Accurate solar radiation data are fundamental to the design of HVAC systems and solar driven devices. Unfortunately, the total radiation data on a horizontal surface has been only reported by meteorological office. Consequently, there is interest in development of model to estimate the solar radiation data. Based on the statistically estimated TAC data which were obtained from measured hourly values collected over a period of ten years at Seoul, the solar radiation model was determined. Atmospheric transmittance for this model was presented in the form of polynominal.

An experimental investigation has been conducted to determine the flow pattern for two-component , two-phase mixtures which flow vertically upwards in concentric annuli based on the measurement for the local void fraction and the distribution of the local void fraction in various radial locations in the annular gap. The annular test section consists of a lucite outer tube whose inside diameter is 38mm and a stainless steel rod, The rod diameter is either :2mm,16mm or 20mm. It is demonstrated that the probability density function of the fluctuations in void fraction may be used as an flow pattern indicator and the local void fraction distribution depends on the flow pattern and radial location in the annular passage.

A study of appling solar assisted heat pump heating system to Korean climatic charac-teritics has been undertaken through computer simulation using TRNSYS (A Transient System Simulation Program). It is insufficient for heating system composed of each of solar and heat pump system to supply heat met with heating load. So SAHP (Solar Assisted Heat Pump) heating systems which combined solar system with heat pump system are analized using the standard weather data of Korea. And SAHP heating systems are categorized into the series system in which the solar storage is used as the source for the heat pump, the parallel system in which ambient air is used as the source for the heat pump, and the dual source system in which the storage or ambient is used as the source depending on which source yields the lowest work input. These combined system are better than each of solar and heat pump heating system in view of thermal performance, and parallel system is most effective among these combined systems.

As one of the explosion suppression methods of LPG tank exposed to hot environment by an accident or fire, some material which has large heat capacity and thermal conductivity can be installed inside the LPG tank in order to suppress the temperature increasement of tank wall. In the present study, theoretical model for the horizontally locating cylindrical LPG tank with and without the aluminum explosion suppression material has been developed to predict the characteristics of system. As a parametric study, effects of two major parameters, thickness of material filling and initial vapor volume fraction, on the time variation of wall temperature, temperature and pressure in tank are numerically examined. The results of present study show that the thickness of material filling does not give big differences in the suppression characteristics when the thickness of filling is larger than three inches. In case of material filling, there are marked suppression effects to the increase-ment of wall temperature, average vapor temperature and pressure in tank compared with the case of no filling.

The combustion kinetics of the imported bituminous coal was studied in the interme-diated heating rate. The activation energy and the frequency factor were obtained by experi-ment of the coal weight loss depending on the combustion time with Ih. furnace. The experi-ments were performed in the heating rates of $1,5,10^{\circ}C/sec\;or\;20^{\circ}C/sec\;at\;the\;600-900^{\circ}C$ maximum temperature, The values of the activation energy(E) which were calculated from the experimental data existed in the range from 3000cal/g-mol to 15000cal/g-mol, and those of the frequency $factor(1nk_O)$ were in the range from 4.5cm/sec to 11.5cm/sec.