this study generlly suggests that the immunological function of swine farm workers exposed to high levels of endotoxin could be modulated toward allergic reactivities.

Objectives: This study aims to assess the concentrations of ammonia and hydrogen sulfide according to task unit area at swine farms. Methods: A total of six swine farms were selected for this study. Ammonia and hydrogen sulfide were monitored using a real-time multi-gas monitor which could sample the gases simultaneously. The sampling was done in the pig building, manure storage facility and composting facility of each farm. Results: The concentration of ammonia in the pig buildings(GM 22.6 ppm, GSD 2.3) was significantly higher(p<0.0001) than in the manure storage facilities(GM 10.4 ppm, GSD 2.7) and composting facilities(GM 8.6 ppm, GSD 2.8). The concentration of hydrogen sulfide in the manure storage facilities(GM 9.8 ppm, GSD 3.2) was higher(p<0.0001) than in the pig buildings(GM 2.3 ppm, GSD 2.3) and composting facilities(GM 1.9 ppm, GSD 2.5). In particular, the levels of hydrogen sulfide in the confined manure storage facilities were higher than those in open-type facilities and the peak concentration(98 ppm) in the confined facilities was approximate to 100 ppm, at the value of Immediately Dangerous to Life or Health(IDLH). Conclusions: Suffocation accidents caused by hazardous gases at a swine farm have occurred annually. Real-time monitoring of the hazards should be done in order to protect farm workers and livestock from the sudden accidents.

Objectives: This study was conducted in order to evaluate personal and area exposure to airborne total dust and endotoxin during harvest and planting tasks at cucumber, yellow melon and potato farms Materials and Methods: Total dust was measured with NIOSH method 0500. Endotoxin were measured using a 37 mm glass fiber filter which was connected to an air pump calibrated to 2 LPM, and then analyzed with a Turbidmetric kinetic method. Results: The average(arithmetic mean) concentrations of total dust in the personal samples were $0.10-3.81mg/m^3$ for cucumbers, $0.21-1.19mg/m^3$ for yellow melon, and $0.08-2.72mg/m^3$ for potato. There was a significant difference in the harvest task among the three farm types(p=0.019 of personal sample, p=0.048 of area sample), in which the air concentration for potatoes was higher than with cucumbers and yellow melons. Conclusions: It was found that potatoes(planting and harvest) should be considered the first priority for studying and reducing total dust exposure.