• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.39 no.11
• /
• pp.891-896
• /
• 2015

This experimental study investigated the wake flow around an elastically supported circular cylinder. In this study, the Reynolds numbers are varied in the region of $1.4{\times}10^4{\leq}Re{\leq}3.2{\times}10^4$. Under these conditions, we have captured the process of the wake mechanism and the moving path of the vortex by measuring the velocity at each position in the wake around the cylinder. Further, these facts from the wind tunnel test are proved by a flow visualization test through a water channel. From the result, we have arrived at the following conclusions : i) The process (formation${\rightarrow}$growth${\rightarrow}$collapse) of vortex is observed in the wake around the cylinder, ii) The vortex efflux angle is approximately $16^{\circ}{\sim}17^{\circ}$ under the experimental conditions. These angles have no relationship with the velocity change and the existence of flow-induced vibrations of the cylinder, and iii) The moving path of the vortex center is obtained by spectrum analysis of the fluctuating velocity behind the cylinder. These are confirmed by conducting visualization tests.

• Journal of the Korean Geotechnical Society
• /
• v.37 no.11
• /
• pp.71-81
• /
• 2021

The purpose of this study is liquefaction phenomenon was simulated using the 1g shaking table test. Analysis of liquefaction and Re-liquefaction behavior according to the ground conditions was analyzed when an embankment exists above the ground. The soil used in the experiment was silica sand and the ground composition was a liquefied layer of 50cm (Case 1), a non-liquefied layer of 17.5cm and a liquefied layer of 32.5cm (Case 2). The embankment was formed by fixing the height of 10cm and the slope of the slope at a ratio of 1:1.8. For seismic waves, excitation of a 5Hz sine wave was performed for 8 seconds, and a total of 5 case excitations were performed. In Case 1, it was confirmed that liquefaction occurred at all depths during the first vibration excitation at the free-field and that liquefaction did not occur at all depths except 5cm at the third vibration excitation. At the center of the embankment, liquefaction occurred up to a depth of 20cm during the first vibration excitation, and it was confirmed that liquefaction did not occur at all depths except for a depth of 5cm during the second vibration excitation.

• Journal of Korea Entertainment Industry Association
• /
• v.14 no.8
• /
• pp.397-405
• /
• 2020

The purpose of study was to compare respiratory function and quadriceps muscle activity in stroke patients by applying inspiratory muscle training combined with whole body vibration. In addition, the purpose of study is to present an exercise method for improving the respiratory function of stroke patients and the function of the lower limb muscles of stroke patients. Totally, 21 patients with Stroke patients were randomly assigned to two groups through clinical sampling. 11 patients who applied whole body vibration combined with respiratory exercise were randomly assigned to Experiment Group I, and 10 patients who applied placebo exercise combined with breathing exercise were randomly assigned to Experiment Group II. And for 5 weeks, 4 days/week, 1 time/day, 4 sets/1 time intervention program was implemented. Before intervention, the respiratory function was measured with a maximum inspiratory pressure meter, the lower extremity muscle activity was measured using the surface EMG, and the balance ability was measured using a bug balance test. And after 5 weeks, the post-test was re-measured and analyzed in the same way as the pre-test. In the comparison of changes within the group of experimental group I, there were significant differences in the activity and balance of the respiratory muscle strength, the biceps femoris, and the anterior tibialis muscle (p<.05). In the comparison of the changes in the experimental group I, there was a significant difference in respiratory strength and balance (p<.05). In the comparison of changes between groups, there was a significant difference in the activity of the biceps femoris and anterior tibialis (p<.01). In the future, research on protocols for respiratory exercise and whole body vibration to improve neuromuscular function is considered to be necessary.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.25 no.12
• /
• pp.843-855
• /
• 2015

This study developed a band-pass filter based artificial filter bank(BAFB) based on that in order to efficiently obtain the significant dynamic responses. The BAFB was then optimized about the El-centro earthquake wave which was often used in the construction research, and the software implementation of BAFB was finally embedded in the wireless unified management system(WiUMS). For the evaluation of the developed BAFB, a real time dynamic response experiment was performed on a cable-stayed bridge model, and the response of the cable-stayed bridge model was measured using both the traditional wired system and the developed BAFB-based WiUMS. The experiment results showed that the compressed dynamic response acquired by the BAFB-based WiUMS matched significantly with that of the traditional wired system while still carrying sufficient modal information of the cable-stayed bridge. Finally, the developed BAFB was able to reconstruct or re-sample the dynamic response wholly from the compressed response signal, and it can be applied as a new kind of measurement system for a wireless sensor networks based structural health monitoring system that secures both economy and efficiency.

• Journal of the Korean Ceramic Society
• /
• v.31 no.7
• /
• pp.695-702
• /
• 1994

Current study was undertaken to explain the structural evolution and corresponding changes in the properties of calcium aluminate glasses with the variation of SiO2 doping concentration. Calcium aluminate glasses in the compositional ranges of (100-x)(0.6CaO+0.4Al2O3)+xSiO2(where x=0~60) were fabricated. DTA analysis confirmed an anomalous behavior in glass transition temperature (Tg) with the maximum of 887$^{\circ}C$ and minimum of 859$^{\circ}C$ when x=5 and 50, respectively. densities and refractive indices monotonically decreased with increasing SiO2 content and IR transmitting cutoff shifted to shorter wavelength side when the amount of added SiO2 exceeded 5 mole%. IR fundamental vibration absorption peaks showed the change that NBOs were inclined to SiO4 tetrahedron in the low-silica region and NBO per SiO4 tetrahedra changed from 2 to 0 with increasing silica content. Based on the analysis of IR fundamental vibration absorption peaks, the model of the structural change can be proposed in three step: 1) SiO4 scavenged the NBOs located at AlO4-tetrahedra, which resulted in the increased of Tg values, 2) NBOs located in the main network again with a decrease in Tg, and 3) dominated by the decrease in the relative amount of NBOs in the glass system, where Tg re-increased.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.25 no.9
• /
• pp.628-636
• /
• 2015

In this study, theoretical and experimental analyses were performed for creating and moving the zone of quiet(ZoQ) to the ear location of a sitter by using active sound control technique. As the ZoQ is actively created at the location of the error microphone basically with an active sound control system using an algorithm such as the filtered-x least mean square(FxLMS), the virtual microphone control(VMC) method was considered to move the location of the ZoQ to around the sitter`s ear. A chair system with microphones and loudspeakers on both sides was manufactured for the experiment and thus an active headrest against the swept narrowband noise as the primary noise was implemented with a real-time controller in which the VMC algorithm was embedded. After the control experiment with and without the VMC method, the location variation of the ZoQ by analyzing the error signals measured by the error and the virtual microphones. Therefore, it is observed that the FxLMS with the VMC technique can provide the re-location of the ZoQ from the error microphone location to the virtual microphone location. Also it is found that the amount of the attenuation difference between the two locations was small.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.05a
• /
• pp.89-101
• /
• 2006

This study is a part of ???A study of the community noise:new guideline and policy' which have three main topics and ten sub-topics. Accordingly this part deals with a transpotation noise specifying road traffic ,railroad and aircraft noise, respectively. At first, the ,roadside traffic noise of whole country in 2004 ,22 major cities of total 29 was exceeded the envionmetal noise standards, 55dB(A) at night time ,therefore 24 milion people ,52.4% of korean, who reside at roadside estimates to be exposured the basic problems of this serious noise polluation comes from:: i)It's very limited noise mitigation measures against to continuously increase the number of automobile yearly. ii) and at beginning of road design, It has been neglect to introduce the anti-noise design and layout of road structural scheme as gadient,cutting and viaduct,embankment and zonning of roadside land-buffer area and also re-designation of noise sensitive areas,etc. Secondly ,concerned with the railroad trafffic noise, a inhabitants who are over the envionmetal noise limits,70dB(A), 65 dB(A) in day and night for 34 locations of mayor cities was exposured of 167,000 and 329,000 respectively. With the development of noise mitigation schemes in line with this study it is likely that noise monitoring system needs new installation as well as common use of noise assessment index with $L_{MAX}\;and\;L_{EQ}$. Lastly,noise complaints of millitary aircraft has been rapidly increasing ,so 2.9%(1.4 minion) person demands a compansation of \2,133 billion complying with their requirements we suggest to minimise the airport noise that is to develop of noise abatement procedure ,to make new noise index, to increase budget for house insulations and also to more increase of those the noise monitoring system and to unify the management etc.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2017.05a
• /
• pp.714-717
• /
• 2017

Among the factors considered in the design stage of a space launch vehicle using liquid propellant, research has been focused out on the pogo phenomenon, longitudinal dynamic instability. The pogo phenomenon refers to the instability that the longitudinal vibration of the launch vehicle structure causes a change in the pressure and flow rate of the fluids in propulsion system, and this change re-excites the fuselage structure. This mechanism constitutes a closed system to gradually increase the vibration of the launch vehicle. This paper specifically focuses on the dynamic analysis of pressure and flow changes in the propulsion system. Based on the example study of the space shuttle, the acoustic modal analysis of the propulsion system is performed to predict the modes of the supply line causing instability of the fuselage.

• Journal of the Korean Society for Precision Engineering
• /
• v.18 no.8
• /
• pp.48-53
• /
• 2001

In order to increase productivity and efficiency, high-speed rotating machines become popular these days. The high-speed rotating machine is likely to vibrate and cause machine failure even though it has small unbalance. Therefore, a balancing technique is studied in this paper. Off-line balancing methods are inadequate to solve unbalance vibration problem occurring in the field due to flexible rotor effect, faster tool change, and shorter spin-up and down, etc. An active balancing is suggested to allow re-balancing of the entire rotating assembly in the machine when a tool is changed. This paper shows how to identify the dynamics of the system using influence coefficient and suggest an active balancing technique based on influence coefficient method for high-speed spindle system.

• Journal of Biosystems Engineering
• /
• v.34 no.6
• /
• pp.425-433
• /
• 2009

The developed final shattering machine for labor-saving mechanization of shattering of sesame consisted of input part, shattering part, re-shattering part for unshattered pod and pneumatic sorter. The bundle of sesame was held as upside down and fed into the machine continuously. Then, the fed bundle of sesame was shattered by side shock and agitation. The performance of shattering for the sun dried bundle of sesame of conventional manual work and final shattering machine was compared. Since the shattering ratio measured by the final machine was 97.2% at the first operation, in case of fully dried sesame by drying stand, the harvest of sesame can be completed by only one time shattering operation. The work hour per area of 10 a for the mechanical work and the manual work were 0.3 hour and 13.9 hour, respectively. The total shattering ratio of the final machine with vertical feedings of bundle of sesames was 97.2%.