• JSTS:Journal of Semiconductor Technology and Science
• /
• v.10 no.2
• /
• pp.118-129
• /
• 2010

A lower-threshold-voltage (LVth) SRAM cell with an elevated cell biasing scheme, which enables to reduce the random threshold-voltage (Vth) variation and to alleviate the stability-degradation caused by word-line (WL) and cell power line (VDDM) disturbed accesses in row and column directions, has been proposed. The random Vth variation (${\sigma}Vth$) is suppressed by the proposed LVth cell. As a result, the LVth cell reduces the variation of static noise margin (SNM) for the data retention, which enables to maintain a higher SNM over a larger memory size, compared with a conventionally being used higher Vth (HVth) cell. An elevated cell biasing scheme cancels the substantial trade-off relationship between SNM and the write margin (WRTM) in an SRAM cell. Obtained simulation results with a 45-nm CMOS technology model demonstrate that the proposed techniques allow sufficient stability margins to be maintained up to $6{\sigma}$ level with a 0.5-V data retention voltage and a 0.7-V logic bias voltage.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.14 no.2
• /
• pp.10-16
• /
• 1977

Memory switching of the amorphous chalcogenide Ge-Te-Si memory devices were observed at various thicknesses and temperatures. For a given thickness, the distribution of threshold voltages shows a strong peaks, which is attributed to the intrinsic switching mechanism. The plot of Vth versus thickness indicates that threshold voltages were lowered and switching fields were raised as thickness was decreased. And threshold voltage sagged as temperature was raised and the fact that threshold voltage can be lowered at the temperature range under Tg was obtained.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2007.08b
• /
• pp.1172-1175
• /
• 2007

We have investigated the threshold voltage shifts(${\Delta}Vth$) and drain current level shift (${\Delta}Ids$) in subthreshold region of a-Si:H TFTs induced by DC Bias (Vgs and Vds) - Temperature stress (BTS) condition. We plotted the transfer curves and the ${\Delta}Vth$ contour maps as Vds-Vds stress bias and Temperature to examine the severe damage cases on TFTs. Also, by drawing out the time-dependent transfer curve (Ids-Vgs) in the region of $10^{-8}\;{\sim}\;10^{-13}$ (A) current level, we can estimate the failure time of TFTs in a operating condition.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.403-404
• /
• 2012

We fabricated TFT devices with the GeSe channel. A single device consists of a Pt source and drain, a Ti glue layer and a GeSe chalcogenide channel layer on SiO2/Si substrate which worked as the gate. We confirmed the drain current with variations of gate bias and channel size. The I-V curves of the switching device are shown in Fig. 1. The channel of the device always contains amorphous state, but can be programmed into two states with different threshold voltages (Vth). In each state, the device shows a normal Ovonic switching behavior. Below Vth (OFF state), the current is low, but once the biasing voltage is greater than Vth (ON state), the current increases dramatically and the ON-OFF ratio is high. Based on the experiments, we draw the conclusion that the gate voltage can enhance the drain current, and the electric field by the drain voltage affects the amorphous-amorphous transition. The switching device always contains the amorphous state and never exhibits the Ohmic behavior of the crystalline state.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.08a
• /
• pp.280-281
• /
• 2011

We fabricated the devices of TFT type with the amorphous chalcogenide channel. A single device consists of a Pt source and drain, a Ti glue layer and a GeSe chalcogenide channel layer on SiO2/Si substrate which worked as the gate. We confirmed the drain current with variations of gate bias and channel size. The I-V curves of the switching device are shown in Fig. 1. The channel of the device always contains amorphous state, but can be programmed into two states with different threshold voltages (Vth). In each state, the device shows a normal Ovonic switching behavior. Below Vth (OFF state), the current is low, but once the biasing voltage is greater than Vth (ON state), the current increases dramatically and the ON-OFF ratio is about 4 order. Based on the experiments, we contained the conclusion that the gate voltage can enhance the drain current, and the electric field by the drain voltage affects the amorphous-amorphous transition. The switching device always contains the amorphous state and never exhibits the Ohmic behavior of the crystalline state.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.9
• /
• pp.697-700
• /
• 2011

Thin-film transistors(TFTs) with magnesium zinc tin oxide(MZTO) channel layer are fabricated by solution-process. The threshold voltage (Vth) shifted toward positive directly with increasing Mg contents in MZTO system. Because the Mg has a lower standard electrode potential (SEP) than Sn, Zn, thus degenerate the oxygen vacancy ($V_O$). As a result, the Mg act as carrier suppressor and oxygen binder in the MZTO as well as a Vth controller.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.43 no.10 s.352
• /
• pp.61-67
• /
• 2006

We developed a constant current source which is insensitive to threshold voltage variation caused by irregular grain boundary distribution in polycrystalline silicon. The proposed current source has superior saturation characteristics over wide range of input voltages as well as small current error compared to the previously reported Vth compensated sources. We measured the circuit performance and error in current due to parameter variation by using HSPICE.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2003.07a
• /
• pp.881-884
• /
• 2003

We propose a new pixel structure for Active Matrix OLED (AMOLED). The proposed pixel structure can display full color images by compensating threshold voltage (Vth) variation of driving TFTs. And we obtain an improved contrast ratio(C/R) of higher than 600:1

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.10
• /
• pp.25-32
• /
• 2011

We have analyzed adjacent cell dependency of threshold voltage shift caused by the cell to cell interference, and we proposed a 3-adjacent-cell model to model the pattern dependency of the threshold voltage shift. The proposed algorithm is verified by using MATLAB simulation and measurement results. In the experimental results, we found that accuracy of the proposed simple 3-adjacient-cell model is comparable to the widely used conventional 8-adjacient-cell model. The Bit Error Rate (BER) of LSB and of MSB is improved by 28.9% and 19.8%, respectively, by applying the proposed algorithm based on 3-adjacent-cell model to 20nm-class 2-bit MLC NAND flash memories.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.1105-1108
• /
• 2003

In this paper, we have fabricated the hydrogenated n-channel polysilicon thin film transistor (TFT) with LDD structure and have analyzed the hot carrier degradation characteristics by electrical stress. We have compared the threshold voltage (Vth), sub-threshold slope (S), and trans-conductance (Gm) for devices with LDD (Lightly Doped Drain) structure and non-LDD at same active sizes. We have analyzed the hot carrier effects by the hydrogenation in devices. As a analyzed results, the threshold voltage, sub-threshold slope for n-channel poly-si TFT were increased, trans-conductance was decreased. The effects of hydrogenation in n-channel poly-si TFT with LDD structure were shown the lower variations of characteristics than devices of the non-LDD structure with nomal process.