• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.11 no.10
• /
• pp.1852-1857
• /
• 2007

The SSB modem performs the modulation process which converts the digital voltage level to the audible frequency band signal and the demodulation process which converts reversely the audible frequency signal to the digital voltage level. The modulator and the demodulator are implemented with a single DSP chip. Because of the SSB specific character, the distortion occurs when the frequency is changed. This distortion has no effect on voice communication but it has an significant effect on data communication. In other words, it is impossible to send data stream with adjacent 2 periods. Therefore, in case of using 2-tone FSK, it is needed to send at least 3 periods to transmit 1 bit. Therefore we implemented the modem using modified phase-delay shift keying to transmit 1 tone signal for high speed transmission. In the 1200[bps] mode, it generates 0, $187{\mu}s$, delay time at 1.3kHz symbol frequency, and in the 2400[bps] mode, 0, $70{\mu}s\;130{\mu}s\;200{\mu}s$, delay time at 1.5kHz symbol frequency. Finally, in the maximum 3600[bps] mode, it generates 0, $100{\mu}s\;160{\mu}s\;250{\mu}s$ 2.0kHz symbol frequency. The measured results of the implemented SSB modem shows a good transfer functional characteristic by spectrum analyzer, almost same bandwidth in pass band and 20dB higher SNR comparing the emu FACTOR and American CLOVER and in the experimental transmitting test, we verified the transmitted data is received correctly in platform.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.46 no.2
• /
• pp.57-71
• /
• 2023

In this study, we analyze a finite-buffer M/G/1 queueing model with randomized pushout space priority and nonpreemptive time priority. Space and time priority queueing models have been extensively studied to analyze the performance of communication systems serving different types of traffic simultaneously: one type is sensitive to packet delay, and the other is sensitive to packet loss. However, these models have limitations. Some models assume that packet transmission times follow exponential distributions, which is not always realistic. Other models use general distributions for packet transmission times, but their space priority rules are too rigid, making it difficult to fine-tune service performance for different types of traffic. Our proposed model addresses these limitations and is more suitable for analyzing communication systems that handle different types of traffic with general packet length distributions. For the proposed queueing model, we first derive the distribution of the number of packets in the system when the transmission of each packet is completed, and we then obtain packet loss probabilities and the expected number of packets for each type of traffic. We also present a numerical example to explore the effect of a system parameter, the pushout probability, on system performance for different packet transmission time distributions.

• Current Research on Agriculture and Life Sciences
• /
• v.31 no.1
• /
• pp.61-64
• /
• 2013

This study identified the effect of night time temperatures on the flowering period of spray-chrysanthemum during the summer season in South Korea. According to the results for 2005, the temperature at night time sustained more than $25^{\circ}C$ for 23.6 days during the short day period and delayed the flowering period for 22 days. Similar observations were reported in 2006, as the night time temperature sustained more than $25^{\circ}C$ for 23.6 days during the short day period and delayed flowering period for 23 days. The results for 2007 year showed that night time temperature sustained more than $25^{\circ}C$ for 31.9 days during the same period and delayed flowering for 31 days. In conclusion, based on the results for 2005 to 2007, a specific correlation was found between high night time temperatures and a delayed flowering period for the 'Euro' spray-chrysanthemum.

• Korean Journal of Culture and Social Issue
• /
• v.20 no.4
• /
• pp.347-364
• /
• 2014

The present study was conducted to investigate how emotional expression change, test delay, and background influence on face recognition. In experiment 1, participants were presented with negative faces at study phase and administered for standard old-new recognition test including targets of negative and neutral expression for the same faces. In experiment 2, participants were studied negative faces and tested by old-new face recognition test with targets of negative and positive faces. In experiment 3, participants were presented with neutral faces at study phase and had to identify the same faces with no regard for negative and neutral expression at face recognition test. In all three experiments, participants were assigned into either immediate test or delay test, and target faces were presented in both white and black background. Results of experiments 1 and 2 indicated higher rates for negative faces than neutral or positive faces. Facial expression consistency enhanced face recognition memory. In experiment 3, the superiority of facial expression consistency were demonstrated by higher rates for neutral faces at recognition test. If facial expressions were consistent across encoding and retrieval, memory performance on face recognition were enhanced in all three experiments. And the effect of facial expression change have different effects on background conditions. The findings suggest that facial expression change make face identification hard, and time and background also affect on face recognition.

• Science of Emotion and Sensibility
• /
• v.26 no.1
• /
• pp.65-78
• /
• 2023

Aircraft are representative of human-machine systems. There is a delay between the human operation and the completion of the machine operation such as when the machine starts to operate and when the force is transmitted to the machine and completed. Time perception is an important component of timing tasks and is known to be affected by the anxiety associated with high arousal. This research verified the impact of weather, flight, and time conditions on the anxiety and time perception of in-service pilots in a virtual reality area. Weather conditions were divided into visual flight weather conditions and very low visibility conditions. Experiments 1 and 2 were performed with different flight and time conditions. In Experiment 1, time perception was measured by employing a button added to the control rod in the scenario of hovering and level flight with relatively little transformed in momentum and little delay. In Experiment 2, time perception was measured in the procedure of naturally taking off the helicopter by employing only the control stick in a takeoff scenario where there was a lot of transformation in momentum and a lot of delays. As a result of the experiment, it was reported that anxiety and heart rate increased in very low visibility conditions In particular, among all flight conditions in Experiments 1 and 2, it was reported that time was overestimated in the scenario of increased anxiety. This outcome can lead to overestimation of time under the impact of anxiety and failure of the timing task, which may lead to challenges in maneuvering and possibly lead to accidents.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.9B
• /
• pp.785-791
• /
• 2006

A CF-Poll frame which contains the channel reservation time can be piggybacked in QoS-Data frame to increase the channel efficiency in HCCA. However, if any QSTA in the network uses the low physical transmission rate, the QoS-Data frame which includes the CF-Poll frame must be transmitted by the minimum transmission rate. Therefore, it can cause the decrease of the channel efficiency and the increase of the frame transmission delay for other traffic streams when any QSTA has the low physical transmission rate. In this paper, we define this phenomenon as the piggyback problem at the low physical transmission rate and evaluate the effect of this problem. In the simulation results, when a CF-Poll piggyback is used, the delay is increased about 25% if any QSTA has the low physical transmission rate, while the delay is decreased about 7.8% if all QSTA has the high physical transmission rate. We also found that the gain of the CF-Poll piggyback mechanism is achieved when all QSTA has higher physical transmission rate than 24 or 36Mbps.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.304-309
• /
• 2004

Recently, the needs for multimedia stream such as digital audio and video in the Internet has increased tremendously. Unlike TCP, the UDP protocol, which has been used to transmit streaming traffic thorough the Internet, does not apply any congestion control mechanism to regulate the data flow thorough the shared network And it leads to congestion collapse of the Internet and results in long-term transmission delay. To avoid any adverse effect on the current Internet functionality, a now protocol of modification or addition of some functionality to perform congestion control and to reduce huge transmission delay in transmitting of multimedia stream are in study. TCP-friendly congestion control mechanism is classified into two : one is window-based congestion control scheme using general window management functionalities, the other is rate-based congestion control scheme using TCP modeling equation. In this paper, we propose an algorithm for improving the transmitting rate on a hybrid TCP-friendly congestion control scheme combined with widow-based and late-based congestion control for multimedia stream. And we also simulate the performance of improved TEAR implementation using NS. With He simulation results, we show that the improved TEAR can provide better fairness and lower rate fluctuations than TCP.

• Journal of the Korean Society for Nondestructive Testing
• /
• v.36 no.1
• /
• pp.27-34
• /
• 2016

The type of ultrasound transducer used influences the quality of a reconstructed ultrasound image. This study analyzed the effect of transducer type on ultrasound computed tomography (UCT) image quality. The UCT was modeled in an ultrasound simulator by using a 5 cm anatomy model and a ring-shape 5 MHz 128 transducer array, which considered attenuation, refraction, and reflection. Speed-of-sound images were reconstructed by the Radon transform as the UCT image modality. Acoustic impedance images were also reconstructed by the delay-and-sum (DAS) method, which considered the speed of sound information. To determine the optimal combination of transducers in observation, point-source, flat, and focused transducers were tested in combination as trasmitters and receivers; UCT images were constructed from each combination. The combination of point-source/flat transducer as transmitting and receiving devices presented the best reconstructed image quality. In UCT implementation, the combination of a flat transducer for transmitting and a point transducer for receiving permitted acceptable image quality.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.11 no.6
• /
• pp.131-142
• /
• 2007

The road user cost in indirect costs as well as direct costs such as the inspection/ diagnosis cost and the repair/reinforcement cost should be considered as one of the important items in the life-cycle cost-effective design and maintenance of the bridges. To estimate the road user cost, this paper formulates the road user cost as a sum of the user delay cost and the vehicle operating cost considering the detour effect. A numerical traffic simulation and a regression analysis are performed to develop a regression model due to a time delay. The proposed regression model is applied to the generation of the maintenance strategy based on the life-cycle cost and performance, and its effectiveness and applicability is investigated. The road user cost has a great influence on establishing the maintenance strategy, and the proposed regression model could be successfully utilized to estimate the road user cost of a bridge.

• International Journal of Advanced Culture Technology
• /
• v.8 no.3
• /
• pp.300-306
• /
• 2020

This study analyzes the distributor's inventory model in a two-stage supply chain consisting of the supplier, the distributor and the end customer. The supplier will allow a credit period before the distributor settles the account with him in order to stimulate the demand for the product he produces. It is also assumed that the distributor pays the shipping cost for the order and hence, the distributor's ordering cost consists of a fixed ordering cost and the shipping cost that depend on the order quantity. The availability of the delay in payments from the supplier enables discount of the distributor's selling price from a wider range of the price option in anticipation of increased customer's demand. As a result, the availability of a credit transaction leads to an increase in inventory levels. On the other hand, in the case of deteriorating products in which the utility of the product perish over time, the deterioration rate with time plays a role in reducing inventory levels. In this regard, we analyze the effect of the length of the credit period and the degree of product deterioration on the distributor's inventory level. For the analysis, we formulate the distributor's annual net profit and analyze the effect of the length of credit period and deterioration rate of the product on inventory policy numerically.