• Journal of Korean Society of Water and Wastewater
• /
• v.9 no.4
• /
• pp.107-114
• /
• 1995

The raw drinking water quality is getting worse because of the winter drought and the conventional treatment system is'nt suitable to obtain the satisfied quality of water. So, the advanced water system, BAC(Biological Activated Carbon) process is said to be effective to remove dissolved organics and ammonia nitrogen. In our study, the BAC pilot plant using Nak-dong river water is tested in low temperature. Following results are found from the study. The ammonia nitrogen removal rate of BAC system using wood-based carbon (PICABIOL) was 99% in $6^{\circ}C$ temperature. Chlorine dosage in wood-based BAC effluent was reduced to 67% of that in sand filtered wate. It resulted from the removal of ammonia nitrogen. Also, THM formed by chlorine addition in wood-based BAC effluent was decreased to 65% of that in sand filtered water. In the case of dual-filter, the removal efficiency of ammonia nitrogen was increased 30% more than in conventional sand filter. According to this result, the ammonia nitrogen load to BAC system could be lessened by the use of dual-filter.

• Journal of Korean Society of Water and Wastewater
• /
• v.21 no.3
• /
• pp.273-278
• /
• 2007

Modern society has moved from a phosphorus recycling loop, where animal manure and human wastes were spread on farming land to recycle nutrients, to a once-through system, where phosphates are extracted from mined, non-renewable phosphate rock and end up either in landfill(sewage sludge, incinerator ash) or in surface waters. In this research, crystallization of nitrogen and phosphate with natural sources of $Mg^{2+}$ in synthetic water was tested. The operational parameters of pH, mixing time, and the magnesium molar ratio were investigated to find optimal conditions of the MAP precipitation using synthetic wastewater. The removal efficiency of phosphate increased with pH up to 11. By MAP precipitaiton of the synthetic waste water, 94% of the phosphate were eliminated at pH 11. It was found that at least 10 minutes mixing time was required and 20 minutes mixing time was recommended for efficient phosphate removal. High efficiency removal of phosphate was possible when the magnesium molar ratio was 1.0~2.0. The comparative study of different magnesium sources showed that coagulants (PAC) was the more efficient sources than only magnesium. The result showed that 97% of phosphate removal. In conclusion, coagulants (PAC) induced crystallization of struvite and hydroxyapatite was shown to be a technically viable process that could prove cost effective for removing phosphate in wastewater.

• Journal of Korean Society of Water and Wastewater
• /
• v.28 no.4
• /
• pp.391-396
• /
• 2014

Ultrapure water (UPW) is water containing nothing but water molecule ($H_2O$). The use of UPW is increasing in many industries such as the thermal and nuclear power plants, petrochemical plants, and semiconductor manufacturers. In order to produce UPW, several unit processes such as ion exchange, reverse osmosis (RO), ultraviolet (UV) oxidation should be efficiently arranged. In particular, RO process should remove not only ions but also low molecular weight (LMW) organic matters in UPW production system. But, the LMW organic matter removal data of RO membranes provided by manufacturers does not seem to be reasonable because they tested the removal in high concentration conditions like 1,000 ppm of isopropyl alcohol (IPA, MW=60.1). In this study, bench-scale experiments were carried out using 4-inches RO modules. IPA was used as a model LMW organic matter with low concentration conditions less than 1 ppm as total organic carbon (TOC). As a result, the IPA removal data by manufacturers turned out to be trustable because the effect of feed concentration on the IPA removal was negligble while the IPA removal efficiency became higher at higher permeate flux.

• Journal of Korea Water Resources Association
• /
• v.32 no.5
• /
• pp.593-601
• /
• 1999

The knowledge about structure of the velocity in the stream IS essential in the investigation of stream meandering, erosion and sediment transport, and dispersion of pollutants in the stream. In this study, theoretical velocity profile model in which transverse profile of the longitudinal velocity in the stream can be predicted using stream hydraulic data was developed. The proposed model was tested with the measured velocity data of the Nakdong river. The result shows that the numerical model simulates properly the general shalxc of the measured velocity profiles. The simulated profiles agree well with measurements, especially in the aspects of skewness and flatness.atness.

• Water for future
• /
• v.18 no.2
• /
• pp.143-152
• /
• 1985

A method is suggested for the reappearance of a surface runoff hudorgraph of a river basin by linking the hydrologic response of a catchment represented by the instantaneous unit hydrograph(IUH) with the Horton's empirical gemorphologic laws. The geomorphologic theory of the IUH developed by G. Itrube et al. and the geomorphoclimatic theory of the IUH developed by Bras et al. are used to derive the new hydrologic response function in consideration of geomorphologic parameters and climatic characteristics by applying to Sukekawa's rainfall-runoff model. The derived response function was tested for on some observed hydrographs in a natural watershed and showed promising, and by considering a drainage basin as m(1∼4) identical linear reservoir in series, it was founded that the model(m=2) is most applicable to predict hydrologic response regardless of the size of basins. A modelization algorithm of a basin using Sthahler's ordering scheme of drainage network will give good result in analysis of the surface runoff huydrograph by the method of this study.

• Conservation Science in Museum
• /
• v.9
• /
• pp.51-58
• /
• 2008

Influence of lighting for exhibition normally used in museum on discoloration of relics and weakening of materials was reviewed, and influence of currently used lightings discoloration of dyed Korean paper similar to relic and change of material quality was directly tested. There were small differences in influence made on dyed Korean paper according to exhibition lighting, and based on these differences, method to select lighting safer for relics were explored. As a result of testing 4 types of fluorescent lamps, one lamp of them showed little influence on discoloration and change of material quality, which is judged to be proper for use in museum.

• Journal of Energy Engineering
• /
• v.14 no.3 s.43
• /
• pp.180-186
• /
• 2005

As an engine has a wide range of RPM $(3000\~12000\;RPM)$, variable control system is necessary in order to increase engine performance. SCV has been frequently referred to as a possible way to increase engine performance at low RPM. The purpose of this study is to investigate on the influence of SCV, specially at the range of lower revolution, in a high-speed small engine. Experiments were conducted on 4 Valves SOHC/air-cooling single cylinder engine and SCV shapes have been tested fur swirl intensity, the performance of power, fuel consumption and emission. As a result, we find to use SCV range be below 5000 RPM which fuel consumption decreased $9\%$.

• Proceedings of the KSRS Conference
• /
• 1999.11a
• /
• pp.343-348
• /
• 1999

Delineation of watersheds is one of the most basic steps for water resource management and National Park management. The purpose of this study is to investigate how to utilize Thematic Mappers scenes to compare watersheds created by running a model with those produced by digitizing topographic maps of Keum River basin. A methodology is designed and tested using Geographic Information Systems (GIS) and remote sensing to map areas with various thematic maps. A CAD data on watersheds from the Decision Support system for Water Quality is converted into GIS format. The digital elevation model with 100-meter resolution is used to create watershed by cumulative watershed method. TM scenes are also classified by new procedures including stacking method, NDVI, NDWI, and unsupervised classification methods. To evaluate the relative correctness Kyerongsan National Park was studied intensively whose area was divided into 6 watersheds in both cases. The boundaries of watershed from the model are less correct than those of the topographic maps. This result shows that automated watershed creating system needs higher-resolution digital elevation model than 100-meters.

• Proceedings of the KSRS Conference
• /
• 2005.10a
• /
• pp.445-449
• /
• 2005

Various methods to detect the phytoplankton/red tide blooms in the oceanic waters have been developed and tested on satellite ocean color imagery since the last two and half decades, but accurate detection of blooms with these methods remains challenging in optically complex turbid waters, mainly because of the eventual interference of absorbing and scattering properties of dissolved organic and particulate inorganic matters with these methods. The present study introduces a new method called Red tide Index (Rl), providing indices which behave as a good measure of detecting red tide algal blooms in high scattering and absorbing waters of the Korean South Sea and Yellow Sea. The effectiveness of this method in identifying and locating red tides is compared with the standard Ocean Chlorophyll 4 (OC4) bio-optical algorithm applied to SeaWiFS ocean imagery, acquired during two bloom episodes on 27 March 2002 and 28 September 2003. The result revealed that OC4 bio-optical algorithm falsely identifies red tide blooms in areas abundance in colored dissolved organic and particulate inorganic matter constituents associated with coastal areas, estuaries and river mouths, whereas red tide index provides improved capability of detecting, predicting and monitoring of these blooms in both clear and turbid waters.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2005.05a
• /
• pp.69-72
• /
• 2005

Recently, there have been many studies seeking towards the utilization of cementitious powder from concrete waste as recycle cement. However, most of the studies actually have been researches about the reuse of mortar or paste, not concrete waste. In fact, either mortar or paste is quite different from a real concrete waste in terms of age and mixture. Thus the purpose of this study is to examine basic physical properties of recycle cement, manufactured with cementitious powder from concrete waste, and analyze differences in chemical and hydraulic properties of the cement and its tested model. As a result of the chemicai analysis, recycle cement is composed mainly of CaO and SiO2, and that it is even lower in the content of CaO than Portland cement, which is also supported by previous studies. But, Differently from previous studies, plastic working at the temperature of 650 was found an optimal condition under which cementitious powder from concrete waste could restore its hydraulic properties.