• 한국광물학회지
• /
• 제20권4호
• /
• pp.289-302
• /
• 2007

전라남도 신안군 자은도의 둔장해수욕장 해변으로부터 채취한 해빈사로부터 중광물 회수공정을 실시하여, 중광물의 특징 및 회수 가능성에 대한 연구를 수행하였다. 채취 시료는 깊이별로 상부, 중부 및 하부시료로 구분한 뒤 각각에 대하여 spiral separation을 실시하여 얻은 중광물군을 초기물질로 3차에 걸친 중광물 선별작업을 실시하였다. 본 역에서 배태되어 있는 중광물로 티탄철석, 저어콘, 금홍석, 아나타제, 모나자이트 및 제노타임 등이 관찰되었다. 3차에 걸친 Table separation을 실시한 결과, 맥석광물인 석영, 정장석, 알바이트 및 백운모가 여전히 존재하였다. 따라서 부가적으로 비중선별이 추가적으로 요구된다. 수선을 통한 중광물의 선별을 실시한 결과, 각 중광물의 다양한 원마도 및 색깔을 보임으로써, 배태된 중광물들이 다양한 성인에 의해 형성되었음을 시사하고 있다.

• 대한기계학회논문집B
• /
• 제25권8호
• /
• pp.1005-1012
• /
• 2001

When vortex tubes are applied to enhance the coefficient of performance of refrigeration system, the smaller one is preferable. However, the existing vortex generator with a nozzle hole diameter of 0.5mm was not suitable due to chocking of the nozzle hole. Therefore, experimental investigation was made to find an appropriate geometry of vortex generator, which could give a comparable effect of energy separation to commercial ones without chocking problem. The tested vortex generators were tangential and spiral types, which had single inducing channel with larger cross-sectional area than that of conventional multi-hole ones. The experimental result showed that the performance of the spiral type was better than that of the tangential one. As a small size of spiral one, the diameter of cold-end orifice is proposed to an half of tube diameter for the application to refrigeration system, while cold mass fraction ratio is 0.5∼0.6 for a desirable operation.

• 한국항공운항학회지
• /
• 제19권3호
• /
• pp.10-15
• /
• 2011

위성용 분리장치는 작동 전까지는 높은 체결력으로 위성의 부속물들을 안정된 체결 상태로 유지해야 한다. 작동 후에는 위성시스템에 손상이 없이 위성본체로부터 분리되어 태양전지판과 안테나와 같은 부속장치의 전개를 성공적으로 수행하여야 한다. 따라서 본 논문에서는 분리충격이 작고 취급이 용이하며 재장착이 가능한 형상기억합금구동기와 태엽스프링을 이용한 소형위성용 비폭발식 분리장치를 제안하였다. 성능을 검증하기 위하여 분리시간, 분리가 가능한 사전하중, 분리장치 작동 시 충격량 측정 실험을 수행하였다.

• 한국자동차공학회논문집
• /
• 제5권3호
• /
• pp.35-46
• /
• 1997

In order to satisfy customer's requirements of ride comfort and high performance, it is necessary for designers to fully understand vehicle aerodynamics and wind noise of newly produced cars because characteristics of flow and wind noise are heavily dependent on each other. In this study numerical and experimental study have been carried out to analyse the effect of flow characteristics at around of rear view mirror on wind noise and soiling on the front S/W. As a result, it's found that the spiral flow mear the front pillar is weakened and spreaded because rear view mirror obstructs the flow. It is also shown that there is abrupt change of gradient of separa- tion line, separation area, intensity of spiral flow and turbulent kinetic energy with varying shape of neck and housing of rear view mirror.

• 천문학회보
• /
• 제44권1호
• /
• pp.79.3-79.3
• /
• 2019

Observational evidence for intrinsic galaxy alignments in isolated spiral pairs is presented. From the catalog of the galaxy groups identified by Tempel et al. in the flux-limited galaxy sample of the Sloan Digital Sky Survey Data Release 10, we select those groups consisting only of two spiral galaxies as isolated spiral pairs and investigate if and how strongly the spin axes of their two spiral members are aligned with each other. We detect a clear signal of intrinsic spin alignment in isolated spiral pairs, which leads to the rejection of the null hypothesis at the 99.9999% confidence level via the Rayleigh test. It is also found that those isolated pairs comprising two early-type spiral galaxies exhibit the strongest signal of intrinsic spin alignment and that the strength of the alignment signal depends on the angular separation distance as well as on the luminosity ratio of the member galaxies. Using the dark matter halos consisting of only two subhalos resolved in the EAGLE hydrodynamic simulations, we repeat the same analysis but fail to find any alignment tendency between the spin angular momentum vectors of the stellar components of the subhalos, which is in tension with the observational result. Several possible sources of this apparent inconsistency between the observational and the numerical results are discussed.

• 천문학회보
• /
• 제44권1호
• /
• pp.35.2-35.2
• /
• 2019

Observational evidence for intrinsic galaxy alignments in isolated spiral pairs is presented. From the catalog of the galaxy groups identified by Tempel et al. in the flux-limited galaxy sample of the Sloan Digital Sky Survey Data Release 10, we select those groups consisting only of two spiral galaxies as isolated spiral pairs and investigate if and how strongly the spin axes of their two spiral members are aligned with each other. We detect a clear signal of intrinsic spin alignment in isolated spiral pairs, which leads to the rejection of the null hypothesis at the 99.9999% confidence level via the Rayleigh test. It is also found that those isolated pairs comprising two early-type spiral galaxies exhibit the strongest signal of intrinsic spin alignment and that the strength of the alignment signal depends on the angular separation distance as well as on the luminosity ratio of the member galaxies. Using the dark matter halos consisting of only two subhalos resolved in the EAGLE hydrodynamic simulations, we repeat the same analysis but fail to find any alignment tendency between the spin angular momentum vectors of the stellar components of the subhalos, which is in tension with the observational result. Several possible sources of this apparent inconsistency between the observational and the numerical results are discussed.

• 공업화학
• /
• 제24권5호
• /
• pp.456-470
• /
• 2013

중공사형 막은 지난 수십 년간 빠르게 성장하고 있는 새로운 기술의 하나이다. 또한, 고분자 소재를 이용한 분리막은 기체분리, 연료전지, 수처리, 폐수처리, 유기물 분리 등 여러 분야에서 주목 받고 있다. 그중에서도 액체분리용 역삼투(RO)와 한외여과(Ultrafiltration)막의 중간 특성을 갖는 나노여과(Nanofiltration)막은 상대적으로 역삼투 막에 비하여 낮은 투자비와 낮은 운전압력, 높은 투과 성능을 가지며 다가 음이온 염과 $200{\sim}1000gmol^{-1}$사이의 유기물에 대한 높은 제거율을 갖는 막이다. 본 논문에서는 NF 중공사 분리막의 소재, 제조 방법(상전이법과 계면중합법)에 따른 멤브레인의 구조 제어 및 다양한 특성 평가에 관한 연구동향을 살펴보고자 한다. 현재 대부분의 NF용 분리막은 평막형(plate and frame type)이나 나권형(spiral wound type)으로 제품화 되고 있는데, 중공사형(hollow-fiber type)의 제품화가 지연되고 있는 것은 기존 소재를 바탕으로 제조할 경우 강도면에서 안정적이지 못한 면이 있으므로 새로운 소재를 개발하거나 기존 소재의 개선이 필요할 것으로 보인다. 이러한 부분을 보완할 수 있을 만한 제조 기술이 확보된다면 중공사 형태의 나노여과막이 점차 나권형막을 대체하여 시장에서 높은 점유율을 나타낼 수 있을 것이다.

• Journal of Biosystems Engineering
• /
• 제26권2호
• /
• pp.131-140
• /
• 2001

This study was conducted to develop a garlic separator which could to reduce the labor in preparation of seeding. After consideration of the design criteria of a garlic separator such as no additional conveying device, simple construction and operation, enhancement of separating efficiency, reduction of damage, degree a rotating corn type garlic separator was designed. The effects of design parameters such as height and angle of the inner and outer corns, rotating speed of inner corn on the separating performance of the prototype were estimated. In performance was compared with manual work. The results are summarized as follows. 1. Garlic bulbs were separated by a spiral movement in the gap between inner rotating corn and outer fixed corn. At constant feed rate of garlic bulbs, the capacity of garlic separation increased with increase of rotating speed of inner corn. Especially, the capacity was very high at the rotating speeds of 300 and 400rpm. 2. The damage degree of separated garlics increased with rotating speed of corn within 10%. Above 300rpm, separability of Uisung garlic was about 100% and incomplete separation of Namdo garlic was within 2%. 3. The capacity of prototype garlic separator developed in this study was 30 times as large as that of human being.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2005년도 추계 학술대회논문집
• /
• pp.21-26
• /
• 2005

Gas Chromatography (GC) is a wisely technique used for the separation and analysis of liquid and gas sample. Separation of the sample vapors is achieved via their differential migration through a capillary column with an insert carrier gas. The identity and quantity of each vapor in the mixer can be determined from its retention time in the column and a particular property of the gas, such as thermal conductivity, which can be related to the concentration of sample vapor in the carrier gas. Therefore, the flow characteristics in the spiral gas chromatographic column are numerically investigated in this study. Especially, different pressure drop between the front and the rear of GC column with various flow rates is estimated the governing equations are derived from making using of three-dimensional Naver-Stokes equation with incompressible and laminar model due to the nature of low Reynolds number flow. Using a commercial code, FLUENT, the pressure and flow fields in GC column are calculated with various flow rates. The characteristics of thermal cycling which is one of the most important factors affecting the column efficiency and analysis time is also estimated. Furthermore, numerical analyses are also carried out by using commercial code, ANSYS, with various values of power, which is applied to the heating element located at lower GC column.

• 멤브레인
• /
• 제4권3호
• /
• pp.142-151
• /
• 1994

역삼투 공정을 농축공정에 이용하기 위해 향류식 역삼투 나권형 모듈을 고안, 제작하여 염수의 농축실험을 수행하였다. 역삼투 분리의 배제도와 농축도의 관계를 고찰한 결과, 배제유량에 대한 투과유량의 비가 양쪽 관계의 중요한 매개 변수이며, 반사계수 값에 따라, 역삼투막의 배제도와 농축도가 Spiegler-Kedem 식의 경향을 따른다. 향류식 역삼투 공정은 일반 역삼투 농축 공정에 비해 농축의 장애 요소인 삼투압차를 효과적으로 저하시키는 효과가 있으며 농축도가 상대적으로 우수하였다. 향류식 나권형 모듈의 수치모사 결과 농축공정의 농축도 증가를 위해서는 모듈의 지름보다 모듈의 길이를 늘리는 것이 유리함을 알 수 있었다.