If one were to say that war is political in its nature, then war could be one of the several ways of achieving political goals. Thus, the aspect of wars will, in certainty, be altered by the changes in political environment. Wars in the past broke out mainly due to ideological differences that ran to extremes and were of high intensity. However, wars today show such restraints as controlling them beforehand or during the war in anticipation of the post-war situation. The trend of ideas to actualize such wars in the effective operation of airpower is on the rise. Airpower normally possesses speed and operative flexibility as well as capability of destruction, so it is possible to destroy the politically declared targets clearly. Previous airpower was merely employed as means of helping to vertically detouring the spatial obstacle that the ground forces encountered. Over the years, due to the speedy improvement of aviation technology and of ideas concerning wars in space, more advanced application has been developed. but they also were nothing more than an auxiliary role to facilotate the ground forces, that needed a longer effective range of firepower and did not become forces with the right of self-determination, that is, the fact of decisive war that makes its outcome. However, under transitional strategic environment like that of the present, Airpower possesses not only the capability to operate as a decisive means of war but also as theories to support it. The advancement in air technology has enabled supremacy over targets in depth, and the development of electronic technology has empowered the improvement of degree of destruction but also triumphant war by means of an overwhelming supremacy in a relatively short period. Thus, the method of systematic destruction that accomplishes the stated goals while rejecting the damage of accumulative destruction has been realized. The progress of such a concept has also proved that the counter-force strategy that has been developed in nuclear strategy is useful in conventional warfare as well. Therefore, it can be said that the under today's strategic environment airpower is an outstanding means of military strategy that can deeply affect to achieve the national objectives.

Data from a series of four studies on leadership behavior are analyzed and compared to identify effective patterns of leadership behavior for platoon leaders and battalion commanders in ROK Army. Multiple-method research strategy is utilized in four studies to overcome some of the limitations of previous researches. Two of four studies employ a questionnaire method, and the rest use content analysis of critical incidents. Important behaviors for leadership effectiveness in both platoon leaders and battalion commanders include Supporting and Motivating Task Commitment. However, Developing and Monitoring Operations are only important in platoon level, and Planning & Organizing and Recognizing & Rewarding only in battalion level. Most discrepancies in results among studies can be explained in terms of either method effects or situational differences in role requirements for leaders.

The fire effectiveness and the operationability of the ground weapon system (such as tank, armored vehicle, howitzer, MLRS, ${\cdots}$), whose operations are usually happened on the ground, are dependent not only on their performances but also on the terrain environments. Especially, the artillery weapons systems' effectiveness is largely varied, because their maneuverability (such as translation, occupation of their sites) and the fire effectiveness are very dependent on the terrain. In this paper, presented are the methods how to analyze the terrain using the digital terrain data. And a software (which are implemented on the IBM PC compatible personal computer) is developed for the analysis of the terrain using the various method of computer Aided Geometric Design and Modeling. The S/W is expected to be very useful for the evaluation of the artillery weapon systems and for the commanders' decision making.

This paper is aimed to develop a Lanchester type combat model for the direct-fire engagement. This model incorporates number of combatants, inter-firing time, detection time by movement, detection probability by the signature of fire, where the inter-firing time and the detection time are assumed to follow a negative exponential distribution. The approach to modeling is as follows : in the process of an engagement, a combatant takes one of the states('observing' state or 'firing' state), a combatant is initially in the observing state, if the combatant detects a target, he changes his state from 'observing' to 'firing' and will cause attrition to the opposing forces. Thus this transition mechanism is embodied into the differential equation form with each transition rate. A limited examination of the validity has been conducted by comparison with the Monte-Carlo simulation model 'BAGSIM', and with a traditional Deterministic Lanchester model.

It is very important to increase defence capability rapidly against any surprise attack. This can be done by fast deployment of mobilization reserved resources. This paper is forcused on optimal allocation of special reserved resources. First of all, the location of special reserved resources is identified and then the location of combat and mobilization units and amount of requirement resources of each unit are identified. Finally, optimal allocation of the special reserved resources is obtained by Out of Kilter method.

In transportation network problems, it is often desirable to select multiple number of the shortect paths. On problems of finding these paths, algorithms have been developed to choose single shortest path, k-shortest paths and k-shortest paths via p-specified nodes in a network. These problems consider the time as the main factor. In wartime, we must consider availability as well as time to determine the shortest transportation path, since we must take into account enemy's threat. Therefore, this paper addresses the problem of finding the shortest transportation path considering both time and availability. To accomplish the objective of this study, values of k-shortest paths are computed using the algorithm for finding the k-shortest paths. Then availabilties of those paths are computed through simulation considering factors such as rates of suffering attack, damage and repair rates of the paths. An optimal path is selected using any one of the four decision rules that combine the value and availability of a path.

In this paper a dispatching rule, $D^{*}$, for AGV operations in automated manufacturing system is proposed to improve the performance measures. And the algorithm is compared with existing heuristic rules via simulation to evaluate its capabilities. It is shown that the proposed rule enhances mean flow time, makespan and throughput, and avoids the locking phenominon which can be fatal to the operation of automated manufacturing systems.

Software system is a hierarchical structure with collection of program units. Software system can import external packages globally or locally depending on the usage within a system. If the imported package is used globally, the soft-ware system can be influenced globally by any change of package and programmer's debugging time for the program maintenance will be greater. To solve these problems, it is desirable to use the imported package locally right on the usage point within the system. The model presented in this paper analyzed entity usage of package in structure of program, identified the usage level to obtain localization and provided information for restructure of the program to localize package usage. To obtain localization, it identified declared entities inside the imported package and analyzed the specification and body part of program unit to identify entities referenced from the imported package. The proposed model can be used to improve the maintainability of software system and contributed to reduction of programmer's debugging time in program maintenance.

This paper presents the Allocation Priority Scheme (APS) for multiprocessor system. The objective of APS is to reduce the time-complexity on a Physical Mapping Scheme(PMS). The PMS is to allocate the nodes of the Data Dependency Graph (DDG) to the multprocessors efficiently and effectively. The APS provides the priority to each node (vertex) in the DDG. In other words, the goal of the APS is to find a request resource mapping such that the total cost (time-complexity) is minimized. The special case in which all requests have equal priorities and all resoruces have equal precedences, and the comparisons between our APS and other schems are discussed in the paper. The APS provides the heuristic rules which are based on maximum height (MH), number of children nodes ($N_c$), number of father nodes ($N_f$), and computation time ($T_c$). The estimation moth of the computaion time is in the paper.

one of the problems the users of DPS-6/45 used to face in the course of having access to work stations was that a telephone call has to be made manually every time to have receiver's modem on or off, and naturally it meant the waste of manpower as well as of time. A program has been worked out to automatically operate and control. utilizing the system clock within the main computer (DPS-6/45), the on/off switch on the modems. It has resulted in; 1) promotion in operability of the main computer, DPS-6/45 2) prevention of unnecessary telephone calls 3) curtailment of expenditure and manpower