• Proceedings of the Korean Geotechical Society Conference
• /
• 1991.10a
• /
• pp.108-122
• /
• 1991

For the tunnel pattern of PD-3, a numerical analysis using the FEM program, MrSoil, was conducted with given geotechnical properties of surrounding rockmasses to verify the analysis results by comparing with other programs. The analyzed domain was extended to the far enough distance from the excavation surface to avoid the restrained effect by the boundary condition, and the construction sequence was employed in the analysis as calculation steps to simulate the time dependent 3 dimentional behavior of surrounding ground due to tunneling. Maximum 35 mm of the tunnel crown settlement and about 13 mm of the surface settlement were computed and the amount of settlement may not give any structural damage on the concrete structures on the ground surface. The shotcrete stress of 84 kg/cm2 and the rockbolt axial force of 9 ton as a maximum are within the allowable limit. The plastic zone was restricted near the excavation surface, but forepoling around the crown may be required to prevent rock falling. It is believed that the tunnel is designed reasonablely from the economical and safety points of view.

• Journal of the Korean Geotechnical Society
• /
• v.30 no.4
• /
• pp.21-34
• /
• 2014

This paper studies the time-dependent behaviors of tunnel and surrounding ground due to tunnel deterioration. In the first part, the literature on deterioration characteristics of tunnels was reviewed. In the second part, a numerical analysis was performed to investigate the behavior of concrete lining on the typical section of Korean high-speed rail tunnel (weathered rock) after determination of input variables related to deterioration impact. The result shows that the settlement at the crown of tunnel and surface ground increased up to 7.0% and 30.2% of the total settlements during construction stage, respectively, and the internal convergence reduction of 9.0 mm for concrete linings was generated within 30 years after completion of tunnel construction. Also the loosening height increased up to 2.55 times of tunnel height within 50 years, which is higher than that of Terzaghi's recommendation on ultimate state. Due to this process of extending zones, it is found that additional loads were applied to concrete lining with the axial stress about 3.20~3.66 MPa, which accelerates tunnel deterioration. Finally the quantitative design approach to evaluate time-dependent behavior of lining and surrounding ground due to tunnel deterioration was proposed.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.20 no.2
• /
• pp.157-164
• /
• 2007

The prediction of the temperature distribution change of the spent nuclear fuel disposal canister and its surrounding structures (bentonite buffer, granitic rock etc.) due to the spent fuel heat is very important for the design of the 500m deep granitic repository for the spent nuclear fuel disposal canister (about 10,000 years long) deposition. In this study, the temperature distribution change of the composite structure which comprises the canister, the bentonite buffer, the deposition tunnel due to the spent fuel heat is computed using the numerical analysis method. Specially, the temperature distribution change of the composite structure is analysed as the deposition time elapses up to m years. The analysis result shows that the temperature of each part of the repository increases slowly in different way but the latest part temperature increases slowly up to 150 years and thereafter decreases slowly.

• Journal of Environmental Impact Assessment
• /
• v.19 no.2
• /
• pp.107-116
• /
• 2010

In this research potential liquation of contaminants from surrounding soil to a reservoir in an island was studied to investigate the cause and route of contamination of Baengyeong-myeon reservoir. Soil of Baengyeong-myeon reservoir consists of $SiO_2$ and has a high iron content because of geological characteristics of its country rock. From the field investigation and simulation study it was found that highly accumulated carbon content in the reservoir sediment was incurred from ground water, which provides a good habitat for microbes. And the liquation, the cause of organics growth, occurs mainly on the bottom of the reservoir consisting marine clay layer once used as farmland. So dredging of the sediment of reservoir and replacing with valley soil is suggested to prevent continuous contamination of a reservoir in an island due to COD production.

• Geomechanics and Engineering
• /
• v.18 no.4
• /
• pp.439-448
• /
• 2019

The bearing capacity of roadside support is the key problem in gob-side entry retaining technology. To study the cooperative bearing characteristics of the roof-roadside support-floor along the gob-side entry retaining, a mechanical model of the composite structure of the roof-roadside support-floor was first established. A method for determining the structural parameters of gob-side entry retaining was then proposed. Based on this model, adaptability analysis of roadside support was carried out. The results showed that the reasonable width of the gob-side entry roadway was inversely proportional to the mining height, and directly proportional to the bearing strength of the roof and floor. And the reasonable width of the "flexible-hard" roadside support was directly proportional to its own strength, and inversely proportional to the width of the gob-side entry retaining. When determining the position and size of the roadside support along the gob-side entry retaining, the surrounding rock environment should be fully considered. Measured results from case study also show the rationality of the model and calculation method.

• Economic and Environmental Geology
• /
• v.33 no.6
• /
• pp.469-489
• /
• 2000

The hydrogeochemical and isotopic studies on deep groundwater (below a 550 m depth from the ground surface) in the Munkyeong area, Kyeongbuk province were carried out. Two types of deep groundwater (${CO_2}$-rich groundwater and alkali groundwater) occur together in the Munkywong area. ${CO_2}$-rich groundwater (Ca-${HCO_3}$ type) is characterized by low pH (5.8~6.5) and high TDS (up to 2,682 mg/L.), while alkali groundwater (Na-${HCO_3}$ type) shows a high pH (9.1~10.4) and relatively low TDS (72~116 mg/L). ${CO_2}$-rich water may have evolved by ${CO_2}$ added at depth during groundwater circulation. This process leads to the dissolution of surrounding rocks and Ca, Na, Mg, K and ${HCO_3}$ concentrations are eniched. The low $Pco_2$ ($10^{-6.4}$atm) of alkali groundwaters seems to result from the dissolution of silicate minerals without a supply of ${CO_2}$. The ${\delta}^{18}O$ and ${\delta}^D$values and tritium data indicate that two types of deep groundwater were both derived from pre-thermonuclear meteoric water and have evolved through prolonged water-rock interaction. The carbon isotope data show that dissolved carbon in the ${CO_2}$-rich water was possibly derived from deep-seated ${CO_2}$ gas, although further studies are needed. The ${\delta}^{34}S$ values of dissolved sulfate show that sulfate reduction occurred at great depths. The application of various chemical geothermometers on ${CO_2}$-rich groundwater shows that the calculated deep reservoir temperature is about 130~$l75^{\circ}C$. Based on the geological setting, water chemistry and environmental isotope data, each of the two types of deep groundwater represent distinct hydrologic and hydrogeochemical evolution at depth and their movement is controlled by the local fracture system.

• Tunnel and Underground Space
• /
• v.25 no.4
• /
• pp.383-396
• /
• 2015

It is analyzed the risk of building damage due to ground surface subsidence occurred during constructing a tunnel below buildings in sand-gravel layer. The overburden and the thickness of sand-gravel layer is about 20m and the width and the height of the tunnel are 12m and 8.6m, respectively. The tunnel is pre-reinforced by umbrella method with three rows of long steel pipes and grouting. Surface subsidence is measured at 36 points surrounding buildings and measured data are used to calculate optimized three dimensional subsidence surface. Depending on the building location, deflection ratio and horizontal strain are calculated to evaluate the risk of building damage. No damage occurs at the buildings because of both the small deflection ratios involved 1~4mm subsidence and compressive horizontal strains.

• Journal of the Korean earth science society
• /
• v.30 no.1
• /
• pp.49-57
• /
• 2009

We studied a structure of the Kunsan basin in the Yellow Sea using ship-borne magnetic data and altimetry satellite-derived gravity data provided from the Scripps institution of oceanography in 2006. The gravity data was analyzed via power spectrum analysis and gravity inversion, and the magnetic data via analytic signal technique, pseudo-gravity transformation, and its inversion. The results showed that the depth of bedrock tended to increase as we approached the center of the South Central Sag in Kunsan basin and that the maximum and minimum of its depth were estimated to be about 6-8 km and 2 km, respectively. Inaddition, the observed high anomaly of gravity and magnetism was attributed to the intrusion of igneous rock of higher density than the surrounding basement rock in the center of South Central Sag, which was consistent with the interpretation of seismic data obtained in the same region.

• Geomechanics and Engineering
• /
• v.20 no.1
• /
• pp.67-73
• /
• 2020

With the increasing number of underground projects, the problem of rock-water coupling catastrophe has increasingly become the focus of safety. Grouting reinforcement is gradually applied in subway, tunnel, bridge reinforcement, coal mine floor and other construction projects. At present, cement-based grouting materials are easy to shrink and have low strength after solidification. In order to overcome the special problems of high water pressure and high in-situ stress in deep part and improve the reinforcement effect. In view of the mining conditions of deep surrounding rock, a new type of cement-based reinforcement material was developed. We analyses the principle and main indexes of floor strengthening, and tests and optimizes the indexes and proportions of the two materials through laboratory tests. Then, observes and compares the microstructures of the optimized floor strengthening materials with those of the traditional strengthening materials through scanning electron microscopy. The test results show that 42.5 Portland cement-based grouting reinforcement material has the advantages of slight expansion, anti-dry-shrinkage, high compressive strength and high density when the water-cement ratio is 0.4, the content of bentonite is 4%, and the content of Nano Silica is 2.5%. The reinforcement effect is better than other traditional grouting reinforcement materials.

• Tunnel and Underground Space
• /
• v.22 no.6
• /
• pp.373-382
• /
• 2012

Cessation of dewatering usually results in groundwater rebound after closing an underground coal mine because the mine voids and surrounding strata flood up to the levels of decant points such as shafts and drifts. Several numerical models have been developed to predict the timing, magnitude and location of discharges resulting from groundwater rebound. This study reviews the numerical models such as VSS-NET, GRAM and MODFLOW, and compares their scopes of assessment at different spatial and time scales. In particular, the GRAM model was reviewed in details to implement it. This paper describes the implementation of GRAM model and its application to the Dongwon coal mine in Korea. The application showed that the groundwater level modeled at the shaft of Dongwon coal mine using the GRAM model is similar to the observed one in the field.