The computer can be used to display a continuously updated list or plot of vessel position. The computer that accept input data from a number of different navigation systems, e.g., Loran , Satnav, Radar, Decca, Compass, Sextant with electrical output etc., can compute the position of a vessel relative to prerecorded objects. The celestial navigation system requires the computer to do not much calculation. Calculation are for trigonometeric, linear systems, finding roots of nonlinear equation and least square estimation etc, . In order to computerize the celestrial navigation system, these calculations must be programmed. The purpose of this thesis is to study the formulation, the design and the test of calculations of the coordinates of celestial bodies, the altitude correction and the solution of the navigational triangle processes.

Marine casualities in the high sea are mainly classified into the breakage of hull and capsize , of which the latter occurs frequently to a small craft and container vessels by extreme rolling. The aim of this study is to develop shiphandling techniques for the prevention of ship's large rolling by way of evaluating dangerous degree of rolling in heavy weather. In this study, rolling motion is analized by using statistical method as follow : (1) 8 sample ships is presented for calculation. (2) Analized sea state are Beaufort scale 7 and 10 (wind velocity 30kts and 50kts respectively) and significant wave height is put as 5.2m and 11.2m. (3) The formula recommended by International Towing Tank Conference (ITTC) is used to calculated the wave spectrum. The results of this study are as follow : The results of this study are as follow : (1) Most of the vessels with beam of 20 meters or less was found to be capized in the waves abeam under the sea condition of Bearfort scale7(30kts). (2) For the vessels range 20m to 30m was found safe under the sea conditions of Bearfort scale 7(30kts) and imminent danger under the sea condition of Beaufort scale 11(50kts). (3) It is proved that any vessel could be capsized by heavy rolling regardless of vessel's size whenever the motion is synchronized with waves abeam. This study concludes that the navigator, especially at night , must anticipate the exact wave direction, referring to the wether report and coastaline, not to lay the vessel in the serial wave abeam.

When a ship is sailing on the sea, she has the six-degrees of freedom of motion. It means that she meets a lot of dangerous situations. Especially, when the VLCC is travelling in irregular sea, the slamming, the deck-wetness and the propeller racing are occured with the sea state she is on. These are the representative steps that a heave-to and a scudding are used for a ship building , but for a predominance in both. The author intends to clarify this problem theoretically. The methods of statistical calculation are based with the ITTC spectral formulation and with the assumption that the wave height histogram follows the Rayleigh distribution. In this study, the author gives an attention on the relative bow motion to a wave in the irregular sea. It is verified that the relative diplacement at the bow to sea level in the following sea is less than that in the head sea. It is confirmed that, therefore, one have to sail with scudding when he is threatened to heave-to at a rough sea. But he must bear the propeller racing in mind in the cases.

This paper presents a practical method to predict the characteristics of ship manoeuvring motions. A attempt is made to calculate the manoeuvring motions utilizing principal particulars of ship hull, properller and rudder as basic input data. The mathematical models, which describe the ship manoeuvring motions, are developed on the basis of MMG(5), Inoue(17), Hooft(18) and so on. Calcuations of manoeuvring motions for three kinds of typical characteristics, namely turning motion, zig-zag manoeuvre response and steady turning performance, are carried out. In order to examine the validity of the calculation method of this paper, simulations are run for seven merchant ships employed by Inoue(4). The computed results by present method are compared with full scale trials and Inoue's calculations(4). It can be concluded that the calculation method proposed in this paper is useful and pwoerful for prediction of characteristics of ship manoeuvring motions at the initial design phase or the application study on manoeuvring motions.

The study presents the optimum design of B/C midship structure based on the classification society's Rule. The SUMT (Sequential Unconstrained Minimization Technique), using the Direct Search Methods (Hooke and Jeeves, Simplex) is applied to the solution of this nonlinear optimum design problem with constraints. Through the optimum designs of existing ships(60k, 186k, 220k), the amount 0.45-6.18% in weight of their midship structures are obtained on the viewpoint of minimum weight design.