• Journal of Korean Society of Environmental Engineers
• /
• v.22 no.2
• /
• pp.375-383
• /
• 2000

A mixed culture isolated from petroleum-contaminated soil was enriched on toluene as a sole carbon and energy source, and degradation characteristics of BTEX(Benzene, Toluene, Ethylbenzene, Xylenes) was observed. In the single-substrate experiments, all the BTEX compounds were degraded, and it was degraded as following orders; toluene, benzene, ethylbenzene, and p-xylene. In the degradation experiments of BTEX mixtures, the degradation rate was decreased compared to that in the single substrate experiment and ethylbenzene was degraded faster than benzene. In the experiments of binary-mixtures, various substrate interactions such as inhibition, stimulation, and non-interaction were observed, and ethylbenzene was shown to be most potent inhibitor of BTEX degradation. In the degradation characteristic studies of xylene isomers, m-xylene and p-xylene were degraded as carbon sources, and it was stimulated in the presence of either benzene or toluene. However, degradation of o-xylene was enhanced only in the presence of benzene.

• 한국생물공학회:학술대회논문집
• /
• 2003.04a
• /
• pp.386-389
• /
• 2003

Organic solvent tolerance bacteria, Pseudomonas savastanoi BCNU 106 could utilize a high contentration of benzene, toluene, ethylbenzene, xylene isomers (BTEX) as a sole carbon source. It was founded that strain BCNU 106 transformed o-xylene to 2-methylbenzyl alcohol, 2-methylbenzoic acid through direct oxygenation of methyl residue on GC-MS analysis.

• Journal of the Korean Society of Safety
• /
• v.21 no.3 s.75
• /
• pp.45-52
• /
• 2006

The AITs(autoignition temperatures) describe the minimum temperature to which a substance must be heated, without the application of a flame or spark, which will cause that substance to ignite. The AITs are often used as a factor in determining the upper temperature limit for processing operations and conditions for handling, storage and transportation, and in determining potential fire hazard from accidental contact with hot surfaces. The measurement AITs are dependent upon many factors, namely initial temperature, pressure, volume, fuel/air stoichiometry, catalyst material, concentration of vapor, time lag. Therefore, the AITs reported by different ignition conditions are sometimes significantly different. This study measured the AITs of benzene, toluene and xylene isomers from time lag using AS1M E659-78 apparatus. The experimental ignition delay times were a good agreement with the calculated ignition delay times by the proposed equations wtih a few A.A.D.(average absolute deviation). Also The experimental AITs of benzene, toluene, o-xylene, m-xylene and p-xylene were $583^{\circ}C,\;547^{\circ}C,\;480^{\circ}C,\;587^{\circ}C,\;and\;557^{\circ}C$, respectively.

• Analytical Science and Technology
• /
• v.16 no.4
• /
• pp.333-338
• /
• 2003

Inclusion selectivity of a three-dimensional piperazine-ligated cyanocadmate host complex, $[Cd_x(CN)_{2x}\{HN(CH_2CH_2)_2NH\}_y]{\cdot}zG$, has been investigated for benzene (B), toluene (T), ethylbenzene (E), o- (O), m- (M), and p-xylene (P) isomers as the aromatic guest molecules. From the binary, ternary and quarternary guest mixtures of E and xylene isomer (X), the order of inclusion selectivity in the host complex is O>E>P>M. From the binary to quinary BTX mixtures, the order of preference in the complex is seen to be B>T>O${\gg}$P>M.

• Journal of the Korean Institute of Gas
• /
• v.13 no.4
• /
• pp.40-45
• /
• 2009

In order to investigate the compatibility of data in MSDS(Material Safety Data Sheet), the flash point of xylene isomer was measured by using Pensky-Martens closed cup (ASTM D93), Setaflash closed cup(ASTM D3278), Tag open cup(ASTM D1310), and Cleveland open cup (ASTM D92) testers. Also, the AITs(autoignition temperatures) of xylene isomers were measured by using ASTM E659-78 tester. The measured the flash points and the AITs were compared with literatures and MSDS in KOSHA(Korea Occupational Safety and Health Agency). The measured the flash points and the AITs were different from those in literatures and MSDS. As a result, this paper is shown that it is needed to investigate combustion characteristics of xylene isomer for the fire safety objectives.

• Journal of Microbiology and Biotechnology
• /
• v.8 no.3
• /
• pp.222-228
• /
• 1998

The characteristics of cometabolic removal of xylenes by Alcaligenes xylosoxidans Y234 were investigated. m-Xylene was found to be degraded while ο- and p-xylene were biotransformed into cresols in the presence of benzene or toluene. A lower level of benzene was required than that of toluene to remove the same amount of xylenes, which suggested benzene was a more effective primary substrate than toluene. ο-Xylene was found to be the most toxic to Alcaligenes xylosoxidans Y234 followed by p-xylene and m-xylene. Rates of cell decay during cometabolic removal of ο-, m-, or p-xylene were decreased by up to $76\%$ when benzene-adapted cells were inoculated. Xylenes were removed efficiently using benzene-adapted cells.

• Applied Chemistry for Engineering
• /
• v.21 no.4
• /
• pp.417-423
• /
• 2010

In this study, an effective method to prepare granular binderless ZSM-5 which is as efficient p-xylene separatory adsorbent was explored. Colloidal silica sol 30 wt% solution as an inorganic binder and microcrystalline cellulose as an organic additive were added to ZSM-5 powder ($SiO_2/Al_2O_3$ = 50). Adsorbent with enough strength (0.721 kgf), high crystallinity (94.6%) and high BET specific surface area ($379.2m^2$/g) was obtained by calcination, binderless treatment, ${NH_4}^+$ ion exchange, and activation after spherical granulation process. A batch type adsorption experiment was proceeded with solutions comprising 3 xylene isomers by 1 : 1 : 1 weight ratio to evaluate adsorption characteristics of prepared absorbent. As a result, the obtained binderless ZSM-5 granule showed a higher selective adsorption performance for para-xylene than that of commercial adsorbent.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.1
• /
• pp.59-64
• /
• 2002

A facile and precise batch oxidation reaction system allows continuous monitoring of the oxidation rate and cumulated oxygen conversion of xylenes, and the side reactions to carbon monoxide and carbon dioxide may also be studied. The oxidation reaction can be analyzed precisely with the rate and amount of oxygen consumed. The reaction reveals that 4-carboxybenzaldehyde is an unstable intermediate of p-xylene oxidation as the reaction proceeds instantaneously from p-toluic acid to TPA (terephthalic acid). The alkali metals accelerate oxidation, even though they retard the reaction initially. The oxidation rate increases with decreasing water concentration. However, in the later part of reaction, the reactivity decreases a bit if the water concentration is very low. This retarding effect of water can be overcome partly by the addition of potassium. The oxidation of o-xylene, compared with the oxidation of p-xylene and m-xylene, proceeds quite fast initially, however, the oxidation rate of xylene isomers in the later stage of reaction is in the order of p-xylene > mxylene > o-xylene.

• KSBB Journal
• /
• v.16 no.1
• /
• pp.61-65
• /
• 2001

In this study, a BTX degrading microbial consortium was obtained from the activated sludges of a BTX releasing sewage water and city sewage water treatment plant. The MY microbial consortium was developed for benzene and toluene degradation, whereas the MA microbial consortium was developed for xylene isomers. The major microorganism of the MA consortium was identified as Rhodococcus ruber DSM 43338T, whereas that of the MY consortium was Rhodococcus sp. In terms of the degradation of a single component, the removal rate of benzene was fastest and decreased in order; toluene, o-xylene, p-xylene and m-xylene. For degradation of mixed BTX, most BTX were degraded within 108 hours and the degradation rate showed either stimulatory or inhibitory effects depending on the composition. MA and MY microbial consortium obtained in this study may be used effectively to remove BTX biologically.

• Proceedings of the Korean Society of Life Science Conference
• /
• 2003.05a
• /
• pp.134-134
• /
• 2003