• JSTS:Journal of Semiconductor Technology and Science
• /
• 제13권3호
• /
• pp.198-206
• /
• 2013

This paper presents a wide band, fine-resolution digitally controlled oscillator (DCO) with an on-chip 3-D solenoid inductor using the 0.13 ${\mu}m$ digital CMOS process. The on-chip solenoid inductor is vertically constructed by using Metal and Via layers with a horizontal scalability. Compared to a spiral inductor, it has the advantage of occupying a small area and this is due to its 3-D structure. To control the frequency of the DCO, active capacitor and active inductor are tuned digitally. To cover the wide tuning range, a three-step coarse tuning scheme is used. In addition, the DCO gain needs to be calibrated digitally to compensate for gain variations. The DCO with solenoid inductor is fabricated in 0.13 ${\mu}m$ process and the die area of the solenoid inductor is 0.013 $mm^2$. The DCO tuning range is about 54 % at 4.1 GHz, and the power consumption is 6.6 mW from a 1.2 V supply voltage. An effective frequency resolution is 0.14 kHz. The measured phase noise of the DCO output at 5.195 GHz is -110.61 dBc/Hz at 1 MHz offset.

• Journal of Power Electronics
• /
• 제19권1호
• /
• pp.201-210
• /
• 2019

This paper proposes a multimode hybrid control strategy that can achieve zero-voltage switching of primary switches and zero-current switching of secondary rectifier diodes in a wide input voltage range for full-bridge LLC resonant converters. When the input voltage is lower than the rated voltage, the converter operates in Mode 1 through the variable-frequency control strategy. When the input voltage is higher than the rated voltage, the converter operates in Mode 2 through the VF and phase-shift control strategy until the switching frequency reaches the upper limit. Then, the converter operates in Mode 3 through the constant-frequency and phase-shift control strategy. The secondary-side diode current will operate in the discontinuous current mode in Modes 1 and 3, whereas it will operate in the boundary current mode in Mode 2. The current RMS value and conduction loss can be reduced in Mode 2. A detailed theoretical analysis of the operation principle, the voltage gain characteristics, and the realization method is presented in this paper. Finally, a 500 W prototype with 100-200 V input voltage and 40 V output voltage is built to verify the feasibility of the multimode hybrid control strategy.

• 전기전자학회논문지
• /
• 제22권2호
• /
• pp.309-315
• /
• 2018

계단 주파수 레이더(Stepped Frequency Radar: SFR)는 송신 펄스의 주파수를 점진적으로 증가시켜 넓은 합성 대역폭을 만듦으로써 높은 거리 해상도를 얻는 방식이다. 그런데 이동표적의 경우 거리-도플러 결합(range-Doppler coupling) 현상으로 정확한 거리 추정을 할 수 없게 되므로 정확한 속도 추정을 통한 보상이 필요하다. 본 논문에서는 코히어런트 펄스열(Coherent Pulse Train: CPT)을 갖는 계단 주파수 레이더 파형을 제안하고, 이를 이용한 속도 추정 및 파라미터에 따른 결과를 기존의 VMD(Velocity Measurement Data) 방식과 시뮬레이션을 통해 비교하고 분석하였다.

• 대한전자공학회논문지
• /
• 제11권4호
• /
• pp.9-16
• /
• 1974

The low channels with frequency range of 54~88MHz and the high channels with frequency range if 174~216 MHz are in use for TV broadcasting in Korea. Since the ratio of the highest frequency to the lowest frequency is 4 to 1, only a logarithmic periodic antenna cou1d cover such an wide frequency range. But, this log-periodic antenna should be big in size. Studies have been done on an antenna of small size with reasonable gain which combines through a channel filter a LPD antenna if low channel with boom length of 2m and a LPD antenna of high channel with boom length of 1.8m. The whole antenna is connected to feeder line through a talun. Experiment shows that the gain of low and high channels is 7 dB and 9 dB respectively, which are lower than theoretical values br nomore than ldB. The difference seemed to come from slight impedance mismatches between antennas and feeder lines, loss in the filter and measurement errors.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제12권1호
• /
• pp.10-17
• /
• 2012

This paper presents a clock regenerator using two $2^{nd}$ order ${\sum}-{\Delta}$ (sigma-delta) modulators for wide range of dividing ratio as defined in HDMI standard. The proposed circuit adopts a fractional-N frequency synthesis architecture for PLL-based clock regeneration. By converting the integer and decimal part of the N and CTS values in HDMI format and processing separately at two different ${\sum}-{\Delta}$ modulators, the proposed circuit covers a very wide range of the dividing ratio as HDMI standard. The circuit is fabricated using 0.18 ${\mu}m$ CMOS and shows 13 mW power consumption with an on-chip loop filter implementation.

• 한국전자파학회:학술대회논문집
• /
• 한국전자파학회 2002년도 종합학술발표회 논문집 Vol.12 No.1
• /
• pp.21-24
• /
• 2002

This paper presents a fully integrated, wide tuning range differential CMOS voltage-controlled oscillator, tuned by pMOS-varactors. VCO utilizing a novel tuning scheme is reported. Both coarse digital tuning and fine analog tuning are achieved using pMOS-varactors. The VCO were implemented in a 0.18-fm standard CMOS process. The VCO tuned from 1.8㎓ to 2.55㎓ through 2-bit digital and analog input. At 1.8V power supply voltage and a total power dissipation of 8mW, the VCO features a phase noise of -126㏈c/㎐ at 3㎒ frequency offset.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1998년도 추계학술대회 논문집 학회본부A
• /
• pp.182-185
• /
• 1998

This paper describes a field orientation control of an induction motor without any speed transducer and proposes a wide-range speed control strategy with the field orientation algorithm. The difference at impedances between the direct and quadrature axis at the injected signal is used for the sensorless field orientation control. But this algorithm has some limitations and should be supported by other method at high speed. In this paper, a sensorless speed control at an induction motor for wide speed range operation is proposed. The proposed algorithm is verified by experimental results.

• 대한전기학회논문지:전기물성ㆍ응용부문C
• /
• 제49권1호
• /
• pp.44-51
• /
• 2000

In this paper, using a wide-band AE sensor with the frequency range from 100[kHz] to 1.5[kHz], the frequency spectra of AE signals generated from the corona discharges of the needle-plane gap and from the partial discharges of an epoxy void were analyzed to determine the proper ultrasonic sensor with optimum frequency range according to the patterns of corona discharges. We also examined the propagation characteristics of AE signals in oil and the relationship between the magnitude of corona discharge and the magnitude of AE signals in peak-to-peak value under the application of 60[Hz] ac high-voltage. From these results, the main frequency spectra of AE signals emitted from the corona discharges of the needle-plane gap were about 130[kHz] by the fast fourier transform, but the main frequency spectra appeared to be 230[kHz] in the partial discharges of an epoxy void. The magnitude of AE signals was proportional to the magnitude of corona discharge and discharge current pulse with increasing the applied voltages.

• 전자공학회논문지
• /
• 제50권12호
• /
• pp.63-70
• /
• 2013

본 논문은 외부 커패시터 없이 광범위 하게 높은 전원 공급 잡음 제거비(PSRR)을 갖는 선형 정류기(LDO)에 관한 것이다. 제안된 LDO는 높은 PSRR과 안정도를 유지하기 하기 위해 nested Miller 보상 기술을 사용하였고, 내부적으로 캐스코드(cascode) 보상과 전류버퍼(current buffer) 보상 기술을 사용하였다. 또한 외부의 부하 커패시터가 없기 때문에 외부 하드웨어 비용을 최소화 하였고, 제안된 보상 기법을 사용하여 내부에 작은 커패시터를 사용하고도 안정도를 확보할 수 있었다. 설계된 LDO는 2.5V~4.5V의 입력 전압을 받아서 1.8V의 전압을 출력하고 최대 10mA의 부하 전류를 구동할 수 있다. 일반 0.18um CMOS 공정을 이용하여 제작하였고 면적은 300um X 120um 이다. 측정된 PSRR은 DC일 때 -76dB, 1MHz일 때 -43dB를 만족한다. 동작 전류는 25uA를 소모한다.

• Current Optics and Photonics
• /
• 제5권4호
• /
• pp.384-390
• /
• 2021

This paper presents a wide-range tunable wavelength-locking technology based on optoelectronic oscillation (OEO) loops for optical fiber sensors and microwave photonics applications, explains the theoretical fundamentals of the design, and demonstrates a method for locking the relative wavelength differences between a leader semiconductor laser and its follower lasers. The input of the OEO loop in the proposed scheme (the relative wavelength difference) determines the radio-frequency (RF) signal frequency of the oscillation output, which is quantized into an injection current signal for feedback to control the wavelength drift of follower lasers so that they follow the wavelength change of the leader laser. The results from a 10-hour continuous experiment in a field environment show that the wavelength-locking accuracy reached ±0.38 GHz with an Allan deviation of 6.1 pm over 2 hours, and the wavelength jitter between the leader and follower lasers was suppressed within 0.01 nm, even though the test equipment was not isolated from vibrations and the temperature was not controlled. Moreover, the tunable range of wavelength locking was maintained from 10 to 17 nm for nonideal electrical devices with limited bandwidth.