• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.26 no.2
• /
• pp.111-117
• /
• 1990

The hydraulic line haulers are now widely used to haul the main line, but the other hauling operations are still done manually in most pot fisheries. The oval type hooks which are connected between the loops and the post are tested for basic capability by the universal tension meter in order to develop the automatic separating system. The pots attached to the oval type hooks are separated automatically from the loops while the oval type hooks are running through the trumpet separator with the side roller and the results are as follows: 1. The tension of the large oval hooks (ø3.1mm) for missing pots and the compressive load at the end of hooks by hand are about 60kg and 6kg, and range of tension for passing through the trumpet is 11~15kg. 2. Automatic separating ratio of the pots with the large oval hooks is about 99% when the trumpet separator is attached to front or rear of the side roller in the laboratory. 3. The separating ratio of the pot with the large oval hooks while hauling operation in the sea is about 97% when the trumpet separator is oriented on the port bulwark departed 2m from the side roller.

• Land and Housing Review
• /
• v.7 no.4
• /
• pp.281-289
• /
• 2016

Structural experiment result showed that PHC(d=600mm) Pile used as a common compression member could resist 83.6 ~ 91.6 tonf of ultimate tension force, if the adhesion of P.C. bar of PHC pile to the concrete foundation is strengthened. Considering a proper safety factor to ultimate tension strength, PHC pile can substitute the anti-floating anchor, or reduce the number of anchors. For this purpose, pullout resistance behavior of a Bored pile embedded in real ground as well as structural tension strength of PHC pile must be evaluated. This study performed the static pullout tests to evaluate the pullout behavior of bored pile, and compared the test results with design value of side resistance. To evaluate the pullout resistance easily, static pullout test results were compared with dynamic loading test results using PDA. As a result, cement paste of the bored pile was hardened which is after 15 days, LH side resistance design value corresponded well to the Static pullout test results, also to the side resistance evaluated by dynamic loading test.

• Journal of Korean Medicine Rehabilitation
• /
• v.29 no.1
• /
• pp.21-29
• /
• 2019

Objectives This study is designed to verify the effectiveness of electroacupuncture (EA) on both side acupuncture point GB12, GB20 for chronic tension type headache (CTTH). Methods Subjects aged 18-65 years who had suffered from CTTH for more than 3months were recruited from September 2016 to May 2017. Thirty subjects were voluntarily recruited and they were randomly divided into 2 groups; 15 to EA group, another 15 to sham-EA group. The treatment sessions were performed every 2-4 days for a total of three sessions over 1 week. The symptoms of headache were assessed before the treatment and after a week from the last treatment by visual analogue scale (VAS), headache frequency (HF), Korean Headache Impact Test-6 (KHIT-6). Demographic characteristics of all participants were compared between the groups upon using chi-square test. Wilcoxon signed rank test was used to evaluate the values between baseline and follow-up. Wilcoxon rank sum test was performed to evaluate the differences between groups. p-values less than 0.05 were considered as significant. Results Before and after the intervention, no difference in VAS and KHIT-6 was observed between groups. HF of EA group decreased significantly compared with that of sham-EA group. Within the EA group VAS, HF and KHIT-6 decreased significantly after the treatment. Meanwhile, only KHIT-6 decreased significantly after the treatment in sham-EA group. Conclusions This study suggests that EA on both side acupuncture point GB12 and GB20 is applicable to improve symptoms in patients with CTTH.

• Ocean Systems Engineering
• /
• v.3 no.4
• /
• pp.275-294
• /
• 2013

Side-by-side offloading operations are widely utilized in engineering practice. The hydrodynamic interactions between two vessels play a crucial role in safe operation. This study focuses on the coupled effects between two floating bodies positioned side-by-side as a shuttle tanker-FPSO (floating production, storage and offloading) system. Several wave directions with different side-by-side distances are studied in order to obtain the variation tendency of the horizontal hydrodynamic coefficients, motion responses and mean drift forces. It is obtained that the coupled hydrodynamics between two vessels is evidently distinguished from the single body case with shielding and exaggerating effects, especially for sway and yaw directions. The resonance frequency and the peak amplitude are closely related with side-by-side separation distance. In addition, the horizontal hydrodynamics of the shuttle tanker is more susceptible to coupled effects in beam waves. It is suggested to expand the gap distance reasonably in order to reduce the coupled drift forces effectively. Attention should also be paid to the second peaks caused by hydrodynamic coupling. Since the horizontal mean drift forces are the most mainly concerned forces to be counteracted in dynamic positioning (DP) system and mooring system, prudent prediction is beneficial in saving consumed power of DP system and reducing tension of mooring lines.

• The Journal of Korean Physical Therapy
• /
• v.21 no.4
• /
• pp.9-16
• /
• 2009

Purpose: This study was done to assess the effect of changes in forward head posture (FHP), neck mobility and headache clinical parameters on episodic tension-type headache (ETTH) and chronic tension-type headache (CTTH) who did craniocervial exercises. Methods: Twelve CTTH subjects and twelve ETTH subjects were studied. Side-view pictures of subjects were taken in both sitting and standing positions, in order to assess FHP by measuring the craniovertebral angle. Cervical range of motion (CROM) was employed to measure cervical mobility. A headache diary was kept to assess headache intensity, frequency, and duration. All subjects did three types of craniocervical exercise over 8 weeks. Measurements were done at pre-treatment, and at 4 and 8 weeks post-treatment. Results: Forward head posture and headache-related clinical parameters showed a significant improvement after craniocervical exercise (p<0.05). Flexion/extension and left/right rotation of CROM was significantly increased after the intervention (p<0.05), whereas changes in left/right bending did not reach statistical significance. Conclusion: This study indicates that craniocervical exercise may be effective in the management of tension-type headache.

• The Journal of Korean Physical Therapy
• /
• v.21 no.2
• /
• pp.71-77
• /
• 2009

Purpose: This study assessed the differences in the forward head posture (FHP), cervical range of motion, and headache clinical parameters in episodic tension-type headache (ETTH) subjects, chronic tension-type headache (CTTH) subjects, and healthy controls (university students). Methods: Fifteen CTTH subjects, 15 ETTH subjects and 15 controls without headache were examined. Side-view images of each group were taken in both the sitting and standing positions, in order to assess the FHP by measuring the craniovertebral angle. The CROM was used to measure the cervical range of motion. A headache diary was kept for 4 weeks to assess the headache intensity, frequency, and duration. Results: The craniovertebral angle was smaller, ie, there was a greater FHP, in the CTTH and ETTH subjects than in the healthy controls in both the sitting and standing positions (p<0.05). The CTTH and ETTH subjects showed a lower cervical range of motion than the healthy controls in the total range of motion as well as in the half-cycles (p<0.05). Conclusion: The increased FHP and decreased cervical range of motion might be a contributing factor in the initiation of tension-type headache.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.50 no.3
• /
• pp.233-243
• /
• 2014

The difference of mooring tension by type of buoy was investigated in the circulating water channel and the wave tank for deducting the most stable buoy from the current and the wave condition. 5 types of buoy made up of short cylinder laid vertically (CL-V), short cylinder laid horizontally (CL-H), capsule (CS), sphere (SP) and long cylinder (CL-L) were used for experiments. A mooring line and a weight were connected with each buoy. A tensile gauge was installed between a mooring line and a weight. All buoy's mooring tension was measured at the same time for the wave test with periods of 1.5~3.0 sec and wave heights of 0.1~0.3 m, and the current test with flow speeds of 0.2~1.0 m/sec. As a result, the order of tension value in the wave test was CL-H > CL-V > SP > CS > CL-L. In the current test CL-V and CL-H were recorded in the largest tension value, whereas SP has the smallest tension value. So it seems that SP buoy is the most effective in the location affected by fast current. CS is predicted to be suitable for a location that influence of wave is important more than that of current if practical use in the field is considered. And it was found that the difference of mooring tension among buoys in wave is related to the product of the cross sectional area and the drag coefficient for the buoy's bottom side in high wave height. The factor for the current condition was not found. But it was supposed to be related to complex factors like a dimension and a shape by buoy's posture to flow.

• Journal of the Korean Institute of Gas
• /
• v.12 no.2
• /
• pp.18-24
• /
• 2008

This paper presents the stress and deformation behaviors of 9% nickel steel inner tank in a full containment LNG storage tank using a FE analysis. For an increased strength safety of an inner tank, the tension cable was fastened around the outside wall of an inner tank, which is known as a weak zone for the hydrostatic pressures, cryogenic temperature loads, and other loadings. Based on the FEM computed results between a conventional inner tank and a inner tank with tension cables around the lower part of the side wall of an inner tank, the redesigned inner tank is more safe than that of the conventional tank without a tension cable. The FEM results recommend $3{\sim}4$ steel tension cables with a diameter of 50mm for an increased strength safety of the inner tank, which may decrease the stress concentration and deformation near the lower part of the side wall. Thus the tension cable around the inner tank may be used as an alternative safety device compared to the stiffener and the top girder structures for the increased LNG storage tank, especially.

• The korean journal of orthodontics
• /
• v.28 no.5 s.70
• /
• pp.699-716
• /
• 1998

This study was designed to evaluate the expression of non-collagenous protein in periodontal tissue during the experimental movement of rat incisors, by LSAB(labelled streptavidine biotin) immunohistochemical staining for osteonectin and osteocalcin. Twenty seven Sprague-Dawley rats were divided into a control group(3 rats) and 6 experimental groups(24 rats) where 75g of force was applied from helical springs across the maxillary incisors. Rats of experimental groups were sacrificed at 12 hours, 1, 4, 7, 14 and 28 days after force application, respectively. And the tissues of a control group and experimental groups were studied immunohistochemically and histologically. The results were as follows : 1. Until 28 days after force application, periodontal fibers had been strectched on tension side and compressed in pressure side of all the experimental groups, and the arrangement of periodontal fibers had not been recovered yet. 2. The expression of osteonectin in control group was rare in dentin, cementum and osteocyte, and was mild in odontoblasts and matrix of alveolar bone. 3. The expression of osteocalcin in control group was negative in gingiva, osteoblasts, osteocyte and cementum, and was rare in predentin, capillaries in pulp and periodontal ligament and the matrix of alveolar bone. 4. There was no difference in the expression of osteocalcin or osteonectin in dentin, cementum, pulp, odontoblasts, between of control and of experimental groups. 5. The expression of osteonectin in intermaxillary suture got the peak in 7-day and was declined after 14-day. The expression of osteocalcin remained in a same degree since it became mild in 14-day. 6. The expression of osteonectin in pressure side of periodontal ligament of experimental group was rare, which was similar to control group. But in tension side, it was increased until 14-day aftrer which it was declined. 7. The expression of osteocalcin in periodntal ligament was rare in 12-hour to 14-day, but became severe in 28-day, which was greater in tension side than in pressure side, and in the periodontal fiber next to alveolar bone than to tooth surface. 8. The expression of osteocalcin in alveolar bone was rare until 14-day in pressure side, but became moderate in 28-day. The expression of osteonectin was increased from 7-day by time dependency, which was greater in tension side than in pressure side.

• Journal of International Academy of Physical Therapy Research
• /
• v.3 no.2
• /
• pp.475-478
• /
• 2012

The purpose of this study is to identify the level of masseter muscle tension according to the levels of restricted movement and pain in the temporomandibular joint(TMJ), thereby verifying the fact that excessive masseter muscle tension can be a cause for restricted movement and pain in the TMJ. The subjects of this study were 81 men and women in their 20s and 30s, who feel uncomfortable with their masticatory function on the preferred chewing side. The subjects were measured in terms of the range of motion (ROM) and deviation of the TMJ and the degree of pain in the affected region. The ROM and deviation of the TMJ were measured using the Global Posture System(GPS) after instructing each subject to open his/her mouth to the fullest and taking photos of the subject with a digital camera. The tension of the masseter muscle was measured with a Pressure Threshold Meter(PTM). After the measurements, in order to compare the ROM of the TMJ, the subjects were divided into two groups based on the ROM of above 35mm and below 35mm. For the deviation and pain, based on the average of total subjects, the subjects were divided into two groups of above and below average. Thereafter, the levels of masseter muscle tension were compared between each pair of groups. According to the results, when each variable was compared between the respective two groups, in terms of the deviation, the pressure pain threshold(PPT) of the masseter muscle revealed a statistically significant difference(p<.05). However, the ROM and pain showed no statistically significant difference. Consequently, masseter muscle tension may cause restricted movement in the TMJ. In particular, the deviation and tension in the masseter muscle is considered to be a factor that causes deviation in the TMJ.