• Current Applied Physics
• /
• 제18권11호
• /
• pp.1248-1254
• /
• 2018

Magnetization versus temperature and magnetic-field measurements, M(T, $H_a$), have been carried out to study the magnetic and critical properties of polycrystalline $La_{1-x}Ba_xCoO_3$ (x = 0.3 and 0.5) cobaltites. These compounds with the density of ${\sim}6.2g/cm^3$ crystallized in the $R{\bar{3}}c$ rhombohedral and $Pm{\bar{3}}m$ cubic structures, respectively. With an applied field $H_a=200Oe$, M(T) data have revealed that the samples with x = 0.3 and 0.5 exhibit the ferromagnetic-paramagnetic (FM-PM) phase transition at the Curie temperature points $T_C=202$ and 157 K, respectively. At 4.2 K, the saturation magnetization ($M_{sat}$) decreases from 35.9 emu/g for x = 0.3-26.1 emu/g for x = 0.5. Particularly, the critical-behavior analyses in the vicinity of $T_C$ reveal all samples undergoing a second-order phase transition, with critical exponent values (${\beta}=0.328$ and ${\gamma}=1.251$ for x = 0.3, and ${\beta}=0.331$ and ${\gamma}=1.246$ for x = 0.5) close to those expected for the 3D Ising model. This proves short-range magnetic order existing in $La_{1-x}Ba_xCoO_3$. We believe that magnetic inhomogeneities due to the mixture of hole-rich FM regions (confined in the trivalent-cobalt hole-poor anti-FM matrix) and uniaxial anisotropy prevent long-range order in $La_{1-x}Ba_xCoO_3$.

• Journal of Microbiology and Biotechnology
• /
• 제2권2호
• /
• pp.135-140
• /
• 1992

The partitioning of recombinant human interleukin-2(rhII-2) in PEG 8000-dextran 38800 aqueous two-phase system has been investigated using three different sources of rhIL-2. In the case of pure rhIL-2, the solubility in a PEG-dextran two-phase system was low and most of rhIL-2 was partitioned into the bottom phase. For the recovery of rhIL-2 from insoluble protein aggregates, the inclusion bodies of recombinant E. coli were solubilized by the treatment with sodium dodecyl sulfate (SDS). The addition of SDS significantly enhanced not only the solubility of rhIL-2 but also the partitioning of rhIL-2 to the top phase. When the ratio of SDS to rhIL-2 was 2.0, the partition coefficient(K) and the recovery yield(Y) at the top phase were 4.5 and 88%, respectively, at pH 6.8. In order to reduce the recovery steps further, SDS was directly added to the intact recombinant E. coli cells and then partitioned into the PEG/dextran aqueous two-phase system. The observed partition coefficient ($K{\cong{3.0$) and recovery yield ($Y{\geq}80%$ )of this method were comparable to the rhIL-2 recovery from insoluble protein aggregates. The results obtained in this work indicate that PEG-dextran two-phase partitioning might provide a simple way for the recovery and partial purification of recombinant proteins which are produced as inclusion bodies.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2008년도 International Meeting on Information Display
• /
• pp.1381-1382
• /
• 2008

Cholesteric Blue phase (ChBP) is constructed by the regular arrangement of the double helix, whereas the Smectic Blue phase (SmBP) has the inter-connected multi-lamellar structure. Orientation fluctuations of polymer stabilized ChBP and spontaneously super-cooled SmBP are discussed. Spatial topology of the defects play key role on the dynamic properties.

• Journal of Power Electronics
• /
• 제19권2호
• /
• pp.333-343
• /
• 2019

Dead time and the nonideal characteristics of components all lead to phase voltage distortions. In order to eliminate the harmful effects caused by distortion, numerous methods have been proposed. The efficacy of a method mainly depends on two factors, the compensation voltage amplitude and the phase current polarity. Theoretical derivations and experiments are given to explain that both of these key factors can be deduced from the compensation time, which is defined as the error time between the ideal phase voltage duration and the actual phase voltage duration in one Pulse Width Modulation (PWM) period. Based on this regularity, a novel method for compensating phase voltage has been proposed. A simple circuit is constructed to realize the real-time feedback of the phase voltage. Utilizing the actual phase voltage, the compensation time is calculated online. Then the compensation voltage is derived. Simulation and experimental results show the feasibility and effectivity of the proposed method. They also show that the error voltage is decreased and that the waveform is improved.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 추계학술대회
• /
• pp.241-244
• /
• 2006

The present paper describes the scale effect correction method for wind turbine by using CFD(computational fluid dynamics). For the correct ions of wind turbine scale effect, various researches on the helicopter rotor scale effect were Investigated and feasibility study of methods was performed to correct wind turbine scale effect The present paper also introduces new scale effect correction method based on two dimensional lift slope modification. In order to test the Present method, performance analyses of NREL Phase VI wind turbines under various scale conditions were carried out by using CFD. The present method showed reasonable results when applied to NREL Phase VI wind turbine.

• Journal of Power Electronics
• /
• 제13권3호
• /
• pp.469-478
• /
• 2013

This paper proposes a novel scheme for the current controller for the grid-side converter (GSC) of permanent-magnet synchronous generator (PMSG) wind turbines to eliminate the high-order harmonics in the grid currents under grid voltage disturbances. The voltage unbalance and harmonics in three-phase systems cause grid current distortions. In order to mitigate the input current distortions, multi-loop current controllers are applied, where the positive-sequence component is regulated by proportional-integral (PI) controllers, and the negative-sequence and high-order harmonic components are regulated by proportional-resonance (PR) controllers. For extracting the positive/negative-sequence and harmonic components of the grid voltages and currents without a phase delay or magnitude reduction, composite observers are applied, which give faster and more precise estimation results. In addition, an active damping method using PR controllers to damp the grid current component of the resonant frequency is employed to improve the operating stability of VSCs with inductor-capacitor-inductor (LCL) filters. The validity of the proposed method is verified by simulation and experimental results.

• 품질경영학회지
• /
• 제37권3호
• /
• pp.83-93
• /
• 2009

This study proposes a stepwise approach to product safety management(PSM), of which roadmap consists of five phases. ISO 9001 QM model is assumed as the first-phase model and each higher-phase model is built by adding a corresponding module to the lower one. In the phase order, those modules are CCMS, a failure to warn, manufacturing defect and design defect. The progress in PSM of a domestic food company is discussed.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2014년도 전력전자학술대회 논문집
• /
• pp.132-133
• /
• 2014

This paper presents an algorithm for an active power filter which can be used in both single-phase and three-phase electric system. The proposed algorithm focuses on the extraction of harmonic component of load current in each phase and in order to verify the validity of the proposed algorithm while loads are nonlinear, simulations have been done by PLECS software and tested by typhoon-HIL which is real time emulator.

• 대한설비공학회지:설비저널
• /
• 제10권1호
• /
• pp.12-21
• /
• 1981

The Enthalpy Model was verified in order to analyze two- dimensional phase change problems. By using the Enthalpy Model, interface locations, frozen fraction rates, heat flux distribution rut cooled surfaces, and surface-integrated heat flux were purely numerically calculated in rectangular thermal storage units, whose initial condition was saturated liquid and phase change material was cooled on its boundaries by convective heat transfer. The calculations were performed for various Stefan numbers and Biot numbers. The effect on those dimensionless numbers were explained.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 B
• /
• pp.807-808
• /
• 2006

This paper covers start-up characteristic of three phase induction motor. When three phase induction motor is started, the inrush current occurs. There are several ways of reducing starting current of a three phase motor. In this paper will explain and propose the types of part windings in order to reduce the starting current.