• Journal of the Korean Ceramic Society
• /
• v.28 no.8
• /
• pp.577-584
• /
• 1991

Among various forming techniques for ceramics, we have studied the slip casting method for the binary system of SiC and carbon. The stability of the slip of silicon carbide and carbon were investigated by measurements of zeta potential, viscosity, sedimentation height, and also studied as functions of PH and amounts of dispersants. A preform of SiC and C was prepared by slip casting and heat treatment at 400∼600$^{\circ}C$ under N2 gas. The preform was reacted with Si metal at 1550$^{\circ}C$, 10-1 mmHg to give rise a reaction bonded SiC with a density of 3.0g/㎤ and a bending strength of 580 MPa.

• Economic and Environmental Geology
• /
• v.43 no.4
• /
• pp.333-341
• /
• 2010

Fluvial sediments are widely distributed in present and old river-beds of the mid-Keum River, the tributaries of which are the Yugu and Jeongan Rivers. The basement of the mid-Keum River area consists of Mesozoic granites which are easily eroded compared to Precambrian gneisses, which are exposed in the upper-Keum River area. The provenance of the fluvial sediments includes both the Precambrian gneisses and Mesozoic granites, which occur in the catchment of the mid-Keum River. The coarse-grained sediments were probably transported from the river-beds and the overbank floodings of the main Keum River and its tributaries when the climate was warm and wet. The oldest mud deposits were dated at ca. 9,400 yr BP by the radiocarbon method. It has been estimated that the sand deposits below the dated muds were formed in a period from the Late Pleistocene to the Early Holocene. However we have revealed that the major part of the present river-bed sediments was formed at ca. 3,000-6,000 yr BP, i.e., in the mid- to late Holocene, when summer monsoon was very strong due to climatic changes. We have calculated fluvial sedimentation rates of 0.12-0.16 cm/yr and 0.02-0.09 cm/yr for borehole KJ-29 river-bed sediments and borehole KJ-28 floodplain deposits, respectively. We conclude that the sedimentation rate is higher near the present stream channel than near the floodplain.

• Journal of Korean Society of Environmental Engineers
• /
• v.29 no.1
• /
• pp.74-81
• /
• 2007

Using the new experimental method named "filtration-permeation", the average specific resistances which plays an important role in designing cake filtration apparatus and the development of cake filtration theory were measured in this study. By this new experimental method, two kinds of average specific resistances are measured. The one from the filtration is named 'filtration average specific resistance $\alpha_{avf}$, and the other from the permeation of particle eliminated water through the pre-formed cake is named 'permeation average specific resistance $\alpha_{avf}$. The "filtration-permeation" method is applied to three different kind of suspensions(i.e. particulate suspension, pre-flocculated suspension and macro-molecule suspension) to obtain filtration and permeation average specific resistances. A theoretical procedure of cake filtration is studied based on the values of permeation average specific resistance. With the study it was concluded that the influence of the sedimentation during particlulate filtration operation could not be ignored as commonly used. And the solid content of suspension, S, which also regarded usually as constant, changes during filtration of particles. It is also verified that the exact value of solid content of cake for floe filtration could not be obtained. These significant problems are all solved by our new "filtration-permeation" experimental method.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.1
• /
• pp.119-125
• /
• 2018

The particle based computational fluid dynamics (CFD) method, which follow Lagrangian approach for fluid dynamics, fluid particle behavior by tracking all particle calculation physical quantities of each particle. According to basic concept of particle based CFD method, it is difficult to satisfy continuum theory and measure influences from neighboring particle. Article number density and weight function were used to solve aforementioned issue. Difficulties continuum mean simulate non-continuum particles such as solid including granular and sand. In this regard, the particle based CFD method modified solid particle problems by replacing viscous and surface tension forces friction and drag forces. In this paper, particle interaction model for solid particle friction model implemented to simulate solid particle problems. The broken dam problem, which is common to verify particle based CFD method, used fluid or solid particles. The angle of repose was observed in the simulation results the solid particle not fluid particle.

• Journal of the Korean Geotechnical Society
• /
• v.22 no.12
• /
• pp.5-14
• /
• 2006

In general, the dredged ground was composed of a big difference of sediment shape through segregating sedimentary of finer soil in case of reclaiming by dredged coarse soils. Therefore, this study was performed to evaluate the change of settling velocity of flow, and the density of sedimentary which is based on settling tests and self-weight consolidation tests, and consolidation test by seepage force according to the percentage of coarse of Kunsan dredge soils. The Yano's method has been applied to estimate the settlement of self-weight consolidation in finer soils at design but it only considers pouring water content and elevation of interface, therefore the other method needs to be introduced for the exact prediction of the settlement of coarse soil in which the segregation sedimentation is occurring. In this study, the settlement of self-weight consolidation was calculated by the change of the density of segregating sedimentary of coarse and finer soils which was analyzed by Yano's method to extend a serious of researches. The self-weight consolidation by Yano's method will not reflect the segregated settling in dredging coarse soil under 40% of #200 passing percentage. As a result, the evaluation technique of settlement of self-weight consolidation considering a change of the density of segregating sedimentary is suggested as a reasonable method that considers the sediment shape of coarse soil.

• Korean Chemical Engineering Research
• /
• v.55 no.6
• /
• pp.816-821
• /
• 2017

An integrated slow mixing/sedimentation and net fit fiber filtration system has been developed to reduce the high concentrations of suspended solid (SS) and total phosphorus (T-P) in the reject water from sewage/wastewater. A filtration device used in this experiment consists of coagulation, in-line mixing, air injection, slow mixing/sedimentation, and filtration processes. The performance test using this device was carried out with six operational modes for reject water from sewage treatment plant. Experimental conditions used were 16.7, 33.3, 41.7 and 50.0 ton/day of flow rate and 2~4 of Al/P molar ratio. By injection of coagulant in each operational mode, the high removal efficiencies of SS and T-P were obtained, but continuous operation time was decreased to 7.8~11.4 min in most modes. However, when the Mode 5 of the developed filtration device was applied, the continuous operation time was maintained up to 88.2 min. Also, it was found that the continuous operation time in the Mode 5 using the developed system was increased from 8 to 11.3 times longer than those in other modes. Backwashing flow rate was also very low at 5.4% of total filtered water. Therefore, it can be concluded that the Mode 5 of the developed filtration system was the most efficient treatment method for the removal of high concentrations of SS and T-P.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.37 no.4
• /
• pp.472-476
• /
• 2008

The possibility of DNA comet assay as a rapid method for screening the irradiated vegetables and grains was evaluated. Vegetables (spring onion, garlic, and tomato) irradiated at $0{\sim}3$ kGy and grains (rice flour and black soybean) irradiated at $0{\sim}9$ kGy were used as samples. Optimum DNA comet assay conditions, such as elution, sedimentation of suspension, and lysis time of cell, were established. The optimum conditions for vegetables were 10 min for the elution time, 0 min for the sedimentation time, and 5 min for the lysis time. The optimum conditions for grains were 15 min for the elution time, 60 min for the sedimentation time, and 30 min for the lysis time. For the food application of DNA comet assay, it was possible to screen various food samples irradiated at the following doses: spring onion at 2 kGy, garlic at 3 kGy, tomato at 1 kGy, rice flour at 9 kGy, and black soybean at 3 kGy. Each sample showed different forms and sizes in DNA comet. Therefore, further studies on various methods using comet shape, concentration, or area in DNA comet assay are necessary.

• Journal of Korean Society of Water and Wastewater
• /
• v.20 no.5
• /
• pp.691-700
• /
• 2006

This study conducted to optimize the design and operation of orifice typed distribution channels which were generally constructed to link the rapid mixing process and flocculation/sedimentation basin. To accomplish the goal of this study, programming step method using FORTRAN 90, was applied it to simulate the performance of existing distribution channel in the selected S DWTP (Drinking Water Treatment Plant). The proposed step method program was validated in terms of the feasibility with comparison between the measurement and prediction value in each orifice. From the evaluation results of the current conditions with the design and operation, it was revealed that the existing gradient of the tapered channel is not appropriate. Also, we suggested that in the case of the inlet width being 3.5m, reducing the downstream width by about 0.5m would make more equitable distribution flow in the channel. Consequently, dealing with various conditions of the design and operation with distribution channel, we could conclude that for the parallel typed channel, as the width is wider and the diameter of orifice is smaller, the more equitable distribution occur. In addition, the inlet flowrate and the number of orifice can affect the flow velocity in the channel.

• Journal of Korean Society of Water and Wastewater
• /
• v.23 no.6
• /
• pp.789-797
• /
• 2009

The flow in the beginning lateral sewer can be characterized as intermittent and unsteady, and a moment maximum flow energy is required to transport fecal solids in the sewer. It is thus difficult to design to satisfy a minimum velocity criteria (0.6m/s), because of the substantially lower discharge in the beginning lateral sewer. This study is the result of a field survey, and aims to determine a design criteria for the minimum slope to prevent sediment in a lateral sewer. The survey performed on the two flat small catchments in Goyang-si consisting of D400mm hume-pipe, aimed to understand the manner in which the scope of a sewer slope has an effect on sediment in the beginning lateral sewer. The survey showed that the sewer slope below 3‰ had sedimentation of 88.7%, while the sewer slope of 3~6‰ had sedimentation of 47.8%. In addition, the minimum design slope was estimated to refer to the result of hydraulic experiments from Public Works Research Institute in Japan. Analysis showed that the D400mm hume pipe should be installed with a slope of 6.5‰ to prevent sediment in the beginning lateral sewer. For future installations, the study results showed that a D300mm plastic pipe requires a minimum slope of 3.5‰, and a D250mm plastic pipe requires a minimum slope of 3.3‰ in the beginning lateral sewer.

• Journal of the Korean Academy of Clinical Electrophysiology
• /
• v.5 no.2
• /
• pp.85-93
• /
• 2007

Summary of background data: It is researched until now and the researches against the effect of position cold treatment the effect which pain threshold, change of skin temperature, researches the effective stiffness, the coldness in the patient it applied and relax an inflammation do the researches against were insufficient. Purpose: This project was to see how much it gives effect by using the cold air therapy an inflammation relief of rheumatoid arthritis patient. Methods: The medical subjects were 10 people from standard to diagnosis category of American College of Rheumatology(ACR) who had rheumatoid arthritis and to inspect informations about inflammation relief, have inspected ESR(erythrocyte sedimentation rate) and WBC(white blood cells). The experiment method was to let the patient bend the joint and lay down flat and treat with cold air from 10 cm away from joint line repeating 5 minutes treatment 1 minute rest and 3 minutes treatment. ESR and WBC cold air therapy reported with 5 days gap and each patient has been applied for 3 times. Result: The 5th day and 10th days ESR and WBC value shows when using cold air therapy, there was a reduction on rejected group but didn't last long, but 15th day it showed only on WBC it had its attention. Conclusions: So the cold air therapy shows it has positive effects on inflammation relief of rheumatoid arthritis patient.