• Korean Journal of Remote Sensing
• /
• v.29 no.4
• /
• pp.361-373
• /
• 2013

The monitoring of urban area, target detection and building reconstruction have been actively studied and investigated since high resolution X-band SAR images could be acquired by airborne and/or satellite SAR systems. This paper describes an efficient approach to reconstruct artificial structures (e.g. apartment, building and house) in urban area using high resolution X-band SAR images. Building footprint was first extracted from 1:25,000 digital topographic map and then a corner line of building was detected by an automatic detecting algorithm. With SAR amplitude images, an initial building height was calculated by the length of layover estimated using KS-test (Kolmogorov-Smirnov test) from the corner line. The interferometric SAR phases were simulated depending on SAR geometry and changable building heights ranging from -10 m to +10 m of the initial building height. With an interferogram from real SAR data set, the simulation results were compared using the method of the phase consistency. One of results can be finally defined as the reconstructed building height. The developed algorithm was applied to repeat-pass TerraSAR-X spotlight mode data set over an apartment complex in Daejeon city, Korea. The final building heights were validated against reference heights extracted from LiDAR DSM, with an RMSE (Root Mean Square Error) of about 1~2m.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.21 no.3
• /
• pp.48-62
• /
• 2018

In this study, landslide of debris flow occurred at 51 sites around Daeryounsan located in between Chuncheon-si and Hongcheon-gun during July in 2013 were investigated in field and behavior characteristics of debris flow were analyzed on the basis of records of rainfall and site investigation. According to debris flow types of channelized and hill slope, location and slope angle of initiation and deposit zone, and width and depth of erosion were investigated along entire runout of debris flow. DEM(Digital Elevation Model) of Daeryounsan was constructed with digital map of 1:5,000 scale. Land slide hazard was estimated using SINMAP(Stability INdex MAPping) and the predicted results were compared with field sites where debris flow occurred. As analyzed results, for hill slope type of debris flow, predicted sites were quite comparable to actual sites. On the other hand, for channelized type of debris flow, debris flow occurrence sites were predicted by using stability index associated with topographic wetness index. As analyzed results of 4 different conditions with the parameter T/R, Hydraulic transmissivity/Effective recharge rate, proposed by NRCS (Natual Resources Conservation Service), predicted results showed more or less different actual sites and the degree of hazard tended to increase with decrease of T/R value.

• The Journal of the Korea Contents Association
• /
• v.12 no.12
• /
• pp.787-796
• /
• 2012

This study, as a purpose of viewshed anaiysis is selected for the view route, View of the target yunseondo wonlim (scenic sites No.34) located in the terrain ridge. Using GIS Viewshed analysis carried out and the results reflect the view route was selected. The basic research for this study, the scenic sites such as the natural and cultural resources for the efficient and optimized to create the route view. Viewshed Analysis results could be summarized as follows: Along a scenic sites located inside the main ridge Viewshed analysis was carried out. This overlapping the cumulative results are Leading to Nakseojae(樂書齎) Seyeonjeong(洗然亭) from space in the visible frequency higher natural villages of the district. Selected the view route and were on the road and in the topographic map nesting along Visible high-frequency region. Based on the results of the nested Viewshed major selected six points Viewshed analysis was carried out. Resource for the surrounding landscape. Results determine whether the visibility of the surrounding landscape was identified as the viewable area appears good. Finally Viewshed Analysis results for six points in the final review.

• Spatial Information Research
• /
• v.10 no.2
• /
• pp.247-261
• /
• 2002

There are much damage of people and property because of heavy rain every year. Especially, there are problem to major facility such as dam, bridge, road, tunnel, and industrial complex in the ground stability. So the counter plan for landslide or ground failure must be necessary In the study, the technique of regional landslide susceptibility assessment near the Ulsan petrochemical complex and Kumgang railway bridge was developed and applied using GIS. For the assessment, the geological structures such as bedding and fault were surveyed and the geological structure, topographic, soil, forest, and land use spatial database were constructed using CIS. Using the spatial database, the factors that influence landslide occurrence, such as slope, aspect, curvature and type of topography, texture, material, drainage and effective thickness of soil, type, age, diameter and density of forest, and land use were calculated or extracted from the spatial database. For application of geological structure, the geological structure line and fault density were calculated. Landslide susceptibility was analyzed using the landslide-occurrence factors by probability method that is summation of landslide occurrence probability values per each factors range or type. The landslide susceptibility map can be used to assess ground stability to protect major facility.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.316-316
• /
• 2017

The objective of this study is to estimate quantitatively soil salinity and soil loss at upland soils in agriculture land region in Saemangeum reclaimed land on the south Korea coasts. Soil loss and soil salinity are the most critical problem at reclaimed tidal saline soil in Korea. The several thematic maps of research area such as land cover map, topographic and soil maps, together with tabular precipitation data used for soil erosion and soil salinity calculation. Meteorological data were measured directly as air temperature, wind speed, solar radiation, and precipitation. The experiment was conducted 2% sloped lysimeter ($5.0m{\times}20.0m$) with 14 treatments and it were separated by low salinity division (LSD) and high salinity division (HSD) install. The cation content in ground water increased during time course, but in the case of land surface water the content was variable, and $K^+$ was lower than that of $Na^+$ and $Mg^{2+}$. At the LSD under rainproof condition, the salinity was directly proportional to soil water content, but at the HSD the tendency was no reversed. In condition of rainproof, the amount of soil salinity was higher at the HSD than at the LSD. Positive correlation was obtained between the soil water content and available phosphorous content at the rainfall division, but there was no significance at the surface soil of the rainproof division. Sodium adsorption ratio and anion contents in soil were repressed in the order of vinyl-mulching > non-mulching > bare field. According to the result of analyzing soil loss, soil loss occurred in a vinyl-mulching, a non-mulching and a bare field in size order, and also approximately 11.2 ton/ha soil loss happened on the reclaimed land area. The average soil loss amount by the unit area takes place in a non-mulching and bare field a lot. Our results indicate that soluble salt control and soil erosion are critical at reclaimed tidal saline soil and the results can provide some useful information for deciding management plans to reduce soil loss and salt damage for stable crop production and diverse utilization or cultivation could be one of the management options to alleviate salt damage at reclaimed tidal saline soil in Korea.

• Economic and Environmental Geology
• /
• v.47 no.2
• /
• pp.121-131
• /
• 2014

The stability of rock slope is mainly controlled by the orientation and shear strength of discontinuties in rock mass. Therefore, in kinematic analysis, the orientation of the combination of discontinuities and slope face is examined to determine if certain modes of failure can be occurred. In previous kinematic analysis, a representative orientation of the slope face and mean orientation of discontinuity set were used as input parameters. However, since the orientations of slope face varies according to locations of measurement, the representative slope face orientation could cause misunderstanding for kinematic instability. In addition, since the orientations of each discontinuity are scattered in the same discontinuity set, there is the possibility that uncertainties are involved in the procedure of kinematic analysis. Therefore, in this study, the detailed digital topographic map was used to obtain the orientation of slope face. In addition, the probabilistic analysis approach was utilized to deal properly with the uncertainties in discontinuity orientation. The proposed approach was applied to steep slopes in mountain road located in Baehuryeong, Chunncheon city, Gangwon-Do. The analysis results obtained from the deterministic and probabilistic analysis were compared to check the feasibility of proposed the analysis.

• Journal of the Korean association of regional geographers
• /
• v.5 no.1
• /
• pp.1-24
• /
• 1999

This is a study on village names in a plain region of Changnyeong-Gun, a mountain region of Bonghwa-Gun and an island region of Namhae-Gun. The three regions differ in geographical features. The data are based on 455 village names in Changnyeong-Gun, 552 village names in Bonghwa-Gun and 275 village names in Namhae-Gun found in the 1 : 50,000 topographic map. The method of this study is to analyze the word structures of village names in the five basic concepts in geography : Man-Land(Natural Environment and Human Activities). Spatial Relation, Distribution, Region and Transition. The main results of this study are as follows: 1. Naming of villages are related to Natural Environment(41%), Human Activities(23%), Region(17%), Spatial Relation(13%), Distribution(5%), and Transition(3%). Of these six factors, Changnyeong-Gun is relatively dominant in village names related to Spatial Relations, Region and Transition ; Bonghwa-Gun Natural Environment and Namhae-Gun Human Activities and Spatial Relations. But the three Guns are absolutely dominant in village names related to Natural Environment and Human Activities. 2. A village name is divided into the specific name part(given name) and the generic name part(classified name). Names related to Human Activities, Spatial Relations, Distribution and Transition are more frequently found in the specific name part. Therefore, they are used as the given name of a village name. Whereas names related to Natural Environment and Region are more frequently found in generic name part, which means that they are used as the classified name of a village. 3. The word structure of a village name usually has two parts a frontal part(given name) and a rear part(classified name). The two parts have a particular pattern in the geographic concept when they are combined. 1) In the village names related to in their frontal part of the word structure, is more frequently combined as their rear part in Bonghwa-Gun, in Namhae-Gun and in Changnyeong-Gun. 2) In the village names related to in their frontal part of the word structure, is more frequently combined as their rear part in Changnyeong-Gun, in Namhae-Gun and in Bonghwa-Gun. Accordingly, Man(Human Activities) - Land (Natural Environment) can be considered the most important concept in the naming of villages, because the concept is most frequently used in the word structures of village names.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.16 no.3
• /
• pp.193-210
• /
• 2013

This study aims to assess the slope stability variation of Jeollabuk-do drainage areas by RCM model outputs based on A1B climate change scenario and infinite slope stability model based on the specific catchment area concept. For this objective, we downscaled RCM data in time and space: from watershed scale to rain gauge scale in space and from monthly data to daily data in time and also developed the GIS-based infinite slope stability model based on the concept of specific catchment area to calculate spatially-distributed wetness index. For model parameterization, topographic, geologic, forestry digital map were used and model parameters were set up in format of grid cells($90m{\times}90m$). Finally, we applied the future daily rainfall data to the infinite slope stability model and then assess slope stability variation under the climate change scenario. This research consists of two papers: the first paper focuses on the methodologies of climate change scenario preparation and infinite slope stability model development.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.16 no.3
• /
• pp.103-114
• /
• 2013

In this study, we established the ortho mosaic imagery on the Korean Peninsula using KOMPSAT-2 images and conducted an accuracy assessment. Rational Polynomial Coefficient(RPC) modeling results were mostly less than 2 pixels except for mountainous regions which was difficult to select a Ground Control Point(GCP). Digital Elevation Model(DEM) which was made using the digital topographic map on the scale of 1:5,000 was used for generating an ortho image. In the case of inaccessible area, the Shuttle Radar Topography Mission(SRTM) DEM was used. Meanwhile, the ortho mosaic image of the Korean Peninsula was produced by each ortho image aggregation and color adjustment. An accuracy analysis for the mosaic image was conducted about a 1m color fusion image. In order to verify a geolocation accuracy, 813 check points which were acquired by field survey in South Korea were used. We found that the maximum error was not to exceed 5m(Root Mean Square Error : RMSE). On the other hand, in the case of inaccessible area, the extracted check points from a reference image were used for accuracy analysis. Approximately 69% of the image has a positional accuracy of less than 3m(RMSE). We found that the seam-line accuracy among neighboring image was very high through visual inspection. However, there were a discrepancy with 1 to 2 pixels at some mountainous regions.

• Korean Journal of Remote Sensing
• /
• v.36 no.5_3
• /
• pp.1013-1025
• /
• 2020

Unmanned Aerial Vehicle (UAV) platform is being widely used in disaster monitoring and smart city, having the advantage of being able to quickly acquire images in small areas at a low cost. Ground Control Points (GCPs) for positioning UAV images are essential to acquire cm-level accuracy when producing UAV-based orthoimages and Digital Surface Model (DSM). However, the on-site acquisition of GCPs takes considerable manpower and time. This research aims to provide an efficient and accurate way to replace the on-site GNSS surveying with three different sources of geospatial data. The three geospatial data used in this study is as follows; 1) 25 cm aerial orthoimages, and Digital Elevation Model (DEM) based on 1:1000 digital topographic map, 2) point cloud data acquired by Mobile Mapping System (MMS), and 3) hybrid point cloud data created by merging MMS data with UAV data. For each dataset a three-dimensional positional accuracy analysis of UAV-based orthoimage and DSM was performed by comparing differences in three-dimensional coordinates of independent check point obtained with those of the RTK-GNSS survey. The result shows the third case, in which MMS data and UAV data combined, to be the most accurate, showing an RMSE accuracy of 8.9 cm in horizontal and 24.5 cm in vertical, respectively. In addition, it has been shown that the distribution of geospatial GCPs has more sensitive on the vertical accuracy than on horizontal accuracy.