• Journal of the Korean Applied Science and Technology
• /
• v.26 no.3
• /
• pp.279-287
• /
• 2009

Fisher-Tropsch synthesis for the production of hydrocarbon from syngas was investigated on 20% cobalt-based catalysts (20% Co/HSA, 20% Co/Si-MMS), which were prepared by home-made supports with high surface areas such as high surface alumina (HSA) and silica mesopores molecular sieve (Si-MMS). In the gas phase reaction by syngas only, 20% Co/Si-MMS catalyst was shown in higher CO conversion and lower carbon dioxide formation than 20% Co/HSA, whereas the olefin selectivity was higher in 20% Co/HSA than in 20% Co/Si-MMS. In the effect of n-hexane added in syngas, the selectivities of $C_{5+}$ and olefin were increased by comparing the supercritical phase reaction with the gas phase reaction in addition to reduce unexpected methane and carbon dioxide.

• Transactions of the Korean hydrogen and new energy society
• /
• v.9 no.1
• /
• pp.25-30
• /
• 1998

4-probe resistivity measurement technique was used to study kinetics of hydrogen absorption on Pd film ($180{\AA}$ thick) in the ${\alpha}$ phase. Hydrogen gas was introduced to the activated Pd film. For very low hydrogen concentration the following rate law is valid in ${\alpha}$ phase very thin Pd film $$v=k\frac{1}{1+KX{_H}}PH{_2}-k^{\prime}\frac{KX{_H}{^2}}{1+KX{_H}}$$ which is similar to that of bulk. The activation energy of the forward reaction is 4.6kcal/mol H and of the backward reaction 8.4kcal/mol H, which yields the reaction enthalpy -3.8kcal/mol H in the temperature range between 25 and $40^{\circ}C$. The values of activation and enthalpy of thin film are rather smaller than that of bulk sample. This may be due to surface area difference between bulk and film.

• Journal of Microbiology and Biotechnology
• /
• v.27 no.2
• /
• pp.297-305
• /
• 2017

The use of peroxidase in the nitration of phenols is gaining interest as compared with traditional chemical reactions. We investigated the kinetic characteristics of phenol nitration catalyzed by horseradish peroxidase (HRP) in an aqueous-organic biphasic system using n-butanol as the organic solvent and ${NO_2}^-$ and $H_2O_2$ as substrates. The reaction rate was mainly controlled by the reaction kinetics in the aqueous phase when appropriate agitation was used to enhance mass transfer in the biphasic system. The initial velocity of the reaction increased with increasing HRP concentration. Additionally, an increase in the substrate concentrations of phenol (0-2 mM in organic phase) or $H_2O_2$ (0-0.1 mM in aqueous phase) enhanced the nitration efficiency catalyzed by HRP. In contrast, high concentrations of organic solvent decreased the kinetic parameter $V_{max}/K_m$. No inhibition of enzyme activity was observed when the concentrations of phenol and $H_2O_2$ were at or below 10 mM and 0.1 mM, respectively. On the basis of the peroxidase catalytic mechanism, a double-substrate ping-pong kinetic model was established. The kinetic parameters were ${K_m}^{H_2O_2}=1.09mM$, ${K_m}^{PhOH}=9.45mM$, and $V_{max}=0.196mM/min$. The proposed model was well fit to the data obtained from additional independent experiments under the suggested optimal synthesis conditions. The kinetic model developed in this paper lays a foundation for further comprehensive study of enzymatic nitration kinetics.

• Journal of the Korean Ceramic Society
• /
• v.28 no.12
• /
• pp.996-1004
• /
• 1991

In this study, we tried to synthesis iron hydroxide suitable for longitudinal magnetic recording media from waste acid, which is a by-product of an iron works factory. Effects of initial pH of reactants, reaction temperature, reaction time for the synthesis of acicular iron hydroxide were studied in relation to particle properties of iron hydroxide and magnetic properties of maghemite powders. As the pH in reactant solution increased, $\beta$-FeOOH(pH=4.5), mixture of $\beta$-FeOOH and $\alpha$-FeOOH(4.5$\alpha$-FeOOH and Fe3O4(6.4$\alpha$-FeOOH (pH>13) was found to from in order. Especially, $\alpha$-FeOOH formed above pH 13 was single phase with superior acicularity. The temperature range over which the single-phase goethite can be formed increased as the initial pH of reactants increased (pH 13:10~5$0^{\circ}C$, pH 13.2:10~7$0^{\circ}C$, pH 13.5:0~8$0^{\circ}C$). The goethite formed between 40~6$0^{\circ}C$ has superior characteristics because the acicularity increased with increasing temperature but at high temperature (>6$0^{\circ}C$) Fe3O4 (pH=13) was found to start to form. Generally, single phase of goethite was found to form after one hour when an optimized condition. The particle size of goethite did not change as the reaction time increased over one hour. Accordingly, the magnetic properties of ${\gamma}$-Fe2O3 produced from goethite were not altered.

• Korean Journal of Materials Research
• /
• v.21 no.6
• /
• pp.327-333
• /
• 2011

Nanostructured cobalt materials have recently attracted considerable attention due to their potential applications in high-density data storage, magnetic separation and heterogeneous catalysts. The size as well as the morphology at the nano scale strongly influences the physical and chemical properties of cobalt nano materials. In this study, cobalt nano particles synthesized by a a polyol process, which is a liquid-phase reduction method, were investigated. Cobalt hydroxide ($Co(OH)_2$), as an intermediate reaction product, was synthesized by the reaction between cobalt sulphate heptahydrate ($CoSO_4{\cdot}7H_2O$) used as a precursor and sodium hydroxide (NaOH) dissolved in DI water. As-synthesized $Co(OH)_2$ was washed and filtered several times with DI water, because intermediate reaction products had not only $Co(OH)_2$ but also sodium sulphate ($Na_2SO_4$), as an impurity. Then the cobalt powder was synthesized by diethylene glycol (DEG), as a reduction agent, with various temperatures and times. Polyvinylpyrrolidone (PVP), as a capping agent, was also added to control agglomeration and dispersion of the cobalt nano particles. The optimized synthesis condition was achieved at $220^{\circ}C$ for 4 hours with 0.6 of the PVP/$Co(OH)_2$ molar ratio. Consequently, it was confirmed that the synthesized nano sized cobalt particles had a face centered cubic (fcc) structure and with a size range of 100-200 nm.

• Journal of the Korean Ceramic Society
• /
• v.40 no.9
• /
• pp.891-896
• /
• 2003

Novel fabrication technique was developed for high strength Reaction-Bonded SiC (RBSC) hot gas filter for use in IGCC (Integrated Gasification Combined Cycle) system. The room and high temperature fracture strengths for Si-melt infiltrated reaction-bonded SiC were 50-123, and 60-66 MPa, respectively. The average pore size was 60-70 $\mu\textrm{m}$ and the porosity was about 34 vol％. RBSC infiltrated with molten silicon showed improved fracture strength at high temperature, as compared to that of clay-bonded SiC, due to SiC/Si phase present within SiC phase. The thickness for SiC/Si phase was increased with increasing powder particle size of SiC from 10 to 34 $\mu\textrm{m}$. Pressure drop with dust particles showed similar response as compared to that for Schumacher type 20 filter. The filter fabricated in the present study showed good performance in that the filtered powder size was reduced drastically to below 1 $\mu\textrm{m}$ within 4 min.

• Journal of the Korean Chemical Society
• /
• v.36 no.4
• /
• pp.546-551
• /
• 1992

Reaction mechanism on the solvent extraction of nickel(Ⅱ) with N-benzylisonitrosoacetylacetone imine(HIAANB) was studied spectrophotometrically. Absorbance was measured by changing the ligand HIAANB concentration in the chloroform organic phase and the pH values in the agueous solution phase. From the absorbance data, the reaction rate was found to be the first order for HIAANB concentration and the inverse first one for [$H^+$]. The rate determining step of the extraction reaction and the rate equation are as follows; $Ni^{2+}$＋HIAANB ${\to}$ Ni-IAANB$^+$＋$H^+$ -d[Ni$^{2+}$] / dt = K'[Ni$^{2+}$][HIAANB]$_0$ / [H$^+$] Calibration curve for the spectrophotometric determination of nickel(Ⅱ) ion in the aqueous solution was linear below the concentration of 1.17 ppm at the optimum experimental condition. And the ligand-to-metal ratio, the relationship between extractability and pH of the aqueous phase, and the effect of diverse ion on the determination of nickel(Ⅱ) ion were examined.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.15 no.3
• /
• pp.15-21
• /
• 2011

With petroleum reserves dwindling, interest has been increasing worldwide in Fischer-Tropsch synthesis (FT) as a method of producing synthetic liquid fuels and chemicals from coal, natural gas or biomass. In general, FT synthesis is operated through the gas phase fixed-bed reaction system. Recently, there are lots of study in supercritical fluid due to unique characteristics such as the quick diffusion of reactant gas, effective removal of reaction heat, and the in-situ extraction of high molecular weight hydrocarbon, such as wax. In this study, our major aim is to obtain a deeper insight into the effect of the type of support on the reaction performance over a supported cobalt catalyst in a fixed bed reactor.

• Journal of the Korean Society of Propulsion Engineers
• /
• v.24 no.6
• /
• pp.69-77
• /
• 2020

A quasi one-dimensional multi-phase reaction flow analysis code is developed for the performance analysis of liquid pintle thrusters. Unsteady flow field, droplet evaporation, finite reaction and film cooling models are composed as the major models of the performance analysis. The droplet vaporization takes account of Abramzon's vaporization model, and the combustion employs a flamelet model based on detail chemical reactions. Shine's model is applied for the film cooling calculation. To verify each model, the Sod shock tube, single droplet vaporization, kerosene droplets combustion, and film length are evaluated.

• Microbiology and Biotechnology Letters
• /
• v.15 no.2
• /
• pp.122-128
• /
• 1987

Lipases from Candida rogosa and Rhizopus arrhizus were immobilized by entrapment with photo-crosslinkable resin prepolymer for the study of fat splitting and interesterification in isooctane-two phase system. Dioctylsulfosuccinate was selected as the most suitable surfactant during the immobilization. Lipase entrapped with hydrophobic photo-crosslinkable resin prepolymer(ENTP-3000) exhibited the highest activity, whereas lipase entrapped with hydrophilic gel(ENT-4000) was more stable in organic solvent. As the degree of hydrophobicity of the immobilization matrix was increased, Vm(app) of the lipase entrapped was increased, but Km(app) was approximately constant. While the optimum pH of the lipases entrapped on hydrophilic gel (ENT-4000) were around pH 7.0 for Candida lipase and Rhizopus lipase, the reaction rate of the lipases entrapped on hydrophobic gel were less dependent on pH variations for short reaction time. However, for longer reaction time, the lipnses from C. rugosa and R. arrhizus entrapped on hydrophobic gel yielded maximum rate at pH 6.0 and 6.5, respectively, Entrapment method endowed the lipase with thermal stability.