• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2019.05a
• /
• pp.413-413
• /
• 2019

• Journal of environmental and Sanitary engineering
• /
• v.14 no.4
• /
• pp.137-142
• /
• 1999

Current semiconductor industry factories are relying on the end-of-pipe treatment technology for waste water treatment and thus they mostly suffer from severe industrial water shortage. As a result in order to solve those waste and industrial water problems, there requires to be changed to the Clean Technology, that is Pollution Prevention Technology. Through above strategic actions with the Clean Technology, we shall strength more powerful and logical environmental pollution prevention system than those in the past. By changing the end-of-pipe treatment technology for waste water treatment and thus they mostly suffer from severe industrial water problems, there requires to be changed to the Clean Technology, that is Pollution Prevention Technology. Through above strategic actions with the Clean Technology, we shall strength more powerful and logical environmental pollution prevention system than those in the past. By changing the end-of-pipe treatment technology with physical, chemical and biological treatment methods as a mixed stream basis for treating of semiconductor waste stream into clean technology with pollution prevention technology as a waste segregation basis, we can bet 20 to 30% investment reduction as compared with end-of-pipe treatment technology.The results for water quality analysis were as follows : 1. Water quality analysis of the before treatment : pH : 9~10.5, Conductivity : $300~7,000{\mu}s/cm$, TDS : more then $3,000mg/{\ell}$, COD : $200~250mg/{\ell}$, SS : $500~600mg/{\ell}$, n-H : $8.3mg/{\ell}$ 2. Water quality analysis of the after treatment : pH : 6.5~7.5, Conductivity : 0.059, TDS : $40{\mu}s/cm$, COD : $20mg/{\ell}$, SS : $5mg/{\ell}$ n-H : $0.6mg/{\ell}$

• Proceedings of the Korean Radioactive Waste Society Conference
• /
• 2017.05a
• /
• pp.253-254
• /
• 2017

• Mass Spectrometry Letters
• /
• v.2 no.1
• /
• pp.12-15
• /
• 2011

The Korean government has regulated emission of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in waste water of manufacturing facilities producing chlorinated compounds since 2009. As this regulation is expected to be reinforced in 2013 to 50 pg I-TEQ/L, a large sample volume is required for the analysis of trace amounts of PCDD/Fs in waste water. Liquid-liquid extraction (LLE) is used to extract PCDD/Fs from aqueous samples; however, its low efficiency makes it inadequate for analyzing large sample volumes. Herein, we present a disk-type solid-phase extraction (SPE) method for the analysis of dioxin at a part per quadrillion level in waste water. This SPE system contains airtight glass covers with a decompression pump, which enables continuous semi-automated extraction. Small (0.5 L) and large (7 L) samples were extracted using LLE and SPE methods, respectively. The method detection limits (MDLs) were 0.001.0.25 and 0.015.4.1 pg I-TEQ/L for the SPE and LLE methods, respectively. The concentrations of detected congeners with both methods were similar. However, the concentrations of several congeners that were not detected with the LLE method were quantified using the SPE method.

• Korean Chemical Engineering Research
• /
• v.51 no.4
• /
• pp.523-526
• /
• 2013

In order to purify the waste water containing natural fatty oil, hydroxy radical and/or ozone are used to remove the fatty oil dispersed in the waste water. The fatty oil is decomposed by oxidation reaction through hydroxy radical and ozone, and eliminated as a function of first order reaction. It is clearly confirmed that the fatty oil in waste water can be effectively removed much more in the use of both hydroxy radical and ozone than only hydroxy radical as an oxydant. In addition, the decomposition chemical reaction mechanism of the fatty oil by hydroxy radical and ozone is proposed.

• Hwankyungkyoyuk
• /
• v.2 no.1
• /
• pp.92-99
• /
• 1991

According to our secondary school curriculum for natural science and technical circles, there be used 353 of chemical reagents including 24 kinds of harmful and toxicant components. At present, most school are discharging their school laboratory waste water without any chemical and physical treatments. So as to solve the environmental problem for water pollution, this study tried to research a kind of adsorbant utilizing saw dust, wasted wood sources and designed the simple processing system using the adsorbent. This adsorbent was made by extracting lignin substances from raw saw dust under the solution of 0.5N-NaOH at the temperature of $100^{\circ}C$. Their metal removed rates was measured not only by processing of column and vessel. but also by comparing the standard solution and real waste water. The results were proved as more than 90(%) of the adsorptive efficiency on the average from Pb, Cd, Cu except Cr(VI)in case of the school experimental waste water soaked in vessels a long with 4g of the adsorbent for 24 hours. The new processing system enables to remove most harmful and toxicant metals by filtering, sedimenting and adsorbing at the low cost.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.20 no.2
• /
• pp.185-192
• /
• 2022

A compacted bentonite buffer is a major component of engineered barrier systems, which are designed for the disposal of high-level radioactive waste. In most countries, the target temperature required to maintain safe functioning is below 100℃. If the target temperature of the compacted bentonite buffer can be increased above 100℃, the disposal area can be dramatically reduced. To increase the target temperature of the buffer, it is necessary to investigate its properties at temperatures above 100℃. Although some studies have investigated thermal-hydraulic properties above 100℃, few have evaluated the water suction of compacted bentonite. This study addresses that knowledge gap by evaluating the water suction variation for compacted Korean bentonite in the 25-150℃ range, with initial saturations of 0 and 0.22 under constant saturation conditions. We found that water suction decreased by 5-20% for a temperature increase of 100-150℃.

• Korean Journal of Environmental Agriculture
• /
• v.30 no.2
• /
• pp.125-131
• /
• 2011

BACKGROUND: Reuse of waste nutrient solution for the cultivation of crops could lead to considerable conservation of water resources, plant nutrients, and water quality. Therefore, this study was conducted to evaluate the potential for reducing the use of chemical fertilizer in Chinese cabbage cultivation via the reuse of waste nutrient solution as an alternative irrigation resource. METHODS AND RESULTS: The nutrients supplied in the waste nutrient solution consisted of 1474.5, 1285.1, 991.6, and 872.6 mg/L for $K+$, ${NO_3}^-$, $Ca^{2+}$ and ${SO_4}^{2-}$, respectively. At 56 days after transplanting (DAT), the leaf length of Chinese cabbage plants irrigated with the waste nutrient solution treatment was significantly higher than that of plants irrigated using a conventional groundwater treatment. Additionally, the leaf width, fresh weight and dry weight of the plants irrigated with the waste nutrient solution were similar or greater than that of plants irrigated with a conventional treatment. Furthermore, the growth of plants treated with the waste nutrient solution +25% fertilizer was the highest among all tested treatments. CONCLUSION(s): These results indicate that the waste nutrient solution can be used as an alternate water resource for crop cultivation. In addition, it can contribute to reduce the fertilizer and to obtain the higher crop yield of Chinese cabbage.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.8
• /
• pp.75-84
• /
• 2012

In this paper, strength and leaching characteristics of water sludge-added lightweight soils(WALS) considering reinforcing materials(waste fishing net, glue treated waste fishing net and geogrid) and layer(1 or 2 layer) were investigated using unconfined compression test and leaching test. Several specimens of water sludge-added lightweight soil consisted of water sludge, cement, and bottom ash were prepared according to flowability. Reinforcing material added into these specimens were waste fishing net and geogrid. A glue treated waste fishing net was also added in order to increase interlocking between soil mixture and waste fishing net. Strength increased in the order of WALS reinforced by waste fishing net, glue treated waste fishing net, and geogrid. Strength of specimen with double layer-reinforcing material was greater than that of specimen with single layer reinforcing material. Leaching result of WALS was also satisfied with standard of ministry of environment.

• Journal of Environmental Health Sciences
• /
• v.27 no.2
• /
• pp.17-21
• /
• 2001

The object of this study is to find out the characteristics of waste oyster shells and determine the proper dosage of powdered waster oyster shells as the conditioning agent for water treatment sludge dewatering process. The large amount of waste oyster shells which discharges from the oyster farming, occurs serious environmental hazards. However, oysters shell contain large amount(about 38% by weight) of alkaline minerals, such as calcium and magnesium and so on, this natural material is thought to have the petential ability as a good conditioning agent. The results of this study are as follows. The optimum condition for improvement of the water treatment sludge dewaterability is when 6 g of waste oyster shell powder added to 200$m\ell$ of water treatment sludge. At optimum condition, the solid contents can reach to 31.78% and the specific resistance of conditioned sludge is 0.16$\times$10$^{8}$ sec$^2$/g. However, exceeding the of powdered waste oyster shell is needed to get the effective result. Consequently, the waste oyster shell can be a recyclable material to improve the dewaterability of water treatment sludges.