• Proceedings of the KIEE Conference
• /
• 2001.11c
• /
• pp.38-41
• /
• 2001

To reduce the wasted power with using an OP-AMP, 3 circuit supplying the same amount of power to load through overall voltage range can able proposed. With this type of design, the power that induced to the devices in the circuit will be reduced, we can also develope a small size power supply with the OP-AMP developed using this design. If we need a OP-AMP needed to handle higher power than usual, another design technique can be proposed. With substituting one device with the devices connected in series, the power loaded to each devices in the series devices can be reduced. This thesis contents the design of an OP-AMP to use in high power fields with small thermal dissipation.

• Economic and Environmental Geology
• /
• v.16 no.1
• /
• pp.37-49
• /
• 1983

The skarn type tungsten deposits are developed in the contact aureole of Jurassic biotite-hornblende granodiorite and limestone beds. The latter can be divided into the Great Limestone Series of Joseon System and Gabsan Formation which is correlative to the Hongjeom Series of Pyeongahn System. The skarns are impregnated in the limestone, sandstone, schist and granodiorite, and showing zonal distribution. The five skarn zones are from fresh limestone inwards to wollastonite-skarn, clinopyroxene-skarn, clinopyroxene-garnet skarn, garnet skarn and vesuvianite skarn zone. The ore mineral, scheelite, disseminates in the clinopyroxene-garnet and vesuvianite skarn zone, and the size of the scheelite crystals in vesuvianite skarn zone is larger than in clinopyroxene- garnet skarn zone. According to the mineral paragenesis and the composition of skarn minerals, oxygen fugacity ($fo_2$) is low. Fluid inclusions in quartz comprise much $LCO_2$ and fluid inclusion studies revealed that the homogenization temperatures range $240-290^{\circ}C$.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.23 no.7
• /
• pp.20-28
• /
• 2009

This paper presents the design of zero current switching ZCS pulse frequency modulation type DC-DC converter for magnetron power supply. A magnetron serving as the microwave source in a microwave oven is driven by a switch mode power supply (SMPS). SMPSs have the advantages of improved efficiency, reduced size and weight, regulation and the ability to operate directly from the converter DC bus. The demands of the load system and the design of the power supply required to produce constant power at 4[kV]. A magnetron power supply requires the ability to limit the load current under short circuit conditions. The current source series resonant converter is a circuit configuration which can achieve this. The main features of the proposed converter are an inherent protection against a short circuit at the output, a high voltage gain and zero current switching over a large range of output power. These characteristics make it a viable choice for the implementation of a high voltage magnetron power supply.

• Proceedings of the KIPE Conference
• /
• 2006.06a
• /
• pp.235-238
• /
• 2006

As the screen size of LCD TV increases, an external electrode fluorescent lamp (EEFL) has been suggested to be applicable as backlight source for LCD TV. Since the EEFL has non-linear characteristics, which makes the analysis and design complicated. In this paper, the characteristics of the EEFL are investigated and a full-bridge RLC series-resonant inverter is analyzed and designed for EEFL backlight of 32-inch LCD TV. Finally, the experimental results are shown to validate the analysis and design.

• Journal of Electrical Engineering and Technology
• /
• v.5 no.3
• /
• pp.415-422
• /
• 2010

The distributed flexible alternative current transmission system (D-FACTS) is a recently developed FACTS technology. Distributed Static Series Compensator (DSSC) is one example of DFACTS devices. DSSC functions in the same way as a Static Synchronous Series Compensator (SSSC), but is smaller in size, lower in price, and possesses more capabilities. Likewise, DSSC lies in transmission lines in a distributed manner. In this work, we designed a fuzzy logic controller to use the DSSC for enhancing transient stability in a two-machine, two-area power system. The parameters of the fuzzy logic controller are varied widely by a suitable choice of membership function and parameters in the rule base. Simulation results demonstrate the effectiveness of the fuzzy controller for transient stability enhancement by DSSC.

• Proceedings of the KIEE Conference
• /
• 1997.07c
• /
• pp.911-913
• /
• 1997

This paper presents a method for optima] placement of series capacitors in order to improve the power system transient stability, using genetic algorithms. For the formulation, this paper considers the objective function which is the energy margin as the difference between transient energy and critical energy. The most important factor in determining an accurate critical energy is the controlling unstable equilibrium point (UEP). This paper proposes the controlling UEP methods, concurrently with the DFP(Davidon-Fletcher-Powell) method, which enables the enhancement of multi-machine analysis. The proposed method is applied to 6-bus, 7-line, 4-machine model system to show its effectiveness in determining the locations to install series capacitors and the it's size to be installed in system, simultaneously.

• Journal of the Korean Chemical Society
• /
• v.15 no.2
• /
• pp.95-105
• /
• 1971

The apparent molal volumes ${\phi}_v$ of a series of homologous tetraalkylammonium chlorides, $Me_4NCl, Et_4NCl, Pr_4NCl,\;and\;Bu_4NCl$, in a series of isopropanol-water mixtures have been determined at $30^{\circ}C$ from precision density measurements using pycnometers. The values of ${\phi}_v$ extrapolated to infinite dilution give partial molal volumes $\={V}^{\circ}$s which are almost additive for successive homologues and enable one to determine the absolute individual ionic partial molal volumes. The experimental results are discussed in terrns of the varying size and surface charge of the ions and the structure of the binary solvent mixtures. The results indicate that at 0.1 mole fraction isopropanol the maximum structuredness of water causes a minimum in the tetraalkylammonium-cation partial molal volumes, while at 0.2 mole fraction the solvent structure is such that the free volumes is a minimum and the electrostrictive effect of chloride ion is a maximum.

• Journal of Electrical Engineering and Technology
• /
• v.13 no.2
• /
• pp.928-935
• /
• 2018

In this paper, a compact fully printable bandpass filter is suggested for a low-frequency channel 3.2 GHz ~ 3.7 GHz in the Ultra-Wideband (UWB) communication system. It is featured with a small geometry of $0.5{\lambda}_g/15$ and a low insertion loss despite using FR4 as a cheap substrate of a high dielectric loss. This is made possible by generating zeroth-order-resonance (ZOR) from one cell comprising two series resonances obviously separated from one shunt resonance as a third-order bandpass filter. Especially, the series resonance elements are combined with spur-lines bent by 90 degrees, which makes the port-impedance matched well and eliminates spurious hikes in the stopband, while the overall size remains almost unchanged. The design is carried out by setting up the equivalent circuit and the circuit simulation is checked by the full-wave EM analysis. The structure is manufactured and measured to show that the circuit modeling and EM simulation results agree with the measured data.

• Journal of the Korean Society of Safety
• /
• v.7 no.2
• /
• pp.5-13
• /
• 1992

If zero-accident movement is to be successful, the objective goal period should be surely obtainable, and much more in our country where frequency rate of injury are remarkably fluc-tuating. However In our country, as far as we know, no method to establish a reasonable zero-accident goal period is guaranteed. In thls paper, a new establishing-method of reasonable goal period for individual industry with considering recent accident trend is presented. A mathematical model for industrial accidents generation was analyzed, and a stochastic process model for the accident generation inteual was formulated. This model could tell the accident generation rate in future by understanding the accident tendency through the time-series analysis and search for the distribution of numbers of accidents and accident interval. On the basis of this, the forecasting method of goal achievement probability by the size and the establishment method of reasonable goal period were developed.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.2
• /
• pp.248-255
• /
• 2009

We proposed a power line channel model. We adopted advantages of other power line channel models to calculate channel responses correctly and simply. Infinite geometric series reduced the calculation complexity of the multipath signal propagation. Description Matrices were also adopted to handle the network topology easily. It represents complex power line network precisely and simply. Newly proposed model considered the effect of the adjacent nodes to channel responses, which have been not considered so far. Several simulations were executed to verify the effect of the adjacent nodes. As a result we found out that it affected channel responses but its effect was limited within certain degree.