• Nuclear Engineering and Technology
• /
• 제32권2호
• /
• pp.108-127
• /
• 2000

Hot leg break LBLOCA(Large Break LOCA) had a potential to be a containment maximum pressure accident in YGN3&4, which was induced from excessive conservatism in the CE analysis methodology of mass and energy release. This study conducted mass and energy release experiment for the hot leg break LBLOCA during post blowdown with an integral test facility, SNUF(Seoul National University Facility). This facility simulated YGN 3&4 with volume ratio of 1/1140 based on Ishii's three level scaling. Experiment showed that SI(Safety Injection) water refilled cold leg first and core later. SI water was vaporized in the core, which resulted in the repressurization of reactor. This increase of pressure drove the water in cold leg to flow up half height of U tubes. However, since the water was drained back soon, the release through the SG side broken section by evaporation was negligibly small. This study also provided experimental assessment of RELAP5 results by KAERI for the release through the SG side broken section.

• 한국물환경학회지
• /
• 제25권5호
• /
• pp.742-749
• /
• 2009

To examine the characteristics of the nutrient release from the sediments in two reservoirs, Lake Paldang and Lake Cheungpyeung, we analyzed physical and chemical properties of the sediments and calculated the nutrient release rates from the sediments. The particle properties of sediments in Lake Paldang changed from silt to sand after summer rainy season, especially in the water area of the Kyeungan River where the water depth was shallow and the width of river was narrow. The sediments in Lake Cheungpyeung had higher contents of silt and clay than in Lake Paldang, and the particle size was not much different before and after rainfall. The release rates of nutrients in two lakes varied with the kind of nutrients and the season. The release rates of DTN and ${NH_4}^+-N$ in Lake Paldang were faster in spring than autumn. But the Lake Cheungpyeung showed similar values of release rates before and after summer rainy season. ${NO_3}^--N$ and phosphorous were not released from sediments or were absorbed into sediments all the time in two lakes. Compared with other lakes, the sediments of two lakes consisted of bigger particles and had a lower organic matters content than other lake-type reservoirs. Due to the short hydraulic retention time and no stratification throughout the year in Lake Paldang and Lake Cheungpyeung, the release rates of nutrients from sediment in these reservoirs were lower than other lakes and this seems to be a typical characteristic of river-type reservoirs.

• 한국물환경학회지
• /
• 제26권1호
• /
• pp.156-159
• /
• 2010

Peroxide is used frequently to provide electron acceptors to aerobes for the purpose of in situ bioremediation of contaminated soil/sediment. In this study, oxygen release rate of peroxides and factors affecting on dissolution and diffusion of oxygen into pore water were evaluated. Peroxides studied in this study were magnesium peroxide ($MgO_2$), calcium peroxide ($CaO_2$), and sodium percarbonate ($Na_2CO_3{\cdot}1.5H_2O_2$). $Na_2CO_3{\cdot}1.5H_2O_2$ showed the highest oxygen release rate per unit mass and the shortest release duration time among three peroxides. A simple first-order decay model for predicting the release rate of oxygen from peroxide into pore water was presented and used to fit the experimental data. The first order oxygen release rate constants k for $MgO_2$, $CaO_2$ and $Na_2CO_3{\cdot}1.5H_2O_2$ were 0.45 /hr, 3.22 /hr and 134 /hr, respectively. If $MgO_2$ was mixed with clay, oxygen release rate was lowered significantly mainly due to limitation of contact area and diffusion, implying that oxygen can be provided to the indigenous aerobes for the extended period of time.

• 한국물환경학회지
• /
• 제20권6호
• /
• pp.685-691
• /
• 2004

Water quality forecasting with long term flow is important for management and operation of river environment. However, it is difficult to set up and operate a physical model for water quality forecasting due to large uncertainty in the data required for model setting. Therefore, relatively simpler stochastic approaches are adopted for this problem. In this study we try several multivariate time series models such as ARMAX models for the possible substitute for water quality forecasting. Those models are applied to the BOD and COD levels at Noryangin station, Han river, and also evaluated the effect of release from Paldang dam on them. Monthly BOD and COD data from 1985 to 1991 (7 years) are used for model building and another two year data for model testing. As a result of the study, the effect of improvement on water quality is much more effective combining with the water quality improvement of dam release than considering only increment of dam release in the downstream Han river.

• 한국농공학회지
• /
• 제30권3호
• /
• pp.95-105
• /
• 1988

This study refers to the development of a hydrologic model simulating daily inflow and release rates for irrigation reservoirs. A daily - based model is needed for adequate operation of an irrigation reservoir sufficing the water demand for paddy fields which is closely related to meteorological conditions. And the objective or this study is to develop a Daily Irrigation Reservoir Operation Model(DIROM) combining the inflow and the release models which depicts the daily water level fluctuations of an irrigation reservoir, and to evaluate the applicability of the model. DIROM was applied to four reservoirs and daily water levels were simulated and compared to the observed data. The model behaviour was also compared with that of a ten - day based model, Reservoir Operation Study(ROS) which has been applied for determining the design capacity of reservoirs. Various combinations of measured and simulated inflow and release rates for tested reservoirs were used to define the daily water level fluctuations. Simulated release rates and measured inflow data resulted in larger errors, and simulated inflow and release rates produced the smallest errors in water level comparison. Two resevoir operation models, DIROM and ROS were applied to the same reservoir and the simulation results compared. The computational errors of DIROM ware smaller than those of ROS, and DIROM was more sensitive to meteorological conditions. DIROM demonstrated its potenial applicability in water management and operation.

• Archives of Pharmacal Research
• /
• 제28권4호
• /
• pp.493-501
• /
• 2005

Effect of solvents on physical characteristics and release characteristics of monolithic acetaminophen (APAP) hydroxypropylmethylcellulose (HPMC) matrix granules and tablets were examined. Various types and amounts of solvents were employed for granulation and coating. APAP and other excipients were mixed and were then wet-granulated in a high-speed mixer. The dried granules were then directly compressed and film-coated with low viscosity grade HPMC. As the amount of water increased, the size of granules also increased, showing more spherical and regular shape. However, manufacturing problems such as capping and lamination in tableting occurred when water was used alone as a granulating solvent. The physical properties of HPMC matrix granules were not affected by the batch size. The initial release rate as well as the amount of APAP dissolved had a tendency to decrease as the water level increased. Addition of nonaqueous solvent like ethanol to water resulted in good physical properties of granules. When compared to water/ethanol as a coating solvent, the release rate of film-coated HPMC matrix tablets was more sensitive to the conditions of coating and drying in methylene chloride/ethanol. Most of all, monolithic HPMC matrix tablet when granulated in ethanol/water showed dual release with about $50\%$ drug release immediately within few minutes followed by extended release. It was evident that the type and amount of solvents (mainly water and ethanol) were very important for wet granulation and film-coating of monolithic HPMC matrix tablet, because the plastic deforming and fragmenting properties of material were changed by the different strengths of the different solvents.

• 대한약학회:학술대회논문집
• /
• 대한약학회 2003년도 Proceedings of the Convention of the Pharmaceutical Society of Korea Vol.1
• /
• pp.295.1-295.1
• /
• 2003

A suitable model for the estimation of the drug release from nanoparticles has been varied and problematic, especially for the release from lipid nanoparticles containing water-insoluble drugs, due to the difficult particle collection from the release medium. Dialysis membrane has been widely used for the release test from colloidal carrier systems. The amount of drug from the carriers in normal dialysis diffusion technique was very low typically. (omitted)

• 한국물환경학회지
• /
• 제18권2호
• /
• pp.213-220
• /
• 2002

In this study the effects of initial pH, temperature, dissolved oxygen concentration, and sediment depth on the release of phosphorus from sediment in Lake Sihwa were investigated. No phosphorus release occurred at $10^{\circ}C$ for all pH values. DO concentrations were decreased and equilibrium was obtained 4-8 days after phosphorus release started. The DO concentrations were less than 1 mg/L. Sediment depth had little effect on phosphorus release rate. In order to control the released phosphorus, raw sludge and chalk were used. Results showed that a portion of phosphorus was removed by adsorption to chalk and raw sludge. About 90 % phosphorus removal was observed using sludge and calcinated chalk from the water sample in Lake Sihwa.

• Nuclear Engineering and Technology
• /
• 제54권3호
• /
• pp.984-990
• /
• 2022

Corrosion release behavior of Alloy 690 in high-temperature water was investigated under the conditions of injected Zn concentrations of 0 ppb, 10 ppb and 50 ppb. A protective oxide film composed of Zn(Fe_xCr_1-x)₂O₄ and Cr₂O₃ was formed with Zn injection, resulting in a better corrosion resistance. In comparison with the Zn-free condition, the corrosion release rate under the Zn-injection conditions was smaller. The corrosion release inhibiting factors were 1.7 and 1.9 under the conditions of 10 ppb and 50 ppb Zn-injection respectively. A foreseen application of the corrosion and corrosion release rates has been proposed and discussed.

• 한국농공학회논문집
• /
• 제54권5호
• /
• pp.17-24
• /
• 2012

The main purposes of the agricultural reservoir enlargement (ARE) project are to secure water supply reliability (WSR) for agriculture and to release environmental water during dry seasons. In this study, an operational rule that will simultaneously satisfy both the above issues was developed. Initial amount of water storage at the beginning of non-irrigation season (1st October) was divided into 3 stages, and the target level of water storage at the beginning of irrigation seasons (1st April) was set up. Required operational curves and release amounts were estimated based on the stages and target water levels. To evaluate the applicability of this rule, the amount of water released for environmental purposes and WSRs were analyzed for three reservoirs (Unam, Jangchi and Topjeong). The ratio between annual amount of release and additional amount of water storage were 1.6, 1.85, and 4.1 for the Unam, Jangchi, Tapjeong reservoirs, respectively. Also, the WSRs of all reservoirs were found to become higher than when the design standard was applied. Therefore, it is considered that the proposed rule is more suitable for the enlarged agricultural reservoirs operation as it satisfies the WSRs while securing the environmental water release.