• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.7 no.3
• /
• pp.45-53
• /
• 1987

The purpose of this research was to study the kinetics of a packed bed aerobic biofilm process. Experiments were carried out by feeding an aerated packed bed reactor with a synthetic wastewater. The reactor packed with glass beads as media had a nominal hydraulic detention time of 5 hours. The flow pattern in the reactor was determined by a tracer test using a NaCl solution to be a completely-mixed type. The results of the research showed that the F/M ratio in the reactor was almost constant since the the biomass increased due to the growth of biofilm as the volumetric organic loading increased. It was also proved theoretically and experimentally that packed bed aerobic biofilm process could be analyzed by the kinetics of completely-mixed activated sludge process with sludge recycle.

• Korean Journal of Environmental Agriculture
• /
• v.29 no.3
• /
• pp.232-238
• /
• 2010

The objective of this study was to investigate a small sewage treatment system. This system was developed to improve a nitrogen and phosphorus removal efficiency and generate less solid using upflow septic tank(UST) - aerobic filter(AF) system. The UST equipped with an aerobic filter, the filter was fed with both raw sewage and recycled effluent from the UST to induce the denitrification and solid reduction simultaneously. Overall removal efficiencies of COD and total nitrogen(TN) were above 96% and 73% at recycle ratio of 200%, respectively. Critical coagulant dose without the biochemical activity was found to be 40 mg/L. Removal efficiency of total phosphorus(TP) in influent was above 90% by chemical and biological reactions. Although the phosphorus concentration was low under the high alkalinity in raw sewage, the pH value was unchanged by the coagulant dose.

• Resources Recycling
• /
• v.25 no.2
• /
• pp.10-16
• /
• 2016

In this study, the Ni base superalloy was recycled by Argon oxygen decarburization(AOD) process using an inconel 713C scrap. During AOD process, argon gas was continuously injected 1,000 sccm and oxygen gas was injected into 10, 20 and 30 minutes of 100, 250 and 500 sccm.. In early stage of oxygen injection, the oxygen dose increased with increasing Al, Cr, and Mo content and decreasing C content. And Al content was decreased by carburization with added elements in late stage Because of oxidation was occurred with Al, Cr etc. after the reaction of carbon has been finished. From the results, the ratio of ${\gamma}^{\prime}$ phase reduced due to decreasing of Al content for that reason Al is the main element to form the ${\gamma}^{\prime}$ phase. Also carbide reduced owing to decreasing of C content so the mechanical properties of the specimens excessively injected by excess $O_2$ gas were decreased.

• International Journal of Highway Engineering
• /
• v.3 no.2 s.8
• /
• pp.103-112
• /
• 2001

This study was performed to evaluate applicability of recycled aggregates as subbase and surface concrete materials for cement concrete pavement. Laboratory compaction test, CBR test and plate load bearing test were conducted to evaluate applicability for pavement subbase materials. Recycled concrete for surface course was manufactured with a design strength of $280kgf/cm^2$. Normal coarse aggregate was substituted with recycled aggregates with five different ratios, 0%, 20%, 40%, 60% and 80% for recycled concrete mixes. Fresh concrete Properties, concrete strength properties for the five substitution percentages of recycled aggregates after 28-day curing and freezing-and-thawing resistance were evaluated experimentally. Based on the experimental results, it was concluded that the recycled aggregate was the material good enough to use for subbase material, and 40% or lower substitution ratio was an appropriate percentage of recycled aggregates replacement for surface concrete.

• Journal of Animal Environmental Science
• /
• v.20 no.4
• /
• pp.195-200
• /
• 2014

Liquid fertilization of pig manure slurry is very useful treatment method to recycle organic waste matter as a valuable fertilizer. The solids precipitate and accumulated at the bottom of liquid fertilization tank. The content of nitrogen and phosphate are higher in sediment than pig manure slurry. The pH of sediment was 7.53. S-COD/T-COD ratio of pig manure slurry and sediment were 0.477, 0.29, respectively. The moisture content of sediment of pig manure slurry and sediment were 80.45~83.82%, 97%, respectively. The content of organic matter of sediment was 8.79~10.56%. The content of nitrogen and phosphate of sediment and pig manure slurry were 9,000~11,100 mg/L, 9,100~11,100 mg/L, respectively. The particle size of pig manure slurry was distributed from 2 mm to 0.125 mm. On the other hand. the particle size of sediment was under 0.125 mm.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.3
• /
• pp.365-371
• /
• 2020

In this study, in order to recycle the stems of opuntia cactus discarded after harvesting the fruit, the cactus stems were powdered and applied as a cement-based admixture. The powder of cactus stem was mixed into the mortar, and its effect on the fresh properties and strength of the mortar was studied. The results were compared with the properties of mortars produced by mixing with a retarder sugar and a viscosity agent methyl-cellulose, which are conventional saccharide-based admixtures. Based on the test results, the cactus stem powder did not clearly show the effect as a retarding agent, whereas the flow and the air content were similar to those of the mortar mixed with methyl-cellulose. This indicated that the cactus stem powder can be used as a viscosity agent. It was found that the strength of the mortar tended to increase when the mixing ratio of the cactus stem powder was lower than 0.3%.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2008.04a
• /
• pp.445-448
• /
• 2008

It is essential that concrete component is made up with aggregate, cement and water. But today, Public concern is increasing of a variety structure and ocean environmental, resource recycle. Also, According to heat of hydration rising, Concrete is make a causative of concrete-crack. Concrete-crack cause a falling-off in quality of concrete. consequently, High-performance concrete is evaluated by concrete material properties and carbonation resistance with different admixture(fixing fly-ash 20%), granulated blast furnace slag replacement ratio (30%, 45%) different W/B (26%, 30%, 34%) and XRD(X-ray Diffraction) analysis.

• Resources Recycling
• /
• v.16 no.5
• /
• pp.51-56
• /
• 2007

Plastics are widely used in everyday life as very useful material. In Korea, about 4 million tons of plastic wastes are generated annually. However, recycling ratio is below 30%, and most of plastic wastes are disposed by landfill and incineration. Hence, the development of material separation technique that can recycle plastic wastes is a necessary situation. In this study, Triboelectrostatic separation for recovery of PET from final plastic wastes obtained from the sink product after wet-type gravity separation has been carried out. In the charging properties, the charge polarity and charge density of PET and PVC were very effective with the tirbo-charger made of PP and HDPE with the decrease in relative humidity. In material separation using HDPE cyclone charger, a PET grade of 96.80% and a recovery of 85.0% were achieved at 30 kV and the splitter position -2cm from the center. In order to obtain PET grade of 98.5%, PET recovery should be sacrificed by 24% with moving the splitter from the center to -6cm position.

• Resources Recycling
• /
• v.16 no.6
• /
• pp.20-27
• /
• 2007

This paper presents a detailed experimental study on the durability properties of mortar matrix made with two kind of recycled fine aggregates(RAA, RAB) and five replacement levels (0, 25, 40, 75 and 100) of the recycled fine aggregates as a partial replacement of natural fine aggregate (NA). The durability properties of mortar matrix was evaluated using compressive strength, chloride ion ingress, sulfate attack and carbonation. The test results indicated that the water absorption and Adhered mortar of the recycled fine aggregate was a major factor controlling durability properties. Hereafter, when using built recycled fine aggregate is expected, appropriate removal Adhered mortar and reasonable replacement ratio of recycled fine aggregates was 25% weight of cement are advised to apply to the concrete materials.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.5
• /
• pp.199-204
• /
• 2015

In this study, prevention methods of radial cracks generated inside of artificial lightweight aggregate made of reject ash and dredged soil were investigated. The reject ash and dredged soil had mixed with weight ratio of 7 : 3 and formed to spheric shape of 5~20 mm diameter, then, the aggregates were manufactured using flash sintering method at $1200^{\circ}C$ for 10 min. The formation of radial cracks in the aggregates were suppressed as the size of specimen decreased. Also, the addition of silica to aggregates had prevented generation of the radial cracks. As the size and the amount of silica powder added increased, the development of radial cracks was constrained. Therefore the artificial lightweight aggregate manufactured in this study expected to be applicable to many fields such as construction and environmental usages. Also it is expected to contribute greatly to increase the recycling rate of reject ash and dredged soil.