The improved Green integral equation using the Kelvin-type Green function in known free of irregular frequencies where the integral over the inner free surface integral is removed from the integral equation, resulting in an overdetermined integral equation. The solution of the overdetermined Green integral equation is shown identical with the solution of the improved Green integral equation Using the B-spline higher order panel method, the overdetermined equation is discretized in two different ways; one of the resulting linear system is square and the other is redundant. Numerical experiments show that the solutions of both are identical. Using the present methods, the exact values and higher derivatives of the potential at any place over the wetted surface of the body can be found with much fewer panels than low order panel method.

It is known that lubrication effect of an air cavity can reduced a drag of a ship. The present study intends to utilize the phenomena for the drag reduction of a passenger ship now operating in a lake. A scaled model of the model when air cavities are formed under the bottom of the model. Model experiments have been performed to determine adequate air supply rates, proper shapes and locations of air supply nozzles. It is shown that energy saving of mere than 10% can be achieved at the design speed of the ship even after excluding additional power consumed for air supplying. Multiple air supply nozzles, if allocated properly, are more effective than single one in resistance reduction of the ship.

A Coanda effect which is known to provide a high lift in a high drag condition has been applied to a flapped rudder of a ship. Model experiments and numerical simulations on the Coanda effect of the flapped rudder have been carried out at various situations and the results are compared to each other. It I found that a remarkable increase in the rudder force occur due to the Coanda effect and that the results ould be utilized for the design of a high-lift rudder system.

Fatigue strength assessment procedures have been implemented in the ship design rules by many classification societies. However, a large variation tin the details of the different approaches exists in practically all aspects influding load history assessment, stress evaluation and fatigue strength assessment. In order to assess the influences of thesd variations on the prediction of fatigue lives. a comparative study is organized by the ISSC Committee III.2 Fatigue and Fracture. A pad detail on the top of longitudinal hatch coaming of a panamax container vessel is selected for fatigue calculation. The work described in this paper is one set of results of this comparative study in which the ABS dynamics approach is applied. Through this analysis the following conclusions can be drawn. (1) With the original ABS approach, the fatigue life of this pad detail is very low, only 2.398 years. (2) The treatment of the stillwater bending moment in the ABS approach might be a source of conservatism. If the influence of stillwater bending moment is ignored, then the fatigue life for this pad detail is 7.036 years. (3) The difference between the nominal stress approach and the hot spot stress approach for this pad detail is about 26%.