• Journal of electromagnetic engineering and science
• /
• v.17 no.2
• /
• pp.57-64
• /
• 2017

In this paper, an asymmetric compact multiband slot antenna is proposed for global positioning system (GPS), worldwide interoperability for microwave access (WiMAX), and wireless area network (WLAN) applications. The top plane, a ground is composed of a rectangular slot with a trapezoidal-like stub, an inverted U-shaped slot at the right side of the rectangular slot, an inverted L-shaped slot at the left side of the rectangular slot, and three stubs. The proposed antenna is fed by an asymmetric cross-parasitic strip on the bottom plane. By properly designing the slots and stubs, four resonant frequency bands are achieved with -10 dB reflection coefficient bandwidths of 50 MHz, 400 MHz, 390 MHz, and 830 MHz in the 1.57 GHz GPS band, 2.4 GHz WLAN band, 3.5 GHz WiMAX band, and 5.5 GHz WLAN bands, respectively. The antenna has a total compact size of $13mm{\times}32mm{\times}0.8mm$. Simulated and measured results indicate that the proposed antenna has sufficient bandwidth and good radiation performance in each band.

• Journal of Advanced Navigation Technology
• /
• v.17 no.6
• /
• pp.646-651
• /
• 2013

In this paper, a small inverted-F antenna with adjustable characteristics is proposed with use of lumped elements, capacitor and resistor. Capacitor is inserted between end of the antenna and ground for size reduction and tuning of resonant frequency. On the other hand, $0{\Omega}$ resistor is replaced as the short line connected to ground. The movement of short point due to use of $0{\Omega}$ resistor results in providing variation of input impedance. Therefore optimum characteristics can be obtained only by proper choice of capacitor and short point without redesign of it's geometry. In order to check the validity, the proposed antenna is designed and fabricated for 2.4 GHz frequency band, and then is applied to a product of Zigbee wireless remote controller. As a result, the size of applied antenna is $8.5{\times}4.5mm^2$ and it is observed that the measured bandwidth and antenna gain are 150 MHz and 2 dBi respectively without redesign of the antenna.

• Journal of the Korea Society of Computer and Information
• /
• v.15 no.8
• /
• pp.59-66
• /
• 2010

In this paper, the internal antenna for mobile communication handset which is able to control both coupling coefficient and resonant frequency without any major modification of radiator and ground plane of antenna. Novel internal antenna with its controllable resonant frequency is presented for triple-band or over mobile handsets. The operating range can include GSM(880~960 MHz), GPS($1,575{\pm}10MHz$), DCS(1,710~1,880MHz), US-PCS(1,850~1,990 MHz), and W-CDMA(1,920~2,170 MHz). The proposed antenna is realized by combination of a half wavelength loaded line antenna and PIFA(Planner Inverted F Antenna). A single shorting and feeding points are used and they are common to both antenna structures. One of two inductors which is placed at each shorting post, one inductor is for adjusts amount of coupling, and the other controlling the resonant frequency in DCS/US-PCS/WCDMA bands. The inductance range for control of input impedance is between 0nH and 6.8nH, and each of gain variation in GSM, GPS and DCS/US-PCS/WCDMA band is under 0.15dBi, 0.73dBi and 0.29dBi. The inductance range for control of the resonant frequency is between 1640MHz and 2500MHz, and each of gain variation in GSM, GPS and DCS/US-PCS/WCDMA band is under 0.46dBi, 0.53dBi and 0.8dBi.

• Proceedings of the KIEE Conference
• /
• 2009.07a
• /
• pp.1561_1562
• /
• 2009

In this paper, designed triple-band antenna of PIFA(Planar Inverted-F Antenna) structure with U-slot. We designed optimal PIFA structure using Evolution Strategy(ES) about two U-slot parameters. We materialized API(Application Program Interface) about EM simulator and Excel using VB(Visual Basic). The result of ES for triple-band PIFA are resonant frequency of 430MHz, 910.5MHz, 2458.5MHz.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.27 no.8
• /
• pp.42-50
• /
• 2013

The reactionary responses to control human standing dynamics were estimated under the assumption that postural complexity mainly occurs in the mid-sagittal plane. During the experiment, the subject was exposed to continuous horizontal perturbation. The ankle and hip joint rotations of the subject mainly contributed to maintaining standing postural control. The designed mobile platform generated anterior/posterior (AP) motion. Non-predictive random translation was used as input for the system. The mean acceleration generated by the platform was measured as $0.44m/s^2$. The measured data were analyzed in the frequency domain by the coherence function and the frequency response function to estimate its dynamic responses. The significant correlation found between the input and output of the postural control system. The frequency response function revealed prominent resonant peaks within its frequency spectrum and magnitude. Subjects behaved as a non-rigid two link inverted pendulum. The analyzed data are consistent with the outcome hypothesized for this study.

• Journal of Advanced Navigation Technology
• /
• v.14 no.6
• /
• pp.817-823
• /
• 2010

Design of IPI feeding structure affecting the antenna gain improvement of mobile phone was investigated. IPI feeder which based on the T matching theory increase line current for internal antenna such as IFA. So IPI feeder makes higher radiation resistance, and also increases the gain with increasing radiation efficiency. To verify IPI feeding effect, feeder is applied to conventional CDMA/DCS dual band IFA. Measurement shows that IPI-IFA has 0.5 ~ 1.4[dBi] higher gain than conventional IFA at CDMA/DCS band. Resonant frequency did not change.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.23 no.3
• /
• pp.328-334
• /
• 2012

This paper proposes a design technique of wide-band antenna for handy phone with 700 MHz LTE(Long Term Evolution) low frequency bandwidth. The proposed antenna based on the PIFA(Planar Inverted-F type Antenna) structure was designed and considered. In order to realize the wide bandwidth, a round structure which is able to control the electric path length of current and a branch line element which can be obtain the dual resonance characteristics were introduced in this design. As a result, It was realized about 95 MHz bandwidth in spite of very small space of $30{\times}34mm$ used for FR-4 substrate with relative permitivity of 4.4 at 700 MHz band. Measurement results of return loss, bandwidth and gain radiation pattern were agreed well with their calculation results.

• Journal of Advanced Navigation Technology
• /
• v.13 no.6
• /
• pp.838-845
• /
• 2009

In order to obtain magneto-dielectrics with various permmittivity and permeability which could be used as the antenna substrate, various magneto-dielectrics compounded of dielectric materials(such as silicon and epoxy resin) and magnetic materials(such as carbonyl iron, barium and strontium powder) were fabricated. The relative permittivity and permeability of those were measured by use of HP 4291B impedance analyzer. Based upon the measured results, inverted-F meander monopole antennas(IFA) which were printed on the magneto-dielectric substrates fabricated as film type were designed and fabricated to investigate into variations of antenna characteristics such as the resonant frequency and impedance bandwidth in comparison with use of dielectric substrate. Some simulated and measured results for the designed IFA were presented. Characteristics of magneto-dielectrics which are different according as the choice of magnetic material or the composition ratio between magnetic material and dielectric material is different have been discussed.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.2
• /
• pp.31-40
• /
• 1999

Characteristics of monopole antenna and planar conductor structure mounted on handheld telephone are anlayzed by using FDTD method. Feeding of monopole antenna is implemented with lumped elements and plastic case is coated on the surface of conductor box. Otherwise, resonant frequency of handheld telephone mounting monopole antenna with no plastic case is 877MHz, when plastic case (${\varepsilon}_r=2$) is coated, the resonant frequency is down to 82MHz and the bandwidth is broadened about 1.5 times. Planar structure of handheld telephone mounted on the body makes to change far-field gain radiation patterns. In this case, radiation patterns are somewhat asymmetrical. Handheld telephone using PIFA(Planar Inverted F Antenna), instead of monopole antenna, is resonated at frequency 1.52GHz that is available onPCS. In the radiation pattern of this structure, azimuth that electric field intensity is presented below 20dB is 14$^{\circ}$.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.16 no.2
• /
• pp.9-17
• /
• 2002

A high-efficiency electronic ballast for HID lamps is presented. The ballast consists of a PFC and a resonant inverter. To reduce losses of the ballast, DC link voltage should be determined by taking into account the peak voltage of lamp and the maximum flux density should be kept 0.2[T] on all of inductors. AR inductor at bridge diode is employed in order to remove currant harmonics from PFC. An inductor is connected in series with an electrolytic capacitor at DC link to reject high-frequency current. The acoustic resonance is eliminated using the stead spectrum technique. The electronic ballast for 250[W] metal-halide discharge lamp is implemented and 96[%] efficiency, no acoustic resonance and low conducted EMI level are accomplished.