• Economic and Environmental Geology
• /
• v.55 no.1
• /
• pp.97-109
• /
• 2022

This study focused on the physicochemical effects of bottom ash dissolved precipitation on the soil and groundwater environment. The iced column and percolation experiments showed that most of the bottom ash particles were drained as the ash-dissolved solution, while the charcoal powder was filtered through the soil. Ion species of Al, As, Cu, Cd, Cr, Pb, Fe, Mn, Ca, K, Si, F, NO₃, SO₄ were analyzed from the eluates collected during the 24 h column test. In the charcoal powder eluates, a high concentration of K was detected at the beginning of the reaction, but it decreased with time. The concentrations of Al and Ca were observed to increase with time, although they existed in trace amount. In the bottom ash eluates, the concentrations of Ca and SO₄ decreased by 30 mg·L^-1 and 67 mg·L^-1, respectively, over 24 h. It is regarded that the infiltration patterns of the bottom ash and biochar in the unsaturated zone were different owing to their particle sizes and solvent properties. It is expected that a significant amount of the bottom ash will mix with the precipitation and percolate below the water table, especially in the case of thin and highly permeable unsaturated zone. The biochar was filtered through the unsaturated zone. The biochar did not dissolve in the groundwater, although it reached the saturation zone. For these reasons, it is considered that the direct contamination by the bottom ash and biochar are unlikely to occur.

• Economic and Environmental Geology
• /
• v.39 no.6 s.181
• /
• pp.739-752
• /
• 2006

Deep-sea surface sediments acquired by multiple corer from 69 stations in the Clarion-Clipperton fracture zone of the northeast equatorial Pacific, were examined to understand the correlation of mass physical properties and sedimen-tological processes. The seabed of the middle part ($8-12^{\circ}N$) of the study area is mainly covered by biogenic siliceous sediment compared with pelagic red clays in the northern part ($16-17^{\circ}N$). In the southern part ($5-6^{\circ}N$), water depth is shallower than carbonate compensation depth (CCD). The mass physical properties such as grain size distribution, mean grain size, water content, specific grain density, wet bulk density, void ratio, and porosity of sediments are distinctly different among the three parts of the study area. Surface sediments in northern part are characterized by fine grain size and low water contents possibly due to low primary productivity and high detrital input. Conversely, sediments in the middle part are characterized by coarse grain size and high water contents, which might be caused by high surface productivity and deeper depth than CCD. The sediments show low water contents and high density in the southern part, which can be explained by shallower depth than CCD. Our results suggest that the variations in mass physical properties of sediments are influenced by combined effects including biogenic primary productivity of surface water, water depth, especially with respect to CCD, sedimentation rate, detrital input, and the geochemistry of the bottom water (for example, formation of authigenic clay minerals and dissolution of biogenic grains).

• Korean Journal of Ecology and Environment
• /
• v.51 no.4
• /
• pp.253-258
• /
• 2018

Phytoplankton community was studied in relation to a typhoon at Bok-gyo Bridge area in Juam Lake, Korea. In August 31, 2000, a typhoon (Prapiroon) was passed by Juam Lake with great power enough to destroy summer stratification of Juam Lake. Destratification resulted in temporal mixing of the whole water column and changed the physical and chemical properties of water bodies, and caused the changes of the biological properties. The transparency decreased from 195 cm before the typhoon to 84 cm after the typhoon with the resuspension of the bottom sediment. In the vertical distribution of the phytoplankton population, the maximum population was measured at depth of 2 m before the typhoon. However, immediately after the typhoon, the population distributed evenly throughout the entire water layers. The carbon biomass of the phytoplankton was also highest at the depth of 2 m before the typhoon, but immediately after the typhoon, it was uniformly distributed throughout the whole water layers. The vertical profiles of the concentrations of chlorophyll a, however, did not show a significant difference before and after the typhoon. The typhoon induced destratification and restratification altered the taxa of the phytoplankton. The major dominant phytoplankton taxa before the typhoon was diatoms including Aulacoseira granulata, but the green algae overwhelmed the diatoms in cell number and biomass after the typhoon. The chlorophycean dominance was replaced by cyanophycean dominance with the heavy rain and descent of water temperture at the end of September.

• Korean journal of food and cookery science
• /
• v.32 no.5
• /
• pp.575-584
• /
• 2016

Purpose: Nurungji is a traditional Korean food made by yellowish scorched rice. After getting gelatinization of rice, a thin crust of scorched rice will usually be left in the bottom of the traditional cooking pot. In this study, physicochemical characteristics and antioxidant properties of five commercial nurungji products (CNP1, CNP2, CNP3, CNP4, and CNP5) were evaluated. Methods: Physicochemical properties of the five commercial nurungji products were evaluated with AOAC method. The antioxidant activities were assessed using the 1,1-diphenyl-2-picryl hydrazyl (DPPH), 2,2-azinobis-(3-ethyl-benozothia zoline-6-sulfonic acid)(ABTS), ferric reducing antioxidant power (FRAP), and reducing power assays. Results: Water content was the highest in CNP3, followed by CNP1, CNP2, CNP5, and CNP4. Crude ash content of all nurungji was less than 1%. In Hunter color parameter, the significantly highest a value (redness) and b value (yellowness) were measured in the CNP4 product, meanwhile the lowest in CNP3 (p<0.05). The nurungji products of CNP4 and CNP5 had the significantly higher content in total polyphenols and total flavonoids, compared to those of other products. CNP3 and CNP2 had the lowest in total polyphenols and total flavonoids, respectively. CNP4 and CNP5 products showed the significantly higher values in antioxidant activities, whereas CNP3 had the lowest activity. Conclusion: The high value of antioxidant activities in CNP4 and CNP5 might have been affected primarily by the total polyphenols with increasing browning color during the heat treatment.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.95-95
• /
• 2014

An OLED(Organic Light-Emitting Diode) device based on the emissive electroluminescent layer a film of organic materials. OLED is used for many electronic devices such as TV, mobile phones, handheld games consoles. ULVAC's mass production systems are indispensable to the manufacturing of OLED device. ULVAC is a manufacturer and worldwide supplier of equipment and vacuum systems for the OLED, LCD, Semiconductor, Electronics, Optical device and related high technology industries. The SMD Series are single-substrate sputtering systems for deposition of films such as metal films and TCO (Transparent Conductive Oxide) films. ULVAC has delivered a large number of these systems not only Organic Evaporating systems but also LTPS CVD systems. The most important technology of thin-film encapsulation (TFE) is preventing moisture($H_2O$) and oxygen permeation into flexible OLED devices. As a polymer substrate does not offer the same barrier performance as glass substrate, the TFE should be developed on both the bottom and top side of the device layers for sufficient lifetimes. This report provides a review of promising thin-film barrier technologies as well as the WVTR(Water Vapor Transmission Rate) properties. Multilayer thin-film deposition technology of organic and inorganic layer is very effective method for increasing barrier performance of OLED device. Gases and water in the organic evaporating system is having a strong influence as impurities to OLED device. CRYO pump is one of the very useful vacuum components to reduce above impurities. There for CRYO pump is faster than conventional TMP exhaust velocity of gases and water. So, we suggest new method to make a good vacuum condition which is CRYO Trap addition on OLED evaporator. Alignment accuracy is one of the key technologies to perform high resolution OLED device. In order to reduce vibration characteristic of CRYO pump, ULVAC has developed low vibration CRYO pumps to achieve high resolution alignment performance between Metal mask and substrate. This report also includes ULVAC's approach for these issues.

• Textile Coloration and Finishing
• /
• v.6 no.1
• /
• pp.62-70
• /
• 1994

Silk fibroin was dissolved in 9.3 M LiBr aqueous solution at 4$0^{\circ}C$ for 1 hour. The dissolved silk fibroin was regenerated by casting the dialyzed solution into the membrane. The freshly prepared silk fibroin membrane was soluble in water and was. mainly consisted of random coil conformation. By the treatments in saturated water vapor at 3$0^{\circ}C$ and in 75% ethanolic aqueous solution (V/V), the insoluble membranes were obtained and the structure and morphology of those were investigated for the structure by means of X-ray diffraction analysis, infrared spectroscopy, thermal analysis. Rheovibron and scanning electron micrograph. Silk II type crystals were obtained by treating amorphous silk fibroin membrane in the random coil conformtion with 75% ethanol solution(V/V). Crystallization to silk II type crystals occured even after a few minutes, and a large number of silk II type crystals were formed after 30 mins. On the other and, the membrane treated in saturated water vapor was composed of the mixtures of silk I and silk II type crystals. A large number of silk I and silk II type crystals were formed after 24 hours. The micro brownian motion in the amorphous regions of silk fibroin membrane started at about 175~185$^{\circ}C$. $\alpha$ dispersion appeared at about 20$0^{\circ}C$ in the amorphous membrane, and at about 22$0^{\circ}C$ in the crystalline membrane. The crystallization of random coil conformation to silkII type crystals occured at about 215$^{\circ}C$. The surface, bottom and cross-section of the membranes were observed by scanning electrom microscope. Fine forms alike spherulites appeared at the surface of crystalline membrane.

• Membrane Journal
• /
• v.29 no.1
• /
• pp.61-65
• /
• 2019

Anisotropic particles have been issued in various fields due to their unique physical properties. Herein, a novel dynamic phase separation method (DPS) is introduced to fabricate anisotropic acorn-like nanoparticles. DPS consists of two dynamic conditions; solvent evaporation and nonsolvent induced precipitation. The bottom layer is controlled by feeding the water as a non-solvent diluent, and the phase separation of the upper layer relies on the diffusion and evaporation of a volatile good solvent. At this condition, the acorn-like particles were fabricated. Under a closed box filled with water (spontaneous phase separation), monodisperse polystyrene (PS) particles were synthesized. At the coexistence between DPS and spontaneous phase separation, the sizes of cap and particle were changed. Also, the volume of PS solutions influences on the particle shape. Since the unique structures could be utilized into various applications, if advanced techniques such as membrane-based controlled water feeding is developed, monodisperse acorn-like particles could be tuned.

• Korean Journal of Environmental Agriculture
• /
• v.33 no.3
• /
• pp.164-168
• /
• 2014

BACKGROUND: Increase in application of liquid pig manure(LPM) in agriculture as nutritional source has become a social issue due to its influence on water quality. Also, proper application methods have not been developed with respect to indigenous properties of LPM and soil physical properties. Therefore, we conducted this experiment to observe the infiltration characteristics and distribution of dissolved organic compounds of LPM in soils having different soil textures. METHODS AND RESULTS: To do this experiment, we collected three different soils and LPM. We analyzed the physical and chemical properties of both soils and LPM to determine the dilution ratios of LPM. The LPM diluted to 4 different ratios with distilled water was applied to the top of soil column. Infiltration rates were observed by time and depth until the amount of effluent collected from the bottom of the soil columns were stabilized while maintaining the hydraulic head 3 cm above the soil column. The results showed that infiltration rates increased with increasing dilution ratios in the order of sandy, loamy sand, and sandy loam. The time required to reach steady state was increased with decreasing sand contents clay. CONCLUSION: The size and amount of the dissolved organic compounds in LPM that can determine the efficiency as fertilizer and environmental problems as nonpoint pollution source in water quality have not been investigated with respect to behavior and transport of them in soil. Therefore, it requires further research how we can properly apply LPM as valuable fertilizer substitute for inorganic fertilizers.

• Journal of Korean Society of Coastal and Ocean Engineers
• /
• v.28 no.4
• /
• pp.222-231
• /
• 2016

Multi-member lattice-type structures including jackets and tripods are being considered as good alternatives to monopile foundations for relatively deep water of 25-50 m of water depth owing to their technical and economic feasibility. In this study, the reliability analysis of bottom-fixed offshore wind turbines with monopile and/or multi-member lattice-type foundations is carried out and the sensitivities of random variables such as material properties, external wind loadings and scouring depth are compared with respect to different types of foundations. Numerical analysis of the NREL 5 MW wind turbine supported by monopile, tripod and jacket substructures shows that the uncertainties of soil properties affect the reliability index more significantly for the monopile-supported OWTs while the reliability index is not so sensitive to the material properties in the cases of tripod- and jacket-supported OWTs. In conclusion, the reliability analysis can be preliminarily carried out without considering soil-pile-interaction in the cases of tripod- and jacket-supported OWTs while it is very important to use the well-measured soil properties for reliable design of monopile-supported OWTs.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.2 no.1
• /
• pp.33-40
• /
• 1969

1. Physicochemical properties of sea water and soil of Korean tidal flats densely populated with species of Mactra veneriformis, Cyclina sinensis, Meretrix lusoria, and Tapes philippinarum, were investigated in order to find out the index of environmental factors in marine bivalve culture. 2. The turbidity varied with the change in concentrations of organic matter, silicate, and the exchangeable copper in sea water. All of these concentrations in Inchon, Kunsan, and Hansando were higher than those in Yusoo. In the 5 areas investigated the lowest were ditected at Kangnung. 3. The minerals and organic matter content in sea water dia not vary significantly among the different bivalve beds. And it was presumed that the soil texture was one of the most important environmental factors for the density of the bivalves in tidelands. 4. The soil texture index of the different bivalve beds was obtained as follow: 5. There were no significant differences of pH, the exchangeable calcium, and the exchangeable copper contents of bottom soils in the 4 different bivalve beds. As important factors in these areas, it seems that the amount of chemical properties might not affect the distribution of bivalve species. 6. Among the 4 beds the soil organic matter content was highest at the T. philippinarum bed and varied with the total nitrogen content. 7. Among the different bivalve beds, it was significant that the water holding capacity and available phosphorus content were highest at the M. veneriformis bed.