• Journal of the Korean Society of Safety
• /
• v.14 no.1
• /
• pp.101-107
• /
• 1999

$TiO_2$ and $xTiO_2-ySiO_2$ system photocatalysts were developed by sol-gel method based on the change of production parameters, and their structure of crystallization and the specific surface area was measured. Considering the efficiency of the ethanol decomposition using the catalyst, the conclusion was made as follows: 1) By means of X-ray analysis of $TiO_2$ powder that is obtained from water and Titanium alkoxide with various molar ratios, it is shown that structure of crystallization is a dominating structure and, on the other hand, the crystallization of rutile also partly exists. The specific surface area is at its maximum value at R=6, which is the molar ratio of water vs. alkoxide, whereas its value goes down as the molar ratio increases. In the reaction of using $TiO_2$ catalyst, the ethanol is decomposed into the extent of 15 ~30% in an hour and three hours are necessitated for 70% decomposition. 2) $TiO_2/SiO_2$ powder is developed from Titanium and Silicon alkoxide by a hetero-condensation process. The increase of SiO$_2$ contents causes the decrease of the degree of crystallization of the gel, whereas the specific surface area preferentially increases. In the decomposition reaction of the ethanol, the decomposition efficiency represents 25~60% in an hour. It is, however, examined that the efficiency inactively increases corresponding to the duration of reaction time. It is shown that more than 90% of ethanol is decomposed when reaction time is about three hours and the efficiency illustrates the maximum value for 60-$TiO_2/4O-SiO_2$ catalyst.

• Korean Chemical Engineering Research
• /
• v.45 no.6
• /
• pp.582-590
• /
• 2007

In view of the analysis of the phenomena and the prediction of the performance, mathematical modelling and simulation of a high temperature pilot reactor for water gas shift reaction (WGSR) has been carried out. Multiscale simulation incorporated computational fluid dynamics (CFD) technique, which has the capability to deal with the reactor shape, fluid and energy transport with extensive degree of accuracy, and process modeling technique, which, in turn is responsible for reaction kinetics and mass transport. This research employed multiscale simulation and the results were compared with those from process simulation. From multiscale simulation, the maximum conversion of was predicted approximately 0.85 and the maximum temperature at the reactor was calculated 720 K, resulting from the heat of reaction. Dynamic simulation was also performed for the time transient profile of temperature, conversion, etc. Considering the results, it is concluded that multiscale simulation is a safe and accurate technique to predict reactor behaviors, and consequently will be available for the design of commercial size chemical reactors as well as other commercial unit operations.

• Korean Journal of Environmental Agriculture
• /
• v.6 no.1
• /
• pp.44-49
• /
• 1987

Present work has been initiated to see if inherent biochemical difference among plants is, in any way, related to the observed selectivity characteristics of preemergence herbicide, alachlor. Application of aqueous solution of alachlor onto three intact plants, soybean, chinese cabbage and barnyard grass resulted in phytotoxicity responses in the testt plants in varying degree. Examination of glutathione (and homoglutathione) contents of the test plants indicated that the phytotoxicity is inversely proportional to the peptide contents of the test plants. It was also noted that four to five water soluble metabolites are readily formed in intact seedling treated with labelled alachlor and glutathionealachlor and homoglutathionealachlor conjugates were tentatatively identified as major metabolites. It is concluded that conjugation reaction involving glutathiones and xenobiotic alachlor, a typical phase II reaction, acts as detoxification reaction in the three test plants and this would, in turn, contribute to observed selectivity of alachlor.

• Korean Journal of Materials Research
• /
• v.26 no.2
• /
• pp.73-78
• /
• 2016

$TiO_2$ nanoparticles were synthesized by a sol-gel process using titanium tetra isopropoxide as a precursor at room temperature. Ag-doped $TiO_2$ nanoparticles were prepared by photoreduction of $AgNO_3$ on $TiO_2$ under UV light irradiation and calcinated at $400^{\circ}C$. Ag-doped $TiO_2$ nanoparticles were characterized for their structural and morphological properties by X-ray diffractometry (XRD), scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and transmission electron microscopy (TEM). The photocatalytic properties of the $TiO_2$ and Ag-doped $TiO_2$ nanoparticles were evaluated according to the degree of photocatalytic degradation of gaseous benzene under UV and visible light irradiation. To estimate the rate of photolysis under UV (${\lambda}=365nm$) and visible (${\lambda}{\geq}410nm$) light, the residual concentration of benzene was monitored by gas chromatography (GC). Both undoped/doped nanoparticles showed about 80 % of photolysis of benzene under UV light. However, under visible light irradiation Ag-doped $TiO_2$ nanoparticles exhibited a photocatalytic reaction toward the photodegradation of benzene more efficient than that of bare $TiO_2$. The enhanced photocatalytic reaction of Ag-doped $TiO_2$ nanoparticles is attributed to the decrease in the activation energy and to the existence of Ag in the $TiO_2$ host lattice, which increases the absorption capacity in the visible region by acting as an electron trapper and promotes charge separation of the photoinduced electrons ($e^-$) and holes ($h^+$). The use of Ag-doped $TiO_2$ nanoparticles preserved the option of an environmentally benign photocatalytic reaction using visible light; These particles can be applicable to environmental cleaning applications.

• Korean Journal of Metals and Materials
• /
• v.47 no.12
• /
• pp.828-833
• /
• 2009

As a fundamental study in the development of a distillation process for ferromanganese alloy melts, the evaporation behavior of an electrolytic manganese melt under reduced pressure was investigated. The melt temperature, vacuum degree, surface area of the melt, and reaction time were considered as experimental variables. The amount of vaporized manganese increases linearly as the reaction time increases, and the evaporation of manganese was promoted by increasing the temperature and surface area of the melt. In the pressure range below the equilibrium vapor pressure of manganese, the amount of vaporized manganese per unit surface area of the melt increased sharply with a decrease of the pressure in the reaction chamber. An empirical equation for the evaporation rate of manganese was derived by regression analysis. The evaporation coefficient of manganese was determined to be approximately $3.84{\times}10^{-3}(g{\cdot}K^{1/2})/(Pa{\cdot}cm^2{\cdot}min)$ under the investigated conditions.

• Polymer(Korea)
• /
• v.31 no.1
• /
• pp.1-7
• /
• 2007

In this study, the sulfonated ion exchange fiber was synthesized by $Co^{60}\;{\gamma}-ray$ radiation-induced graft copolymerization. Degree of grafting (DG) increased with increasing the total dose and showed the highest value at 50 v/v% styrene monomer. And also, the degree of sulfonation (DS) increased with increasing the DG and reaction temperature. DS showed the maximum value at 20 min. Ion exchange capacity and swelling ratio of ion exchange fibers increased with increasing the DS and their maximum values were 4.76 meq/g and 23.5%, respectively. Ammonia adsorption increased as increasing the ammonia concentration and ion exchange capacity and remained constant over 10 cycles.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.23
• /
• pp.10469-10473
• /
• 2015

Background: Solanum nigrum L. has been used in traditional Chinese medicine because of its diuretic and antipyretic effects. The present research concerned effects of crude polysaccharides isolated from Solanum nigrum L. on erythrocyte membranes of tumor-bearing $S_{180}$ and $H_{22}$ in mice. Materials and Methods: Fluorescence-labeled red blood cell membranes were used with DPH fluorescence spectrophotometry to examine erythrocyte membrane fluidity, and colorimetry to determine degree of erythrocyte surface membrane blocking. Extent of reaction by tumor-bearing mice with the enzyme erythrocyte membrane bubble shadow detection of red cell membrane variation in the degree of closure before and after administration. Results: Solanum nigrum polysaccharide could significantly improve the $S_{180}$ and $H_{22}$ tumor-bearing mice erythrocyte membrane fluidity, compared with the control group, the difference was significant (p<0.01), SNL can significantly improve the red blood cell membrane and then $S_{180}$ tumor-bearing mice sealing ability, compared with the negative control group, the difference was significant(p<0.05, p<0.01). $H_{22}$ tumor-bearing mice can increase red cell membrane and then sealing ability, the difference was significant (p<0.05). Solanum nigrum polysaccharide degree of fluidity and blocking two transplanted tumors in mice restored the ability to raise the red cell membrane has a significant effect. Conclusions: Solanum nigrum L.-type mice transplanted tumor can affect the red blood cell membrane fluidity and re-closed, through the red cell membrane of red blood cells to enhance the immune function of the possibility of erythrocyte immunity against tumor formation garland provide experimental basis.

• Journal of the Korea Institute of Building Construction
• /
• v.13 no.6
• /
• pp.522-529
• /
• 2013

As concrete forms, panel forms made of plywood used to be widely used, but recently a system form made of aluminum has been broadly adopted because of the advantages it offers in terms of constructability and economy. However, an aluminum form reacts with concrete, which is alkali, and creates hydrogen gas. As a result, air pockets occur on the concrete's surface, and its finishability deteriorates. Therefore, this research analyzed the relationship between the distribution of voids and surface roughness and the damage degree and number of uses of the aluminum form. The analysis of the distribution of voids shows that the number of voids of 0.1~1 mm, which are considered to have occurred because of chemical reaction, was 200~500 on the coating plywood, but was 1 500~2 000 on the aluminum form after 3 uses, and impossible to count after a higher number of uses. Surface roughness was $1.7{\sim}3.2{\mu}m$ on the coating plywood form, but was about $2.6{\mu}m$ after the first use and about $6.8{\mu}m$ after 10 uses, a 2.6-fold increase. Distribution of voids did not show a particular tendency depending upon the degree of damage to the concrete form, but surface roughness showed an increasing tendency as the degree of damage grows. Therefore, when using aluminum forms, surface maintenance should be carried out completely, such as prevention of damages to the form surface coating materials and spreading of separating materials on forms.

• The Journal of Korean Medicine
• /
• v.31 no.2
• /
• pp.36-47
• /
• 2010

Objective: The purpose of this study was to investigate the effects of skin application with Gelidium amansii extract on skin with deep second degree burns in mice. Methods: BALB/c mice were divided into four groups: normal (NOR) group; burn-elicited mice (CON) group, Silmazine-treated mice after burn elicitation (ST) group, and Gelidium amansii-extract treated mice after burn elicitation (GT) group. To examine the skin recovery effect after burn, changes of burn area, angiogenesis and histologic structure were analyzed. To measure effect of edema regulation, matrix metalloproteinase-9 (MMP-9) was analyzed. To estimate the skin regenerative & stable effect, 5-bromo-2'-deoxyuridine (BrdU) and substance P were analyzed. Results: 2 weeks later, 1. The size of burn area decreased in the GT and ST groups more than the CON group. 2. Alleviation of angiogenesis appeared in the GT and ST groups more than in the CON group. 3. Blood clot, epithelial cell hyperplasia, and inflammatory cell infiltration declined in the GT and ST groups more than in the CON group. 4. MMP-9, BrdU, and substance P positive reaction decreased in the GT and ST groups more than in the CON group 5. In the comparative study, the GT group was superior to the ST group. Conclusion: The skin application of Gelidium amansii extract could lessen skin damage by the medium of regulation MMP-9 activation. This skin stabilization was induced in mice with deep second degree burns.

• Korean Journal of Food Science and Technology
• /
• v.41 no.6
• /
• pp.622-627
• /
• 2009

The objectives of this study were to evaluate a protease suitable for the enzymatic hydrolysis of a snow crab processing by-product (SPB) and to optimize the hydrolysis conditions using response surface methodology (RSM). The SPB was hydrolyzed at $50^{\circ}C$ and pH 7.0-7.2 to obtain various degree of hydrolysis (DH) using Flavourzyme at an enzyme/substrate (E/S) ratio of 3.0%. The reaction progress curve exhibited an initial fast reaction rate followed by a slowing of the rate. The DH was increased to 30% at 90 min with a final DH 32 to 36%. A central composite experimental design having three independent variables (reaction temperature, reaction time, and E/S ratio) with five levels was used to optimize the enzymatic hydrolysis conditions. Based on the DH data, the optimum reaction conditions for the enzymatic hydrolysis of the SPB were a temperature of $51.8^{\circ}C$, reaction time of 4 hr 45 min, and an E/S ratio of 3.8%. It was demonstrated that the enzymatic hydrolysate of SPB could be used as a flavoring agent or a source of precursors for the production of reaction flavors.