• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.17 no.4
• /
• pp.270-282
• /
• 2012

This study was conducted to investigate the impact of sand addition to an intertidal for the development of the Manila clam habitat on benthic community structure. For this, we focused on the spatio-temporal changes in the surface sediment condition and benthic community structure before and after the event. Study site was an sandbank in Gonam-myeon, Taean-gun where sand added to on July 2010. We set three stations at each of sand adding area (experimental plot) and non sand-adding area (control plot) and did sampling works ten times from June 2010 to October 2011. Directly after the event, surface sediments changed to very coarse sand, but the state was not maintained over four months because of seasonal sedimentation and finally got back to very fine sand in eight months. The number of species and density were temporarily reduced right after the event and crustacean species such as Apocorophium acutum, Photis sp. were most negatively affected by the event. However, the number of species recovered from the reduction in three months and density did in four months due to the recolonization by the existing species and species in the vicinity of the plot. During the study period, dominant species continuously changed from the species such as A. acutum, Photis sp. at the time before the event, through the species such as Heteromastus filiformis, Macrophthalmus japonicus at the time right after the event, to the species such as Musculista senhousia, Ruditapes philippinarum, Mediomastus californiensis in the latter part of the study period. Although surface sediment properties and ecological indices recovered within a certain period after the event, the recovery of community structure has never been observed up to the end of the study.

• Asian-Australasian Journal of Animal Sciences
• /
• v.21 no.5
• /
• pp.692-700
• /
• 2008

A trial was conducted to study the influence of different levels of a commercial enzyme complex on performance, nutrient availability, blood parameters, digestive tract measurements, amylase and trypsin activity of the digestive tract and gut morphology in broilers fed the typical diets in north China. There were four treatments: the control diet and the other three enzyme complex supplemented diets which were 180 mg/kg, 360 mg/kg and 720 mg/kg enzyme complex supplemented to the control diet, respectively. The birds fed the diets supplemented with 180 mg/kg and 360 mg/kg enzyme complex had better performance and nutrient availability, the activities of amylase and trypsin in the digestive tract in the two treatments were improved, the villus height and surface area of villus in the small intestine increased and the crypt depth and epithelial thickness of small intestine decreased. Relative weights of pancreas and relative weights and lengths of small intestine decreased. However, the addition of 720 mg/kg enzyme complex had no effects on these parameters and increased crypt depth and epithelial thickness of the small intestine. The data suggested that suitable supplementation of enzyme complex was beneficial for the birds, while excess enzyme complex inhibited secretion of endogenous enzyme and destroyed the structure of the small intestine.

• Transactions of the KSME C: Technology and Education
• /
• v.3 no.4
• /
• pp.249-255
• /
• 2015

Functional nanochannels were fabricated in order to control selective ion transportation with high permeability and low energy consumption. In this research, nanochannel platform fabrication process and surface functionalization process were developed. In addition, selective ion transportation and concentration measurement system was also set-up. By using fabricated multilayer metal membrane with electrical bias, 95% of ion ($Cl^-$) was blocked. This developed process is new-conceptional membrane fabrication technology and is expected to be applied to next-generation water purification/desalination, portable artifical kidney, and artificial sense organ.

• Investigative Magnetic Resonance Imaging
• /
• v.22 no.1
• /
• pp.26-36
• /
• 2018

Purpose: Children born with single ventricle physiology demonstrate poor growth rate and suffer from malnutrition, which lead to increased morbidity and mortality in this population. We assume that an anabolic steroid, oxandrolone, will promote growth in these infants by improving myocardial energy utilization. The purpose of this paper is to study the efficacy of oxandrolone on myocardial energy consumption in these infants. Materials and Methods: We modeled single ventricle physiology in a lamb by prenatally shunting the aorta to the pulmonary artery and then postnatally, we monitored cardiac energy utilization by quantitatively measuring the first order reaction rate constant, $k_f$ of the creatine-kinase reaction in the heart using magnetization transfer $^{31}P$ magnetic resonance spectroscopy, home built $^1H/^{31}P$ transmit/receive double tuned coil, and transmit/receive switch. We also performed cine MRI to study the structure and dynamic function of the myocardium and the left ventricular chamber. The spectroscopy data were processed using home-developed python software, while cine data were analyzed using Argus software. Results: We quantitatively measured both the first order reaction rate constant and ejection fraction in the control, shunted, and the oxandrolone-treated lambs. Both $k_f$ and ejection fraction were found to be more significantly reduced in the shunted lambs compared to the control lambs, and they are increased in oxandrolone-treated lambs. Conclusion: Some improvement was observed in both the first order reaction rate constant and ejection fraction for the lamb treated with oxandrolone in our preliminary study.

• Applied Biological Chemistry
• /
• v.50 no.3
• /
• pp.160-166
• /
• 2007

This study was performed to analyze the molecular structural and physical properties changes of modified rice starch, which particle structure was broken using high impact planetary mill and ultra fine pulverizing techniques. The average diameter and specific surface area of rice starch after pulverization decreased 20% and increased 25%, respectively. Low molecular substances content in rice starch using GPC (gel permeation chromatography) increased from 36.5% to 59.5% after pulverizing of rice starch. Damaged starch contents in rice starch also increased from 16.4% to 99.2% after pulverizing of rice starch. Water holding capacity, solubility and transmittance of rice starch after pulverization increased compared to those of control. Apparent viscosity value of rice starch after pulverization decreased to 7% in control based on $30^{\circ}C$ and 20 RPM conditions.

• Journal of Korean Society for Atmospheric Environment
• /
• v.13 no.1
• /
• pp.91-98
• /
• 1997

Y-zeolite and ${\gamma}$-Al$_2$O$_3$ were used as supports on CO and $C_3$H$_{6}$ oxidation for diesel emission control. The catalysts composed of Pd and Pt as active components were wash coated on honeycomb type ceramic substrate. The oxidation of CO and $C_3$H$_{6}$ was carried out over prepared honeycomb in a fixed bed continuous reactor in the temperature range of 20$0^{\circ}C$~50$0^{\circ}C$ and 20,000 GHSV (h$^{-1}$ ). Surface area of Y-zeolite was larger than that of ${\gamma}$-Al$_2$O$_3$ due to channel structure of Y-zeolite. Therefore, high conversion of CO and $C_3$H$_{6}$ could be obtained because of good dispersion of active metals over Y-zeolite. The honeycomb used Y-zeolite as a support showed higher $C_3$H$_{6}$ conversion than that of ${\gamma}$-Al$_2$O$_3$ due to better cracking and isomerization activity of Y-zeolite. PdPt catalyst showed high conversion of CO and $C_3$H$_{6}$ at low temperature region, 20$0^{\circ}C$~30$0^{\circ}C$, for their synergy effects. PdPt/Y-Zeolite catalyst could achieve more than 80％ conversion of $C_3$H$_{6}$ at 30$0^{\circ}C$. The use of Y-zeolite as a support increased CO and $C_3$H$_{6}$ conversion, and decreased SO$_2$ conversion very effectively. Y-zeolite found to have a good adaptability as a support for the diesel emission after treatment system.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.24 no.7
• /
• pp.532-536
• /
• 2011

The silicon nitride films were prepared by chemical vapor deposition using inductively coupled plasma. During the deposition, the substrate was heated at $150^{\circ}C$ and power 1,000 W. To evolution low temperature manufacture, we have studied the role of source gases, $SiH_4$, $NH_3$, $N_2$, and $H_2$, to produce Si-N and N-H bond in a-SiNx:H film growth. $SiH_4$, $NH_3$, and $N_2$ flow rate fixed at 100, 10, and 10 sccm, $H_2$ flow rate varied from 0 to 10 sccm by small scale. To get the electrical characteristics, we makes MIM structure, and analysis surface bonding state. Experimental data show that Si-N and N-H bond is increased and hence electrical characteristics is showed 3 MV/cm breakdown-voltage, and leakage-current $10^{-7}\;A/cm^2$.

• Journal of Microbiology and Biotechnology
• /
• v.26 no.10
• /
• pp.1746-1754
• /
• 2016

Recently, spherical beads entrapping quorum quenching (QQ) bacteria have been reported as effective moving QQ-media for biofouling control in MBRs for wastewater treatment owing to their combined effects of biological (i.e., quorum quenching) and physical washing. Taking into account both the mass transfer of signal molecules through the QQ-medium and collision efficiencies of the QQ-medium against the filtration membranes in a bioreactor, a cylindrical medium (QQ-cylinder) was developed as a new shape of moving QQ-medium. The QQ-cylinders were compared with previous QQ-beads in terms of the QQ activity and the physical washing effect under identical loading volumes of each medium in batch tests. It was found that the QQ activity of a QQ-medium was highly dependent on its specific surface area, regardless of the shape of the medium. In contrast, the physical washing effect of a QQ-medium was greatly affected by its geometric structure. The enhanced anti-biofouling property of the QQ-cylinders relative to QQ-beads was confirmed in a continuous laboratory-scale MBR with a flat-sheet membrane module.

• Journal of Periodontal and Implant Science
• /
• v.44 no.5
• /
• pp.227-234
• /
• 2014

Purpose: Dentin hypersensitivity is a potential threat to oral health. Laser irradiation may provide reliable and reproducible treatment but remains controversial. The present study aimed to evaluate the effects of $CO_2$ or erbium-doped yttrium aluminium garnet (Er:YAG) laser therapy, and to assess mineral content. Methods: Eighteen human single-rooted teeth affected with advanced periodontitis were obtained. Buccal and lingual surfaces were planed to form 36 specimens. Ethylenediaminetetraacetic acid gel (24%) was applied to remove the smear layer and simulate hypersensitive teeth. The experimental groups were: group 1, control (no irradiation); group 2, $CO_2$ laser (repetitive pulsed mode, 2 W, $2.7J/cm^2$); and group 3, Er:YAG laser (slight contact mode, 40 mJ/pulse and 10 Hz). To evaluate dentinal tubule occlusion, six specimens per group (2-mm thickness) were prepared and observed using scanning electron microscopy (SEM) for calculation of the occlusion percentage. To evaluate the mineral content, six specimens per group (0.6-mm thickness) were used, and then the levels of Ca, K, Mg, Na, and P were measured by inductively coupled plasma-atomic emission spectrometry. In addition, the surface temperature of the specimens during laser irradiation was analyzed by a thermograph. Results: The SEM photomicrographs indicated melted areas around exposed dentinal tubules and a significantly greater percentage of tubular occlusion in the $CO_2$ and Er:YAG laser groups than the control, and in the Er:YAG group than the $CO_2$ laser group. In addition, no significant differences were noted among the experimental groups for the mineral elements analyzed. The $CO_2$ laser group showed an evident thermal effect compared to the Er:YAG group. Conclusions: $CO_2$ and Er:YAG laser are effective in treating dentin hypersensitivity and reducing its symptoms. However, the Er:YAG laser has a more significant effect; thus, it may constitute a useful conditioning item. Furthermore, neither $CO_2$ nor Er:YAG lasers affected the compositional structure of the mineral content.

• Journal of the Korean Wood Science and Technology
• /
• v.23 no.1
• /
• pp.42-48
• /
• 1995

The purpose of this study is to evaluate the efficacy of metabolites produced form Streptomyces rimosus in controlling the growth of sapwood - inhabiting fungi. In order to carry out this task, the following specific fungi were tested : sapstain fungi - Ceratocystis pilifera, Ceratocystis piceae, and Aureobasidium pullulans ; mold fungi - Trichoderma hazianum, Trichoderma viride, Penicillium cirtrinum, and Aspergillus niger. Based on the tests, the following observations can be drawn. 1. The conidial germination of sapstain and mold fungi was completely inhibited leaving a clear zone around the paper disc treated with metabolites. The best inhibition was observed in A. pullulans plate and the least in T. viride. 2. Concentration of SB medium for the production of metabolites from St, rimosus affected antifungal activity of metabolites against sapwood - inhabiting fungi. Metabolites prepared from 1/3${\times}$SB medium showed the best activity and the least activity was observed in metabolites form 1/4${\times}$medium. 3. in vivo and in vitro test using wood blocks, treatment of pine sapwood blocks with metabolites also inhibited conidial germination and thus prevented discoloration. 4. Treatment with metabolites did not change the macroscopic structure of wood and did not cause the discoloration of the surface of wood by pigments produced form St. rimosus. In conclusion the results of this study indicate that antifungal metabloites of St, rimosus could be used for the biological control of sapstain and mold fungi.