• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.27 no.2C
• /
• pp.191-200
• /
• 2002

A frequency synthesizer that can be used in IMT-2000 was designed and fabricated using dual loop PLL(Phase Locked Loop) in this paper. For improving phase noise characteristic two loops, reference loop and main loop, were divided. Phase noise was improved by transformed clamp type voltage controled oscillator and optimizing loop bandwidth in reference loop. And voltage controlled oscillator open loop gain in main loop. Fabricated the frequency synthesizer had 1.81GHz center frequency, 160MHz tuning range, 13.5dBm output power and -119.73dBc/Hz low phase noise characteristic.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.1
• /
• pp.325-330
• /
• 2015

With approval from the Asia Pacific Metrology Program Working Group on Materials Metrology (APMP WGMM), an international comparison for sheet resistance standards for silicon wafers was firstly conducted among Korea Research Institute of Standards and Science (KRISS) in Korea, CMS/ITRI in Taiwan, and NIM in China, which are national metrology institutes (NMIs), from August 2011 to January 2012. The sheet resistance values of the standards are $10{\Omega}$, $100{\Omega}$, and $1000{\Omega}$; the measurement was conducted in sequence at KRISS, CMS/ITRI, NIM, and KRISS again using the four-point probe method with single and dual configuration techniques. The reference value for the measurement results of the three NMIs was obtained through averaging the values of the three results for each sheet resistance range. The differences between the reference value and the measured values is within 0.22% for $10{\Omega}$, 0.17% for $100{\Omega}$, and 0.12% for $1000{\Omega}$. Therefore, the international consistency for conducting sheet resistance measurements is confirmed within 0.22% through the APMP WGMM approved comparison.

• Journal of Positioning, Navigation, and Timing
• /
• v.3 no.1
• /
• pp.25-30
• /
• 2014

Differential Global Positioning System-Correction Projection (DGPS-CP) algorithm, which has been suggested as a method of correcting pre-calculated position error by projecting range-domain correction to positional domain, is a method to improve the accuracy performance of a low price GPS receiver to 1 to 3 m, which is equivalent to that of DGPS, just by using a software program without changing the hardware. However, when DGPS-CP algorithm is actually realized, the error is not completely eliminated in a case where a reference station does not provide correction of some satellites among the visible satellites used in user positioning. In this study, the problem of decreased performance due to the difference in visible satellites between a user and a reference station was solved by applying the Multifunctional Transport Satellites (MTSAT) based Augmentation System (MASA) correction to DGPS-CP, instead of local DGPS correction, by using the Satellite Based Augmentation System (SBAS) operated in Japan. The experimental results showed that the accuracy was improved by 25 cm in the horizontal root mean square (RMS) and by 20 cm in the vertical RMS in comparison to that of the conventional DGPS-CP.

• Journal of Institute of Control, Robotics and Systems
• /
• v.10 no.7
• /
• pp.625-633
• /
• 2004

In this paper, position control of a car-like mobile robot using a neural network is presented. positional information of the mobile robot is given by a laser range finder located remotely through wireless communication. The heading angle is measured by a gyro sensor. Considering these two sensor information as a reference, the robot posture is corrected by a cascaded controller. To improve the tracking performance, a neural network with a cascaded controller is used to compensate for any uncertainty in the robot. The neural network functions as a compensator to minimize the positional errors in on-line fashion. A car-like mobile robot is built as a test-bed and experimental studies of several controllers are conducted and compared. Experimental results show that the best position control performance can be achieved by a cascaded controller with a neural network.

• 제어로봇시스템학회:학술대회논문집
• /
• 2003.10a
• /
• pp.1099-1104
• /
• 2003

In this paper, the position control of a car-like mobile robot using neural network is proposed. The positional information of the mobile robot is given by a laser range finder located remotely through wireless communication. The heading angle is measured by a gyro sensor. Considering these two sensor information as references, the robot posture by localization is corrected by a cascaded controller. In order to improve the tracking performance, a neural network with a cascaded controller is used to compensate for any uncertainty in the robot. The remotely located neural network filter modifies the reference trajectories to minimize the positional errors by wireless communication. A car-like mobile robot is built as a test-bed and experimental studies of proposed several control algorithms are performed. It turns out that the best position control can be achieved by a cascaded controller with neural network.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.48 no.11
• /
• pp.34-40
• /
• 2011

This paper presents a low-dropout (LDO) linear regulator using ultra-low output impedance buffer for frequency compensation. The proposed buffer achieves ultra low output impedance with dual shunt feedback loops, which makes it possible to improve load and line regulations as well as frequency compensation for low voltage applications. A reference control scheme for programmable output voltage of the LDO linear regulator is presented. The designed LDO linear regulator works under the input voltage of 2.5~4.5V and provides up to 300mA load current for an output voltage range of 0.6~3.3V.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.3
• /
• pp.403-408
• /
• 2008

The gyroscope is the sensor for detecting the rotation in inertial reference frame and constitute the navigation system together an accelerometer. As the inertial reference equipment for attitude determination and control in the satellite, the mechanical gyroscope has been used but it bring the disturbance for mass unbalance so the disturbance give a bad influence to the observation satellite mission because the mechanical gyroscope has the rotation parts. During the launch. The mechanical gyroscope is weak in vibration, shock and has the defect of narrow operating temperature range so it need the special design in integration. Recently the low orbit observation satellite for seeking the high pointing accuracy of image camera payload accept the FOG(Fiber Optic Gyro) or RLG(Ring Laser Gyro) for the attitude determination and control. The Ring Laser Gyro makes use of the Sanac effect within a resonant ring cavity of a He-Ne laser and has more accuracy than the other gyros. It need the 1000V DC to create the He-Ne plasma in discharge tube. In this paper, the design process of the High Voltage Power Supply for RLG(Ring Laser Gyroscope) is described. The specification for High Voltage Power Supply (HVPS) is proposed. Also, The analysis of flyback converter topology is explained. The Design for the HVPS is composed of the inverter circuit, feedback control circuit, high frequency switching transformer design and voltage doubler circuit.

• Applied Chemistry for Engineering
• /
• v.26 no.1
• /
• pp.116-119
• /
• 2015

Field-effect transistor (FET)-based ion or biosensors have been intensively studied so far. Among many measurement methods, the variation of the drain current can be induced when ions or biomolecules are interacted with sensing membranes located on the gate insulator of FET. One of typical FET-type sensors is an ion-sensitive field-effect transistor (ISFET) utilized in this study. In ISFET, the voltage is usually applied to the reference electrode instead of the gate voltage. Firstly, the voltage applied to the reference electrode versus the drain current was observed, and the steepest slope in this graph was found. Using this point, the optimized condition was established for the larger variation of the drain current in the saturated region in response to the variation of the input in the dynamic range.

• Journal of Nutrition and Health
• /
• v.22 no.3
• /
• pp.175-184
• /
• 1989

This survey was carried out to obtain the information concerning nutritional status, including factors of food intake and health condition of elderly women living in Ulsan city. Main results were as follows. 1) Dietary intake data showed the average daily intake of energy, protein, vitamin A, riboflavin and ascorbic acid were lower than Korean recommended dietary allowances (RDA). According to the percentage of RDA, Vitamin A was the nutrient found to be least sufficient. 2) Among the various influencial factors, pocket money, meal-mate, skip meal and health concern influenced on nutrient intake considerably. A meal condition score based on influencial factors, showed significant correlations with all nutrient intake(P<0.001). A health score based n the subjects complains about health condition, showed significant correlations with intake of energy, carbohydrate, thiamin, and niacin(P<0.05). 3) Average hight was below Korea reference, while average body weight of subjects was close to Korean reference. Average body mass index was 23.0. 4) The average systolic and diastolic blood pressure was 140mmHg/88mmHg, the proportion of hypertension was 32.4 percent. The average hemglobin concentration was 12.7g/dl, only 6.7 percent of subjects were anemic. Serum cholesterol concentration was normal range(140~220mg/dl) in all subjects.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.34 no.8
• /
• pp.1403-1414
• /
• 2010

Consumer decisions and responses about the price to pay vary. Some consumers might decide the appropriate price range prior to shopping, while others compare and evaluate prices. Especially, consumers can have different reference points for price evaluation based on various price searching behavior that represent heterogeneous responses for prices in the clothing purchase decision-making process. This research identifies how consumers evaluate the price and helps explain their decision-making based on price searches. By analyzing qualitative research, we found that consumers recalled price information as a representative indicator and product level price information through the internal search. Their level of internal references can be an important factor affecting price evaluations. In addition, each consumer groups were subdivided into high and low external searching. The four types of responses to price were classified in the price search process and the identified differences in the price evaluation. Therefore, pricing strategy needs to be differentiated for these various consumer types.