• Particle and aerosol research
• /
• v.10 no.2
• /
• pp.61-75
• /
• 2014

Five on-road measurements were made using a mobile laboratory (ML) to characterize spatial and temporal air pollutant distributions over roads around a day-care center in urban area on 30 August 2013. Fixed monitoring was also done near the day-care center using the ML during the periods between on-road measurements. On-road air pollution monitoring route was classified into seven sections and three zones to identify severe polluted roads among many roads having different traffic volumes and directions. Typical pollutants emitted from vehicles such as $NO_x$, black carbon, particle-bound polycyclic aromatic hydrocarbons, and submicron particles including nanoparticles were monitored using real-time instruments. Peak concentration episodes were frequently observed during the on-road measurements and most peaks were simultaneously monitored at four pollutants. Colored on-road air pollution map for each pollutant provides an insight on spatial air pollution distribution, showing heavily polluted roads and sections. Average on-road $NO_x$ concentration of each run was similar to that monitored at the nearest roadside air monitoring station.

• Journal of Korean Society of Transportation
• /
• v.30 no.1
• /
• pp.31-43
• /
• 2012

Domestic road type-and period-specific driving pattern measurement was required as Korea's participation in developing "Worldwide harmonized light-duty vehicle emission test procedure (WLTP/DHC)" studied by UN WP29. This study measured road driving data reflecting road and traffic conditions of Korea, and analyzed seven types of representative road type-and period-specific driving patterns with driving pattern standardization methodology proposed by WP29. PAMS (Portable Activity Monitoring Systems) equipment was used to collect enormous (35,410km) road driving data. There are significant difference among seven derived driving patterns.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.46 no.6
• /
• pp.48-55
• /
• 2009

The feedback interference channels are those made through the multipaths that are built by moving and stationary objects around transmit and receive antennas mounted at the same point. This paper describes the method to measure the feedback interference channels in the rural regions and sides of highways and the analysis on channel characteristic parameters. Using the measured samples, we estimated scattering functions, delay power spectra, and Doppler power spectra, and we analyzed the channels using eight parameters including coherence bandwidth, coherence time, maximum excess delay, average excess delay, rms delay spread, Doppler shift, Doppler spread, and spread factor, and delay and Doppler cumulative distributions. Even though many observations are made, note that the feedback signals of high Doppler frequencies and large energy are observed in the sides of highways due to high speed vehicles while low Doppler frequencies occurred in the rural region due to rare traffic.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.11 no.5
• /
• pp.7-14
• /
• 2012

We frequently confront with cars interfering into our lane on the ramp. We suffered from serious traffic congestion due to the interfering cars. But the police enforcement has not done actively because it's hard to enforce. In this study, we have evaluated the systems to enforce cutting-in cars through the field test. Generally, the image processing method depends on the weather. To overcome this limitation we proposed a new algorithm combined with section detection method. In the filed test we concluded the results as follows. Whereas the violation detection rate of the general image processing was 58.2%, a new algorithm proposed by this study was 74.5%. And, an error rate enforcing vehicles that do not violate was 0.0%. Also, we can use the existing facilities, such as street light because of compact and lightweight systems which are integrated camera with controller. Therefore, we concluded that it is possible to enforce the interfering Cars using vehicle enforcement systems.

• International Journal of Highway Engineering
• /
• v.18 no.6
• /
• pp.69-76
• /
• 2016

OBJECTIVES : The objective of this study is to propose a capacity analysis methodology for riverside bike-exclusive roads. METHODS : Three steps were performed to develop a methodology to estimate bikeway capacity. First, we reviewed previous studies on the vehicle-road capacity analysis and proposed their applicability to bikeways. Second, two assumptions were made based on the traffic flow characteristics of bikeways: (1) the capacitated state in bikeways occur within a bicycle platoon, and (2) a bicycle platoon consists of more than three bicycles running in close proximity. In addition, it is assumed that the mean time headway of a bicycle platoon represents the characteristics of the platoon. The normality of the mean-time headway of a bicycle platoon calculated using the central limit theorem leads to the development of a method that estimates the riverside bikeway capacity using data collected from two different riverside bike-exclusive roads (Han-river and Anyangcheon). We used a location-fixed video camera to record videos of running bicycles and wrote a special-purpose software program to code the time-headway data from the videos. RESULTS : Time headways from 189 bicycle platoons were analyzed. The estimated mean-time headway of the capacitated bicycle flow is 1.01 s, from which the capacity of the bikeway is found to be 3578 vehicles/h. CONCLUSIONS : The proposed method that estimates bikeway capacity could be applicable to the analysis of short-range congested area rather than planning the number of lanes. In other words, it determines the sections that are temporarily highly congested and proposes appropriate strategies to mitigate the congestion.

• Journal of the Society of Disaster Information
• /
• v.16 no.2
• /
• pp.310-317
• /
• 2020

Purpose: In this study, the characteristics of hazardous chemical transport vehicle accidents during the last six years from 2014 to 2019 was analyzed. This study is to prevent chemical transport accidents. Method: Using statistics from the Ministry of Environment, chemical transport vehicle accidents were classified into accident type, accident cause and vehicle type. Result: Of the total 506 cases chemical accidents, 105 cases were caused by transport vehicle. More than 20 percent of total accidents were reported. Most of the accidents were caused by spill·leak. The main causes of the accident were traffic accidents(49 cases) and management negligence(29 cases). This was more than 74% of all transport vehicle accidents. By vehicle type, 57 cases(54%) were most common in tank lorries, followed by trucks (39 cases, 37%) and trailers (9 cases, 9%). Conclusion: In order to prevent accident of transport vehicle, thorough inspection of the transport vehicle is required and safe operation of the driver. In addition, the government needs to expand real-time monitoring of transport vehicles and comprehensively manage different systems by the relevant ministries.

• Journal of Environmental Science International
• /
• v.16 no.2
• /
• pp.187-195
• /
• 2007

Long-term passive diffusive samplers(PDS) have been used to measure $NO_2\;and\;SO_2$ concentrations at 21 sampling sites in Daejeon, Korea during the period of January 2000 - December 2002. The spatial distributions of annual $NO_2\;and\;SO_2$ concentrations were mapped. Average annual $NO_2$ concentration over the sampling period was $28.5{\pm}12.5\;ppb$, ranging from 1.2 to 81.7 ppb. Average annual $SO_2$ concentration over the sampling period was $7.7{\pm}4.8\;ppb$, ranging from 0.6 to 26.8 ppb. On average, $NO_2$ concentration was approximately 5.8%(1.6 ppb) larger in 2002. $SO_2$ concentration was decreased by 13%(1.1 ppb) during the sampling period. The seasonal variation of $NO_2\;and\;SO_2$ concentration was observed with a tendency to be higher in fall and winter. $NO_2\;and\;SO_2$, concentrations measured at different site types(patterns of land use) show significant difference. The observed difference in concentration was associated with difference in emissions of $NO_2$ from motor vehicles and $SO_2$ by non-traffic fuel consumption for heating.

• Journal of the Korea Concrete Institute
• /
• v.16 no.5 s.83
• /
• pp.645-650
• /
• 2004

As time passes, bridge structures require extension work on bridge in use from various effects such as social economical, or traffic environment change. When the concrete is poured at the connection of extension work initial curing concrete is influenced by vibration of vehicles that are passing through the old bridge superstructure. Concrete at early curing stage in construction site should be properly protected, enough to have established sufficient integrity to withstand outside vibration, impact etc. Currently there is no standard specification or regulation in our country. In this paper, experimental variables were divided by vibration velocity and time of loading, and concrete compressive strength and bond strength were measured.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.20 no.3
• /
• pp.88-97
• /
• 2012

To measure the traffic pollutants with high temporal and spatial resolution under real conditions, a mobile emission laboratory (MEL) was designed. The equipment of the mini-van provides gas phase measurements of CO, NOx, CO2 and THC (Total hydrocarbon), and number density & size distribution measurements of fine and ultra-fine particles by a fast mobility particle sizer (FMPS) and a condensation particle counter (CPC). The inlet sampling port above the bumper enables the chasing of different type of vehicles. This paper introduces the technical details of the MEL and presents data from the experiment in which a MEL chases a city bus fuelled by diesel, DME and Bio-diesel. The dilution ratio was calculated by the ratio of ambient NOx and tail-pipe NOx. Most particles from the bus fuelled by diesel were counted under 300 nm and the peak concentration of the particles was located between 30 and 60 nm. However, most particles in the exhaust of the bus fuelled by DME were nano-particles (diameter: less than 50 nm). The bus fuelled by Bio-diesel shows less particle emissions compare to diesel bus due to the presence of the oxygen in the fuel.

• Asian Journal of Atmospheric Environment
• /
• v.10 no.1
• /
• pp.32-41
• /
• 2016

Particle-phase concentrations were measured at 10, 80, and 200 m from the roadside of a national highway near Seoul in January and May 2008. The highway has two lanes each way, with an average hourly traffic volume of 1,070 vehicles. In January 2008, $PM_{10}$ concentrations decreased from 10 to 80 m but increased at 200 m. Black carbon (BC) decreased only slightly with distance due to the influence of biomass burning and open burning from the surrounding areas. In May 2008, the effect of secondary formation on both $PM_{10}$ and $PM_{2.5}$ was significant due to high temperatures compared with January. Because on-road emissions had little effect on secondary formation for a short time, variations in $PM_{10}$ concentrations became smaller, and $PM_{2.5}$ concentrations increased with distance. The effects of fugitive dust on PM concentrations were greater in May than in January when the mean temperature was below freezing. In the composition variations, the amounts of primary ions, organic carbon (OC), and BC were larger in January, while those of secondary ions and others were larger in $PM_{10}$, as well as $PM_{2.5}$ in May.