• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.6
• /
• pp.1067-1072
• /
• 2011

If the flow of booster gas which is exhausted to the rear part of a canister is properly restricted in the canister of a hot-launch system, the resultant pressure built up in the canister provides additional force to accelerate the missile to a required launch velocity. These thrust augmentation performances can be controlled through the configuration design of baseplate orifices. In this paper, the simple technique to analyze the thrust augmentation performances of baseplate orifices is suggested and the thrust augmentation characteristics by its various configurations are compared. According to the initial displacement of a missile, the inner pressure of a canister is measured from scaled cold flow tests, and the discharge coefficient of baseplate orifices is calculated. Then the thrust augmentation in a canister is simulated by applying these discharge characteristics to the AMESIM software for launch dynamics.

• Journal of Power Electronics
• /
• v.15 no.4
• /
• pp.964-973
• /
• 2015

This paper presents a simple approach for the selective harmonic elimination (SHE) of multilevel inverter based on the transistor-clamped H-bridge (TCHB) family. The SHE modulation is derived from the sinusoidal voltage-angle equal criteria corresponding to the optimized switching angles. The switching angles are computed offline by solving transcendental non-linear equations characterizing the harmonic contents using the Newton-Raphson method to produce an optimum stepped output. Simulation and experimental tests are conducted for verification of the analytical solutions. An Altera DE2 field-programmable gate array (FPGA) board is used as the digital controller device in order to verify the proposed SHE modulation in real-time applications. An analysis of the voltage total harmonic distortion (THD) has been obtained for multiple output voltage cases. In terms of the THD, the results showed that the higher the number of output levels, the lower the THD due to an increase number of harmonic orders being eliminated.

• Proceedings of the KSRS Conference
• /
• 2002.10a
• /
• pp.88-88
• /
• 2002

Satellite Image archiving system requires large storage and long transmission time. A simple and cheap way of overcoming these limitations is to increase the compression ratio. However this requires a feasibility study for accurate applications. Here, a new still image compression standard is being developed, the JPEG2000. It provides lossless and lossy compression, progressive transmission by pixel accuracy and by resolution, region-of-interest coding, user-defined tiling size, random codestream access and processing etc. In this study, we will briefly introduce the JPEG2000 compression standard which provides a new compression technique based on the wavelet technology and offers better compression ratios, and evaluate the compression ratios of JPEG2000 for satellite image by performing various image quality tests. Also, we will compare brief test result using the commercial remote sensing software.

• Proceedings of the KIEE Conference
• /
• 2005.10c
• /
• pp.56-59
• /
• 2005

This paper describes a novel method of detecting excitation position in Switched Reluctance Motor(SRM) drive. Some strategics for position sensorless control methods of the SRM include the measurement of phase current. The principle of the rotor position estimation is based on the defection of phase current according to rotor position. This sensorless method is very simple to detect excitation position estimation and gives efficient control of drive system. The suggested method is verified by some simulations and experimental tests

• Journal of the Korean Society of Tobacco Science
• /
• v.6 no.1
• /
• pp.51-62
• /
• 1984

The chemical components of non-blended and blended cigarettes and their smoke have been analyzed to investigate the correlation between them. Some regression of linear equations were obtained based on the simple correlation data(r), for the various smoke components such as tar, nicotine, nitrogen dioxide, steam volatile phenols, formaldehyde, acetaldehyde, acrolein and hydrogen cyanide. Chi-square tests were carried out to observe the probabilities of the values estimated by the regression of linear equations. The probabilities of the greater values were 0.900-0.999 to tar, nicotine, formaldehyde, acetal dehyde, acrolein, steam volatile phenols, nitrogen dioxide and hydrogen cyanide of the non-blended cigarettes, and 0.900-0.999 to tar, nicotine, nitrogen dioxide, steam volatile phenols and static burning rate (SBR) of the blended cigarettes.

• Fire Science and Engineering
• /
• v.7 no.1
• /
• pp.11-16
• /
• 1993

Fixed temperature heat detectors that respond to the heat generated in fire plume and alarm when the temperature reaches a specified point, give a great influences to the loss of life and property according to their reaction sensitivity. In this study, hot wind tunnel tests and compartment fire experiments were performed to investigate the response time and temperature of fixed temperature heat detector. As a result, simple equations were derived which can be predicted the response time and temperature of the fixed temperature heat detector for the ramp type fire. Also other useful data, such as the effective temperature, time constant, response time index(RTI) were obtained.

• Food Science and Biotechnology
• /
• v.15 no.4
• /
• pp.494-498
• /
• 2006

An increase in variance (overdispersion) can occur when a binomial statistical analysis is applied to sensory difference test data in which replicate sensory evaluations (tastings) and multiple evaluators (judges) are combined to increase the sample size. Such a practice can cause extensive Type I errors, leading to serious misinterpretations of the data, especially when traditional simple binomial analysis is applied. Alternatively, the use of beta binomial analysis will circumvent the problem of overdispersion. This brief review discusses the uses and computation methodology of beta binomial analysis and in practice evidence for the occurrence of overdispersion.

• Earthquakes and Structures
• /
• v.8 no.1
• /
• pp.1-18
• /
• 2015

A simple method of assessing the risk of overturning of precast reinforced concrete columns is presented in this paper. The displacement-based methodology introduced herein is distinguished from conventional force-based codified methods of aseismic design of structures. As evidenced by results from field tests precast reinforced concrete columns can be displaced to a generous limit without sustaining damage and then fully recover from most of the displacement afterwards. Realistic predictions of the displacement demand of such (rocking) system in conjunction with the displacement capacity estimates enable fragility curves for overturning to be constructed. The interesting observation from the developed fragility curves is that the probability of failure of the precast soft-storey column decreases with increasing size of the column importantly illustrating the "size effect" phenomenon.

• Wind and Structures
• /
• v.18 no.4
• /
• pp.375-389
• /
• 2014

The high-frequency force-balance (HFFB) technique and its subsequent improvements are reviewed in this paper, including a discussion about nonlinear mode shape corrections, multi-force balance measurements, and using HFFB model to identify aeroelastic parameters. To apply the HFFB technique in engineering practice, various validation studies have been conducted. This paper presents the results from an analytical validation study for a simple building with nonlinear mode shapes, three experimental validation studies for more complicated buildings, and a field measurement comparison for a super-tall building in Hong Kong. The results of these validations confirm that the improved HFFB technique is generally adequate for engineering applications. Some technical limitations of HFFB are also discussed in this paper, especially for higher-order mode response that could be considerable for super tall buildings.

• Geophysics and Geophysical Exploration
• /
• v.6 no.4
• /
• pp.180-186
• /
• 2003

We have developed an one-dimensional (ID) inversion program that can invert multiple frequency small-loop EM data from horizontal coplanar (HCP) and vertical coplanar (VCP) configurations. The inverse problem is solved using least-squares method with active constraint balancing (ACB) method and Jacobian matrix is calculated analytically. Tests using synthetic data from simple ID models indicate that conductivity and depth of each layer can be estimated properly when both real and imaginary data are used together.