• Proceedings of the Optical Society of Korea Conference
• /
• 2003.07a
• /
• pp.118-119
• /
• 2003

조명각 변조방식에 의한 3차원 디스플레이 모듈의 구성요소는 back light unit(BLU), stripe-patterned LC shutter, lenticular lens sheet이다. 이런 3차원 디스플레이 에서 조명각도의 올바른 변조를 위해서는 stripe-patterned LC shutter, lenticular lens sheet 상호 결합이 가장 중요하다. 그림 1 은 이러한 입체영상 module의 개념도이다. 그림과 같이 LC shutter위에 적절한 렌티큘러 렌즈 어레이를 설치할 때, 줄무늬 모양의 면 광원에서 방출된 빛이 한번은 정확히 오른쪽 눈으로 다음 번에는 왼쪽 눈으로 향하게 하여 양안 시차에 의해 3D영상이 보이도록 하는 것이 이 모듈의 핵심원리이다. (중략)

• Fire Science and Engineering
• /
• v.24 no.5
• /
• pp.50-59
• /
• 2010

Four fire scenarios, as the cases of fire sizes of 2 MW and 5 MW, and no installation and activation of atrium fire shutter for dormitory building of Daegu 'D college', were developed and fire simulations were run using FDS (ver. 5.5.0) and Pathfinder 2009 programs. By assessing fire and evacuation, the effects of atrium fire shutter and vents on the smoke control of atrium were evaluated and this study also analyzed fire hazard and egress safety for occupants in the dormitory. Fire shutter's preventing smoke transport around atrium was much effective, but smoke layer descended down the design limit of smoke height and kept about 2 m height from the atrium floor in all cases because flow rate through vents was not enough. For the case of 5 MW fire and no fire shutter, fire hazard was higher due to visibility than temperature and allowable egress time to stairwell was short less than 5 seconds for the occupants on the floors of 4F to 7F. For total occupants, egress time out of main doorway was calculated about 136 seconds. It is sure that additional systems improving the performance of smoke control need to be installed for more safe evacuation.

• 전기의세계
• /
• v.22 no.3
• /
• pp.79-80
• /
• 1973

This is the abstract of lecture on Electro-optic characteristics of D-KDP crystal and its application for high speed shutter made by Dr. Naomi Furuya; The professor of Yamanashi University in Kofu Japan on March 31, 1973 for KEEI in the auditorium of Korea Electric Company. His lecture is listened by KEEI members that KDP Z-cut crystal can be utilized as a high speed shutter of 10$^{-6}$ second, combining special camera and 2-3KV electrical impulse generator and also recording slide photographs on tungoten lamp crystal voltage and melting fuse phenomena due to over-current taken by this special equipment had been demonstrated.

• JOURNAL OF ELECTRICAL WORLD
• /
• no.10 s.130
• /
• pp.17-25
• /
• 1987

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.2
• /
• pp.133-140
• /
• 2014

3D stereoscopic display is becoming increasingly common. Most stereoscopic displays still require the viewers to wear 3D glasses to watch 3D contents. As it is widely known, especially in shutter glass method, 3D glasses normally cause to reduce the perceived colorfulness and sharpness considerably as well as brightness. In this paper, we have estimated and analyzed the degradation of perceptual brightness in 3D images viewed through the shutter glasses by using CIECAM02 model. This study focuses on loss of colorfulness and sharpness when PDP-TV is watched at 3D mode in shutter-glass type 3D-TV. We analyze perceptual colorfulness and sharpness of 3D display with glasses and propose a method to compensate 3D colorfulness and sharpness for the best 3D experience.

• Korean Journal of Optics and Photonics
• /
• v.9 no.6
• /
• pp.368-372
• /
• 1998

A 16-views 3 dimensional imaging system is designed by spatially combinding two 8-views time multiplexed image channels. Each 8-views channel composed of 3 primary color CRTs and a dichroic beam splitter which combining the three CRTs as one channel. Each CRT displays 8-view images time sequentially. These images are projected to a holographic screen of a size 1$\times$0.8 $m^2$ through a projection optics. Characteristics of the three different configurations of projection optics are examined with the optics designing program "DEMOS" to select an optimized projection optics for the system. The configulation of the optimized projection optics is found like following; images from each channel combined by two-fold mirror are projected by a projection objective through a 16-strips LCD shutter. In this configuration, the shutter should be located at the entrance pupil of the objective, and the folded edge of the two-fold mirror should contact symmetrically to the center line of the shutter.e shutter.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.53 no.2
• /
• pp.109-116
• /
• 2016

Sensing module of standing and moving human body using shutter method was developed. The module consists of Fresnel lens, pyroelectric infrared (PIR) sensor, interface circuit of the PIR, micro control unit(MCU), and alarm light emitting diode(LED). The principle for standing human body is chopping the thermal of human body using camera shutter. The human sensing signal in MCU by algorithm of interrupt function is detected. By unifying an apparatus and print circuit board(PCB), the developed module can be replaced as commercial moving human body detector. Experiment results show that sensing distance is about 7.0m and sensing angles is about $110^{\circ}$ at room temperature. In these condition, sending ratio was 100% and the power dissipation of the module was 100mW.

• Journal of the Ergonomics Society of Korea
• /
• v.9 no.2
• /
• pp.29-35
• /
• 1990

To investigate and analyze of the human brain-wave changes during 3-dimenslonal image load were expected to take not only an important basic information of 3-dimensional TV usage but also 3-dimensional image design. In this experiment, to analyze the difference of visual analyze handing system for which we present the 2- dimensional image having no parallex and 3-dimensional image by visual evoked potentials(VEP). 2-dimensional image and 3-dimensional image displayed on the screen through video. In the test, the time interval was one sec for presentation of stimulus considering united time of visual information of right eye and left eye during watching the 3-dimensional image also display time interval was 200 mesc for each stimulus image. Results are as follow, (1) N190 appears faster 16msec-20msec in the point of Fz, Cz, Pz, Oz when loaded 3D4 angle than 2D3 angle. (2) About of the P300, 3D4 angle(Otherwise, Oz point was reverse) and in the case of no equipment of liquid crystal shutter, there appeared PEAK near the P250. (3) There were 5% significant difference when the liquid crystal shutter was equiped and didn't, Therefore, this phenomenon show the possibility that Liquid crystal shutter influences on Visual Evoked Potentials.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.42 no.12
• /
• pp.111-116
• /
• 2005

We propose a BASK (Binary Amplitude Shift Keying) system for Giga-bit Modem in millimeter band. The proposed system consists of a high speed shutter of the transmitter and a repeater of the receiver. The shutter of the proposed system is introduced for pulse shaping to improve the intersymbol interference (ISI). The repeater consists of several stage converters. A converter is constructed with a low pass filter and a limiter. The repeater can improve the signal-to-noise ratio (SNR) and make the rectangular pulse train. The proposed system is a simple system that uses conversion method without IF (Intermediate Frequency) process.

• Journal of Digital Contents Society
• /
• v.5 no.1
• /
• pp.73-78
• /
• 2004

In this paper we implemented a field-sequential stereoscopic endoscope system that can generate stereoscopic images with different perspective depth using LCD shutter. The stereoscopic image is generated form stereoscopic adapter that has LCD shutter. We have compared the stereoscopic depth of a field-sequential stereoscopic endoscope system with that of the conventional endoscope system. And the implemented system is verified by evaluation the field-sequential stereoscopic image on a Monitor. This system will be use to medical instruments in time.