• Transactions of the Korean Society of Mechanical Engineers
• /
• v.8 no.1
• /
• pp.18-25
• /
• 1984

The transition boiling of a liquid droplet on a heated flat surface was studied utilizing Kotake's model with the effects of viscosity of a thin vapor layer between the droplet and the hot plate taken into account. This problem was analyzed considering the process of the droplet evaporation which resulted in hydrodynamic instability at the liquid-vapor interface. The results of the study are as follows; (1)The effect of the viscosity in the vapor layer at the interface appears as a dimensionless number N, namely .sigma. .delta.$_{0}$ /.rho.nu.$^{2}$ (2)The time required for evaporation at the transitional region increases with the temperature difference ratio .DELTA. T$_{r}$. The rate of increase of the total evaporation time becomes larger as increasing of N$_{m}$(N number at maximum heat flux) increases.s.

• Proceedings of the IEEK Conference
• /
• 2001.09a
• /
• pp.789-792
• /
• 2001

성능향상에 관한 실험을 하였다. 화자식별 방식은 등록된 음성과 테스트 음성을 비교하여 결정논리에 의하여서 화자를 식별하는 방식이다. 이러한 시스템에서 전처리(preprocessing)를 어떻게 해 주느냐에 따라서 인식률에 큰 영향을 미치게 된다. 본 논문에서는 전처리 과정 중에서 음성구간 검출에 대한 실험을 수행하여 성능을 비교 하였다. 본 논문에서는 시간영역에서 안정구간(stationary region)과 전이구간(transition region)에서 Normalized AMDF를 적용하였을 때 피치점에서 골(valley)의 기울기가 크다는 점을 이용하여 유성을 검출하였다. 그리고 검출된 유성음 구간 앞뒤로 인접 샘플의 자기상관관계함수(Autocorrelation)의 비를 이용하여 무성음을 검출하였다. 결과적으로 처리시간은 비슷하였으나 전체 인식률은 약 2%정도 개선되었다.

• Journal of Advanced Marine Engineering and Technology
• /
• v.10 no.4
• /
• pp.67-77
• /
• 1986

The information on the heat transfer characteristics, flow pattern and pressure drop, are very important for the desing of general heat exchanger, refrigerating system, air conditioning system and energy recovery system. In these systems, water or lubricating oil contained in working fluid affects greatly the flow and heat transfer condition and this phenomena must be considered in the practical design. An experiment has been performed for studying the flow and heat transfer characteristics of the forced convective horizontal flow of R-113 under the range of the liquid single phase state to the boiling flow state. Basic experimental results are obtained in the case that water or lubricating oil does not contaminate in the test fluid. Experimental results are as follows; (1) The local heat transfer coefficients in the nucleate boiling region and transition boiling region are almostly ten times as large as that of liquid single phase flow. (2) The measured heat transfer coefficient in the present experimental range is relatively agreed well with the predicted value from the various experimental results for the boiling flow.

• Tribology and Lubricants
• /
• v.9 no.2
• /
• pp.29-35
• /
• 1993

The thermohydrodynamic(THD) performance of a large tilting pad journal bearing in laminar and turbulent flow regions is investigated experimentally. The continuous shaft surface temperature, and bearing surface temperature are measured along with the shaft speed and the bearing load for various flow rates. It is observed that the shaft surface temperature is constant in the circumferential direction and increases with the increase of shaft speed in both low and high shaft speed region, however, there exist transition region where the shaft surface temperature decreases with the increase of shaft speed. When the turbulence occurs in the lubricant film, both the inlet and maximum bearing surface temperature steeply increase and the temperature gradient in the circumferential direction decreases.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.20 no.2
• /
• pp.193-199
• /
• 2015

This paper proposes a regeneration braking algorithm for Brushless DC (BLDC) motor system. The unipolar switching method has a limitation about the regeneration braking when the BLDC motor is operated in the low speed region. The proposed algorithm alternatively utilizes the unipolar and bipolar switching method to implement the regeneration braking for overall speed range. The bipolar switching method is used when the BLDC motor is operated in the low speed region. The switching transition point is determined by analyzing the unipolar and bipolar switching during the regeneration braking. The effectiveness of proposed algorithm is verified by using the experimental results.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.11
• /
• pp.1645-1654
• /
• 2003

When vortex shedding is locked-on to a single frequency oscillatory flow, the variations of vortex dynamics are investigated using a time-resolved PIV system. Wake regions of recirculation and vortex formation, dynamic behavior of the shed vortices and the Reynolds stress fields are measured in the wake-transition regime at the Reynolds number 360. In the lock-on state, reduction of the wake region occurs and flow energy distributed downstream moves upstream being concentrated near the cylinder base. To observe the dynamic behavior of the shed vortices, the trajectory of the vortex center extended to the inside of the wake bubble is considered, which describes well the formation and evolution processes. The Reynolds stresses and their contributions to overall force balance on the wake bubble manifest the increase of the drag force by the lock-on.

• Journal of Microbiology and Biotechnology
• /
• v.15 no.6
• /
• pp.1392-1396
• /
• 2005

Proteolytic digestion and CD measurement of wild-type and mutant cyclic AMP receptor proteins (CRPs) were performed either in the presence or absence of cyclic nucleotide. Results indicated that transition of a structural change to the hinge region by the binding of cAMP to the anti site was required for the binding of cAMP to the syn site near the hinge region and, although the occupancy of cAMP in the anti site increased the protein stability, CRP adopted more a stable conformation by the binding of cAMP to the syn site.

• Journal of Microbiology and Biotechnology
• /
• v.4 no.3
• /
• pp.176-182
• /
• 1994

The light-organ symbiont of pine cone fish, Vibrio fischeri, senses its presence in the host and responds to environmental changes by differentially expressing its symbiosis-related luminescence genes. The V. fischeri luminescence genes are activated by LuxR protein in the presence of an autoinducer. In an effort to elucidate the mechanism of regulation of luxR, a plasmid containing luxR was mutagenized in vitro with hydroxylamine and a luxR mutant plasmid was isolated by its ability to activate luminescence genes cloned in E. coli in the absence of the autoinducer. The specific base change identified by DNA sequencing was only single base transition at ＋78 from the transcriptional start of luxR. Based on a Western immunoblot analysis, the nucleotide change directed the synthesis of much higher level of LuxR protein without any amino acid substitutions. The results suggest that the region including the ＋78th base is presumably internal operator required for autorepression of luxR, and the increased cellular level of LuxR results in activation of luminescence genes by autoinducer independent fashion.

• Journal of the Korean Society of Safety
• /
• v.17 no.2
• /
• pp.32-38
• /
• 2002

In this paper, a new approach for the SynRM(Synchronous Reluctance Motor) control which ensures producing MTPA(Maximum Torque per Ampere) over the entire field weakening region is presented. In addition, this paper presents a speed sensorless control scheme of SynRM using flux observer. Also, by adjusting the base speed for the field weakening operation according to the flux level, the current and voltage limit, the smooth and precise transition into the field weakening operation can be achieved. The validity of the proposed scheme is verified through simulation.

• Journal of the Korean Magnetic Resonance Society
• /
• v.16 no.1
• /
• pp.11-21
• /
• 2012

The line-width of carbon nanotubes (CNTs) was studied as a function of the temperature at a frequency of 9.49 GHz in the presence of external electromagnetic radiation. The relative frequency dependence of the absorption power is obtained with the projection operator technique (POT) proposed by Kawabata. The line-width increased as the temperature increased in the high-temperature region (T>200 K). The scattering is little affected in the low-temperature region (T<200 K) because there is no correlation between the resonance field and the Fermi-Dirac distribution function. Thus, the present technique is considered to be more convenient to explain the resonant system as in the case of other optical transition problems.