• The Bulletin of The Korean Astronomical Society
• /
• v.37 no.2
• /
• pp.219.2-219.2
• /
• 2012

We are developing Adaptive Optics (AO) system for 24 inch telescope at Seoul National University Observatory. It consists of the tip-tilt correction system and the residual wavefront error correction system with a deformable mirror and a wavefront sensor. We present the construction and performance measurements of the tip-tilt correction system. The tip-tilt component is the single largest contributor to wavefront error, especially for small telescope. The tip-tilt correction system consists of a quadrant photodiode, a tip-tilt mirror and a feed back loop. The collimated He-Ne laser beam is used for input light source and is artificially disturbed by air turbulence generated by a heat gun. Most of the turbulence is of low frequency less than 20 Hz, but extends to a few hundreds Hz. It is found that the closed loop system using proportional-integral-derivative (PID) control successfully corrects tip-tilt error at a rate as high as 300~400 Hz.

• Journal of the Semiconductor & Display Technology
• /
• v.20 no.3
• /
• pp.18-21
• /
• 2021

This paper analyzes the distortion correction of the in the micro DMD(digital micro mirror device) projector system using 0.25 or less optical throwing distance ratio. The distortion of projected image occurs depending on the performance of the optical lens, the installation location of the projection system, and the tilt of the screen. This study analyzed the physical tilt values influencing of the distortion of projected image, removed the tilt distortion of throwing distance ratio optical lens, and adjusted the distortion image by the simulation of calibration displacements. The results of this study demonstrated within 5% TV distortion reference. Moreover, the correction method reduced the pin-distortion correction of projection system.

• The Bulletin of The Korean Astronomical Society
• /
• v.38 no.1
• /
• pp.69.1-69.1
• /
• 2013

We are developing Adaptive Optics (AO) system for 1m telescope at Gwacheon National Science Museum Observatory. The beam spot of the Gwacheon 1m telescope. The tip-tilt correction system consists of a CMOS sensor, a tip-tilt mirror and a feed back loop. The beam spot location at the CMOS sensor indicates the tip-tilt components of the incoming light. The tip-tilt mirror is controlled by DAC output voltage calculated by proportional-integral-derivative (PID) controller. This system successfully corrects the tip-tilt motion of the spot.

• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.2
• /
• pp.132.2-132.2
• /
• 2011

We are developing Adaptive Optics (AO) system for astronomical use. The He-Ne laser works as an artificial light source. The tip-tilt correction servo is added to our AO system. The tip-tilt term, among the Zernike terms, is the biggest contributor of wavefront deformation caused by atmospheric turbulence at small telescopes. The tip-tilt correction servo consists of a Piezo tip-tilt platform with a mirror, a quadrant photodiode as a tip-tilt sensor, and controllers. The Shack-Hartmann wavefront sensor measures the residual wavefront errors and they are corrected by the MEMS (Micro Electro Mechanical System) deformable mirror. The MEMS deformable mirror allows the compact size at low cost compare to adaptive secondary mirror and other deformable mirrors. As the frame rates of the MEMS deformable mirror is about tens of kHz, the frame rates of the detector in wavefront sensor is the bottleneck of the wavefront correction speed. For faster performance, we replaced a CCD which provides frame rates only 70 Hz with a CMOS with frame rates up to 450 Hz.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.31 no.3 s.258
• /
• pp.395-402
• /
• 2007

This paper considers about the tilt measurement of lens module with multiple lenses. The tilt between lenses in lens module and barrel or between image sensor and barrel can be measured precisely with the proposed algorithm. The magnitude and direction of the tilt vector of lens and image sensor can be measured from the best focal surface. The selecting and setting of image sensor, test chart, image sensor centering to lens module, axis align, focus measure method are also explained to get highly precise tilt results. The proposed algorithm is verified with the lens module inspection system we developed, and the experimental results show that the tilt measure proposed in this paper is robust and precise. With the proposed tilt measurement algorithm, the tilt of an image sensor and any other lens which intermediates light can be measured.

• Journal of IKEEE
• /
• v.18 no.3
• /
• pp.362-367
• /
• 2014

Music score recognition applications running on a smartphone, which is one of the necessities of modern people, have already been released on the market. These applications have the several limitations, especially the recognition rate of printed music scores is low so that many errors occur when the score is played. The major factor to decrease the recognition rate comes from poor tilt-correction of the captured staff-line. In this paper, we propose a efficient method that can automatically shoot the printed music score through preview analysis, which increases the recognition rate via tilt-correction.

• Journal of The Korean Astronomical Society
• /
• v.54 no.4
• /
• pp.113-119
• /
• 2021

It is difficult for observers to conduct an optical alignment at an observatory without the assistance of an optical engineer if optomechanical parts are to be replaced at night. We present a practical tilt correction method to obtain the optimal optical alignment condition using the symmetricity of optical aberrations of a wide-field on-axis telescope at night. We conducted coarse tilt correction by visually examining the symmetry of two representative star shapes obtained at two guide chips facing each other, such as east-west or north-south pairs. After coarse correction, we observed four sets of small stamp images using four guide cameras located at each cardinal position by changing the focus positions in 10-㎛ increments and passing through the optimum focus position in the range of ±200 ㎛. The standard deviation of each image, as a function of the focus position, was fitted with a second-order polynomial function to derive the optimal focus position at each cardinal edge. We derived the tilt angles from the slopes converted by the distance and the focus position difference between two paired guide chip combinations such as east-west and north-south. We used this method to collimate the on-axis wide-field telescope KMTNet in Chile after replacing two old focus actuators. The total optical alignment time was less than 30 min. Our method is practical and straightforward for maintaining the optical performance of wide-field telescopes such as KMTNet.

• PNF and Movement
• /
• v.20 no.2
• /
• pp.215-222
• /
• 2022

Purpose: The purpose of this study was to compare the effects of passive scapular upward rotation and posterior tilt and active scapular posterior tilt on the muscle activity of the upper trapezius (UT), lower trapezius (LT), and serratus anterior (SA). Methods: Fifteen healthy subjects performed general arm elevation, arm elevation with passive scapular upward rotation and posterior tilt, and arm elevation with active scapular posterior tilt. For active scapular posterior tilt, the subjects were trained in this movement using visual biofeedback and a motion sensor. During each arm elevation condition, electromyography was used to measure the muscle activity of the UT, LT, and SA. The measured data were analyzed using a one-way repeated ANOVA. Results: LT muscle activity was significantly increased during arm elevation with active scapular posterior tilt compared to both general arm elevation and arm elevation with passive scapular upward rotation and posterior tilt (p < 0.05). SA muscle activity was greater during arm elevation with passive scapular upward rotation and posterior tilt than during general arm elevation (p < 0.05). There was no significant change in UT muscle activity among the tested arm elevation conditions (p > 0.05). Conclusion: Performing arm elevation with active scapular posterior tilt and performing arm elevation with passive scapular upward rotation and posterior tilt may be useful strategies for increasing muscle activation of the LT and SA, respectively.

• Journal of The Korean Society of Integrative Medicine
• /
• v.8 no.2
• /
• pp.109-119
• /
• 2020

Purpose : The purpose of this study was to investigate the effects of a combined exercise program using a ballet bar and elastic bands on the body composition, physical strength, and postural correction of middle-aged women. Methods : The subjects were 28 middle-aged women with no ballet experience. They were divided into an experimental group (n=14; exercise group) and a control group (n=14; non-exercise group) through random sampling. The experimental group underwent an exercise program using a ballet bar and elastic bands for 50 minutes twice a week for 12 weeks, whereas the control group performed no exercise. The subjects in both group had their body composition, physical fitness, and postural angles measured before and after the intervention. A paired t-test was used to compare pre- and post-test values within each group, and a two-way repeated measures ANOVA was employed to compare pre- and post-test changes between the two groups. Results : Regarding body composition, statistically significant differences in BMI (p<.05), body fat percentage (p<.001), and muscle mass (p<.001) were observed between the two groups before and after the intervention. For physical fitness, the experimental group showed statistically significant increases in quick reflexes (p<.001), muscle endurance (p<.001), and muscle strength (p<.001). For postural correction, the experimental group exhibited statistically significant decreases in all variables: the head (p<.001), shoulder (p<.001), cervical tilt (p<.001), right-left pelvic tilt (p<.001), and anterior-posterior pelvic tilt (p<.001). Conclusion : A combined exercise program using a ballet bar and elastic bands had positive effects on the body composition, physical fitness, and postural correction of middle-aged women.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• v.46 no.6
• /
• pp.379-384
• /
• 2020

Objectives: We sought to identify a clinically useful method of analyzing orbital dystopia to aid in diagnosis and treatment planning and to quantify vertical discrepancies in eye level and variations in canthal tilt in Koreans. Patients and Methods: In 76 Korean patients with a mean age of 23.12 years, mean differences in the level of the pupils, lateral canthi, medial canthi, and canthal tilt were measured. The difference in pupil level was calculated from the perpendicular lines drawn from the midpupil area of each eye to the midline of the face to determine the amount of skeletal discrepancy of the eye. Soft tissue discrepancies were determined according to the vertical difference between the lines drawn from the lateral or medial canthus of each eye perpendicular to the midline of the face. The canthal tilt was determined from the inclination of a line connecting the lateral and medial canthi, then classified as class I, II, or III. Results: Mean differences in pupil level, medial canthi, and lateral canthi were 1.57±1.10 mm, 1.14±1.07 mm, and 2.03±1.64 mm, respectively. The mean degree of canthal tilt were 8.45°±3.53° for the right side and 8.42°±3.81° for the left side. No study participants presented with class III canthal tilt. The mean canthal tilt values for those with class I tilt were 3.21°±1.68° for the right side and 3.18°±1.63° for the left side, while, for those who had class II tilt, the values were 9.60°±3.66° for the right side and 9.54°±2.99° for the left side. Conclusion: The presented diagnostic method of orbital dystopia can be used to effectively establish a treatment plan that takes into consideration the patient's skeletal and soft-tissue discrepancies.