• Geomechanics and Engineering
• /
• v.12 no.4
• /
• pp.561-577
• /
• 2017

Vast parts of the east of Tabriz city have been covered by Baghmisheh formation marls. These marls can be classified into three types based on their color as identified in yellow, green, and gray marls. Many high-rise buildings and other projects were founded and now is constructing on these marls. Baghmisheh formation marls are classified as stiff soil to very weak rock, therefore they undergo considerable consolidation settlement under foundation loads. This study presents the physical properties and consolidation behavior of these marls. According to the XRD tests, major clay minerals of marls are Illite, Kaolinite, Montmorillonite and Chloride. Uniaxial compressive strength are 100-250, 300-480 and 500-560 kPa for yellow, green and gray marls, respectively. Consolidation and creep behavior of Baghmisheh marls investigated by using of one dimensional consolidation apparatus under stress level up to 5 MPa. The results indicate that yellow marls have high compressibility, settlement and deformation modules. Green marls have an intermediate compressibility and settlement and while gray marls have low compressibility and settlement and from the foundation point of view have high stability. According to the creep test results, all types of marls have not been entered to progressive creep phase up to pressure 5 MPa.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2004.03b
• /
• pp.219-226
• /
• 2004

We measure subsidences occurred in a reclaimed coastal land, Noksan industrial complex, by using JERS-1 SAR (1996-1998) and RADARSAT-1 SAR (2002-2003) dataset. SAR with a high spatial resolution (about several or several tens meter) can reveal the two-dimensional distribution of settlement that would be bardly estimated from in situ measurements. The DInSAR results show significant deformation signal associated with soil consolidation. Accuracy of the settlements estimated by 2-pass differential interferometry (DInSAR) is evaluated using the measurements of settlement gauge. A two-dimensional subsidence map is constructed from 7 qualified pairs. Comparing the JERS-1 radar measurements with the ground truth data yields the correlation coefficient of 0.87 (RMSE of 1.44 cm). The regression line shows the gradient of 1.04 and intercepts close to the origin, which implies that the unbiased settlement can be measured by DInSAR technique. The residual settlements are also detected from RADARSAT-1 pairs. The extent and amount of the settlements are matched well with ground truth data.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2009.03a
• /
• pp.702-706
• /
• 2009

From the result of analysis the necessity of root fixing stone construction through the result of finite element method, following results were acquired. 1. The consolidation settlement by stone weight is small amount so that it is interpreted there is no stone settlement reducing effect by root fixing stone. 2. It is interpreted that there is no effect existence and nonexistence of the heaving soil to the settlement. 3. There is little settlement reducing effect by root fixing stone but there may be protection of excavation effect. Therefore, for long-term stability, installing the root fixing stone to the section where the typhoon effect directly would be proper.

• Geomechanics and Engineering
• /
• v.10 no.2
• /
• pp.155-174
• /
• 2016

A total of 104 laboratory model tests on a square footing subjected to eccentrically inclined loads supported by sand reinforced with randomly distributed polypropylene fibers were conducted in order to compare the results with those obtained from unreinforced sand and with each other. For conducting the model tests, uniform sand was compacted in a test box at one particular relative density of compaction. The effect of percentage of reinforcement used, thickness of the reinforced layer, angle of inclination of load to vertical and eccentricity of load applied on various prominent factors such as ultimate load, vertical settlement, horizontal deformation and tilt were investigated. An improvement in ultimate load, vertical settlement, horizontal deformation and tilt of foundation was observed with an increase in the percentage of fibers used and thickness of reinforced sand layer under different inclinations and eccentricities of load. A statistical model using non-linear regression analysis based on present experimental data for predicting the vertical settlement ($s_p$), horizontal deformation ($hd_p$) and tilt ($t_p$) of square footing on reinforced sand at any load applied was done where the dependent variable was predicted settlement ($s_p$), horizontal deformation ($hd_p$) and tilt ($t_p$) respectively.

• Geomechanics and Engineering
• /
• v.10 no.2
• /
• pp.225-245
• /
• 2016

Settlement of foundations in permafrost regions primarily results from three physical and mechanical processes such as thaw consolidation of permafrost layer, creep of warm frozen soils and the additional deformation of seasonal active layer induced by freeze-thaw cycling. This paper firstly establishes theoretical models for the three sources of settlement including a statistical damage model for soils which experience cyclic freeze-thaw, a large strain thaw consolidation theory incorporating a modified Richards' equation and a Drucker-Prager yield criterion, as well as a simple rheological element based creep model for frozen soils. A novel numerical method was proposed for live computation of thaw consolidation, creep and freeze-thaw cycling in corresponding domains which vary with heat budget in frozen ground. It was then numerically implemented in the FISH language on the FLAC platform and verified by freeze-thaw tests on sandy clay. Results indicate that the calculated results agree well with the measured data. Finally a model test carried out on a half embankment in laboratory was modeled.

• Journal of Navigation and Port Research
• /
• v.33 no.2
• /
• pp.119-125
• /
• 2009

The effect of plastic board drains (PBDs)on ground improvement was checked out considering three crucial factors: ground settlement, undrained shear strength, and residual water head. First, the settlement analysis including initial settlement induced by reclamation of sand mat was conducted by back calculation analysis with measured data. Its result showed toot the PBDs used for this site worked well on improving soft ground. Secondly, the undrained shear strength was investigated by laboratory and in-situ tests including unconsolidated-undrained triaxial compression (UU) tests, unconfined compression tests, in-situ vane tests, and cone penetration tests. From the test results, they showed that the undrained shear strength of the improved ground by PBDs was significantly increased as well as the strength increasing ratio especially $10{\sim}15m$ below the ground surface on site. Thirdly, the residual water head measurement from the in situ dissipation test was found the same as the static water head, which indicated primary consolidation was completed and the effect of soil improvement with PBDs can be confirmed.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.1
• /
• pp.67-80
• /
• 2006

This paper presented an application of the geotechnical hybrid-online simulation to the consolidation settlement problem of soft clay. Conventional numerical analyses have used idealized soil constitutive models obtained from the laboratory soil tests. On the other hand, in the hybrid-online simulation, soil response was directly introduced to numerical analyses from the soil element test, and, therefore, the complicated parameter estimation was not required in this method. Fundamentals of the hybrid-online simulation method and the development of the algorithm and corresponding hardware and software for the system were presented in this study. Furthermore, an incremental loading consolidation and the hydraulic conductivity test and a comparative study using the Terzagh's conventional consolidation theory were carried out for the system verification including the performance of the experimental device and source coding of software components, and the data reliability obtained from the system. In conclusion, we found that the hybrid-online consolidation simulation system could reproduce the consolidation behavior of the remolded Kaolinite specimen withoutany discrepancies.

• Journal of the Korean GEO-environmental Society
• /
• v.7 no.5
• /
• pp.5-11
• /
• 2006

A primary factor affecting on the design of soft ground is to determine the soil properties (Compression index, Coefficient of consolidation) and the depth of soft ground. It could be the basic sources to estimate settlement behavior of soft ground. Even though the reliable soil examination equipment was used to examine soil to determine the depth of soft ground, it's very hard to find out the accurate properties of soft ground, because the condition of indoor experiment cannot reproduce the circumstances of ground perfectly. Therefore, this study was re-estimated to find out the most reliable soil properties by using back-analysis with field monitoring data of "Site preparation for Airplane Mooring of Incheon International Airport Phase II Development" for 317days.

• Journal of the Korean GEO-environmental Society
• /
• v.10 no.2
• /
• pp.29-36
• /
• 2009

A series of two-dimensional (2D) finite element analyses have been performed to study the behaviour of single piles in consolidating ground. The analysis was conducted based on coupled analyses by considering changes of pore water pressure in the clay. In the analyses the soil slippage at the pile and the soil interface has been included. The method widely used in practice somewhat overestimates dragload by about 25% compared to the rigorous numerical analysis since partial mobilization of skin friction near neutral plane and reductions in the vertical soil stress is not incorporated. When soil slip develops at most of the pile length at the pile-soil interface during consolidation, further increases in dragload is not significant. Application of coating on the pile surface can reduce dragload and pile settlement substantially, but under an axial load on the pile head very large pile settlement can be developed unless pile tip is located to a stiff bearing layer.

• Geotechnical Engineering
• /
• v.11 no.2
• /
• pp.51-70
• /
• 1995

Types of foundation of high rise buildings are primarily determined by loads transmitted from super structure, soil bearing capacity and available construction technology, The use of deep foundation of the buildings considered in this study due to the fact that rock of enough bearing capacity is not found down until 90~l00m. When a concentration of high soil pressure must be distributed over the entire building area, when small soft soil areas must be bridged, and when compressible strata are located at a shallow depth, mat foundation may be useful in order to have settlement and differential settlement of variable soils be minimized. The concept of mat foundation will also demonstrate some difficulties of applications if the load bearing demand directly carried down to the load -bearing strata exceeds the load -bearing capacity. This paper introduces both the analysis and design of mat type foundation for high rise buildings as well as the method-ology of modelling of the soil foundation, especially, engineered to redistribute the stress exceeding the soil bearing capacity. This process will result in the wide spread of stresses over the entire building foundation.