• Geomechanics and Engineering
• /
• v.16 no.2
• /
• pp.113-124
• /
• 2018

Under repeated loading, the residual stresses within the subgrade and subsoil can accelerate the deformation of the road structures. In this paper, a series of laboratory cyclic loading model tests and small-scale model tests were conducted to investigate the dynamic stress response within soils under different loading conditions. The experimental results showed that a dynamic stress accumulation effect occurred if the soil showed cumulative deformation: (1) the residual stress increased and accumulated with an increasing number of loading cycles, and (2) the residual stress was superimposed on the stress response of the subsequent loading cycles, inducing a greater peak stress response. There are two conditions that must be met for the dynamic stress accumulation effect to occur. A threshold state exists only if the external load exceeds the cyclic threshold stress. Then, the stress accumulation effect occurs. A higher loading frequency results in a higher rate of increase for the residual stress. In addition to the superposition of the increasing residual stress, soil densification might contribute to the increasing peak stress during cyclic loading. An increase in soil stiffness and a decrease in dissipative energy induce a greater stress transmission within the material.

• Architectural research
• /
• v.20 no.1
• /
• pp.27-34
• /
• 2018

To improve the chloride ingress resistance of concrete, slag is widely used as a mineral admixture in concrete industry. And currently, most of experimental investigations about non steady state diffusion tests of chloride penetration are started after four weeks standard curing of concrete. For slag blended concrete, during submerged chloride penetration tests periods, binder reaction proceeds continuously, and chloride diffusivity decreases. However, so far the dependence of chloride ingress on curing ages are not detailed considered. To address this disadvantage, this paper shows a numerical procedure to analyze simultaneously binder hydration reactions and chloride ion penetration process. First, using a slag blended cement hydration model, degree of reactions of binders, combined water, and capillary porosity of hardening blended concrete are determined. Second, the dependences of chloride diffusivity on capillary porosity of slag blended concrete are clarified. Third, by considering time dependent chloride diffusivity and surface chloride content, chloride penetration profiles in hardening concrete are calculated. The proposed prediction model is verified through chloride immersion penetration test results of concrete with different water to binder ratios and slag contents.

• Fisheries and Aquatic Sciences
• /
• v.13 no.2
• /
• pp.112-117
• /
• 2010

Altered mRNA expression of two metallothionein isoforms (MT-IA and MT-IB) in response to acute heavy metal exposure was examined in mud loach, Misgurnus mizolepis, fry using a real-time RTPCR assay. Sublethal exposure (1 or 5 ${\mu}M$) to Cd, Cr, Fe, Mn, Ni, and Zn resulted in highly variable transcriptional responses of the two MT isoforms to the heavy metal ions, including upregulation, a steady state, and downregulation. Overall, the most potent inducer of both MT isoforms was Cd (up to 6-fold). Another exposure experiment using a series of doses of Cu revealed that the stimulation patterns of the two MT isoforms differed: MT-IA transcription was soon saturated at higher concentrations (about 2-fold at 1-4 ${\mu}M$ of Cu), whereas the activation of MT-IB was more dependent on the treatment dose (increased up to 5-fold at 3 ${\mu}M$). The isoform-specific allotment of constitutive and inducible functions was not as clear in fry as in adult tissues. Coordinated interaction between the MT-IA and MT-IB isoforms was hypothesized based on the finding that MT-IA represented a primary action under 'less stressful' or 'sublethal' conditions, whereas the activation of MT-IB became important under 'more stressful' or 'lethal' circumstances in this species.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.21 no.12
• /
• pp.2038-2046
• /
• 1997

In this paper the instability of the system which has a disk and a mass-spring-damper system interacting through a medium having stiffness and damping is analyzed. To solve the equations of motion of this systme, it is assumed that the solution consists of the eigenfunctions which are the products of the Bessel functions and sine or cosine functions. The former represents the radial characteristics of the disk and the latter represents the circumferential characteristics. Using this assumed solution and the orthogonality of the eigenfunctions, the equations of motion can be transformed into a set of equations of motion with variables dependent only on the time. After this set is changed to the state equation, the eigenvalue problem can be made. Once the eigenvalues are calculated according to the angular velocity of the disk, the dynamic characteristics ofthis system is obtained. Because the thickness of the disk and the element characteristics of the mass-spring-damper system have important effects on the stability of the system, it will be understood how these factors affect the system and then a method to ameliorate the stability of the system with a disk will be presented.

• Korea-Australia Rheology Journal
• /
• v.20 no.1
• /
• pp.27-34
• /
• 2008

Clay suspensions in liquid polymers exhibit a time-dependent behaviour that includes viscoelastic as well as thixotropic features. Because of the presence of interacting clay platelets, particulate networks can develop, which are broken down during flow and rebuild upon cessation of the flow. Here, the use of thixotropic techniques in probing flow-induced structures in nanocomposites is explored with data on a hectorite-poly(isobutylene) model system. By means of fast stress jump measurements the hydrodynamic contributions to the steady state stresses are determined as well as those caused by the stretching of the clay floes. Flow reversal measurements do not provide a clear indication of flow-induced anisotropy in the present case. The recovery of the clay microstructure upon cessation of flow is followed by means of overshoot and dynamic measurements. The development of a particulate network is detected by the appearance and growth of a low frequency plateau of the storage moduli. The modulus-frequency curves after various rest times collapse onto universal master curves, regardless of the pre-shear history or temperature. The scaling factors for this master curve are the crossover parameters. The crossover moduli are nearly a linear function of the crossover frequency, the relation being identical for recovery after shearing at different shear rates. This function depends, however, on temperature.

• Journal of Chest Surgery
• /
• v.25 no.12
• /
• pp.1399-1403
• /
• 1992

The evaluation of the effectivess of ongoing cardiopulmonary resucitation efforts is dependent on the commonly used methods, such as the presence of femoral or carotid artery pulsations, arterial blood gas determinations, peripheral arterial pressure and intracardiac pressure monitoring. But recent studies suggest that end-tidal carbon dioxide tension serves as a non-invasive measurement of pulmonary blood flow and therefore cardiac output under constant ventilation. A prospective clinical study was done to determine whether end-tidal carbon dioxide monitoring in open heart surgery under cardiopulmonary bypass could be used as a prognostic indicator of bypass weaning. We monitored end-tidal PCO2 values continuously during cardiopulmonary bypass in 30 patients. "Ohmeda 5210 CO-2 monitor" under infrared absorption method were incorperated into the ventilator circuit by means of a side point adaptor between endotracheal tube and ventilator tubing. 18 patients[Group I ] were res-ucitated from partial bypass followed by aorta cross clamp off and 12 patients[Group II ] from aorta cross clamp off followed by partial bypass. But there was no difference between two groups[p>0.05]. The value of end-tidal carbon dioxide tension during ventricular fibrillation or nearly arrest state was 6.6$\pm$2.9 mmHg, and at the time of spontaneous beating was 19.3$\pm$5.6 mmHg[Mean$\pm$Standard deviation], In conclusion end-tidal carbon dioxide tension monitoring provides clinically useful, continous, noninvasive and supplementary prognostic indicator during cardiopulmonary bypass weaning procedures.rocedures.

• Korea-Australia Rheology Journal
• /
• v.18 no.4
• /
• pp.199-207
• /
• 2006

Measurements by Luap et al. (2005) of elongational viscosity and birefringence of two nearly monodisperse polystyrene melts with molar masses $M_{w}$ of $206,000g{\cdot}mol^{-1}$ (PS206k) and $465,000g{\cdot}mol^{-1}$ (PS465k) respectively are reconsidered. At higher elongational stresses, the samples showed clearly deviations from the stress optical rule (SOR). The elongational viscosity data of both melts can be modeled quantitatively by the MSF model of Wagner et al. (2005), which is based on the assumption of a strain-dependent tube diameter and the interchain pressure term of Marrucci and Ianniruberto (2004). The only nonlinear parameter of the model, the tube diameter relaxation time, scales with $M_{w}^{2}$. In order to get agreement with the birefringence data, finite chain extensibility effects are taken into account by use of the $Pad\'{e}$ approximation of the inverse Langevin function, and the interchain pressure term is modified accordingly. Due to a selfregulating limitation of chain stretch by the FENE interchain pressure term, the transient elongational viscosity shows a small dependence on finite extensibility only, while the predicted steady-state elongational viscosity is not affected by non-Gaussian effects in agreement with experimental evidence. However, deviations from the SOR are described quantitatively by the MSF model by taking into account finite chain extensibility, and within the experimental window investigated, deviations from the SOR are predicted to be strain rate, temperature, and molar mass independent for the two nearly monodisperse polystyrene melts in good agreement with experimental data.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07a
• /
• pp.415-418
• /
• 2005

To understand effects of carbon nanotubes (CNTs) dispersed in nematic liquid crystal (NLC) on electro-optic characteristic and orientation of the LC, we CNT-doped homogeneously-aligned NLC cells driven by in-plane field have been fabricated. The CNTs were aligned with a LC director from the initial state to below critical ac field, whereas the CNTs disturbed the LC director field above critical ac field. We observed motional textures in the form of vertical stripes in the local area between electrodes, which were associated with a deformation of the LC director orientation. This indicates that CNTs start vibrating three dimensionally with translational motion. Further, the hysterisis studies of voltage-dependent transmittance under dc electric field show that the amount of residual dc, which is related to image sticking problem in liquid crystal displays, is greatly reduced due to ion trapping by CNTS while keeping operating voltage and response time about the same compared to the un-doped LC cell.

• Computers and Concrete
• /
• v.3 no.4
• /
• pp.249-260
• /
• 2006

Self-consolidating concrete (SCC) in the fresh state is known for its excellent deformability, high resistance to segregation, and use, without applying vibration, in congested reinforced concrete structures characterized by difficult casting conditions. Such a concrete can be obtained by incorporating either mineral or chemical admixtures. This paper presents the results of an investigation to asses the applicability of Abram's law in predicting the compressive strength of SCC to any given age. Abram's law is based on the assumption that the strength of concrete with a specific type of aggregate at given age cured at a prescribed temperature depends primarily on the water-to-cement ratio (W/C). It is doubtful that such W/C law is applicable to concrete mixes with mineral or chemical admixtures as is the case for SCC where water to binder ratio (W/B) is used instead of W/C as the basis for mix design. Strength data of various types of SCC mixtures is collected from different sources to check the performance of Abram's law. An attempt has been made to generalize Abram's law by using various optimization methodologies on collected strength data of various SCC mixtures. A set of generalized equations is developed for the prediction of SCC strength at various ages. The performance of generalized equations is found better than original Abram's equations.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.11
• /
• pp.3211-3217
• /
• 2013

Density functional theory (DFT) and time-dependent DFT (TD-DFT) calculations have been employed to investigate the molecular structures and absorption spectra of three D-${\pi}$-A-type organic dyes (C1-1, D5 and TH208) containing identical ${\pi}$-spacers and electron acceptors, but different aromatic amine electron-donating groups (tetrahydroquinoline, triphenylamine and phenothiazine). The coplanar geometries indicate that the strong conjugation is formed in the dyes. The electronic structures suggest that the intramolecular charge transfer from the donor to the acceptor occurs, and the electron-donating ability of tetrahydroquinoline is stronger than those of triphenylamine and phenothiazine. The computed orbital energy levels of these dyes confirm that the electrons could be injected from the excited dyes to the semiconductor conduction band and the oxidized dyes could be reduced effectively by electrolyte. The TD-DFT results show that the CAM-B3LYP/6-31+G(d, p) is suitable for calculating the absorption spectra. The first absorption band for these dyes is assigned to the HOMO${\rightarrow}$LUMO and HOMO-1${\rightarrow}$LUMO transitions.