• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.43 no.9 s.351
• /
• pp.60-68
• /
• 2006

Using the wireless communication among unacquainted vehicles, an intelligent vehicle safety system can be constructed to exchange vehicle safety-related information, such as urgency stop, traffic accident and road obstacles. In the majority of vehicle safety applications, vehicle safety messages are propagated in the form of broadcast. However, this approach causes some effectiveness and performance problems with massive radio collision, multi-hop propagation. This paper presents a priority based relay node selection method for propagating vehicle safety messages of traffic accident protection system. With this method, vehicle safety messages are relayed by a node that locates in proper distance out of the nodes that are included in the radio transmission range. By decreasing the number of duplicated messages, the packet overhead is lessened while the communication performance is raised. The proposed method was proven to be better than other schemes through network simulations.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.24 no.12
• /
• pp.1639-1645
• /
• 2020

In this paper, we propose a virtual full-duplex relaying scheme based on data ferrying using two unmanned aerial vehicles (UAVs). By utilizing high mobility of two UAVs, the proposed relaying scheme can make each UAV communicate with a source node or a destination node when the UAV is near the source node or the destination node. The proposed relaying scheme can overcome the performance limitations of the half-duplex relaying and the implementation constraints of the full-duplex relaying. In addition, we propose an algorithm to shift the center point of two UAVs' trajectory with consideration of inter-relay interference (IRI). We show the simulation results of our proposed trajectory's center point shift algorithm. From the simulation results, it is shown that our proposed relaying scheme can achieve higher end-to-end spectral efficiency (SE) than the conventional static relaying scheme.

• Journal of Korea Multimedia Society
• /
• v.12 no.9
• /
• pp.1273-1287
• /
• 2009

PEGASIS, a chain-based protocol, forms chains from sensor nodes so that each node transmits and receives from a neighbor. In this way, only one node (known as a HEAD) is selected from that chain to transmit to the sink. Although PEGASIS is able to balance the workload among all of the nodes by selecting the HEAD node in turn, a considerable amount of energy may be wasted when nodes which are far away from sink node act as the HEAD. In this study, DERP (Distance-based Energy-efficient Routing Protocol) is proposed to address this problem. DERP is a chain-based protocol that improves the greedy-algorithm in PEGASIS by taking into account the distance from the HEAD to the sink node. The main idea of DERP is to adopt a pre-HEAD (P-HD) to distribute the energy load evenly among sensor nodes. In addition, to scale DERP to a large network, it can be extended to a multi-hop clustering protocol by selecting a "relay node" according to the distance between the P-HD and SINK. Analysis and simulation studies of DERP show that it consumes up to 80% less energy, and has less of a transmission delay compared to PEGASIS.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.11 no.4
• /
• pp.1911-1930
• /
• 2017

Overlay routing has emerged as a promising approach to improve reliability and efficiency of the Internet. The key to overlay routing is the placement and maintenance of the overlay infrastructure, especially, the selection and placement of key relay nodes. Spurred by the observation that a few relay nodes with high betweenness centrality can provide more optimal routes for a large number of node pairs, we propose a resilient routing overlay network construction method by introducing Super-Relay nodes. In detail, we present the K-Minimum Spanning Tree with Super-Relay nodes algorithm (SR-KMST), in which we focus on the selection and connection of Super-Relay nodes to optimize the routing quality in a resilient and scalable manner. For the simultaneous path failures between the default physical path and the overlay backup path, we also address the selection of recovery path. The objective is to select a proper one-hop recovery path with minimum cost in path probing and measurement. Simulations based on a real ISP network and a synthetic Internet topology show that our approach can provide high-quality overlay routing service, while achieving good robustness.

• Journal of Communications and Networks
• /
• v.10 no.2
• /
• pp.186-193
• /
• 2008

A two-hop multiple-input multiple-output (MIMO) relay network which comprises a multiple antenna source, an amplify-and-forward MIMO relay and many potential users are studied in this paper. Consider the achievable sum rate as the performance metric, a joint design method for the processing units of the BS and relay node is proposed. The optimal structures are given, which decompose the multiuser MIMO relay channel into several parallel single-input single-output relay channels. With these structures, the signal-to-noise ratio at the destination users is derived; and the power allocation is proved to be a convex problem. We also show that high sum rate can be achieved by pairing each link according to its magnitude. The sum rate of three broadcast strategies, time division multiple access (TDMA) to the strongest user, dirty paper coding (DPC), and beamforming (BF) are investigated. The sum rate bounds of these strategies and the sum capacity (achieved by DPC) gain over TDMA and BF are given. With these results, it can be easily obtained that how far away TDMA and BF are from being optimal in terms of the achievable sum rate.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.12 no.4
• /
• pp.31-36
• /
• 2012

In this paper, we proposed spectrum sensing using cooperative relay to solve problem of sensing performance degradation due to CPE (Customer-Premises equipments) which causes low SNR (signal-to-noise ratio) problem. In cooperative communication system, AF (amplify-and-forward) and DF (decoded-and-forward) is widely used for relay mechanism. Also, it is expected that cooperative relay scheme guarantees the high sensing performance by its diversity gain. Based on these backgrounds, in this paper, we apply to cooperative relay scheme to the CR (Cognitive Radio) system, and simulation results show comparison of the sensing performance.

• Journal of Satellite, Information and Communications
• /
• v.7 no.1
• /
• pp.7-12
• /
• 2012

In this paper, we proposed spectrum sensing using cooperative relay to solve problem of sensing performance degradation due to CPE (Customer-Primise equipments) which causes low SNR (signal-to-noise ratio) problem. In cooperative communication system, AF (amplify-and-forward) and DF (decoded-and-forward) is widely used for relay mechanism. Also, it is expected that cooperative relay scheme guarantees the high sensing performance by its diversity gain. Based on these backgrounds, in this paper, we apply to cooperative relay scheme to the CR (cognitive radio) system, and simulation results show comparison of the sensing performance between AF and DF.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.9 no.4
• /
• pp.17-24
• /
• 2009

This paper deals with the cancellation performance of loop back interference signal in the case of multihop relay of 16-QAM received signal at the USN radio network. For this, it is necessary to the exchange of information with long distance located station by means of the relay function between the node in the USN environment. In the relay node, the loop-back interference signal which the retransmitting signal is feedback to the receiver side due to the antenna of transmitter and receiver are co-used or very colsely located or using the nonlinear device. Due to this signal, the performance of USN system are degraded which are using the limited resource of frequency and power. For improve this, it is necessary to applying the adaptive signal processing algorithm in order to cancellating the unwanted loop-back interference signal at the frontend of receiver in relaying node, we can get the better system and multi hop performance. In the adaptive signal processing, we considered the 16-QAM signal which has a good spectral efficiency, firstly, than, the QR-Array RLS algorithm was used that has a fairly good convergence property and the solving the finite length problem in the H/W implementation. Finaly, we confirmed that the good elimination performanc was confirmed by computer simulation in the learing cuved and received signal constellation compared to the conventional RLS.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.3A
• /
• pp.215-222
• /
• 2011

In this paper, we propose a power control scheme for effective serving cell selection in Relay environment of 3GPP (3rd Generation Partnership Project) LTE (Long Tenn Evolution)-Advanced system. A conventional serving cell selection scheme which does not use channel states of backhaul link has a problem that this scheme does not select serving cell supporting maximum throughput. Also, conventional proposed serving cell selection schemes that eNB or RN transmits channel states of backhaul link have problems that conventional schemes need to additional data transmission, serving cell selection process complexity is increased because UE considers channel states of backhaul link, and received signal is degraded because strong interference which is transmission signal from RN. Therefore, for solve these problems, we propose power control scheme that RN control transmission power according to received SINR (Signal to Interference plus Noise Ratio) of backhaul link. By extensive computer simulation, we verify that the power control Relay scheme is attractive and suitable for the Relay environment.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.7 no.7
• /
• pp.1547-1568
• /
• 2013

Wireless body area network (WBAN) is an emerging short-range wireless communication network with sensor nodes located on, in or around the human body for healthcare, entertainment and ubiquitous computing. In WBANs, energy is severely constrained which is the prime consideration in the medium access control (MAC) protocol design. In this paper, we propose a novel MAC protocol named Energy-efficient Relay MAC with dynamic Power Control (ERPC-MAC) to save energy consumption. Without relying on the additional devices, ERPC-MAC employs relaying nodes to provide relay service for nodes which consume energy fast. Accordingly the superframe adjustment is performed and then the network topology can be smoothly switched from single-hop to multi-hop. Moreover, for further energy saving and reliability improvement, the dynamic power control is introduced to adjust the power level whenever a node transmits its packets to the coordinator or the relaying node. To the best of the authors' knowledge, this is the first effort to integrate relay, topology adjustment and power control to improve the network performance in a WBAN. Comprehensive simulations are conducted to evaluate the performance. The results show that the ERPC-MAC is more superior to the existing standard and significantly prolongs the network lifetime.