• EDISON SW 활용 경진대회 논문집
• /
• 제4회(2015년)
• /
• pp.274-278
• /
• 2015

There are different kinds of aircrafts, such as conventional airplane, rotorcraft, fighter, and unmanned aerial vehicle. Their shape and feature are dependent upon their assigned mission. One of the fundamental analyses during the design of the aircraft is the structural analysis. The structural analysis becomes more complicated and needs more computations because of the on-going complex aircrafts' structure. In order for efficiency in the structural analysis, a simplified approach, such as equivalent beam or plate model, is preferred. However, it is not clear which analysis will be appropriate to analyze the realistic configuration, i.e., an equivalent beam or plate analysis for an aircraft wing. It is necessary to assess the boundary between the one-dimensional beam analysis and the two-dimensional plate theory for an accurate structural analysis. Thus, in this paper, the static structural analysis results obtained by EDISON solvers were compared with the three-dimesional results obtained from MSC NASTRAN. Before that, EDISON program was verified by comparing the results with those from MSC NASTRAN program and analytic solution.

• Biomolecules & Therapeutics
• /
• 제6권1호
• /
• pp.63-72
• /
• 1998

-4-Quinolone antibiotics (pefloxacin, ciprofloxacin, norfoxacin, ofloxacin and enoxacin) were tested for mutagenicity in Salmonella typhimurium TA98, TA100, TA1535, TA1537, TA1538 and TA102, for chromosomal aberrations in cultured Chinese hamster lung (CHL) cells, and for wing somatic mutations and recombinations (wing spot) in Drosophila. Five 4-quinolones did not show any mutagenicity in Salmonella typhimurium TA98, TA100, TA1535, TA1537 and TA1538. However, they were mutagenic inSalmonella typhimurium TA102 with and without metabolic activation in both plate incorporation method and preincubation method. Ciprofloxacin induced structural chromosome aberrations in CHL cells both with and without metabolic activation, and the frequencies were 6% and up to 28%, respectively. Pefloxacin showed equivocal evidence, however, norfloxacin, ofloxacin and enoxacin did not induce the structural chromosome aberrations both in the presence and absence of metabolic activation. In the wing spot assay in Drosophila, ofloxacin increased the frequency of small single spots significantly in a dose-dependent manner but there was no dose-dependent increase of single or twin spots in the others.

• 드라이브 ㆍ 컨트롤
• /
• 제14권2호
• /
• pp.37-44
• /
• 2017

In this study, in order to prevent cavitation in a variable swash-plate type hydraulic pump, a basic model impeller has been applied to a new pump, and the impeller shape has been optimized through flow analysis. Based on the analysis results, we could propose an impeller shape with high efficiency and low possibility of cavitation in comparison with the basic model. The simplification of the basic shape of the impeller of the hydraulic pump was performed in three parts in the order of hub shape, wing, and curvature, and eight design parameters were defined to satisfy the design requirement. Compared with the initial model of the impeller, when the differential pressure of the optimum model increased, the efficiency was improved. It achieved the goal of design improvement because cavitation did not occur under the rated operating conditions.

• International Journal of Naval Architecture and Ocean Engineering
• /
• 제9권1호
• /
• pp.55-65
• /
• 2017

Underwater torpedo has control fin with very low aspect ratio due to launching from limited size of cylindrical torpedo tube. If the aspect ratio of control fin of underwater vehicle is very low three-dimensional flow around control fin largely reduces control forces. In this study, the end plate was applied to reduce the three-dimensional flow effects of partially movable control fin of underwater vehicle. Through numerical simulations the flow field around control fin was examined with and without end plate for different flap angles. The pressure, vorticity, lift and torque on the control fin were analyzed and compared to experiments. The comparison have shown a reasonable agreement between numerical and experimental results and the effect of end plate on a low aspect ratio control fin. When the end plate was attached to the movable control fin, the lift increased and the actuator shaft torque did not significantly change. As this means less consumption of the actuator shaft torque compared to the control fin that has the same control force, the inner actuator capacity can be reduced and energy consumption can be saved. Considering this, it is expected to be effectively applied to the control fin design of underwater vehicles such as torpedoes.

• 한국식품위생안전성학회지
• /
• 제12권4호
• /
• pp.277-280
• /
• 1997

The effects of acetic acid (AA) on aerobic plate counts (APC), gram-negative bacterial counts (GNC), and generation time (GT) in chicken wings stored at 4* were assessed. Chicken wings were treated with 0.5-1.5% (v/v) AA at exposure times of 5 min. Treatments of AA for 5 min significantly (P<0.05) reduced aerobic plate counts (APC) and gram-negative bacterial counts (GNC) on the surface of chicken wings for 8 days, respectively. After 4 days of storage, treatments of 1.0% AA and 1.5% AA for 5 min completely (P<0.05) inhibited APC and GNC compared to initial controls. Based on these results, treatments of 1.0% AA and 1.5% AA for 5 min prolonged the microbiological shelf-life for 8 days compared to those of 0.5% AA and the controls. All treatments of AA increased the lag phase and GT of aerobic microorganisma.

• 대한조선학회논문집
• /
• 제48권5호
• /
• pp.381-389
• /
• 2011

In this study, we are focusing our attention on lift characteristics of the low aspect wings for Wing-In Ground effect crafts (WIG). Experimental measurements at an open-type wind tunnel are carried out and results are comparatively presented. In order to simulate the realistic ground condition in where the WIG craft is flying, moving ground is implemented by a conveyor belt rotating with the same velocity of the inflow. We consider two different wings (NACA0012 and DHMTU section) which have four different aspect ratios (0.5, 1.0, 1.5 and 2.0). Forces acting on the wings are measured and lift characteristics are elaborately investigated for various different conditions. In addition, end-plate effects are estimated. Results are validated by comparing with theoretic solutions of the symmetric airfoil. Present results show that ground effects are differently generated in moving or fixed ground conditions, and hence left characteristics are affected by the ground condition. Consequently, accurate aerodynamic forces acting on the WIG craft are guaranteed in a realistic moving ground condition.

• 한국항공우주학회지
• /
• 제44권1호
• /
• pp.1-11
• /
• 2016

큰 가로세로비를 가지는 유연날개의 변형정보는 구조 건전성 평가를 위한 실시간 모니터링에 필요하다. 비행 중인 날개 구조 대변형은 날개 외피의 변형률과 곡률의 관계식을 기반으로 한 비선형 변위 예측 알고리즘을 통해 예측될 수 있다. 그러나 동체에 고정된 날개의 기하학적인 형상으로 인하여 고정단 부근에서의 변형률 분포는 복잡한 양상을 나타내며, 변형률 센서가 부착된 센싱라인의 코드방향 위치에 따라 변위가 다르게 예측될 수 있다. 본 논문에서는 스팬방향 변형률의 보정을 통하여 변형률 센싱라인의 코드방향 위치에 관계없이 예측변위의 정확도를 향상시키는 연구를 수행하였다. 변형률 보정을 위하여 스팬방향 및 코드방향 변형률의 비, 재료의 포아송비, 보와 평판 모델의 변형률 비를 이용하였다. 보정된 변형률을 이용하여 예측한 변위는 해석변위와 잘 일치하였으며, 이를 실험을 통하여 검증하였다.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2003년도 추계 학술대회논문집
• /
• pp.102-105
• /
• 2003

The effect of the external balance strut on the wind tunnel model is investigated with simplified geometries. For this study, flat plate and elliptic wing are simulated with and without a cylinder. Pressure and wall shear stress distribution are analyzed to understand the effect of the cylinder.

• 유체기계공업학회:학술대회논문집
• /
• 유체기계공업학회 2006년 제4회 한국유체공학학술대회 논문집
• /
• pp.209-212
• /
• 2006

Insect and birds in nature flap their wings to generate fluid dynamic forces that are required for the locomotion. Most of the previous published papers discussed mainly on the effect of flapping parameters such as flapping frequency and amplitude on the thrust at a fixed Reynolds number. However, it is not much known on the values of the flapping parameters that the flapping wing requires to generate the thrust at the low Reynolds number flow. In this paper, the onset of the thrust generation is investigated using the lattice Boltzmann method. The wake patterns and velocity profiles behind a flat plate in heaving oscillation are investigated for the heaving amplitude of 0.5C. The time-averaged thrust coefficient value is investigated by changing the reduced frequency from 0.125 to 3.0 for three values of heaving amplitude (h/C=0.25, 0.325, 0.50). It is also found that the critical Strouhal number over which the flat plate starts to produce the thrust is around 0.1 and the thrust is an exponential function of the Strouhal number.

• Wind and Structures
• /
• 제29권6호
• /
• pp.457-469
• /
• 2019

In this paper, a numerical solution is presented for supersonic flutter analysis of cantilever non-symmetric functionally graded (FG) sandwich plates. The plate is considered to be composed of two different functionally graded face sheets and an isotropic homogeneous core made of ceramic. Based on the first order shear deformation theory (FSDT) and linear piston theory, the set of governing equations and boundary conditions are derived. Dimensionless form of the governing equations and boundary conditions are derived and solved numerically using generalized differential quadrature method (GDQM) and critical velocity and flutter frequencies are calculated. For various values of the yaw angle, effect of different parameters like aspect ratio, thickness of the plate, power law indices and thickness of the core on the flutter boundaries are investigated. Numerical examples show that wings and tail fins with larger length and shorter width are more stable in supersonic flights. It is concluded for FG sandwich plates made of Al-Al₂O₃ that increase in volume fraction of ceramic (Al₂O₃) increases aeroelastic stability of the plate. Presented study confirms that improvement of aeroelastic behavior and weight of wings and tail fins of aircrafts are not consistent items. It is shown that value of the critical yaw angle depends on aspect ratio of the plate and other parameters including thickness and variation of properties have no considerable effect on it. Results of this paper can be used in design and analysis of wing and tail fin of supersonic airplanes.