• Journal of Ocean Engineering and Technology
• /
• v.16 no.2
• /
• pp.21-26
• /
• 2002

In this study, the characteristics of long period waves are analyzed by field observation at Sokcho harbor on the eastern coast of Korea. firstly. the pressure data obtained from field observation are transformed into water surface elevations and the wave by wave analysis is applied to the observed wave data. also, we select long period waves by setting up the range 30-200sec, and suggest the relationship between ordinary waves and long period waves using the concept of the significant wave height. and, we examine the effects oft he long period waves on the rate of the harbor operation. The observation results demonstrate that the long period waves with heights of 1.2-14.6cm and periods of 35.8-162sec exist at Sokcho harbor. also, we found the rates of harbor operation based on long period waves are 61.8%-99.5% lower than the usual rates of 93.8%-100%.

• Journal of Ocean Engineering and Technology
• /
• v.24 no.3
• /
• pp.11-20
• /
• 2010

The purpose of this study is the investigation of the wave interaction with the rectangular floating breakwater. The flow profile obtained by PIV technique is represented to understand the vortical flow due to the wave interaction with a rectangular floating breakwater in the roll motion and the fixed condition. Also, the transmission coefficients are compared in both conditions over the extensive wave periods, which represent the performance of breakwater to attenuate the incoming waves. These results would be applied to design the floating breakwater having the mooring system to improve its performance for a certain wave period.

• Journal of Astronomy and Space Sciences
• /
• v.32 no.4
• /
• pp.327-333
• /
• 2015

Previously, all-sky airglow images observed at Shigaraki ($34.9^{\circ}N$, $136.1^{\circ}E$), Japan, during 2004 and 2005 were analyzed in relation to those observed at Mt. Bohyun ($36.2^{\circ}N$, $128.9^{\circ}E$) for a comparison of their gravity wave characteristics (Kim et al. 2010). By applying the same selection criteria of waves and cloud coverages as in the case of Mt. Bohyun all-sky images, we derived apparent wavelengths, periods, phase velocities, and monthly occurrence rates of gravity waves at Shigaraki in this study. The distributions of wavelengths, periods, and speeds derived for Shigaraki were found to be roughly similar to those for Mt. Bohyun. However, the overall occurrence rates of gravity waves at Shigaraki were 36% and 34% for OI 557.7 nm and OH Meinel band airglow layers, respectively, which were significantly higher than those at Mt. Bohyun. The monthly occurrence rates did not show minima near equinox months, unlike those for Mt. Bohyun. Furthermore, the seasonal preferential directions that were clearly apparent for Mt. Bohyun were not seen in the wave propagation trends for Shigaraki. These differences between the two sites imply different origins of the gravity waves near the Korean peninsula and the Japanese islands. The gravity waves over the Japanese islands may originate from sources at various altitudes; therefore, wind filtering may not be effective in causing any seasonal preferential directions in the waves in the airglow layers. Our analysis of the Shigaraki data supports recent theoretical studies, according to which gravity waves can be generated from in situ sources, such as mesosphere wind shear or secondary wave formation, in the mesosphere.

• International Journal of Ocean Engineering and Technology Speciallssue:Selected Papers
• /
• v.3 no.1
• /
• pp.29-34
• /
• 2000

This paper proposes a long-term prediction of offshore structures in ocean waves. All short-term statistics is generated by the simulation for all the combinations of significant wave heights and spectral peak periods. The simulation has been tested first on linear system, whose analytic solution is known, to verify if the simulation works accurately. Then the scheme was applied to the nonlinear system. This paper demonstrated that the proposed scheme could be an efficient tool in estimating the response of offshore structures.

• Proceedings of the Korean Society of Coastal and Ocean Engineers Conference
• /
• 2003.08a
• /
• pp.376-381
• /
• 2003

The reliability analysis of overtopping probability is proposed. In order to estimate the expected overtopping probability of the rubble mound breakwater, the experimental results of individual wave runup height is applied for the analysis of irregular wave system. The joint distribution of wave heights and periods is used for the input data of runup calculation because the runup height depends on the wave height and period. The runup heights during the one event that the design wave attacks the rubble mound breakwater extend to the one life cycle of 60 years. Utilizing the Monte-Carlo method, the one life cycle is tried more about 60 times for obtaining the expected value of overtopping probability. It is found that the inclusion of the variability of wave tidal and wave steepness has great influence on the computation of the expected overtopping probability of rubble mound breakwater. The previous design disregarding the tidal fluctuation largely overestimates or underestimates the expected overtopping probability depending on tidal range and wave steepness.

• Proceedings of the KSRS Conference
• /
• 2003.11a
• /
• pp.1246-1248
• /
• 2003

Internal wave with a soliton-like, large amplitudes within several kilometers, is frequently observed in the sea surface caused by tidal rectification due to sill or rough topographic changes. Internal waves can perturb current and density field, initiate bottom sediment re -suspension and mix nutrients to photic zone. Previous studies indicate that the appearance of internal wave in the Lombok Strait have been detected in SAR image data. This paper studies effect of internal wave in the Lombok Strait to chlorophyll distribution in the surrounded areas using SeaWiFS and ERS SAR images data during 1996-2001 periods. The preliminary result concludes that the internal waves presumably affect phytoplankton distribution spreading southeastward in the coast off Bali Island. The distribution of phytoplankton at southern coastline off Bali Island when internal wave occurred is elongated and distributed further to westward (from 8.8$^{\circ}$ to 10.7$^{\circ}$LS) than the area when internal wave did not occur on August 2000 (from 9.25$^{\circ}$ to 10.25$^{\circ}$LS) as shown in figure 3. It shown that the surface phytoplankton concentration near coastal area, i.e. from 8.8$^{\circ}$ to 9.25$^{\circ}$ LS, increased when internal wave is occurred.

• Journal of Ship and Ocean Technology
• /
• v.7 no.2
• /
• pp.20-28
• /
• 2003

A table of annual sea state occurrences is prepared based on the significant wave heights and modal periods, two parameters representing a Bretschneider wave spectrum. Measurements of them were done by the Korean Ocean Research and Development Institute (KORDI) at 67points around the Korean peninsula for 22 years. Also the average values of parameters over 4 regions and 4 seasons were derived. Comparative seakeeping calculations using wave parameters prevalent around Korea and those of the North Pacific at sea state numbers 3, 4, and 5 respectively, show some differences in the assessed seakeeping performance.

• Smart Structures and Systems
• /
• v.10 no.1
• /
• pp.47-65
• /
• 2012

The presence of crack-like defects in mechanical and structural elements produces failures during their service life that in some cases can be catastrophic. So, the early detection of the fatigue cracks is particularly important because they grow rapidly, with a propagation velocity that increases exponentially, and may lead to long out-of-service periods, heavy damages of machines and severe economic consequences. In this work, a non-destructive method for the detection and identification of elliptical cracks in shafts based on stress wave propagation is proposed. The propagation of a stress wave in a cracked shaft has been numerically analyzed and numerical results have been used to detect and identify the crack through the genetic algorithm optimization method. The results obtained in this work allow the development of an on-line method for damage detection and identification for cracked shaft-like components using an easy and portable dynamic testing device.

• Ocean Science Journal
• /
• v.41 no.4
• /
• pp.245-254
• /
• 2006

Long term wave climate of both extreme wave and operational wave height is essential for planning and designing coastal structures. Since the field wave data for the waters around Korean peninsula is not enough to provide reliable wave statistics, the wave climate information has been generated by means of long-term wave hindcasting using available meteorological data. Basic data base of hindcasted wave parameters such as significant wave height, peak period and direction has been established continuously for the period of 25 years starting from 1979 and for major 106 typhoons for the past 53 years since 1951 for each grid point of the North East Asia Regional Seas with grid size of 18 km. Wind field reanalyzed by European Center for Midrange Weather Forecasts (ECMWF) was used for the simulation of waves for the extra-tropical storms, while wind field calculated by typhoon wind model with typhoon parameters carefully analyzed using most of the available data was used for the simulation of typhoon waves. Design wave heights for the return period of 10, 20, 30, 50 and 100 years for 16 directions at each grid point have been estimated by means of extreme wave analysis using the wave simulation data. As in conventional methodsi of design criteria estimation, it is assumed that the climate is stationary and the statistics and extreme analysis using the long-term hindcasting data are used in the statistical prediction for the future. The method of extreme statistical analysis in handling the extreme vents like typhoon Maemi in 2003 was evaluated for more stable results of design wave height estimation for the return periods of 30-50 years for the cost effective construction of coastal structures.

• Journal of Advanced Research in Ocean Engineering
• /
• v.1 no.1
• /
• pp.44-54
• /
• 2015

Breakwaters are the coastal structures constructed either perpendicular (shore connected) or parallel (detached) to the coast. The main function of breakwater is to create a tranquil medium on its leeside by reflecting the waves and also dissipating the wave energy arriving from seaside, resulting in ease of manoeuvrability to boats or ships to their berthing places. Different types of breakwaters are being used at present, such as rubble mound breakwater, vertical wall type breakwater and composite breakwater. The objective of this paper is to investigate reflection coefficients (Kr) and dissipation (loss) coefficients (Kl) for physical models of Quarter circle caisson breakwater of three different radii of 0.550 m, 0.575 m and 0.600 m with S/D ratio of 2.5 (S=spacing between perforations, D=diameter of perforations). The models were tested in the monochromatic wave flume of the department, for different incident wave heights (Hi), Wave periods (T) and water depths (d). It was observed that reflection coefficient increased with increase in the wave steepness (Hi/gT2) and decreased with increase in depth parameter (d/gT2) and hs/d (Height of structure including rubble base/depth of water). The loss coefficient decreased with increase in the wave steepness and increased with increase in depth parameter and hs/d.